Have plugged my ipod into 24 volt truck socket. is it able to be fixed?????
is my ipod fixable i plugged it into 24v truck??
Message was edited by: daleharris
iPods don't take the vehicle voltage directly so you have to use a USB to iPod lead, and USB is 5V. Automobile adapters expect 12V and convert to 5V so you might have blown up the adapter but it should protect the iPod if it sees 24V, but this isn't guaranteed. Depending on the quality of the adapter, it might work fine at 24V continuously, or work for short periods at 24V before shutting down, or blow itself up, or allow more than 5V to the USB, as the quality of design goes down. So if you used a cheap adapter, it could have allowed more than 5V through the USB and this could damage the iPod. It might still work, but after being stressed by more than the specified maximum voltage, it might not.
I'd leave it for an hour in case any internal component got hot, then try turning it on when its not plugged into a charger. Then I'd try charging it using an approved method (USB to computer or an Apple mains charger). If neither work, you are going have to take in for repair/replacement.
Similar Messages
-
My ipod touch 4th gen will not turn on, i have held the power and home buttons, i have plugged my ipod into itunes and tried again, yet nothing happens, what should i do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
i have plugged my ipod into my mac desktop and get no indication of a device while in itunes
If you have iTunes 11 turn on the Sidebar. Go to iTunes>View and click on Show Sidebar. You can also do a Crtl+S to show the sidebar. The sidebar is where Devices appears. and Control+B to show the Menu bar
Then try:
iOS: Device not recognized in iTunes for Mac OS X -
My iPod touch is synced to my old Mac and I have a new PC. Now when I plug my iPod into the new computer it will make the connection sound, but will not show up in my iTunes. I do not care to have the content copied over. Any suggestions?
Start here:
iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows -
have erased my ipod as i am selling it on. I wanted to check all my stuff (pictures, notes ect) had been erased, but everytime i plug my Ipod into the computer it isnt recognized. it says plug into Itunes, and i have. Nothing happens. what do i do? HELP
Start here:
iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows -
i just installed itunes 12 and now when i plug my ipod into my computer it won't sync I have tried different ipods still nothing
Syncing to a "New" Computer or replacing a "crashed" Hard Drive: Apple Support Communities
-
When i plug my ipod into my computer it is not recharging. The computer doesn't even acknowledge that it is plugged in. Any ideas why? It does have power left so i can use it but i want to recharge it of course. Any input is appreicated.
Plug it into the wall using the supplied charger.
Barry -
My ipod nano library is on a computer we no longer have connect to internet. When I plug my ipod into wife's computer all I see his her itunes library. I want to use my wifes computer to get to my library. How can I do this? thanks
never mind. New Itunes seemed to have solved issue.
-
If I deauthorize my desktop and all other computers with my account will I still be able to have all my music if I plug my iPod into my laptop and start using that?
Yes... as long as your Laptop is Authorised.
About authorization and deauthorization -
When i plugged my ipod into the computer it started to make buzzing and screeching noises. It became hot so i removed it and then the screen froze while it continued to make these noises. I have never had anything like this happen. (never gotten it wet or had it exposed to extreme temperatures) It is also unresponsive to any buttons on the ipod and it didn't show up when i plugged it into my computer. What do I do? Also if it is unfixable could i get a free one from apple?
Hey briannagrace96,
Welcome to Apple Support Communities! I'd check out the following article, it looks like it applies to your situation:
iPod: Appears in Windows but not in iTunes
http://support.apple.com/kb/ts1363
You'll want to go through the following troubleshooting steps, and for more detail on each step follow the link to the article above:
Try the iPod troubleshooting assistant:
If you have not already done so, try the steps in the iPod Troubleshooting Assistant (choose your iPod model from the list).
If the issue remains after following your iPod's troubleshooting assistant, follow the steps below to continue troubleshooting your issue.
Restart the iPod Service
Restart the Apple Mobile Device Service
Empty your Temp directory and restart
Verify that the Apple Mobile Device USB Driver is installed
Change your iPod's drive letter
Remove and reinstall iTunes
Disable conflicting System Services and Startup Items
Update, Reconfigure, Disable, or Remove Security Software
Deleting damaged or incorrect registry keys
Take care,
David -
I plugged my ipod into the computer to charge and then, this morning when I went to use it there is a password lock (that I never set up) that I have no idea what it is.
Go to Settings>General>Reset>Erase all content and setting. Then re-setup the iPod with your account/media. To redownload iTunes purchases see:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
I have an IPOD Tough and a MAC. When I plug my IPOD into the MAC, no IPOD device icon appears on the MAC. Additionally when I go to Itunes, there is no IPOD device listed. How can I get the MAC to recognize the IPOD?
See this article for some solutions:
iOS: Device not recognized in iTunes for MAC OS X, http://support.apple.com/kb/TS1591 -
although I plug my iphone5 into a power socket or my laptop,the phone will not charge. The phone indictaes it is charging, but the phone does not recharge
Hi syvliebaby88888888,
If you are having issues with recharging your iPhone's battery, I would suggest that you troubleshoot using the steps in this article -
iPhone and iPod touch: Charging the battery
In particular, this section -
Inspect the connector at the bottom of the phone:
Make sure that there are no bent pins in the connector.
Make sure that the connector is free from debris.
If there are bent pins or debris, please contact Apple Support.
Otherwise, continue troubleshooting.
Make sure that the outlet you're using works.
Make sure that the Apple USB cable and Apple USB power adapter work.
Plug the device in to power and let it charge until your device turns on. This could take between 10 and 30 minutes. If you don't have an Apple USB power adapter, try connecting to a computer's high-power USB 2.0 port (not a keyboard). The computer must be on.
If the device still exhibits an issue, try turning your device off and then on again while connected to power.
If the issue persists, please contact Apple Support.
Thanks for using Apple Support Communities.
Best,
Brett L -
My 120GB IPod classic is not recognized by my Windows 7 PC. When I plug the ipod into my computer I receive a message saying that the USD device is not recognized. The Device Manager lists it as an Unknown Device. I've tried uninstalling iTunes and reinstalling it, but it had no affect. The odd thing is that our other iPod (160 GB Classic) is recognized on the same computer using the same USB cable. When I plug the ipod in question into another PC, the PC seems to recognize the iPod and lists it in Windows Explorer (iTunes is not installed on this machine). There seems to be something out of wack with this PC/iPod combo. Any thoughts on what I can do to try to resolve this issue? I tried all of the steps listed here, but they didn't help me. http://support.apple.com/kb/TS1538
Any help would be greatly appreciated.Are you plugging the iPod into a high powered USB 2.0 port on the back of your PC? Have you tried a different USB cable?
What happens if you try to reset the device with it still connected to the PC?
How to reset iPod
Has this iPod ever worked on this PC or is this the first time you have time you have tried connecting it?
Have you carefully worked through each and every single suggestion in this Apple support document?
iPod not recognized in 'My Computer' and in iTunes for Windows
B-rock -
Recently, U2 music appeared on my ipod without my requesting it or wanting it. I was able to delete all of the songs except for one. How do I delete the last one from my ipod? The song does not show up in iTunes when I plug my ipod into the computer. The version installed on my ipod is 7.1.2(11D257).
Hi donfrommars,
Welcome to the Apple Support Communities!
Please use the following article for information and instruction on deleting the U2 album from your devices and account.
Remove iTunes gift album "Songs of Innocence" from your iTunes music library and purchases
Have a great day,
Joe
Maybe you are looking for
-
Photoshop CS6 shuts downs when using the move tool
Photoshop CS6 shuts downs when using the move tool. It seemas to run fine until i try and use the move tool. PS worked fine just a few weeks ago and now it has this issue. What can i do to resole this issue? Thnaks, System Specs Windows XP Home SP3 A
-
Spry menu problems. Please help.
Hello, I am new to web design so please try and be patient with me . I am trying to create a horizontal spry menu bar into a new page. Even though I select horizontal, the menu is vertical. I have read through many previous posts and FAQ'q, but ca
-
Hi team... I want to know if is possible to block the Term of Payment at lever Contract, Schedule Agreement and Purchase Orders?? Is possible to restric only a Schedule Agreement Level?? How I can do that effect? Thanks.
-
Need the the underlying table names which the Material Plan Detail Search p
Our supply planning users would like to obtain the demand and supply plan for a bunch of given parts by running a query against some tables. The data they need via a PS Query output in Excel format is the same data that is provided by the Material Pl
-
Hi I am having a problem with the World Clock Widget. When Tiger first came out I downloaded a Wideget the helped manage widgets (before apple took care of this) and I ended up deleting that widget. But sometime when I was using that widget World Clo