Final Settelment Error CJ88

Question

Dear All,
while i am trying to settle the AUC with WBS, i am getting below error message.
Debit to source assignment REV cannot be settled
Message no. KD569
Diagnosis
There are costs for a cost element on the integrated asset under construction (AuC), which were assigned to the source assignment REV in the source structure (-> Sender settlement rule -> Parameters).
This source structure does not have a distribution rule with settlement type FUL. Alternatively the total of the percentage rates is < 100%.
Note:
During FUL settlement (full settlement) of an investment measure, all costs incurred up to the settlement period on the AuC, and not yet settled to the finished asset or to another CO receiver, are settled. During a partial capitalization of the investment measure (settlement with processing type 3, if the measure has not yet got the "Technically complete status"), you can capitalize individual costs from the AuC on the finished asset. Alternatively, you can settle them to another CO receiver.
Procedure
Maintain the distribution rules for source structure REV and settlement type FUL, or use partial capitalization.
If required, change the error message category in Customizing, under General Controlling -> Change message control
Please suggest me where can i maintain the distribution rules for source structure REV and settlement type FUL, Any path or T-Code.
Regards,
Shekar.

Answer 1

Hi,
Allocation Structrure & other setting are all fine, it showing below error message & procedure to resolve.
Error Message
Debit to source assignment REV cannot be settled
Message no. KD569
Procedure
Maintain the distribution rules for source structure REV and settlement type FUL, or use partial capitalization.
If required, change the error message category in Customizing, under General Controlling -> Change message control
Please suggest where i have to maintain the distribution rules for source structre REV and settlment type FUL.