Flashplayer was working fine, then not recognised when I switch on my computer again

Websites tell me I haven't got the correct version of Flash player installed (I've never had any problems and have always been able to play videos).  I uninstall Flash player following the instructions on the Adobe website and then install the correct version (after changing my internet security settings).  Then videos work perfectly.  When I switch my computer on the next day, it says I don't have the correct version of Flash player installed again.  I reinstalled it again, and everything was fine again.  Now today it says I haven't got any the right version again.
Please help!
Cheers

Hello abk99, 
Welcome to the forums. 
Have a look at this knowledge base article regarding the error message you are seeing. 
KB15544
"Could not launch camera application" error appears when opening the camera on the BlackBerry smartp...
Hope this helps. Have a good day.
-SR
Come follow your BlackBerry Technical Team on twitter! @BlackBerryHelp
Be sure to click Kudos! for those who have helped you.Click Solution? for posts that have solved your issue(s)!

Similar Messages

  • TS3274 The Ipad was working fine, then just went blank. It will not turn on again. It was fully charged.

    The Ipad Air was working fine - then it went blank. It will not turn on again. It was fully charged It is less than 2 months old.

    A reset may help. Tap and hold the Home button and the On/Off buttons for approximately 15-20 seconds, until the Apple logo reappears. When the logo appears, release both buttons.
    No content is affected by this procedure.

  • Itouch 5th gen was working fine then I shut it off and it wont turn on. tried itunes and when its siting here it heats up badly

    Itouch 5th gen was working fine then I shut it off and it wont turn on. tried itunes and when its siting here it heats up badly

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       
    The hotness indicates a possible hardware problem. If the iPod is defective and not abused Apple will exchange it at no cost

  • TS3274 I pad was working fine then started to to get a message I pad not connected to internet. Other devices are working in our home. wireless is working. Help

    I pad was working fine then when tring to access safari or facebook recieved a message Safari cannot open page because your I pad is not connected to the internet. How do I correct?

    1. Turn router off for 30 seconds and on again
    2. Settings>General>Reset>Reset Network Settings

  • Private Photos App - pictures not displaying This app was working fine, then suddenly it won`t display any of the photos.

    This app was working fine, then suddenly it won't display any of the photos. One day the photos were there, gone the next. It still shows how many photos are there but just shows a white screen. I can't export anything to the photo album. Adding photos to existing folders yields the same result, only white screen displayed. However, I can create new albums and add photos to those without issue. Does anybody know how to recover the "missing" photo"  I was going to try reinstalling the app but it's no longer available in the iTunes App Store. Thanks, Tracy

    1, you can't at the moment, though with iOS 5 in the Autumn, from http://www.apple.com/ios/ios5/features.html#photos :
    Even organize your photos in albums — right on your device
    2, by removing it from you synced from and re-syncing. Only photos taken with the iPad, copied to it via the camera connection kit, or saved from emails/websites etc can be deleted directly on the iPad (either via the trashcan icon in the top right corner if viewing the photo in full screen, or via the icon of the box with the arrow coming out of it in thumbnail view)
    3, the location of the photos that you synced to the iPad should be listed on the iPad's Photos tab when connected to your computer's iTunes.
    4, you can copy the photos from your iPad to your computer : http://support.apple.com/kb/HT4083 . You should also be able to delete them from the iPad as part of the transfer process to your computer, and it's then your choice whether to add them to your sync photo list so as to copy them back to the iPad. Copying them to your computer would allow you to organise them into folders and therefore be able to sync them back into separate albums.
    5, I don't use Dropbox either. There are some third-party browser apps in the iTunes App Store that allow you to download pages so that you can view them when offline e.g. Atomic Web (the whole page is saved within Atomic Web, it doesn't place a photo into the Photos app)
    6, deleting content should help. If you remove an app from your iPad then you also remove the content that it's got on the iPad - so if you then decide to reinstall it back onto the iPad then you will need to manually add back any content that you want in it. None of the Apple built-in apps (including Photos) can be removed from the iPad

  • HT201263 my phone just shut off and will not come back on no matter what I do. It was working fine then just went compeltely dark and is unresponsive. Help!!

    My phone was working fine, then just went completely blank, and now is totally unresponsive

    Plug it in to mains power for at least 15 minutes.  If it doesn't automatically come on, try a Reset... press the home and sleep/lock buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.

  • I am no longer able to get video playback on my pad.  Was working fine, then nothing. What do I do?

    I am no longer able to get video play on my pad.  It was working fine, then when I went to use it again later, nothing.  Any suggestions as to what to do?

    Quit the Videos app completely and reboot the iPad. Go to the home screen first by tapping the home button. Double tap the home button and the recents tray will appear with all of your recent apps displayed at the bottom. Tap and hold down on any app icon until it begins to wiggle. Tap the minus sign in the upper left corner of the app that you want to close. Tap the home button or anywhere above the task bar.
    Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
    If that doesn't work - try this. Swipe to the right from your first home screen to get to the iPad Spotlight search. Type in the name of any of your movies in the field at the top. When the movie appears in the search - tap on it and it should start to play. Let it play for a minute or so - hit done - go back to videos app and see if all is OK.

  • FaceTime was working fine then stopped. Wants me to sign in but fails to activate. I rebooted my IPad but that didn't help.

    FaceTime was working fine then stopped. Wants me to sign in but fails to activate. I rebooted my IPad but that didn't help.

    Hi jrthomus,
    Welcome to the Support Communities!  The article below will help you troubleshoot the issue you are having with Facetime on your iPad:
    iOS and OS X: Link your phone number and Apple ID for use with FaceTime and iMessage
    http://support.apple.com/kb/HT5538
    Your iPhone telephone number is linked to your Apple ID when you sign in to FaceTime or iMessage. This allows you to use your iPhone number with FaceTime and iMessage on other iOS devices.
    This feature isn't available on iPod touch (3rd generation) and iPad (1st generation).
    This feature is available with OS X Mountain Lion v10.8.2 or later.
    You can sign in to your Apple ID on an iPhone by tapping Settings > FaceTimeand Settings > Messages > Send & Receive.On iOS devices, find out which addresses are enabled with FaceTime and iMessage by tapping:
    Settings > Messages > Send & Receive > You can be reached by iMessage at:
    Settings > FaceTime > You can be reached by FaceTime at:
    iOS: Troubleshooting FaceTime and iMessage activation
    http://support.apple.com/kb/TS4268
    iPhone automatically registers your phone number for use with FaceTime and iMessage during activation.
    To use FaceTime with your Apple ID, navigate to Settings > FaceTime and tap "Use your Apple ID for FaceTime."
    To use iMessage with your Apple ID, navigate to Settings > Messages > Receive At and tap "Use your Apple ID for iMessage."
    When you enable FaceTime or iMessage with an iPad or iPod touch, you will need to enter a valid Apple ID and password. Other users will be able to contact you on FaceTime and iMessage using this email address.
    iOS: Troubleshooting FaceTime
    http://support.apple.com/kb/ts3367
    I hope this information helps ....
    - Judy

  • Just got familiar with my address book on my YouTube channel. I was adding contacts and everything was working fine then out of nowhere I got a Stop Script.

    Hi,
    I just got familiar with my address book on my YouTube channel. I was adding contacts and everything was working fine then out of nowhere I got a Stop Script pop up notice. I am using Firefox. Now when I go to my address book on YouTube it freezes and I often have to use CTL + ALT + DLT to stop it and start over.
    Is this a Firefox or YouTube problem? I tried looking at this page on IE and the same thing happens.

    You are telling us by yourself that is a Youtube problem, because it happens also on IE.
    Anyway that may be an issue with your e-mail account. Maybe you have too many e-mails and YouTube gets so busy trying to add all of them. If you hadn't added them already, you could export that directions to CSV and divide the CSV in parts so YouTube wouldn't have so much work. How many directions you wanted to add?

  • Is there a way to revive my ipod? it was working fine, then all of a sudden its completely dead.

    is there a way to revive my ipod? it was working fine, then all of a sudden its completely dead.

    Have you seen this article yet?
    iPod won't turn on
    B-rock

  • My iphone 4s was working fine then it just turned off and wont turn back on but my home button dosent work what do i do?

    my iphone 4s was working fine then it just turned off and wont turn back on but my home button dosent work what do i do?

    Apart from the battery being dead (make sure by plugging into a power source for 15 minutes), hold the sleep/wake button and home button together for 10 - 20 seconds or until the apple logo appears.
    If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support

  • I HAD ADOBE READR 10 AND IT WAS WORKING FINE. I TRIED TO INSTALL 11 AND MY COMPUTER GOT JAMMED. I DI

    I HAD ADOBE READR 10 AND IT WAS WORKING FINE. I TRIED TO INSTALL 11 AND MY COMPUTER GOT JAMMED. I DID A SYSTEM RETORE AND GOT BACK TO 10, BUT WHEN I TRY TO USE IT NOW I GET 2 MESSAGES. " THIS APPLICATION HAS REQUESTED THE RUNTIME TO TERMINATE IN AN UNUSUAL WAY" AND ADOBE READER STOPPED WORKING.

    What is your operating system?  What means "JAMMED"?
    P.S. please do not post in all-caps; it is very difficult to read!

  • IPod touch was working fine, then next time will not power on. Just over a year old

    iPod touch was working fine, next time no power uo

    You should try doing a restore. A restore on your ipod touch will delete all it's storage and set it back to it's factory conditions but it should fix your problem. Before the restore, I suggest making a backup file for your ipod touch on itunes.
    To restore your ipod touch:
    1.Connect your ipod touch to your computer and open itunes if not already open.
    2.Select your ipod touch name in the devices section of the source pane.
    3.Click the restore option under the version section in the summary tab. An alert will pop up asking you if you really want to do this. To affirm, click restore.
    4.The restore process has now started.
    With  your ipod touch restored, you can resync it working fine.

  • My itunes app was working fine then all of a sudden I'm getting an error - The Itunes application could not be opened.  The required folder cannot be found.  But it doesn't tell me what folder.

    I am using Windows Vista.  My itunes launched fine until now.  Now I get an error - "The Itunes application could not be opened.  The required folder cannot be found".  I have no idea what file it is looking for.  Has anyone seen this error? 
    I have also tried to uninstall the package and I get the error Could not access network location %APPDATA%\.  And it won't uninstall.  I don't know why it's complaining in both cases. 
    Itunes was working 3 weeks ago with no problem.
    HELP!!! 

    hey did u ever get you itunes fixed?

  • Need help my ipod touch will not let me on the net iam with sky and it was working fine then a padlock appeared next to it and it keeps asking for password

    I have set up my ipod touch too use the internet which is sky its been working fine but now when i try it say unable to join network and there is a padlock beside the sky wi fi thing when i tap that it asks for password and i cant remember the password is there anything else i can try

    You can guess the passwoard.  That is all you can do.
    You can enter the router etup and change the password.  You may have to rese the whole router.  Look at/download the manual for the router to find out how to do that.

Maybe you are looking for

  • Goods receipt against PO in packs

    Hi, As per the buisness requirement, the GR against PO and GI against Process Order occurs packwise. For example GRN occurs against PO for 100 kg in 10 packs of 10 kg each. Similarly GI can occur against process order for 55 kg (5 packs of 10 kg each

  • Dynamically changing frame target

    hi i want set the frame target of a form -tag depending on the value selected from the user. is this possible by setting the response header appropriatly ( and how should i set it). another possibility should be using javascript and onSubmit in the f

  • When I use black wallpaper my lockscreen is error in iOS 7

    My lockscreen an error when I use black wallpaper in iOS 7 you will see the drifference between both of photo. I've already restore, all reset but this error still remains last time it's swipe with normal and error but now it's error all time. please

  • How do i uninstall xcode 4.3?

    hello, i need to uninstall xcode 4.3 because i found out my installation was corrupt. i used CleanMyMac to uninstall the app, but i can't dowload it from the app store because it sais it's still installed. i looked and the /Developer folder doesn't e

  • RMI totally broken on Websphere & AS/400

    I am trying to bind an object to a port using Websphere on the IBM AS/400 and it totally does not work. I developed on Win2K and it works fine, an exception ### ----------> Error initializing RMI interface. Exception Server RemoteException; nested ex