Help, DVD Driver keeps ejecting DVD and requesting a Blank, I insert a Blank and the same message keeps coming up, any suggestions ?
DVD Driver keeps ejecting DVD and requesting a Blank, I insert a Blank and the same message keeps coming up, any suggestions ?
Hi
a. You are using Cheap media as Memorex, NoName etc DVDs - I only use Verbatim
b. You use a DL-DVD or DVD+/-RW type of media - Old Macs can not use DL-DVDs - I only use DVD-R
c. Your DVD-burner needs a cleaning - Cleaning DVD without liquid but the brush type
d. Is there OK free space on Your Start-Up (Macintosh HD) hard disk - I never go less than 25Gb free.
e. Can You describe the material used to create Your DVD
- Video Codec/s
- Photo file formats
- Audio file formats
iDVD can not use all but only a few of them - still it tries and then often fails
Just to start by.
Yours Bengt W
Similar Messages
-
I get en error message 42408. I have tried several times to activate my account but the same message keeps reappearing. Please help. I cant even sink my iPad or iPhone. Thanks
After searching, found a few answers and tried one last thing-- allowing Safari to accept Cookies. I never use Safari so never changed any settings in it ever. However, I guess an update along the way turned off cookies in it and that was the blockage. Once I allowed Safari to use cookies I was able to redeem the gift card. SO, glad this board is here for these types of questions!!!!
-
this phone cannot be used because the required software is not installed. i have installed and re installed the program and every time i plug my iphone 6 in the same message pops up
Have managed to cure it based upon the following information received -
I keep having this problem with iTunes when I try to connect my iPod Touch to iTunes. I keep getting this error message: "This iPod cannot be used because the required software is not installed".
What I did:
Run the iTunes installer to remove iTunes, then install the 64-bit version of iTunes.
I have already done this required step about a hundred times and I am still getting this same error so if you have any idea of what I can do please help.
Solution
I was running the 64-bit version if iTunes, and I did uninstall and re-install just to make sure -- no luck. Turns out there's a really easy solution, I'll spare you the detail of how I figured it out, but if you encounter the same issue, here's the solution:
1) Using WinRAR (or any other decent archiving program), extract iTunesWindows64Setup.exe
2) Right click on AppleMobileDeviceSupport64.msi and choose Properties.
3) Switch to the Compatibility tab and check the "Run this program in compatibility mode for:" box, and select your only option, "Previous versions of Windows", in the drop-down box.
4) Click OK
5) Double click the AppleMobileDeviceSupport64.msi
6) Tell it to Repair your current installation
7) Done! -
I recently downloaded ios 6.1.3 in my iphone 3, but unable to install the download. This message keeps showing "unable to install update, an error occurred installing the ios 6.1.3 I have tried several times but the same message keeps coming. What is the solution?
There is no such thing as an iPhone 's3'. There is a 3G which can only be updated to iOS 4.2.1 and a 3GS which can be updated to iOS 6.1.3.
Which model iPhone is this?
Identifying iPhone models -
I used to be able to keep my finger on a key to select an accent in mountain lion but I cannot do the same thing in Mavericks. Any suggestions?
I found the following info at file:///Users/gordondoyle/Desktop/Mac%20OS%20X%20Tips.webarchive
Here’s yet another iPhone feature that has cropped up on the Mac in Lion. While typing, simply pressing and holding on a key will bring up a popup showing all the possible diacritics (accents, cedillas, etc.) that can be added to the letter. You can then choose from the possibilities by pressing the corresponding number on your keyboard, or by clicking the one you want.
This seems to be a fairly quick way typing accents, and is much easier to use than the old method which involved remembering a number of Option key combinations. It does have one drawback however — it stops you from pressing and holding to write a long line of repeated letters, like thiiiiiiiiiiiiiiiis.
If you don’t regularly type accents, then losing the repeated character functionality might not be worth it for you. In this case, you can disable this new feature using a Terminal command. Open up Terminal (located in Applications/Utilities), paste the following line and press Return.
defaults write -g ApplePressAndHoldEnabled -bool NO
You will need to restart each application for the changes to take effect. Simply repeat the command with YES at the end to reverse.
and it seems to be related to your suggestion that I follow the threads related to the link you provided except that the above info is the reverse of what I think that I need to do. I will try what is shown in the threads however and see what happens - most appreciatively! -
I can't access Safari any longer. Each time I click on the icon, it states that "the address is not valid".
I've even deleted the Safari and downloaded it again, but the same message persists. Does anyone have any ideas what the problem could be?address bar wasn't accessible, so I did the Toolbar drag back. The invalid address is set as home page in Safari - Preferences - General.
Tried opening safari again holding the shift key, but made no difference Andy.
Can I just type in a new address in "home page in Safari - Preferences - General"? -
I restored my ipod but the same message keeps popping up all the time
I have a 2GB iPod Nano, and while I was trying to charge it today a message popped up from iTunes saying that the ipod is in a recovery mode and I must restore it so that it works with itunes. But when I restored it the same message popped up again. I restarted the computer and the laptop, I reinstalled itunes but I still get the same message. The ipod works and charges fine but it's empty now and I can't upload my songs to it because itunes keeps giving me the "restore" message. Please help me, I don't know what to do!
a relentless recovery mode message like that can sometimes be caused by a Windows drive letter confusion. for troubleshooting advice on that possibility, see the following document:
"iTunes has detected an iPod in recovery mode - Use iTunes to restore" -
no matter how many times I ask T'bird to check for new mail I get back ANOTHER copy of the same message dated 7:28am and NO MAIL received after that reaches my INBOX. On my other PC running Windows 7 only ONE copy of the 7:28am transmission arrives as does all subsequent email sent to me at this address... both PC's are protected by Avast anti-virus software. Turning the rogue PC off and on did not help nor did uploading and installing an updated version of T'bird.
Are the setup the same? same accounts, same folders, same messages, same filters same add-ons?
If that the case make a copy of the good profile and replace the bad one with that. -
I need to sync my laptop and iphone with my bosses laptop and iphone. We need to be able to have access to the same files.
Any suggestions?Yes you can both use the same iCloud account.
-
help
Change to UK App Store
1. Tap "Settings"
2. Tap "iTunes & App Stores"
3.Tap "View Apple ID"
4. Enter your user name and password.
5. Tap "Country/Region."
6. Tap "Change Country/Region"
7. Select the region where you are located.
8. Tap "Done". -
The last time this happened I hit the wrong button and wound up subscribing. So I had to go on-line and cancel. And I will have to check to assure that it has been cancelled because I have had many cancellation requests ignored in the past.
Go into your phone menu => apps and select the app and disable it. You won't get the message anymore.
-
please help me
Make sure your time and date are set properly for your city/timezone. In fact, you should have your location services set to automatic. Also it is important that you have all of the latest software updates for your operating system installed through Apple software updates.
-
This happens when I have the Menu Bar hidden. It happened with the betas and now with the RC
Start Firefox in [[Safe Mode]] to check if one of the add-ons is causing the problem (switch to the DEFAULT theme: Tools > Add-ons > Themes).
* Don't make any changes on the Safe mode start window.
* [[Troubleshooting extensions and themes]]
In Firefox 4 [http://kb.mozillazine.org/Safe_mode Safe mode] disables extensions and disables hardware acceleration.
* Tools > Options > Advanced > General > Browsing: "Use hardware acceleration when available" -
if i open firefox and use it, when i get to last window and close it, if i try to reopen it, it says already open and to close pages but it will not close--the same box keeps coming back
== This happened ==
Every time Firefox opened
== first time i loaded it onto new computer with win 7 64 bitFirefox v 3.6.3 running Win 7 Home premium. About every 6th or 7th time I go to open Firefox from my desktop I receive the same msg as the original poster receives. I must restart to clear up the problem. When I select restart it states a forced shutdown is required and asks if I want to proceed. I click yes, the computer restarts and problem is fixed until the next occurrence.
My thanks for any assistance that may be available.
If you require a screenshot let me know, please include instructions on how to do this though. -
When connecting my ipad mini to my lap top I keep getting an error message sugesting I need to install 64bit version of Itunes. I have done this repeatedly but the same message keeps recurring. Cananyone help? Thanks
For general advice see Troubleshooting issues with iTunes for Windows updates.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down page in case one of them applies.
Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
tt2
Maybe you are looking for
-
With out using IDX2.....in file to idoc scenario
Hi Masters, i have one doubt .. Can i send normal file from sender system to sap system in the form of idoc.. with out using IDX2... if it is possible then plz explain me about the steps .. and also explain me wht is the actual use
-
JNDI look up failure from JUnitEE for Sunone AppServer 8
Hi, Dear All: I am trying to set up a test framework for developing J2EE application, I successfully deployed the EJB components, see the sun-ejb-jar.xml below: <?xml version="1.0" encoding="UTF-8"?> <!DOCTYPE sun-ejb-jar PUBLIC "-//Sun Microsystems,
-
my sound card driver is -- soundmax intergrated digital hd audio .....my laptop is compaq 6720s running on vista 32bit i have only one slot for sound output(headphone)......and have 3 cables from the 5.1 sound system........... please tell me what to
-
Dropped conference call issue!
Dear All; I have cucm 8.5 and h323 GW (2911) with many FXO port , I have used a software conference bridge and I can make internal conference call only ; my problem is: when I dial out side number via H323 GW the call is esablished, and when I press
-
Installed new printer cartridges (black, yellow, magenta, cyan, and photo) Ran alignment tool and failed. Can you help?