Help :( DVD Drive will not read Blank DVDs but movie and data DVDs ok.

I am at loss what to do. Whenever I put in DVD with media in it (including +R), it plays and reads it all just fine. CD data reads no problem too. However, when I put in a Blank DVD, it chugs and ejects it out completely.
Preferences are fine. It says 'Ask What to Do' is set when 'You insert a Blank DVD'
Here was how it started. Previously, I could put in a blank DVD and it would be just fine but I'm having problems burning after the 10.5.6 update. Read in a post somewhere to try resetting your PRAM which I did and now it won't accept the blank DVDs. Everything else is fine.
I know a lot may say it's a bad batch, but I bought a new batch, Memorex vs. Verbatim and nothing.
Would really appreciate ANY help I can get!
Hardware Overview:
Model Name: MacBook Pro 17"
Model Identifier: MacBookPro2,1
Processor Name: Intel Core 2 Duo
Processor Speed: 2.33 GHz
Number Of Processors: 1
Total Number Of Cores: 2
L2 Cache: 4 MB
Memory: 4 GB
Bus Speed: 667 MHz
Boot ROM Version: MBP21.00A5.B08
SMC Version: 1.14f5
Serial Number: W86*
Sudden Motion Sensor:
State: Enabled
MATSHITA DVD-R UJ-85J:
Firmware Revision: FAV1
Interconnect: ATAPI
Burn Support: Yes (Apple Shipping Drive)
Cache: 2048 KB
Reads DVD: Yes
CD-Write: -R, -RW
DVD-Write: -R, -RW, +R, +R DL, +RW
Write Strategies: CD-TAO, CD-SAO, DVD-DAO
Media: Insert media and refresh to show available burn speeds
< Edited by Host >

Repairing permissions yes. But in my head, if everything is working fine for it, just won't read Blank media, could it be a software thing?
I'll give it a shot in a few hours

Similar Messages

Imac dvd drive, will not read games disks

imac dvd drive, will not read games disks whilst running in windows 7, cd and film dvd run ok. Can not believe Apple care who told me I cannot run pc games on iMac EVEN under windows 7. Any help please.

Zap the PRAM and Reset the SMC, then try again.

CD/DVD Drive will Not read CD/DVDs

This desktop is only about 3 months old and so far has worked great!! But since last week for some reason the CD/DVD Drive will not read any disc. The tray will open but then nothing happens at all once a CD/DVD is in. Doesn't even sound like it is spinning. Any ideas?? Please help!! Thanks!!

Also it is running Windows 8 and is a Ideacentre K410. And the CD/DVD Drive it is showing I have installed is TSSTCorpDVD-RW SH-216BB Not sure if that has always been the drive or not.

DVD drive will not read DVD-Roms

I recently tried to reinstall a game that I had played previously, only to find that my drive will not read it. I can hear the disk spinning, but my computer will not recognize that there is a disk in the drive. I tried some of my other games and I noticed that all of the older games, that ran on CD-Rom, had no trouble installing, while the ones that ran on DVD-Rom never showed up in the drive.
This is strange because I have installed all of these DVD-Rom games on my laptop before with no problem. I've tried doing simple fixes, like updating everything and uninstalling then reinstalling the drivers, but nothing helps.

Hi,
If it worked before then try few System Restore points and check. Could have happened due to some update.
Also provide the Product number of your notebook if restore doesnt help.
Note:
If you have HP Support Assistant installed on the computer(The Blue Question Mark) then open it ==> Complete all pending Updates & Tuneups==> Restart and Check. It may solve your problem
Although I am an HP employee, I am speaking for myself and not for HP.
**Click on “Kudos” Star if you think this reply helped** Or Mark it as "Solved" if issue got fixed.

Why my dvd drive will not read or run any install software,

after i did my system recovery my dvd drive will not load or run any software, need somE HELP

will the drive read cds? If the ODD will read the cds then it maybe a update will fix it. If it won't read those too, you may need to get a new ODD (dvd drive).

DVD drive will not recognize blank DVDs after upgrade to Lion.

It finds burned DVD/CDs but not blank ones. Disk utility partially sees blank dvd, gives option to eject it, but will not allow eject it. Finder does not see it at all. have to restart to have it eject. Tried different DVD's (Manufactures and -R / +R, etc). Have followed recommendations on resets and have even reloaded the OS. This problem started immediately after upgrade from snow lepoard to lion.

Repairing permissions yes. But in my head, if everything is working fine for it, just won't read Blank media, could it be a software thing?
I'll give it a shot in a few hours

My CD/DVD drive will not open

My CD/DVD drive will not open when I insert any type CD/DVD. The CD/DVD just runs but will not open.

Try cleaning the lens:
Use a DVD lens cleaning disk.
Use a few shots of compressed air in the slot.
Wrap a fine microfiber cloth (eyeglasses cleaning cloth?) around a business card and gently insert it in the slot.
If no success, a trip to the genius bar at an Apple store is the best option.
Ciao.

Updated my HP Laptop to Windows 8 and now DVD driver will not work. Help!

I have a Hp Pavilion dv-7013cl Entertainment PC and everything was working perfectly. I updated to Windows 8 about a month ago and had some problems. I then did a clean install of Windows 8 and now all the bugs are fixed except my DVD drive will not work.
I insert a DVD or CD and nothing happens. I go to My Computer and click on it and it just ejects the DVD. I don't know what to do and need my DVD drive.
Also, I tried to go to device manager and reinstall the driver but that didn't help.

Hi Crosby,
Take a look at this document and try the troubleshooting steps. Please let me know if it helps to resolve your issues.
Good luck!
↙-----------How do I give Kudos?| How do I mark a post as Solved? ----------------↓

Cd/dvd drive will not receive a disc, can anyone please help?

cd/dvd drive will not receive a disc, can anyone please help?

Apple Portables: Troubleshooting the slot load optical disc drive
Cures for an uncooperative CD/DVD drive

CD/ DVD Drive is not reading any discs! - HP Pavillion DV6747TX

Hi there, I have a problem. My CD/ DVD Drive is not reading any discs! I have no idea what's happened..it was going fine and then all of the sudden it stopped working.
The computer I have is a HP Pavillion DV6700 or DV6747TX to be exact and the CD/DVD-Rom drive is a TSSTcgrp CDDVDW TS%L632N ATA Device. It seems to be present in the Device Manager and in the Computer Menu. When I put a CD or DVD into the disc drive lights are blinking and it sounds like it's trying to load or do something, but nothing is coming up. CD Drive E still says CD Drive E instead of reading the disc that's in there and when I click on Drive E it says Windows cannot read the disc in drive E.
I have tried searching the net for answers including the suggestions on this website and have tried a few other ideas I have come across but nothing seems to be working. Any help would be greatly appreciated

This is usually a known software conflict and happens across the board will all computer manufacturers due to a issue with multiple media burning/ripping applications being installed on your system.
You can either run this file, go online to Microsoft's site for a fix, or manually fix it by following the instructions below:
Manually delete the registry entries
Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
322756 (http://support.microsoft.com/kb/322756/ ) How to back up and restore the registry in Windows
Note Before you use this method, uninstall all CD or DVD writing or recording programs. Deleting the corrupted registry entries might cause problems with any other CD or DVD writing or recording programs that are installed on your computer. Uninstalling these programs before you start will help you avoid any problems that removing the registry entries might cause. You can reinstall these programs after the problem is resolved.
This method provides step-by-step instructions for how to use Registry Editor to delete the following corrupted Registry entries:
UpperFilters
LowerFilters
Step 1: Start Registry EditorStart Registry Editor
Start Registry Editor...type "regedit" into the run box on the start menu.
Step 2: Delete the UpperFilters registry entry
In Registry Editor, expand My Computer, and then expand HKEY_LOCAL_MACHINE.
Expand SYSTEM, and then expand CurrentControlSet.
Expand Control, and then expand Class.
Under Class, click {4D36E965-E325-11CE-BFC1-08002BE10318}.
In the details pane of Registry Editor, on the right side, click UpperFilters.
Note You may also see an UpperFilters.bak registry entry. You do not have to remove that entry. Click UpperFilters only.
If you see the UpperFilters registry entry in the details pane of Registry Editor, go to step 6.
If you do not see the UpperFilters registry entry, you still might have to remove the LowerFilters registry entry. To do this, go to "Step 3: Delete the LowerFilters registry entry."
On the Edit menu, click Delete.
Click Yes when you receive the following message:Are you sure you want to delete this value?
Step 3: Delete the LowerFilters registry entry
In the details pane of Registry Editor, on the right side, click LowerFilters.
Note You might see a LowerFilters.bak registry entry. You do not have to remove that entry. Click LowerFilters only.
If you do not see the LowerFilters registry entry, unfortunately this content is unable to help you any more. Go to the "Next Steps" section for information about how you can find more solutions or more help on the Microsoft Web site.
On the Edit menu, click Delete.
Click Yes when you receive the following message:Are you sure you want to delete this value?The LowerFilters registry entry is removed.
Exit Registry Editor.
Step 4: Restart your computer
Restart your computer. After you have done this, try to access the CD or DVD drive. If you can access the CD or DVD drive, and if you do not receive an error message, the problem is resolved. You can reinstall your CD or DVD writing or recording software.

CD/DVD Drive is not reading any discs on Equium A100

My cd/dvd drive is not reading any discs whatsoever, blank, written or commercially written. It opens and closes and the light to show it is working is on. Device manager says the device is working properly.
Tried updating drivers, no updates available. Tried system restore back 1 day then 1 week then 1 month and still the problem cannot be rectified. When i put a cd/dvd in the drive and try to access it, it says: D:\ is not accessible. The request could not be performed because of an I/O device error.
Can anybody help me i've tried everything me and my friends can think of, or is it a better idea to just send it back to toshiba under the warranty.

Hello,
Here are a few windows articles that could help.
http://support.microsoft.com/kb/891894/en-us
This one might do the trick, if not try this one.
http://support.microsoft.com/kb/826510/en-us
Hope these help resolve the problem. If not it could be a registry setting error which can be rectified as well. But only if these 2 above do not help to resolve the problem.

DVD Drive will not recognize any movie DVD disk in the drive - thus will not play any dvd movies.

HP G71 449WV dvd drive will not recognize any dvd disc that has a movie on it. Will not play movies, keeps saying to insert disc when there is a disc in there. It will recognize a dvd data disc or a blank dvd, it just will not recognize any dvd movies. I've tried the microsoft fix it, downloaded new codecs, using different dvd playback software but none of that works since the drive will not recognize there is even a dvd movie in the drive. Computer is out of warranty.

Hello crollinsphoto1, welcome to the HP Forums.
It appears that you're not able to play movie DVD's in the DVD player in your notebook. I will try to assist you with this.
I'd recommend starting with this document:
Resolving DVD and Blu-ray Movie Problems (Windows 7).
Also, are these purchased DVD's or burnt DVD's?
Do the movies play in other sources? (DVD player, other PC)
Let me know how this goes.
Thanks.
I worked on behalf of HP.

Tecra M5: DVD drive does not read these mini DVDs

I have canon dvd handycam, and mini dvd works on it. One month back i recorded movie and pictures on mini dvd using handycam and ran mini dvd on my tecra M5 dvd drive, it worked very fine.
Now after 1 month i have 5 mini dvds with movies and pictures which i took on 1 month vacation in diffierent countries, i tried my best but tecra dvd drive does not read these mini dvd, cd drive label appears instead dvd drive when i put mini dvd in it.
All other standard size dvds, cds working fine on it.Its complicated and as well as irritating.
Any suggestions?
Why its messedup?

Seems the lens cannot read this miniDVDs. Possibly the drive lens cannot calibrate and therefore the miniDVDs are nonreadable.
Try the solution from sascha. Maybe youre a lucky man and it works.
If not, try to remove the drive physically from the notebook. Reboot the notebook without the drive. The Windows and BIOS shouldnt recognize the drive.
Then shuts down again, put the drive into the notebook and boot up the unit.
The notebook should recognize the drive and should indicate the firmware again.
Im not sure if this will help you but its attemptable

Dvd drive does not read dvd but reads cd only.

my hp compaq 420 core2 duo dvd drive does not read the dvds but only reads the cds. How can i solve this problem, please help me with the correct answer.
This question was solved.
View Solution.

It will likely require replacement of the drive. There is more than one laser in there: one for each function. One can go bad without the other going bad.
608141-001
Above is the part number for the DVD burner drive. I could not find one on eBay. Here is one online:
http://www.mydvddrives.com/replacement-for-hp-compaq-608141-001-sata-cd-dvdrw-dvd-ram-drive-burner-l...
Replacement is easy. Remove a single screw on the bottom and slide the old drive out and replace with the new drive.

My CD/DVD drive will not accept a disk anymore. Any ideas?

My CD/DVD drive will not accept disks anymore. Any ideas to make this work short of a very expensive replacement?

Read the os Help menu.
Apple Portables: Troubleshooting the slot load optical disc drive
Cures for an uncooperative CD/DVD drive

Help :( DVD Drive will not read Blank DVDs but movie and data DVDs ok.

Similar Messages

Maybe you are looking for