Flashing apple logo when properly ejected

I eject the ipod nano correctly, but instead of saying "okay to disconnect" it just starts flashing the apple logo. It does not reset.
Why won't the ipod properly eject?
I can go into disk mode, but I don't want to delete all the songs when it will do this each time i disconnect.

Most likely faulty battery. Battery replacement at Apple Store is $80, and you will get perfect working iPhone 4 same as your current iPhone, except it will be working. Make Genius Reservation and take to Apple. Or have battery replaced elsewhere.

Similar Messages

  • Blank screen flashing apple logo

    My iPhone 5 suddenly no repsonse but blank scree. Flashing apple logo when plug in power.

    If still problem see the remainit actions of:
    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar

  • My ipod nano 6th gen just flashes the apple logo when plugged in but goes blank when not plugged in. i have tried changing format to fat32 but i can't on windows 7

    i have recently recieved an ipod nano 6th gen after the 1st gen recall, and out of nowhere it just started flashing the apple logo when connected to computer. Help please!

    Universal Serial Bus controllers
         Intel(R) ICH9 Family USB Universal Host Controller - 2934
         Intel(R) ICH9 Family USB Universal Host Controller - 2935
         Intel(R) ICH9 Family USB Universal Host Controller - 2936
         Intel(R) ICH9 Family USB Universal Host Controller - 2937
         Intel(R) ICH9 Family USB Universal Host Controller - 2938
         Intel(R) ICH9 Family USB Universal Host Controller - 2939
         Intel(R) ICH9 Family USB Universal Host Controller - 293A
         Intel(R) ICH9 Family USB Universal Host Controller - 293C
         USB Composite Device
         USB Root Hub
         USB Root Hub
         USB Root Hub
         USB Root Hub
         USB Root Hub
         USB Root Hub
         USB Root Hub
         USB Root Hub
    I'm not sure if it charged when I hooked it up to my roommate's computer, but it definately didn't register either. If I put it on the dock it plays so the port is fine, but that still doesn't help me sync it to my computer.

  • My iPhone 4 won't turn on unless I plug it in to a charger it says the battery is 100% and that I need to conect to iTunes when I plug it in to my computer it just comes up with a flashing apple logo :(

    My iPhone 4 won't turn on unless I plug it in to a charger it says the battery is 100% and that I need to conect to iTunes when I plug it in to my computer it just comes up with a flashing apple logo :(

    The terms of service of the Apple Support Communities prevent us from helping anyone with a jailbroken phone.
    You're on your own.  Good luck.

  • Iphone 4 unresponsive and flashes apple logo but itunes wont recognise it . when plugged into the mains it turns onto recovery mode and asks to be plugged into itunes, when i unplug it from the mains it turns straight off again

    please help! my iphone randomly went unresponsive, when plugged into itunes it flashes apple logo and itunes doesnt recognise it and when plugged into the mains its in recovery mode, asks to be connected to itunes, but immediately turns off when unplugged from mains

    You could try to do a hard reset, sometimes resetting the phone helps. Hold down the sleep/wake button on the top and the home button until you see the apple logo, this make take a minute or two but this might help.

  • AppleTV 3 only showing Apple logo when connected to very new Panasonic plasma - worked Ok with older Panasonic (2007)

    AppleTV 3 only showing Apple logo when connected to very new Panasonic plasma - worked Ok with older Panasonic (2007) - have reset AppleTV, tried 3 HDMI cables.

    Tried again as you suggested - no luck. Ref sequence below
    A. Pressed menu & down to reset Apple TV
    B after reset & restart pressed menu & up buttons to change resolution. After pressing both buttons for 6 sec, LED starts flashing - released both buttons. TV screen blank. After 20 to 30 sec horizontal lines came on screen remained for 20 sec then screen again went blank. Waited for couple minutes. LED still flashing - pressed Menu button for 2/3 sec  - flashing stopped & LED glows continuously. Screen blank
    C. Reset the unit again by pressing menu & down. When it restarted - while LED was still flashing, got orange color screen with Apple logo in the middle. This screen remained till LED stopped flashing & then screen went blank

  • My ipad mini is showing an flashing apple logo

    My ipad mini is showing an flashing apple logo.i have tried resetting (off button and home button), but when it turns back on, its the same problem., i have also tried a hard reset twice, but it wont continue until i put the passcode into ipad.any help really appreciated.

    Hi patriciabognorregis,
    Thank you for using Apple Support Communities.
    To help resolve this issue where your iPad will not boot past the Apple logo, I'd like you to please follow the troubleshooting steps in the article linked to below.
    iOS: Not responding or does not turn on - Apple Support
    Take care,
    Alex H.

  • Flashing Apple logo - does not come on and cannot power it down

    My husband has original iPhone from Dec '07. For some reason, while using it, his volume went low and he could not raise it. He tried powering it down to reset it but screen went black and then apple logo came on, then went black, then came on, flashing like that for several minutes before going black. He brought it home, i tried holding the sleep/wake button, but same result - flashing apple logos for few minutes, then black. Tried holding home button but also same result. Plugged into computer - it came on but the "Sync in Progress, do not disconnect" did not come on and phone did not register on desktop even though iTunes showed it. Anyways, did a complete restore with most recent software but again, we're still having the same problem. Phone works when plugged into computer, but not in the way it should and once you unplug it from the computer, sleep/wake button does nothing and cannot power it down. After restoring it, i again tried to power down holding sleep/wake button, but got flashing apple logos again. Any suggestions? Do we need to just take this in and have it looked at?

    Have you tried booting it to recovery? If you haven't, try these steps:
    1) Close iTunes and unplug and power down your iPhone
    2) Press and hold the home button
    3) Keeping the home button held down, plug your iPhone into your computer
    5) Keep the button held down until a recovery screen with a pic of a USB cable with an arrow pointing to an iTunes icon shows.
    6) Open iTunes and perform a restore
    If this doesn't solve your problem, you have to go to an Apple store and get it exchanged, as the above post said.
    Message was edited by: eaglesflight1258

  • 7th gen nano flashed apple logo

    My 7th gen ipod nano is flashing the apple logo when connected to the computer and nothing when disconnected. I finally got to a point that the PC saw it and went through the restore then when itunes tried to reboot to complete restore it went back to flashing the apple logo.

    Howdy tiffanyboho,
    Thanks for using the Apple Support Communities.
    From your post I see that your iPod nano will not boot past the Apple logo, and it will not allow you to restore through iTunes.  To troubleshoot this issue, please follow the steps in the article below.
    iPod only shows an Apple logo and doesn't start up - Apple Support
    Take care,
    Alex H.

  • My ipod touch is not connecting to itunes and wont turn on all i get is the apple logo when i turn it on. how do i fix this?

    My ipod touch is not connecting to itunes and wont turn on all i get is the apple logo when i turn it on.
    How do I fix this?
    can anyone help?

    Start her:
    iOS: Not responding or does not turn on

  • My iPod says "cannot be synced. The required file cannot be found. Always when half way through a sync. It also shows apple logo when I try to access photos and I think the issues are linked. Any ideas?

    My iPod says "cannot be synced. The required file cannot be found" it also defaults to apple logo when I try to access photos. I think the issues are linked. Any ides?

    So you have tried removing/trashing your iPod's photo cache? See here for more information on where to find this file.
    iTunes: Understanding the iPod Photo Cache folder
    B-rock

  • HT4623 After installing the above mentioned update, my ipad will no longer turn on. I have just a black screen with the apple logo when I attach it to a power source.  Anyone else having this problem, please advise on how to fix.

    After installing the above mentioned update, my ipad will no longer turn on. I have just a black screen with the apple logo when I attach it to a power source.  Anyone else having this problem, please advise on how to fix.

    IF RESET DOESN'T WORK, FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port. Do not release button until you see picture of iTunes and plug (very important)
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note: Data will be lost

  • I was updating my ipad 2 and got it disconnected and its not responding,giving a blank screen with apple logo. when i connect it to itunes then it is giving an error that enter your passcode but the screen is blank how can enter my passcode?

    I was updating my ipad 2 and got it disconnected and its not responding,giving a blank screen with apple logo. when i connect it to itunes then it is giving an error that enter your passcode but the screen is blank how can enter my passcode?

    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/TS1275
    iPad: Unable to update or restore
    http://support.apple.com/kb/ht4097
     Cheers, Tom

  • How do i get my Iphone 5 to turn back on from the flashing apple logo?

    I kist [icked it up and the screen was black so i put it on the charger and now its a flashing apple logo and i cannot get it to do anything else.

    Hello, lwilson20. 
    I would recommend processing the steps in the article below. 
    iOS: Unable to update or restore
    http://support.apple.com/kb/HT1808
    Regards,
    Jason H. 

  • How can i fix my iphone 3g if and only it displays the apple logo when it is connected to its charger but it displays nothing when the charger is removed?

    how can i fix my iphone 3g if and only it displays the apple logo when it is connected to its charger but it displays nothing when the charger is removed?

    Plug it into a wall outlet and leave it plugged in for approximately 20 minutes.
    Then try a reset by pressing and holding the home and power buttons for 15-20 seconds.
    Does the device power on at this point?  If not, the battery or logic board is gone.
    Take it to Apple for evaluation.
    It may be worth replacing the battery, but I personally wouldn't spend the $149US for an Out of Warranty replacement on a 3+yr old device.

Maybe you are looking for

  • Line chart in jsp

    Hai, i want to generate a line chart in jsp. can you plz help on this. plz dont suggest me any third party tools. Thanks in advance.

  • Linux J2SE 1.5.0 install w/o graphical interface

    Here's a special situation from the geniuses at Sun. 1. Bundle NetBeans for the J2SE. Never mind that people may want a 'server' installation. 2. So, I try to run it with the installer with the -console option on Linux (Fedora Core 4): $ ./jdk-1_5_0_

  • ITunesSetup.exe unable to download

    I cannot download even the iTunes installer everytime I try to download it on internet explorer or firefox it stays at 1% and Estimated Time Left rockets up to like 10 hours. I do not understand this is the first time downloading itunes on this compu

  • Setting up FA Depreciation tables

    I need assistance setting up a sspecial depreciation table where the client has specific requirements to depreciate over 15 months in a declining manner. Where can i find samples of set up steps?

  • Wrong Unit displaying in the QRY

    Hi Friends ,             I have a field in the report which is computed by Price/Qty , I have the price displaying in $ and the Qty displaying in EA. So the final field displaying in my report is $40/EA, but I wanted only $40. Please advice where I n