Hello I am having problem with sound system of my iPod touch

The sound of my iPod touch just becomes low even I have set the tone volume at medium range it started happening from last 2 days it happens when I play a game or app but didn't have affected the sound when played in earphone pls reply thank you

You can try to following to rule out/fix a software problem:
- Reset. Nothing will be lost
Reset iPod touch:  Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Restore from backup
- Restore to factory defaults/new iPod
If still a problem you very likely have a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

Similar Messages

  • HT1657 I am having problems with sound in my rental movies

    We rent movies all the time but lately we are having problems with sound for our movie rentals.  We watch the first half hour without a problem than the voice is choppy all the time.  Sometimes it is good for five minutes than noting for a while.  We  have tried everything we could think of with no avail.  I could see one movie but the last 5 or so have been the same.  Done trying we need to fix this!  Help!  Any ideas?

    First try resetting your iPad by simultaneously pressing and holding the Home and Sleep/Wake buttons until you see the Apple Logo. This can take up to 15 seconds so be patient and don't release the buttons until the logo appears. Try again to see if the problem persists.
    If you still have the same issue, it's possible that something is lodged in the earphone jack. This can cause the iPad to think earphones are plugged in when they are not. Use a vacuum to try to suck any dust, lint or other foreign matter from the jack. If that still doesn't work, try CAREULLY using a toothpick.

  • Hello, i am having problems with itunes store. it wont connect almost as if its hanging, any ideas how to fix this problem

    hello, i am having problems with itunes store. it wont connect almost as if its hanging, any ideas how to fix this problem

    BOB we need you urgently
    Perhaps Bob will see this thread, he is the professor in these cases.
    You do not use a WEP password but wpa/wpa2 on router and equipment.
    All equipment connects to WiFi, but for your iPad.
    Even with all other equipment WiFi off, you cannot connect your iPad.
    Your iPad connects to other WiFi nets correctly.
    All resets etc done on iPad and Router.
    Still I am not sure it is your router for sure, frustrating...
    I want to test 2 other things:
    1. in your iPad, set everything OFF in Settings/Cellular, turn off/then/on your WiFi, and see whether it will still not connect...
    2. If that does not do it: disconnect the router as well as the modem from the power, for 15 seconds, then reconnect the modem, let it fully start, then reconnect the routet let it fully start, turn of your WiFi in iPad, then on, and see whether it will connect.

  • TS1702 Hello, I,m having problems with Polish spell check. It says in iPnstruction that this App (pages) should show my writing mistakes. Check spell button is on but but check spell is not working. Need help Please.

    Hello, I,m having problems with Polish spell check. It says in iPnstruction that this App (pages) should show my writing mistakes. Check spell button is on but but check spell is not working. Need help Please.

    Hello, I,m having problems with Polish spell check. It says in iPnstruction that this App (pages) should show my writing mistakes. Check spell button is on but but check spell is not working. Need help Please.

  • Hello I'm having problems with the installation of EFI 2.2 my macbook shutdown every time I try to install the actualization is this normal?

    Hello I'm having problems with the installation of EFI 2.2 my macbook shuts down every time I try to install the actualization is this normal?

    Hello I'm having problems with the installation of EFI 2.2 my macbook shuts down every time I try to install the actualization is this normal?

  • Can anyone please help me, I'm having problems with sound while watching video clips using flash player using Internet Explorer\

    Can anyone please help me, I'm having problems with sound while watching video clips using flash player & Internet Explorer

    There's a good chance that this is a known issue.  We'll have a Flash Player 18 beta later this week that should resolve this at http://www.adobe.com/go/flashplayerbeta/

  • HT1688 hello i am having problems with my iphone 3gs

    hello i am having problems with my iphone 3gs i cont have a sim card to activate it in there anyway i can by pass the activation part of the phone?

    I would restore the phone as new
    iTunes: Restoring iOS software - Apple
    then get it replaced through apple

  • HT204382 Hi, Ive just got myself a Macbook Pro, and Im having problems with sound on movie files. The format is wmv and they play OK on a windows 7 laptop, and Im trying to play them now on the MAC. The picture is OK , but no sound. I have Flip4Mac - no d

    Hi, Ive just got myself a Macbook Pro, and Im having problems with sound on movie files. The format is wmv and they play OK on a windows 7 laptop, and Im trying to play them now on the MAC. The picture is OK , but no sound. I have Flip4Mac - no diference

    Download and install the free VLC for Mac - that should work:
    http://www.videolan.org/vlc/download-macosx.html

  • Help! Having problems with sound on my 4s

    Ive been having problems with the sound on my iphone 4s, it sometimes has a ringtone and has keyboard clicks but it wont play music or have any ringtones or anything. It doesn't even come up with the volume scroll bar or the volume buttons on the side no longer work. This isn't due to liquid damage or anything, this is a software issue. Is there anyway to fix this?

    pheebs273 wrote:
    I It doesn't even come up with the volume scroll bar or the volume buttons on the side no longer work. This isn't due to liquid damage or anything, this is a hardware issue. Is there anyway to fix this?
    If it's a hardware issuem the hardware needs to be fixed.

  • We recently purchased the iphone5 (2) and are having problems with sound coming thru the earbuds when we plug them in to the iphones.  works fine with the ipad.  help please

    recently purchased the iphone5 (2 of them) and are having problems with the earpods.  no sound when plugged in to the iphone.  both phones.  works with the ipad.  help please

    Hi P5052,
    Welcome to the Support Communities ... and congratulations on the purchase of your iPhone 5's!
    It is very unusual that neither phone is working with the new earpods. 
    Have you tried a different headphone just to see if the issue is with the earpods or the iPhones?
    The article below will give you the basic troubleshooting steps for this issue.
    Click on the link below to see more details and screenshots. 
    I've quoted some helpful highlights for you:
    iPhone: Can't hear through the receiver or speakers
    Symptoms
    When someone calls, I can't hear them through the receiver or speaker phone, and I can't hear music through the speaker. I also can't be heard by someone who is calling me.
    Note: iPhone has one speaker, which is adjacent to the dock connector. On iPhone 4 or later models, the speaker is to the right of the dock connector. On earlier iPhone models, the speaker is to the left of the dock connector.
    Resolution
    Verify that there is nothing plugged in to the headset jack, including headsets, headphones, or adapters.
    Make sure the Ring/Silent switch is not switched to silent.
    While on the Home screen, adjust the volume buttons. If you see the icon below, indicating that headphones are attached, there may be debris or an object lodged in the headset jack:
    Check the headset jack. If there is an object lodged in the headset jack that is not easily removed, have the iPhone serviced to remove object.
    For Original iPhone: If there is light debris, such as lint, in the headset jack, try connecting a pair of headphones to the headset jack and then remove the headphones. Repeat this several times to remove the debris.
    If you have installed a protective film on the display, either ensure that the receiver is not covered or remove the film completely.
    Check the receiver mesh (which is on the top front of the device, above the display). If it appears blocked, use a clean, small, dry, soft-bristled brush to carefully and gently brush away any debris.
    If you have paired with a Bluetooth headset that is nearby, either use the headset or turn Bluetooth off (chooseSettings > General > Bluetooth).
    Restart the iPhone.
    If restarting the iPhone doesn't resolve the issue, try restoring the device.
    If the issue persists, go to the Service Answer Center - iPhone for information on service.
    Hope this helps!
    - Judy
    <Edited by Host>

  • Hello i am having problem with facebook app

    i am having problem with facebook app . the problem is that whenever i logout i still appear to be online .my friends tell me that i am always online but i hardly come on facebook for half an hour on my ipod touch .please tell how to solve this problem coz this can get misunderstanding between me and my friends that being offline they would still think that i am online and not replying them on purpose so please help...thank you..

    Try the Flash Player forum. 
    http://forums.adobe.com/community/flashplayer

  • I am having problems with my system preferences freezing everytime it is opened

    I have had this problem for months. and i want to know if there is something i can do without having to set up an appointment in store. Everytime i open my system preferences app, it freezes and i have to close it before i can even begin to do anything.....

    That means either your graphics card does not support 3D or that there is a problem with your graphics drivers. See if your GPU maker has an update.
    Error: "Graphics hardware not officially supported for 3D" | Photoshop CC, 13.1

  • My ipod classic is having problems with docking system worksok with earphones

    my ipod classic seems to having problems on docking station gear4 houseparty smart dock. its playing ok but am unable to make louder and wont respond to remote . its charged to the full and my sons i phone works perfectly

    Hey Silverdemon, sounds like a short, most likely in the headphones. Try a different set of headphones with this iPod or try the headphones with a different device. If the problem stops with your iPod or it moves to another device, then replace the headphones. If within 1 year of date of purchase Apple will replace the headphones for  free if problem is a defect, not abuse. If the problem continues with a different set of headphones, check the port for damage and foreign debris. If you note debris, attempt to remove it, if damage noted contact Apple and set up an appointment to have it evaluated. if nothing appears wrong, try plugging / unplugging to jack about 12 times maybe corrosion on the contacts if so that should clean it. Next thing to try reset your iPod. After that try restore from backup. Last resort, restore to new. Just make sure you make a full backup to your computer before you restore so no data is lost. If nothing works, contact Apple and set up an appointment to have your iPod evaluated. Good luck, Cheers.

  • I have an i pod and am having problems with sound. When I watch any video on the device with headphones the music is always too loud for the voice meaning i can't hear what is being said. This problem is accompanied with a buzz in some parts of the music.

    When watching a video with my headphones the volume of speech seams very low even when i adjust volume. The speech also tends to make a humming sound in places. When I listen to music humming is sometimes transmitted, but the volume level is normal. The problem is that when the video is playing i can only hear music and humming with the voice too quiet to hear properly. How can I make both volumes balanced? Also. This happens in all music videos.

    - Try cleaning out/blowing out the headphone jack. Try inserting/removing the plug a dozen times or so.
    - Reset the iPod. Nothing will be lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup
    - Restore to factory settings/new iPod.
    - Make an appointment at the Genius Bar of an Apple store. Seems you have a bad headphone jack.
    Apple Retail Store - Genius Bar
    If not under warranty Apple will exchange your iPod for a refurbished one for this price. They do not fix yours.
    Apple - iPod Repair price                  
    A third-party place like the following will replace the jack for less. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens
    Replace the jack yourself
    iPod Touch Repair – iFixit

  • Is anyone else having problems with Sound Check playing tracks at the wrong volume in Album view?

    I have noticed in the last few weeks that when I play an album on iTunes, some of the tracks are played at a lower volume.  I am using sound check, and when I play the tracks individually from the "Songs" view they all play at the correct volume.  However, when i choose album view, some of the same tracks are played at a lower volume.  I have rang the support line and they couldn't tell me why this is happening.  Has anybody else had this happen to them, and does anyone know a way round this?

    I have problems with many of the same issues you mention with zoom on iOS8.  Its not entirely clear if this is intended functionality or a number of bugs.  The setting for full screen view versus window/regional view seems to not apply globally, which is insanely frustrating.  Window view pops up without warning, particularly in a keyboard pop-up event.
    I don't particularly liek the popup menu either, but now I HAVE to use it to constantly change from the sudden change to window focus to full screen zoom.
    Some of the new filter features are nice additions, but don't seem to work well. or be performance optimized.  Low-light, for example, stutters on zooming.
    I would also assert that zooming in and out seems more abrubpt and less accurate.
    iOS8 is definitely a decrease in usability and performance from its predecessors.  Apple, please work out the bugs and get this right!

Maybe you are looking for

  • Profit center substitution ?

    Hi ALL, I am working on a client requirement u201CContract wise Profitabilityu201D (PCA is activated and Document splitting is not activated). thought i am able to get the Contract wise Profitability report , but PC reporting is effected Business pro

  • Pop-up message in Acrobat Pro 9.5.2

    "Adobe Acrobat Updater has not been able to check for updates recently.  Check online to see if solutions are available from the Adobe website."  I have checked online, downloaded everything I can find that appears to apply to Acrobat Pro 9.5.2 and s

  • Trying to open a link in notification, but getting error

    Hi, We have developed a custom page using JDeveloper. The same is registered as JSP Function in apps and is also imported in database. This page works fine. We have developed a custom workflow. A notification is being sent to employees providing a li

  • HT2499 How do I find the DVD remote control and restart my DVD where I left off?

    Hello. I have the external disc player. When I inserted a DVD the first time, the movie started automatically and the DVD remote control came to the screen. However, I had to shut down before I finished watching the movie. I kept the disc drive plugg

  • Regarding shipment process

    Dear Gurus, In shipment process, we assign deliveries to shipments. One shipment means one truck in my company. My question is; If that truck is on way, in that case user can not use that truck again until it is released. So how can I implement it in