Fire Wire Connect

I have an older iMac ( pod type ) without a wireless connection. I have a MAC Mini. I have a firewire connecting the two.
I can't figure our how to access the iMac from the Mini. I've tried everything that I know but the iMac will not show up on the Mini. ( shouldn't it show up as if it were an external hard drive ? )
Any suggestions ?
Thank you.

When you are starting the iMac, are you holding down the T key - to put it into FireWire Target Disk Mode?

Similar Messages

  • Ipod nano and fire wire connection

    Is a fire wire connection compatible with the second generation ipod nano. It came from the factory with a USB 2.0 cable. I have a 20 gig ipod that was supplied with a firewire connection. Are these two interchangeable with either unit? Awaiting a reply, thanks.

    FireWire cables cannot be used to sync an iPod nano or Fifth Generation iPod.
    (22435)

  • I'm getting a very low signal from my Blackbird interface. The fire wire connection is selected properly and track recording sliders set. However the recording level slider in the lower right corner is grayed out. How can I get better signal?

    I'm getting a very low signal from my Blackbird interface. The fire wire connection is selected properly and track recording sliders set. However the recording level slider in the lower right corner is grayed out. How can I get better signal?

    If it's slow on startup it would be extensions loading or LaunchDaemons starting up. 
    You should have a look in:
    /Library/LaunchDaemons
    /Library/Extensions
    You can count out anything in your home folder and it shouldn't put anything in /System as that's reserved for Apple. 

  • Fire wire - connecting / disconnecting devices

    When connecting a fire wire device like a HD or camera for example, do you need to switch the device and computer of or can you connected it while the computer and device is on like USB ?
    Thanks

    Like USB. Be sure to use the finder to eject the device before disconnecting it or turning it off.

  • Which video cameras w/HD have a Fire Wire connectivity?

    Recently, I bought a Sony video camera w/HD that had a USB cable to transfer data from a video camera HD to IMac. However, when I've attempted to do that, an application IMovie informed me that I must have a Fire Wire cable which video camera didn't have. What kind video cameras are recommend for easy transfer data to IMac?

    Fencer
    When you say HD you mean Hard Drive, right?
    What kind video cameras are recommend for easy transfer data to IMac?
    Any MiniDV camcorder will have a firewire connection.
    Probably you have to read [* THIS THREAD *|http://discussions.apple.com/thread.jspa?threadID=995562&tstart=50].
    Hope that helps !
      Alberto

  • Fire wire connection not supported for 30g iPod

    Can someone please tell me why my newly purchased 30g video iPod is not supported by Fire wire cable. USB cable would take yrs to down load and updated
    thanks

    Try the instructions on this page.
    (21822)

  • 2 fire wire connections

    I have a Fantom 120 x hard drive. It has 2 fire wire ports. I have 2 computers. Can I hook one up to each fire wire port at the same time? I don't want to try it until I hear it's ok. I couldn't get any info on the drive web site.
    Thanks, Don.

    No you can't do that. The other firewire port is to create "chains" of firewire devices.
    You may actually break your device by plugging it into two computers at the same time. Don't do it!

  • Fire wire connection

    I was told this might be a just a software issue however I'm unsure about that.
    My camera connected to Final Cut keeps telling me that no device is not connected when it WAS working the night before and nothing was disconnected.
    When trying to capture footage, I even went to iMovie and iMovie won't recognize the camera anymore. I'm using a 4 to 6 point Firewire for HDV footage, so I even tried it on a older computer and it wasn't recognize it. I thought it might just be the firewire until a friend tried uploading his camera with his different connections including USB to the computer and nothing was still recognized.
    The 2 externals and the USB for a digital camera for Kodak all still work just fine though. The older laptop I tried it on probably isn't a viable source as that things is practically falling apart.
    Any ideas let me know. Thanks.

    have you tried rebooting the computer?
    have you tried another firewire cable?
    dose the device show up in system profiler, under firewire?

  • Since 5.1.1 update can not play music in vehicle. Vehicle is 08 Toyota tacoma with fire wire connection into back of of stock stereo unit. Acessory connected screen glitches and no sound music or notifications will play

    Have tried everything including several restores, set up as new phone. Also deleted firmware file in itunes and restored with fresh firmware all results in the same symptom. Have talked with 3 Apple tech support and no solution. Also tried another 4s 5.1.1 with stereo and it worked perfect so definately an issue with my phone not cable etc....

    http://usaspec.com/product.php?ProductID=17&forceShowProduct=1
    This would be said adapter

  • New ti mac////have old sony cam corder modle ccd-tr940 no fire wire connect

    can i use the camcorder or is there an adapter i can use. how can i convert analog to digital?
    mini mac   Mac OS X (10.3.8)  

    Thanks.
    Then this thread is useful:
    http://discussions.apple.com/thread.jspa?threadID=284047&tstart=0

  • Fire wire or usb Connection for external disk dvd disk drive

    is it worth the extra money buying a external dvd re-wrighter with fire wire connection rather than the traditional usb connection? would it work like a normal disk drive as my internal dvd/cd drive is broken.

    Thanks SCB and malcom
    Ive got a budget of around £100 to spend and have been looking at a lacie dvd+16x light scribe 4.7gb/8.5gb with fire wire. Any idea if there any good?
    Pioneer any models i should be looking for?
    thanks

  • Fire wire - # and number of pins?

    I want to add an external drive to my mac mini (non intel), and I plan to do this with a fire wire connection. I have found that fire wire cables are defined by the number of pins (4 or 6) an number IEEE-1396 or 1394. I believe I need to buy a cable, IEEE-1394 with 6 pins on each end. Can anyone confirm this belief before I buy the cable.
    Thank you for your comments.

    Hi,
    I admit I have never heard of IEEE 1396 before you posted it here.
    However a quick googling came up with quite some hits.
    To my knowledge (and from the Google hits) it seems that IEEE 1396 is used to determine a 6-pin to 6-pin cable connection, whereas IEEE 1394 is used for a 6-pin to 4-pin cable connection.
    4-pin ports are usually only used with external devices, that don't need/want to draw power from the Firewire cable (like Digital cameras and the like) or computers (like Notebooks) that don't provide power over the Firewire cable.
    Nonetheless the only 'official' name for Firewire of any kind is IEEE 1394 with the addition of small letters like 'a' 'b' or 'c' to distinguish the differences in speed (Firewire 400; Firewire 800).
    So look at the Firewire ports you want to connect with the cable to determine which cable you need.
    Take care and thanks for the star.
    Stefan

  • Fire wire issue

    I wish to purchase an Apple computer. The computer must have a fire wire connection. I don’t want to buy an Apple Pro (too expensive and I don’t need all the computering power), is there any Apple computer currently available that would have a fire wire connection other than the Apple Pro? If the answer is “no”, is there any point in me waiting (one is planned) or do I have to go the PC route? Thank you for your assistance.

    Ziatron wrote:
    or do I have to go the PC route?
    No need to go to the "Dark Side".
    There is no dark side.. my 3yr old $560 Acer has served very well as a multi-track (8 simultaneous) mobile recording studio, not one problem or lost session in 3 years, use the built in Firewire for the audio interface. The dual G5 does the same job in the studio, no problems with WinXP or Win7, no problems with Panther, Tiger or Leopard... well, Leopard is a little kludgey mainly because of the extra graphic layers.
    It's all good.
    Get what you need!
    pancenter-

  • What is fire wire

    I would like to buy a hard drive to upgrade my mac from Tiger to Snow Leopard.  I would like to buy an external hard drive. My MacBook is a white 13 inch 2007. My very basic question is: does this mac have fire wire port?  On the left side of the computer there is a port I never use.  The icon is in the shape of a Y.  Is this the fire wire connection?  If not what does the icon above the fire wire connection look like.
    Thank You

    Yes, FireWire is the Y port you have.  The icon is this:
    There are two flavors of FireWire so far: 400 and 800.  They have slightly different cables.  In this picture, the left one is FW 800; the right one is FW 400:
    Pay attention to exactly what interface the drive has (USB vs. FW400 vs. FW800.  All will be compatible with your MacBook, but each will require a differnent kind of cable.  All cables are available from your retailer or from auction sites.

  • Fire wire for backup

    I'm purchasing an external hard drive for TM and hard drive purposes. Is it an advantage to choosing one that has a Fire Wire connection vs a regular USB Connection??

    V.K. is, as usual, entirely correct.
    You may do better with F/W 400 vs. USB, though, as many think it's much more reliable. If you do get a USB drive, get one with it's own power supply, as many people have trouble with those that take their power from the Mac via the USB cable.
    The amount of power available on USB ports is limited, and if some other device like a printer wants some while the disk is busily doing a backup, the disk may not get enough momentarily and the backup may fail.

Maybe you are looking for

  • Messages are in waiting mode in SMQ2

    Hello All, I have plenty of messages in waiting mode of SMQ2. How do I release these messages from the queues. The queue name starts with ABC* in SMQR and it is Registration mode. Please let me know step by step solution and checklist Thanks Mike

  • Creating a Sampler bassline that can be triggered by one key?

    Hi all I've just found the video on the Apple website that shows you how to convert, say, a beat to a sampler instrument using transient markers. A Sampler instrument is created with ascending MIDI notes that can then be altered. I would like to do a

  • How can I save a Photoshop Elements 12 file as HTML?

    How can I save a Photoshop Elements 12 file as HTML?

  • Script validation

    a)I need to check the date validation in javascript.i.e from-date should be less than to-date...both from-date and to-date should be in the format MM/DD/YYYY format. b)i want to check the date difference is comes under catagories of i)Daily(from-date

  • Problem compiling assembler using as

    I am attempting to learn how to program in assembler for my intel mac mini. I wrote a hello world in C and ran gcc with the -S option to have a look. gcc hello_world.c -o hello_world.s -S Then, I tried to use as to assemble this file. as hello_world.