Hardware Clocking Error PCI-5122

Question

I tried to run the vi attached (which i've run many times before) and my computer bluescreen.  When it rebooted, I could no longer use my PCI-5122 digitizer card.  When I try to do a device test or device reset in MAX, it tells me that theres a hardware clocking error..   I was using an external trigger for the aquisition, but don't think I was using an external reference clock.  Could someone help me fix this?
Thanks
NI Hardware: PXI-7853R, PCI-5122, PCI-6733, PXI-1036, PCI-MIO-16E-4, PCI-6110
Computer Hardware: Xeon Quad Core - 2.33 Ghz, 8 GB RAM
Software: Labview 2009, Labview FPGA 2009, Vista 64-bit, MAX 4.6, DAQmx 9.0, NI-SCOPE 3.5
Solved!
Go to Solution.
Attachments:
OPO Monitor.vi ‏53 KB

Answer 1

Hi,
This error may be the result of a hardware failure where the only
solution is a repair or replacement. There are however, some basic
troubleshooting steps that have been known to correct this issue
without a return.
Reboot the PC or PXI controller.
Try a different PCI or PXI slot.
Update the driver to the latest version.
If possible try the card on a different machine.
If these steps to not correct the issue then it is likely the
board requires repair which can be arranged by contacting National
Instruments Technical support (in france: 01 57 66 24 24).
Best regards,
Thomas B. | CLAD
National Instruments France
#adMrkt{text-align: center;font-size:11px; font-weight: bold;} #adMrkt a {text-decoration: none;} #adMrkt a:hover{font-size: 9px;} #adMrkt a span{display: none;} #adMrkt a:hover span{display: block;}
>> Inscrivez-vous gratuitement aux Journées Techniques : de l'acquisition de données au contrôle/com...