Error message on installation with 3250

Hiya
I've upgraded PC suite from v6.5... I'm trying to install the latest version of PC Suite (from the Nokia site) but keep getting the following error message:
'Error 1901.Error attempting to read from the source installation database: C:\WINDOWS\Installer\3e10da.msi.'
I kept clicking retry only to get the same message so had to cancel it entirely.
Anyone got any ideas as to how to solve this?
Thanks in advance x

what is your windows version, is it original and official with all the needed service packs etc. ?

Similar Messages

  • I have a problem with installing PS13 as I get an error message "This installer does not support installation on a 64-Bit Windows operating system. Please download the 64-Bit version of Photoshop Elements." how do i do this?

    i have a problem with installing PS13 as I get an error message "This installer does not support installation on a 64-Bit Windows operating system. Please download the 64-Bit version of Photoshop Elements." how do i do this

    Try downloading the trial. It ought to detect that you have a 64-bit system.
    You aren't using Vista, are you? PSE 13 requires at least win 7 and I think a few folks with vista have gotten a similar error message on trying to install it.

  • When I try to install adobe photoshop 13 on my computer it comes up with the following error message " This installer does not support installation on a 64bit windows operating system" error code 6. How to I recify this? TIA

    When I try to install adobe photoshop 13 on my computer it comes up with the following error message " This installer does not support installation on a 64bit windows operating system" error code 6. How to I recify this? TIA

    You can try downloading the 64 bit version.  You can download the trial version of the software thru the page linked below and then use your current serial number to activate it.
    Be sure to follow the steps outlined in the Note: Very Important Instructions section on the download pages at this site and have cookies enabled in your browser or else the download will not work properly.
    Photoshop/Premiere Elements 13: http://prodesigntools.com/photoshop-elements-13-direct-download-links-premiere.html

  • HT201272 I recently upgraded from an Iphone 4S to 5. I am having trouble with magicjack; each time i install it it gives me an error message "The installation associated with this device is invalid". Cannot seem to access account info or make calls.

    I recently upgraded from an Iphone 4S to 5. I am having trouble with magicjack; each time i install it it gives me an error message "The installation associated with this device is invalid". Cannot seem to access account info or make calls.

    I have exactly the same trouble.
    If you wet the answer, please let me know!!

  • When downloading itunes onto my windows 7 pc I get the following error message "this installation package could not be opened verify that the package exists and that you can access it"

    I am having trouble downloading Itune, icloud etc onto my Windows 7 PC and keep getting the following error message "this installation pack could not be opened, verify that the package exists and that you can access it"

    tried downloading the quicktime installer, I get the same message with it too

  • I can't Start, Uninstall or Install new iTunes. I'm getting the same error message: Window Installer Service could not be accessed.  No other programs have similar problem. Any suggestion what can be done?

    I can't Start, Uninstall of Install new iTunes. I'm getting the same error message: "Window Installer Service could not be accessed". No other programs having similar problem. Any suggestions how to fix it?

    For general advice see Troubleshooting issues with iTunes for Windows updates.
    The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
    The further information area has direct links to the current and recent builds in case you have problems downloading, need to revert to an older version or want to try the iTunes for Windows (64-bit - for older video cards) (not for XP) release as a workaround for installation or performance issues, or compatibility with QuickTime or third party software.
    Your library should be unaffected by these steps but there are also links to backup and recovery advice should it be needed.
    tt2

  • When I try to install itunes 10.5.2, I get the following error message "The installer has insufficient privileges to modify this file c\progamfiles\itunes\itunes.exe and won't install. help

    When I try to install itunes 10.5.2, I get the following error message "The installer has insufficient privileges to modify this file c\progamfiles\itunes\itunes.exe and won't install. help

    Okay ... so it's not one of the cases of bodged up ACLs on the Apple folder in Common Files. (That's been underlying a few of the recalcitrant E7W5s.
    Just in case, let's try the fixit from the following document:
    Fix problems with programs that can't be installed or uninstalled

  • Error message-The installer has insufficent privileges to modify this file:C:\Program Data\microsoft\windows\start menu\programs\iTunes\.iTunes.ink

    error message-The installer has insufficent privileges to modify this file:C:\Program Data\microsoft\windows\start menu\programs\iTunes\.iTunes.ink     
    How do I correct this to download iTunes so it will run?

    That one's consistent with disk/file damage. The first thing I'd try with that is running a disk check (chkdsk) over your C drive.
    XP instructions in the following document: How to perform disk error checking in Windows XP
    Vista instructions in the following document: Check your hard disk for errors
    Windows 7 instructions in the following document: How to use CHKDSK (Check Disk)
    Select both Automatically fix file system errors and Scan for and attempt recovery of bad sectors, or use chkdsk /r (depending on which way you decide to go about doing this). You'll almost certainly have to schedule the chkdsk to run on startup. The scan should take quite a while ... if it quits after a few minutes or seconds, something's interfering with the scan.
    Does the chkdsk find/repair any damage? If so, can you get an install to go through properly afterwards?

  • Have downloaded i Tunes 10.5.1.42 but get an error message on installation saying unable to write to CFNetwork.dll. This file is present in Program Files\Common Files\Apple\Apple Application Support which is where it should be....any ideas??

    Have downloaded i Tunes 10.5.1.42 but get an error message on installation saying unable to write to CFNetwork.dll. This file is present in Program Files\Common Files\Apple\Apple Application Support which is where it should be....any ideas??
    Is a copy of the CFNetwork file available for download if mine is corrupted?
    Thanks

    get an error message on installation saying unable to write to CFNetwork.dll. This file is present in Program Files\Common Files\Apple\Apple Application Support which is where it should be....any ideas??
    That one's consistent with disk/file damage. The first thing I'd try with that is running a disk check (chkdsk) over your C drive.
    XP instructions in the following document: How to perform disk error checking in Windows XP
    Select both Automatically fix file system errors and Scan for and attempt recovery of bad sectors, or use chkdsk /r (depending on which way you decide to go about doing this). You'll almost certainly have to schedule the chkdsk to run on startup. The scan should take quite a while ... if it quits after a few minutes or seconds, something's interfering with the scan.
    Does the chkdsk find/repair any damage? If so, can you get an install to go through properly afterwards?

  • Error Message, The installer database is corrupt.

    I get the error message, "The installer database is corrupt" when I try to install Photoshop CS3 on my new computer with Windows 8.

    run the cleaner, http://www.adobe.com/support/contact/cscleanertool.html
    restart your computer
    reinstall using compatibility mode.

  • Internet Download error message: the connection with the server has been reset

    With an WRT54GS v6 firmware v 1.50.9 on Windows XP SP2 with Internet Explorer 7, Intel wireless internal adaptor w/ 802.11b,  I was getting the error message "The connection with the server has been reset" when downloading most anything from the Internet.  My IP address would then be reset and download would be interrupted.  To resolve, I turned off the WZC (Wireless Zero Configuration) Services, and this seems to correct the problem.
    Control Panel > Admin Tools > Services > Wireless Zero Configuration > Disable
    Hopes this helps.

    Hi!
    Im using Windows 7.... I tried looking for the Wireless Config - but it isn't in the Services options!
    So, what can I do now?
    Thanx

  • I am trying to update ITunes from 10.4 to 10.5 I have tried from both the program, and from a download on Apple's website. Regardless, I get the following error messages: (1) Installation package for iTunes cannot be found. Try installing to find the inst

    I am trying to update ITunes from 10.4 to 10.5 I have tried from both the program, and from a download on Apple's website. Regardless, I get the following error messages: (1) Installation package for iTunes cannot be found. Try installing to find the installation package 'iTunes.msi' in a folder from which you can install iTunes.  I can't find this folder. I have tried to completely unistall iTunes through the Control Panel, but it wouldn't let me: I tried going directly to the files themselves, but cannot uninstall. Any help would be greatly appreciated. System OS: Win XP SP 3.

    Set the permissions for Everyone in the folder in which CCPackager created, to "Read/Write" enabled. This is strange since there is only an administrator account on the Mac (and that account already has read/write), but it seems to resolve the issue.

  • I tried down loading mozilla firefox to use as a web browser. It was downloaded 100% then when prompted to "run" the error message comes up with a red cross and the message'This file is corrupted" and won't let me proceed. What do I do now?

    I tried down loading mozilla firefox to use as a web browser. It was downloaded 100% then when prompted to "run" An error message comes up with a red cross and the message'This file is corrupted" and won't let me proceed. What do I do now?

    It is possible that your anti-virus software is corrupting the downloaded files or otherwise interfering with downloading files by Firefox.<br />
    You can try to disable the real-time (live) scanning of files in your anti-virus software temporarily to see if that makes downloading work.
    See http://kb.mozillazine.org/Unable_to_save_or_download_files

  • My installation for Photoshop Elements 12 Failed. I have Windows Vista. I get an error message stating:installer failed to initialze. Please help!!

    My installation for Photoshop Elements 12 Failed. I have Windows Vista. I get an error message stating:installer failed to initialize. Please help!!

    Error "Installer Failed to Initialize" | Install desktop application | Windows

  • When I try to reformat there is an error message about configurations with the pointing device

    When I try to reformat there is an error message about configurations with the pointing device
    I am not sure I am on the correct section in the support area for Lenovo.
    I had a mouse issue. It was unable to read the mouse. Now the mouse is working and it is initialized.
    I have no idea why.
    There is an error message saying that I should press F 1or F2. I pressed down F 1 and I tried to work with it and I enabled the mouse or I tried. The mouse is working fine but the computer will not recover completely the way it used to.
    It is very confusing. When I shut down and restart there is an message that was not there before about the pointing device. Also the recovering operation never asked me for disks. Now it is doing that. I have disks but this is all confusing. I just want the computer to be the way it was. It is working fine except for booting up and the messages.

    Hi marissa, welcome to the forums,
    you may or may not be in the right place, but it would certainly help members to help you if you could post exactly which Lenovo system; notebook / computer, you have and which operating system is installed on it.
    Thanks in advance
    Andy  ______________________________________
    Please remember to come back and mark the post that you feel solved your question as the solution, it earns the member + points
    Did you find a post helpfull? You can thank the member by clicking on the star to the left awarding them Kudos Please add your type, model number and OS to your signature, it helps to help you. Forum Search Option T430 2347-G7U W8 x64, Yoga 10 HD+, Tablet 1838-2BG, T61p 6460-67G W7 x64, T43p 2668-G2G XP, T23 2647-9LG XP, plus a few more. FYI Unsolicited Personal Messages will be ignored.
      Deutsche Community     Comunidad en Español    English Community Русскоязычное Сообщество
    PepperonI blog 

Maybe you are looking for

  • HT4437 How do I play ipad air movies on my tv

    I'm trying to play back videos & movies on my ipad air to my tv using a lightning to 30 pin adapter to an apple red, white, & yellow RCA output cable. I'm not getting a signal on my tv. What am I doing wrong? Additionally, I don't see a setting for v

  • Wolfenstein not running on Macbook white early 2008

    hello all. i've been playing RTCW since i had a G4 Cube with Mac OS 9. bought a mini in november 2007, installed it, and been playing it with no problems since then. in december 2008 ago i bought a Macbook white early 2008, and could never get RTCW t

  • Maximum size of a stored procedure

    Hi all, I am having a stored procedure with size specifications mentioned below. SOURCE_SIZE PARSED_SIZE CODE_SIZE ERROR_SIZE 163624 1292 150380 0 Is this exeeding pl/sal standard size? What is the optimal size of a procedure? Does the above given si

  • Is there any documentation on Peoplesoft CRM 9 HelpDesk SLA's?

    Hi, Is there any documentation available on Peoplesoft CRM 9.0 HelpDesk about Service Level Agreements for internal employees? We are looking into implementing Service Level Agreements on the Help Desk module for internal clients (employees). I am lo

  • Skype User issues

    For some reason I cant seem to get the router to allow me to use my cam on Skype and other chat sites.