Error QE503- in QE11 transaction (results acquisition) for Equipment calibration

Question

Hi Gurus
I'm working on QM-PM environment to set-up a Equipment Calibration process.
I've defined a  routing for Equipment, and I've linked few Quantitative Inspection characteristics to the PM Order Operation.
When I run IP10 to schedule the Maintenance plan defined for the equipment, the system create fine a Lot Inspection.
When I try to set the inspection result using QA32/QA11 the system isssue the Error  "QE503-Enter a valuation for this qualitative characteristic"
rather Inspection charactristics are defined QUANTITATIVE !!
Where is the error ??
Thanks in advance for your help.
Claudio

Answer 1

Hello ,
Whenever you are working in QM/PM environment , your using inspection point as well as define sampling procedure in task list so that inspection lot created w.r.t equipment. Now because you are using inspection point w.r.t equipment i.e. 300 then definitely you check and if not maintained then maintain the inspection point valuation in QM customizing in plant level settings.
Before UD it is required to put the valuation against the inspection point and then post the UD.
goto QM---> Basic setting---> Plant level---> Define inspection point valuation.
Now, as you said this is related to MIC, please provide the screen shot of Error message. If any assignment is there then system will provide you the MIC number for which it is required.
Another, check whether you selected the correct task list or not. i.e. same Grp but different grp counter. it may possible that mistakenly you selected the another grp counter.
Check all master data first, and then go to customizing part for correction.
Regards