Firewire port status on cisco 435HDC?

Question

Is there any advanced diagnostic screen to see what the status of this port might be? I knew how to get to it on the Motorola boxes but can't find anything similar for this new hardware.

Answer 1

Accessing the VZ OSD Menu Screen Using the Remote Control
The key combinations for the remote control to launch the VZ OSD is to press and hold the "D" key for 3 seconds and then press the  key or the  key. After the "D"  key is held down for 3 seconds, the Message LED on the front panel should start to blink to indicate it is ready
to accept the second key press. The Message LED should keep blinking until the second key is pressed within 10 seconds. If no second key is
pressed within 10 seconds, Message LED should stop blinking and the OSD activation process should be aborted.
Pressing the  key on the remote control on any of the OSD screen will exit from the OSD.
Accessing the VZ OSD Menu Screen Using the Front Panel
The key combinations for the front panel is to press Left Arrow (or VOL –) button and Center (or OK) button at the same time and hold them down for 3 seconds. (The front panel buttons are not available on the Class-E STB.)
Anthony_VZ
**If someones post has helped you, please acknowledge their assistance by clicking the red thumbs up button to give them Kudos. If you are the original poster and any response gave you your answer, please mark the post that had the answer as the solution**
Notice: Content posted by Verizon employees is meant to be informational and does not supersede or change the Verizon Forums User Guidelines or Terms or Service, or your Customer Agreement Terms and Conditions or plan