Hello I have 2 seperate airport express systems on my network, each connecting to a stereo in a different room. suddenly, the one in the living room will not stop flashing amber, but the one in the bedroom works fine. I have already tried resetting it

Question

Hello
I have 2 seperate airport express systems on my network, each connecting to a stereo in a different room. suddenly, the one in the living room will not stop flashing amber, but the one in the bedroom works fine. I have already tried resetting it with a pin, resetting it while plugging it in, and trying to find it in airport express setup (the setup assistant can't find it at all).
What am i doing wrong?

Answer 1

How do I configure the AX to connect to the hub's wireless network? It will only scan one base station Airport Express at a time in the Airport Utility. I think what I am trying to do is use the hub as a router to the two AX's. Is there a specific way to set this up?
To set up the AX to join a wireless network as a "Wireless Client," using the AirPort Utility, either connect to the AX's wireless network or temporarily connect your computer directly (using an Ethernet cable) to the Ethernet port of the AX, and then, try these settings:
Launch the AirPort Utility.
Select the AX.
If not already connected to the AX's wireless network, go ahead and switch to it when prompted.
AirPort Utility > Select the AX > Manual Setup > AirPort > Wireless
Wireless Mode: Join a wireless network
Network Name: <type in the network name/SSID of the wireless network that you want to join or select it from the pop-up menu>
Wireless Security: None OR, if you are using security on your wireless network:
Wireless Security: <Select the appropriate level of security for the existing wireless network: WPA/WPA2 Personal | WPA2 Personal>
Password: <enter your wireless network security password>
Verify Password: <re-enter the same security password>
Click Update to write the new settings to the AX.