Hello my ipod touch stays blinking of de lock screen to the apple logo

Hello my ipod touch stays blinking of de lock screen to the apple logo i try the hard reset  and came off  when start again  makes the same blink of the lock screen  to the apple logo

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar       

Similar Messages

  • I wanted to restore my ipod touch 4G, but everytime it is restoring with the apple logo, the screen goes partially white and my itunes says "error 9"... what should i do?

    I wanted to restore my ipod touch 4G, but everytime it is restoring with the apple logo, the screen goes partially white and my itunes says "error 9"... what should i do?
    plz answer me~

    Error 9
    This error occurs when the device unexpectedly loses its USB connection with iTunes. This can occur if the device is manually disconnected during the restore process. This issue can be resolved by performing USB troubleshooting, using a different USB dock-connector cable, trying another USB port, restoring on another computer, or by eliminating conflicts from third-party security software.
    http://support.apple.com/kb/TS3694#error9

  • My iPod touch is alternating between a white screen and the Apple startup logo. I can't seem to bring it out of that sequence.

    My iPod touch is alternating between a white screen and the apple startup logo. Is it done for?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • Ipod touch wont switch on and constantly only shows the apple logo screen

    ipod touch wont switch on and constantly only shows the apple logo screen. Have tried to reset by holding both buttons down but hasnt worked. it also doesnt appear on itunes.

    Hvae you tried:
    - Reseting the iPod and then try restoreing the iPod
    - Placing the iPod in recovory mode and then restoring the iPOd.  For recovery mode see:
    iPhone and iPod touch: Unable to update or restore
    - Next try DFU mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

  • My touch is frozen on a black screen with the apple logo and a load bar, nothing works, tried resetting and everything, any suggestions?

    My touch is frozen on a black screen with the apple logo and a load bar, nothing works, tried resetting and everything, any suggestions?

    In that case....if you have Apple Care, give support a call - otherwise, walk it into the nearest Apple Store.
    Good luck.

  • My iPod touch 5th gen won't turn on past the apple logo, do I need to restore to factory settings? If so, is there a way to save my photos?

    I've had my iPod touch 5th gen for a little over half a year now, haven't had any issues until now. Yesterday it randomly shut down, and when I try to turn it back on, the apple logo shows up but the iPod just stays on that screen, it doesn't turn on any further. I think I might need to restore it to the factory settings to get it to work again, but I'm concerned that I'm going to lose all my photos. I found the backup folder in my computer but it doesn't have any files in it. I have over 600 pictures on my iPod and I really don't want to lose them all. Is there a way that I can either get my iPod to work again without restoring, or a way that I can extract the photos without the iPod actually being in functioning condition? The computer doesn't recognize the device when it gets connected via the USB. Thanks!

    - Connect the iPod to your computer and try to make a backup
    iOS: How to back up and restore your content
    - Next reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    and try making a backup again. If you can't then there is no way of getting the info off the iPod unless data recovery company can do it. Not cheap.
    - If photos are in an existing iPod backup (iTune>Preferences>Devices  for iTunes backup or an iCloud backu) then restore from that backup. See the restore topic of:
    iOS: How to back up
    - If you used PhotoStream then try getting them from your PhotoStream. See that topic of:
    iOS: Importing personal photos and videos from iOS devices to your computer

  • While i was updating my ipod touch it had an error and froze at the apple logo with a loading bar underneath.How do I fix it? Its stuck there,  tried everything, turn off button home screen button even the volume buttons, nothing is working.

    I was updating my ipod touch and the updation had an error and it froze at the apple logo with the loading bar underneath. How do I fix it? I tried the turn off button home screen button and even the volume buttons. I cant get anything to work. Please help me.

    Connect to itunes and retore.

  • My ipod touch wont turn on it is stuck on the apple logo

    Hi i was on facebook on my ipod touch and i deleted the app and when i went to open twitter it froze so i restarted holding down the lock and home key and now it won't turn back on its just stuck on the apple logo screen even if i try to reset it again it just goes back to the apple logo.  I tried to plug it into the computer and nothing happened.  Then it flashed a white screen and when back to the apple logo screen.

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • Can someone help me get my IPOD Touch 3g started? It will only flash the Apple logo off and on. Has been through restore multiple times on different computers, and still will not start.

    I have tried restoring the ipod on different computers, one Vista, and one 7. On both, the restore process seems to complete just as it should, until the point where it says "your IPOD will now restart and will appear in listed devices. This IPOD never restarts. The Apple logo just stays on for approximately 30 seconds and then the screen turns off for five or ten seconds and the logo comes back on, over and over for approximately forty five minutes or so, Occasionally the "connect to USB" will come back on, but that is rare. When that does happen, the I-Tunes recognizes it again as an IPOD that needs to complete the restore process. VERRRRRY AGGRAVATING!!!

    Time for an appointment at the Genius Bar of an Apple store. It appears you have a hardware problem.

  • IPod touch won't turn on. I see the Apple Logo then in 5 seconds it's off.

    Okay so i see the apple logo when i turn it on wait 5 seconds and its off.
    i have had this problem since last night when i tried to restart it. i have attempted to sync it to itunes but it wouldnt turn on while connected to my computer either...its also been in the charger all night and had a full battery when i went to restart it.
    any hel is greatly needed...thanks:DDDDD

    I would put it into a recovery mode to fix it. Try these steps:
    1. Unplug the touch from your computer
    2. Hold the Sleep/Wake switch until you see the red slider and turn the iPod off. (Note: this may not work and if it doesn't go to the next step.)
    3. Start iTunes
    4. Hold down the Home button and continue to hold it down while you plug your touch back into your computer.
    5. Continue holding it down until iTunes gives you a - "device detected in recovery mode" message.
    6. Follow the onscreen instructions to restore your iPod.

  • My ipod touch is frozen wont do anything, but displays the apple logo only

    my ipod is frozen wont do anything, but displays the apple logo only

    Try:
    - iOS: Not responding or does not turn on
    - If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

  • Hello,my ipod touch 4G was stolen and i was wondering if apple could help me find it??

    hello, my ipod touch 4G was stolen and i was wondering if apple could help track it down??

    Nope, Apple can't track it for you.

  • Hello I have just purchased a 2nd hand Ipod touch 4th Gen, I cannot seem to delete the Apple ID in the message settings of the previous owner?

    Hello I have just purchased a 2nd hand Ipod touch 4th Gen, I cannot seem to delete the Apple ID in the message settings of the previous owner?

    Go to Settings>General>Reset>Erase all Content and Settings. Then setup the iPod with your account.
    If necessary, place the iOS device in Recovery Mode if necessary to allow the restore.
    If recovery mode does not work try DFU mode.
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    For how to restore:
    iTunes: Restoring iOS software

  • How do i fix my ipod touch 4g? on my lock screen my (slide to unlock) wont move when  i run my finger over it.

    how do i fix my ipod touch 4g? on my lock screen my (slide to unlock) button wont work when i slide my finger over it.

    Turn off, and then turn on your iPod. Restart it

  • Ipod touch wont turn on i tried restoring it but every time i do it just says its waiting for the ipod to respond. meanwhile my ipod is no longer a black screen but the apple logo with a loading bar underneath that after leaving for 8 hours hasnt moved.

    my ipod touch wont turn on ive tried restoring it but every time i do it just says its waiting for the ipod to respond. meanwhile my ipod is no longer a black screen but the apple logo with a loading bar underneath that after leaving for 8 hours hasnt moved.

    Try:
    - Another cable
    - Another USB port
    - Reboot the computer
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

Maybe you are looking for

  • Setting Up a Java Web Server on Linux

    Greetings, After a lot of reading, I've decided to learn Java server-side technologies (I already know Java (desktop) but with little experience) in order to develop my database driven dynamic website projects. However, I'm completed lost between the

  • XI and user authentication VS R/3 systems

    Hi *, I'm trying to configure this kind of scenario: 1) user xyz sends a request to a web service, which is exposed by XI via its outbound interface 2) XI performs all the necessary mapping stuff and via the routing procedure identifies the right inb

  • In *.sqljsp problem whit SQL st. execution

    Executed statement doesn't chanege when i change SQL statemen. Every time the first one is executed. I have to restart Apachie every time to be possible chnges to take an effect What do i have to change in my setings? Thanks in advance

  • Passing multipe vairable to a Dynamic Page

    Hi I creating a dynamic page that will display a list of values based on what the user input into the parameters. It works find as long as they only input a single value in (ex. Create User) but when attempting to input multiple values (ex. Create Us

  • Pro Tools User Considering Logic Express

    Hi Everyone, I've been a Pro Tools LE user for a number of years. When I read that Avid would be charging $250 for an upgrade to Pro Tools LE 9 (plus $40 for the mandatory iLok) I decided to explore other options. My main concern is with CPU overload