Front audio problem

Question

I purchased a K7N2 Delta NVIDIA nForce 2 FSB 400 Motherboard, and installed it today.  I have everything working except for the front audio port.  The power supply that I have (ATX) has eight cords for the front audio:
1 R In
2 R Out
3 L In
4 L Out
5 Mic-In
6 Mic-In
7 Gnd
8 Gnd
However, in the manual describing the JAUD1 Front Audio Connector it lists ten (two of which have no pins):
1 AUD_MIC
2 AUD_GND
3 AUD_MIC_BIAS
4 AUD_VCC
5 AUD_FPOUT_R
6 AUD_RET_R
7 HP_ON (No Pin)
8 KEY (No Pin)
9 AUD_FPOUT_L
10 AUD_RET_L
So I have two questions:
1. To which port of the JAUD1 panel of the motherboard am I supposed to connect the above eight plugs? I tried different combos with no success.
2. After I figure out which plugs to go into where, do I need to dl the Realtex AC97 drivers, or do I only need to do that if I still have problems.
You guys rock.  Thank you very much for your help.  I look forward to hearing back from you.

Answer 1

Try this (Case connection -> Mobo connection)
1 R In -> 5 Aud_FPOut_R
2 R Out -> 6 Aud_Ret_R
3 L In -> 9 Aud_FPOut_L
4 L Out -> 10 Aud_Ret_L
5 Mic In -> 1 Aud_Mic
6 Mic In -> 1 Aud Mic - Try this instead of 5 if mic doesn't work
7 Gnd -> 2 Aud_Gnd
8 -> 2 Aud_Gnd - Try instead of 7 (or might need to splice them together)
You might need to swap 1&2, and 3&4, depending on what they class as "In" or "Out"
There should currently be a jumper on JAUD1 between pins 5&6 and 9&10
You should get audio out on the rear green socket if there is nothing plugged into the FP socket. (My case doesn't have the switched audio returns from the FP, so I wired it so that the jumpered pins were still connected to each other, as well as to the FP connector.)
Drivers would probably be a good idea.
Cheers