HELP!-Desktop SW says Memory is Over-Capacity- Card shows "other" as the issue
When syncing my Tour that has a 1GB memory card installed onto my MAC, the Blackberry Desktop SW says Memory is full at "+94MB", which doesn't make any sense as I only have about 20 pics (all less than 300-400KB each) saved to the card.. no video, no music..nothing else, and whenever I try to take pics or video it errors out and says I have no memory available. However if I look in the memory breakdown under options, it shows that the majority of my card is being consumed by "other". My question is what in the world is "other" and how do I get it off? Like I said, I don't have anything else that I save to the memory card so how is "other" getting saved on the card?
FYI I have Mass Storage enabled, if that means anything.
kaeandcolesmon,
If you open the recovery drive (partition) it should only have a single folder (Recovery).
To make sure that your not saving restore points to that drive.
See:
Start, Control Panel, System, System Protection tab. Make sure the D drive partition is set to OFF so that it does not save there.
I am a volunteer. I am not an HP employee.
To say THANK YOU, press the "thumbs up symbol" to render a KUDO. Please click Accept as Solution, if your problem is solved. You can render both Solution and KUDO.
The Law of Effect states that positive reinforcement increases the probability of a behavior being repeated. (B.F.Skinner). You toss me KUDO and/or Solution, and I perform better.
(2) HP DV7t i7 3160QM 2.3Ghz 8GB
HP m9200t E8400,Win7 Pro 32 bit. 4GB RAM, ASUS 550Ti 2GB, Rosewill 630W. 1T HD SATA 3Gb/s
Custom Asus P8P67, I7-2600k, 16GB RAM, WIN7 Pro 64bit, EVGA GTX660 2GB, 750W OCZ, 1T HD SATA 6Gb/s
Custom Asus P8Z77, I7-3770k, 16GB RAM, WIN7 Pro 64bit, EVGA GTX670 2GB, 750W OCZ, 1T HD SATA 6Gb/s
Both Customs use Rosewill Blackhawk case.
Printer -- HP OfficeJet Pro 8600 Plus
Similar Messages
-
I am having trouble updating my operatI am having trouble updating the operating system on both my ipad and iphone. I get a strange message when I open my PC desk top that says "the procedure entry point sqlit3_wal-checkpoint could not be located in the dynamic link library SQLite3.dll" Any ideas what my problem is?
Hi whatsthe77,
Welcome to Apple Support Communities.
You may want to follow the steps in this article to reinstall iTunes:
Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7
http://support.apple.com/kb/HT1923
Have a great day,
Jeremy -
when i try to access the itunes store to buy music, it loads at the top and says connecting to itunes store..then it loads all the way and goes to a blank page. it loads and seems like it is will work, but then goes to a blank page. Why is it doing this?
Hello katyhale,
I found a couple of articles that might help with the issue you are experiencing with the iTunes Store.
If you are getting a white screen when accessing the iTunes Store and using a Windows computer, I recommend reviewing this article:
Apple software on Windows: May see performance issues and blank iTunes Store
http://support.apple.com/kb/TS4123
If you are still not able to access the store, I recommend the following article:
iTunes: Advanced iTunes Store troubleshooting
http://support.apple.com/kb/TS3297
Thank you for using Apple Support Communities.
Best,
Sheila M. -
When I try to sync my iPod with iTunes I can't because it says it's over capacity. It's not. It's a 16 GB iPod, it's only 105 songs on there. No movies or pictures or such. Anybody got a word of advise? I've tried resetting the iPod but get the message that it's not possible cause i'm not connected to internet. I am though. Tried managing music manually. I've tried all the usual stuff.
Go to Settings > General > Usage and see how much is shown available and how much is in "Other".
-
Please help me. My YouTube app will not work. Every time I open it says 'cannot connect to youtube'. I have searched for help and tried resetting my settings and rebooting my ipad2 but nothing has solved the issue.
Yes, I am connected to the Internet through my wifi. Everything is working fine with the e eption of youtube. I have reset all Internet settings and have tried synching to iTunes followed by rebooting. This is all the advice I have found although none of it has been helpful.
Has anyone else encountered this problem? -
Ipod Nano says I am "Over Capacity" but is not storing any music
Ipod Nano says I am "Over Capacity" but is not storing any music. Do you know why i can't get any music on it? I have uninstalled and re-installed itunes as well.
Look at the colored graph under the iPod's Summary tab in iTunes showing you the types of content and how much space it is consuming on the iPod. What seems to be taking up all of the iPod's available space?
B-rock -
i have an iPhone 4 and when i connect it to my mac i cannot back up device and the bar is for the phone is only showing "Other" as the memory , Help ?
Make sure you have the Latest Version of iTunes (v11) Installed on your computer
iTunes free download from www.itunes.com/download
Then...
Connect to iTunes on the computer you usually Sync with and Restore
http://support.apple.com/kb/HT1414 -
It says I've got 12,3 GB free space left, of my total 25GB. But my iPhone tells me there is no more space to take pictures or download stuff. It clearly says I have 12,3 GB left. What's the issue here??
The issue is probably space on the phone, not in your iCloud account. (Space in your iCloud account does not give you more space on your phone.) Check Settings>General>Usage at the top to see how much available space you have. If it's low, you'll have to delete or sync something off our phone to make room for more.
-
HT201269 i hardly have things on my iphone but its saying my memory is over capacity
im having trouble with my memory being over capacity
Hello lyndsey1430,
From what I can gather, it sounds like you're having issues restoring your device. After reviewing your post, I have located an article that can help in this situation. It contains helpful advice concerning recovery mode:
If you can't update or restore your iPhone, iPad, or iPod touch
Use recovery mode
You might need to use recovery mode to restore your device in these cases:
iTunes doesn't recognize your device or says it's in recovery mode.
You see the Apple logo onscreen for several minutes with no progress bar.
You see the Connect to iTunes screen.
Learn what to do if you see the progress bar onscreen for several minutes.
To put your device into recovery mode, follow these steps:
Turn off your device and leave it off.
Plug in your device's USB cable to a computer with iTunes.
Hold down the Home button on your device as you connect the USB cable. Keep holding down the Home button until you see the Connect to iTunes screen.
When you see this screen, release the Home button. If you don't see this screen, try steps 1 through 3 again.
When your device is connected, iTunes will open. You'll see a message saying that iTunes has detected an iPhone, iPad, or iPod touch in recovery mode.
Use iTunes to restore your device. Restoring in recovery mode will erase your device. If you previously synced with iTunes or iCloud, you might be able to restore from your backup.
Get more help
Learn what to do if you don't see your device in iTunes for OS X, or in iTunes for Windows.
If you put your device into recovery mode by mistake, restart it. Or you can wait 15 minutes and your device will exit recovery mode by itself.
Thank you for contributing to Apple Support Communities.
Cheers,
BobbyD -
just says my ipod is over capacity when it's a 16gb ipod so it obviously isn't, can someone help!
How many songs depends upon the format of the some. Some are not compressed at al and they take up a lot of storage.
In the Summary pane for the iPod in iTunes you can compress songs that are synced to the iPod. Check the box that says Convert higher bitrate songs to XX kpps ACC. An XX or 128 is a good compromise of quality and compression.
Also,
Connect the iPod to your computer and look at the storage used by the various categories as shown in the colored bargarph in iTunes.
Come back with the results.
What is the Other on my iPhone and How to Remove It -
HT4061 when I click on the itunes icon on my desk top it says that it is corrupt or installed wrong
how do i uninstall the itunes on my desk top computer and then reinstall it. when I click on the current itunes icon it says it's corrupt or install wrong but we've been using this icon for quite some time
See: http://support.apple.com/kb/HT1925
DO NOT "just" download iTunes; follow all of the instructions in the above article. -
Attempting to download photos from desk top, keeps saying unit not responding or disconnected?
Attempting to down load photos from desk top. Keeps saying unit not responding or disconnected?
what is send to ipad?
either sync using i tunes;
e mail them to your self
or try a third party transfer program such as photo symc or Transfer (photosync works pretty good.
If you are using one of those - and if it is not working, try sending smaller batches. -
Pls advise because this has happened before w Camera RAW on my desk top but not laptop. Adobe support can fix, share computer, by re-installing on the desktop but it is a real pain.
When I replied to your post, I was replying to an original post that came in via my e-mail today at 2:30 and was the most recent thing in the ACR forum and had remained unanswered for 1.5 hours, so I decided to reply. Had your post been put in a forum I subscribed to and happen to notice days ago, then I might have seen it, then, but didn't see it until this afternoon, and the e-mail version of your post only had the scant initial information, not the subsequent question and answer about your OS that you'd replied to on the other forum. So as you say, I had not read the thread, because it was on a forum I didn't subscribe to. So be shocked and perhaps awed as is necessary. My treat.
Second, I did make a typo when I said Win8/8/8.1 and it should have been Win7/8/8.1, which might have been deduced by the repeated 8, so you could have asked for clarification.
Seeing as you're on Windows 7 which ACR 8.4 should be compatible with, one minor detail is that I see in the compatible Lightroom 5.4 requirements that it needs Windows 7 Service Pack 1, which would mean you'd want to be caught up on your Windows Updates, which I would assume you'd be.
There are direct links to ACR 8.4(.1) on Jeff Tranberry's blog that are distinct for PS-CS6 and PS-CC so maybe that is what isn't right?
Keeping Photoshop Up-To-Date
You might check what version of PS-CC you have. 14.2.1 is the most current, and maybe that is prerequisite to ACR 8.4.1, I don't know.
If worse comes to worse, uninstall everything Adobe, then run the CS Cleaner then re-install CC Desktop and see what happens as you install PS-CC and it's updates. It may need to be run several times.
Once you're ready to retry your installs, you also might try to Quit CC Desktop and run it As Administrator in case there is a permissions issue.
The CS Cleaner can be found, here:
Use the CC Cleaner Tool to solve installation problems | CC, CS3-CS6 -
Okay So my little sister got a new 8Gb iPod Touch and it says that there is a little over 6Gb of space on it. I guess a little must be used up for formating or the operating system of the device. So that is normal I'd assume. Then she starts to sync her music library to the divice, all of the music that she had on her old 4Gb iPod.During the process it says that she is over capacity by .22Gb? How is that possible? How is it that her entire music library from Itunes and her CDs, a grand total of 700 songs, were able to fit on the 4Gb iPod but makes the 8Gb with 6Gb of usable space (said to be able to hold like 2,000 or more songs) over capacity?! could someone run me through a process to get all the music together so that we can get it set up right. I really have a feeling that somewhere we must have screwed up.
Thank you in advance for any help you can give.This is really a guess but perhaps it's the factory-installed apps.
You might want to try a system reset. It cures many ills and it's quick, easy and harmless...
Hold down the on/off switch and the Home button simultaneously until the screen blacks out or you see the Apple logo. Ignore the "Slide to power off" text if it appears. You will not lose any apps, data, music, movies, settings, etc. -
ITunes saying iPhone is over capacity
I have an iPhone 5 16GB and am running the latest version of iTunes on my Mid 2010 MacBook Pro. When I look at the usage section on my phone without it connected to the computer, it says I have 1.5GB available. But when I connect and sync it to the computer, the availability in 'usage' drops to 0 bytes and iTunes says the phone is over capacity by 253mb. Please Help!!!
ThanksI found the culprit in my case: after update to itunes 12 iPhone is X GB over the limit.
Check your sync settings for each type of content in the left sidebar. In my case I had sync turned off for everything but ringtones. After iTunes update for some reason the entire music library is set to sync with the phone. Turning it off reconciled the storage issue. Perhaps in your case it is some other new content marked for syncing.
Maybe you are looking for
-
Cannot browse PDF file on OSX Yosemite without severe usability problems. (Reader 11.0.10)
I have 7GB of ram on a MacPro (tower, early 2009) with Adobe Reader 11.0.10, The PDF file I was trying to view is available @ https://archive.org/download/examplesofenglis00coll_0/examplesofenglis00coll_0.pdf Here is a screencast of the usability iss
-
Insert Statements on Databsae to be rolled back in case of failure
Hi Friends, We are developing a Scenario where we r supposed to Insert Records in three Tables. We have developed three different Interfaces for it. The Requirement is that even when 1st two
-
How do I get Gmail to "ask permission to show alerts in Notification Center" ?
In my Safari preferences, under notification settings, it says "These websites have asked for permission to show alerts in Notification Center." How do I get Gmail to prompt that. It used to be in there, but then I removed it to troubleshoot some not
-
PLOGI EVCRE & PLOGI COSTI - Integration Switches
Dear All, Our system currently has - PLOGI <> EVCRE (Generate event with entry T77INT (action designat.) currently unflagged and we would like to understand the impact of having this flagged. By making it flagged does this generate/activate the workf
-
Hello! I read through the swing tutorial to create an Applet with Swing components. I can see the applet on this site in IE: http://java.sun.com/docs/books/tutorial/uiswing/components/applet.html I created an own JApplet with Swing components and tri