EVB3 Plug In Problem....I can't hear anything!

All of my plug ins work fine except this one. I checked the plugin folder everything is in place but I'm still not hearing anything.....help I'm stuck?!

EVB3 only works on 3 midi channels 1,2 & 3 for upper, lower and bass pedals respectively.

Similar Messages

  • My iphone thinks my adapter is still plug in so I can't hear anything.

    I bought an adapter so i can use my own headphones for my iphone. after i take this thing out my iphone thinks its still plug in so the speakers don't work. when i tried to call somebody i can't hear anything.

    Frank,
    You can try some of the troubleshooting steps in this article:
    http://support.apple.com/kb/TS1630
    Hope this helps,
    Jennifer B.

  • No sound for incoming calls but it works using speaker and earpiece. I can't hear anything but the other party can hear me clearly. I was told it's hardware problem. Would anyone please help? Thanks

    No sound for incoming calls but it works using speaker and earpiece. I can't hear anything but the other party can hear me clearly. I was told it's hardware problem. Would anyone please help me? Thanks

    This is an annoying problem for many people. Most likely your dock connector (on the bottom where you plug in your phone) is dirty or screwed up and is probably just coincidence that it happened after you updated. Some people have had success cleaning the port with a dry clean tooth brush. There is a long discussion going on at the thread I linked below. Good luck...
    https://discussions.apple.com/thread/2475631

  • Hello apple I have the problem with my iPhone and my friends have this problem too. My iPhone have the problem about calling and answer the call. When I use my iPhone to call I can't hear anything from my iPhone but the person that I call can answer it bu

    Hello apple
    I have the problem with my iPhone and my friends have this problem too.
    My iPhone have the problem about calling and answer the call. When I use my iPhone to call I can't hear anything from my iPhone but the person that I call can answer it but when answer both of us can't hear anything and when I put my iPhone to my face the screen is still on and when I quit the phone application and open it again it will automatic call my recent call. And when my friends call me my iPhone didn't show anything even the missed call I'm only know that I missed the call from messages from carrier. Please check these problem I restored my iPhone for 4 time now in this week. I lived in Hatyai, Songkhla,Thailand and many people in my city have this problem.
    Who have this problem??

    Apple isnt here. this is a user based forum for technical questions. The solution is to restart, reset, and restore as new which is in the manual after that get it replaced for hard ware failure. if your within your one year warranty its replaced if it is out of the warranty then it is 199$

  • My iphone 5 ATT, i can hear the recording, but can not hear anything from neither ear speaker or loud speaker when i call? what is the problem? what can i do, it is out of warranty.

    My iphone 5 ATT, i can hear the recording, but can not hear anything from neither ear speaker or loud speaker when i call? what is the problem? what can i do, it is out of warranty.

    1357b wrote:
    My iphone 5 ATT, i can hear the recording
    What recording?
    but can not hear anything from neither ear speaker or loud speaker when i call?
    You just wrote you could hear the recording...
    You can take it into an Apple store and have it checked out.

  • I can't hear anything on my new itunes microphones plugged into my toshiba

    I can't hear anything why not, I tried all the stuff I thought I needed to try, like going to the sound thing on operating system and taking it off mute, and my diamond is moving, just no sound comes through, it may be a toshiba thing,

    Do you mean the headphones are plugged into your toshiba?

  • My iPod touch has no volume I can't hear anything on it. On pandora you can't hear anything. I've reset it and nothing happened. Do I have to upload it to iOS 6.1.5. Will it do better. Help ASAP

    My iPod touch has no volume I can't hear anything on it. On pandora you can't hear anything. I've reset it and nothing happened. Do I have to upload it to iOS 6.1.5. Will it do better. I dont know what happend to it help ASAP

    Is there no sound period? I mean nothing through the headphones or the speaker? If the sound works only through the speaker or just through the headphones the switch inside the headphone port maybe stuck open. Try plugging and unplugging 10 to 12 times to unstick it. If no sound at all, go into Settings>Music>Volume Limit. See if it is turned on, if so check that the limit is not turned down to zero. If still not the problem try a soft reset, press and hold the power and home buttons together until the Apple logo appears, about 15 seconds, then release. if still no joy go into Settings>General>Reset>Reset All Settings. If still no joy, connect to iTunes via the cable and Restore to backup. If that doesn't work Restore to new. Just remember to save all your stuff that can be wiped before you restore, pictures, music, contacts etc. If none of this works, then maybe a hardware issue contact Apple Genius Bar or store and have your iPod evaluated. Hope this helps, Good luck.

  • I can't hear anything during a phone call

    This just randomly started up this morning, and the nearest Apple store is 2 hours away, so I'm turning here. I have an iPhone 4 (not the S) and the newest IOS. When someone calls me, my phone rings like normal, but when I answer, I can't hear them at all. I can make phone calls, but when I do, I can't hear the phone ringing before the person answers, and I still can't hear anything on the other line. I only know that the call went through because the screen says a call is in progress, and the people I've tested it on can hear me just fine.
    I've tried resetting my phone to factory settings, and I've turned it off and on multiple times. I don't know what else I can do. My phone is in good shape: a hairline crack in the screen, but it's just cosmetic. Nothing else is wrong. I hear all the alerts and everything else I'm supposed to hear, and I was able to have normal conversations as of last night. I dropped my phone early this morning from about 3 feet off the ground, but it's in an Otterbox and well protected. I am somewhat panicking that I can't talk to people, and I'm not eligible for an upgrade until July. Also, I did not purchase the extended Applecare plan.
    If someone could please help, I would really appreciate it. I'm planning on taking it to Best Buy once they open. I don't know if they can do anything, but I'm stuck.

    One more thing:
    I suspect that this problem is not related to the “headphones mode problem” because I have no problems with the laudspeaker.
    Maybe an HW issue?

  • ITunes 7.3.1 - I can't hear anything!

    I upgraded to the new version of iTunes the other day and since then, when I've tried to play a song, the counter still goes like the song is playing but I can't hear anything. I can still hear the sound effects on my computer and I tried playing a movie on QuickTime and the sound works on there fine so it must be iTunes.
    Anyone know what's going on?

    Some have solved the problem by starting Garage Band.

  • Can't hear anything on my iphone after syncing

    Hey, someone please help!
    I've just synced my iPhone and that was all ok.  Now, I can't hear anything on my iPhone.  It rings, but I can't hear the other person speaking, also when I make a call, I can't hear anyone unless I put it on loudspeaker!
    I restored (and used the last backup I had before my sync just now) but it still the same.
    Any ideas?

    Hello Angela,
    Thank you for the details of the issue you are experiencing with sound on your iPhone.  I recommend the following steps for an issue like this:
    Verify that the volume is set to a level you would normally be able to hear.
    Ensure that there is nothing plugged in to the headset jack or the dock connector.
    If the iPhone is in a protective case, make sure that the speaker port isn't blocked by the case.
    Make sure that the speaker and dock port aren't clogged with debris. If necessary, clean it with a clean, small, dry, soft-bristled brush. Carefully and gently brush away any debris.
    If an audio issue occurs when using a specific application, try testing other applications to see if the issue persists.
    If the iPhone is paired with a Bluetooth headset or car kit:
    Try turning off Bluetooth.
    If you experience difficulties with the Bluetooth feature, followthese troubleshooting steps.
    Restart the iPhone.
    If restarting doesn't fix the issue, ensure that your iPhone is updated to the latest version of iOS.
    If the issue is not resolved after restoring the iPhone software, please contact Apple Support.
    You can find the full article here:
    iPhone: No sound or distorted sound from speaker
    http://support.apple.com/kb/ts5180
    Thank you for using Apple Support Communities.
    Best,
    Sheila M.

  • When trying to make calls the timer starts counting as if i am connected but i can't hear anything and my speaker button has turned blue

    when trying to make calls the timer starts counting as if i am connected but i can't hear anything and my speaker button has turned blue

    Did you use the latest backup after setting it up "as new device"? If yes, try again, this time without using the backup, maybe it contains damaged data causing your problem.
    If this does not bring any change, you should get it serviced.

  • Soundblaster recognized, but I can't hear anyth

    I bought an old PS/ IBM PC 300 GL type 656 with Windows 95. The soundblaster is being recognized, but I can't hear anything. I've checked everything on the software side. All mutes are off, it all seems to be working, but no sound. Where am I making my mistake?
    Sound moron

    peace,
    this is really an ennoying problem. in the end i solved
    that...(thanks my god!..).in the begining of my search to fix my
    problem i visited this page and i saw there are others who have the
    same problem... in the end i found out that the problem was
    discussed in this forum and useful sugesstions were posted..i
    returned to this page to anounce it to u.. u can visit this adress
    to see the pcedent discussion about "Going Crazy: Why No Sound w.
    Flash 9 ..."
    http://www.adobe.com/cfusion/webforums/forum/messageview.cfm?forumid=44&catid=184&threadid =1175007&enterthread=y#4209759
    i have tried the following suggestion and fixed my problem..
    i wish it works for you too..
    "All you need to do is to open registry editor by going to
    Start menu, Run, typing regedit and then Enter. After that, in the
    registry editor, walk yourself through the tree in the left pane,
    till you reach
    My Computer\HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows
    NT\CurrentVersion\Drivers32
    And then on the right pane, right click and click on New,
    select String value, enter "wavemapper" (without quots of course),
    ENTER, type "msacm32.drv", ENTER.
    Close the editor. No need to restart. Video on Google and
    YouTube et al would work fine now."

  • I can't hear anything on my iPad mini4 what do I do this happened a few days ago too

    I can't hear anything on my iPad mini 4 and  I tried everything what do I do?!? Even when I have headphones on!?

    Who is your email provider?
    You can try resetting your iPad by simultaneously pressing and holding the Home and Sleep/Wake buttons until you see the Apple Logo. This can take up to 15 seconds so be patient and don't release the buttons until the logo appears. Try again to see if the problem persists.
    If yes, try deleting the mail account and adding it again.

  • When I click on a video on FB that takes me to YouTube, I can't hear anything on my phone.  I am up to date on software.  Any suggestions?

    WWhen accessing a music video on FB that takes me to YouTube, I can't hear anything.  I am up to date on software.  How do I fix this?

    Start Firefox in <u>[[Safe Mode|Safe Mode]]</u> to check if one of the extensions (Firefox/Tools > Add-ons > Extensions) or if hardware acceleration is causing the problem.
    *Switch to the DEFAULT theme: Firefox/Tools > Add-ons > Appearance
    *Do NOT click the Reset button on the Safe Mode start window
    *https://support.mozilla.org/kb/Safe+Mode
    *https://support.mozilla.org/kb/Troubleshooting+extensions+and+themes
    Do a malware check with several malware scanning programs on the Windows computer.
    Please scan with all programs because each program detects different malware.
    All these programs have free versions.
    Make sure that you update each program to get the latest version of their databases before doing a scan.
    *Malwarebytes' Anti-Malware:<br>http://www.malwarebytes.org/mbam.php
    *AdwCleaner:<br>http://www.bleepingcomputer.com/download/adwcleaner/<br>http://www.softpedia.com/get/Antivirus/Removal-Tools/AdwCleaner.shtml
    *SuperAntispyware:<br>http://www.superantispyware.com/
    *Microsoft Safety Scanner:<br>http://www.microsoft.com/security/scanner/en-us/default.aspx
    *Windows Defender:<br>http://windows.microsoft.com/en-us/windows/using-defender
    *Spybot Search & Destroy:<br>http://www.safer-networking.org/en/index.html
    *Kasperky Free Security Scan:<br>http://www.kaspersky.com/security-scan
    You can also do a check for a rootkit infection with TDSSKiller.
    *Anti-rootkit utility TDSSKiller:<br>http://support.kaspersky.com/5350?el=88446
    See also:
    *"Spyware on Windows": http://kb.mozillazine.org/Popups_not_blocked

  • I can't hear anything whatsoever - what am I doing wrong?

    I can't hear anything whatsoever - what am I doing wrong?

    Could you give some more details on your problem, please?

  • Battery 3 - Can't hear anything either

    I'm using battery 3 and I can't hear anything with this at all?

    Brad Low wrote:
    I have changed all the settings and I still can't hear anything in Battery 3 by NI. Any ideas?
    um.. change all the settings again?
    You're going to have to be a little more descriptive than that if anyone here is to stand a chance of being able to help you. I'd suggest you read some threads here and see the kind of fully detailed explanations people give to describe their problems. What equipment are you using, does it work normally apart from this problem, what settings exactly are you talking about, etc etc. I mean if I said to you, 'I can't start my car, I've tried everything, help!'.. would you know where to start?

Maybe you are looking for