HELP! iPhone 4s displays blinking apple logo during boot.
During reboot, my iPhone 4s just displays the blinking apple logo. I have read several solutions regarding this problem I haven't found any.
Hi sexy popcorn,
Welcome to Apple Support Communities.
It sounds like there is an issue with your iPhone starting up, it only shows the Apple logo. The article linked below provides lot of great troubleshooting suggestions and information about setting up service, if the issue isn't resolve from those 5 troubleshooting suggestions.
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
I hope this helps.
-Jason
Similar Messages
-
How can I stop iPhone 5s from blinking apple logo
how can I stop iPhone 5s from blinking apple logo
Hello tigersrock,
Thank you for using Apple Support Communities.
For more information, take a look at:
iOS: Not responding or does not turn on
http://support.apple.com/kb/ts3281
Have a nice day,
Mario -
Help: iPhone 3GS Stuck on Apple logo screen
Today my iPhone was not connecting to the wifi network so I decided to "Reset Network" on the iPhone. Well, during the reset, it went to the Apple logo screen and is stuck in that screen. I cannot turn off the phone, tried to reset pressing the home and on/off together for 10 seconds and it is still stuck on that screen. I tried to restore but iTunes does not recognize that the phone is plugged to the computer. Has anyone seen this? Do I have to send it to Apple for repair?
Try this article...
http://support.apple.com/kb/HT1808
This is not a normal result from trying to reset network settings... -
MacBook Pro won't get past Apple logo during boot
Hey, recently while I was using on my MacBook Pro (note: just simply browsing the internet), the battery ran dry and the computer shut down almost immediately. When I plugged it in and turned on the computer again, the familiar Apple logo appeared and looked as though it would start up normally. However, an unfamiliar grey progress bar appeared and the usual grey gear started spinning. The progress bar looks as though it reaches up 10-15% completed but the computer just shuts down after that every time. I know it has nothing to do with the charge in the battery as I tried doing it plugged in and even waiting overnight for the battery to charge fully with the plug plugged in.
So, I tried using Disk Utility on the Snow Leopard Install disc (my original MacBook Pro install discs had Leopard on it so I just used the Snow Leopard discs instead). After using the "Verify Disk" command on the Macintosh HD volume, it stated that 'Invalid node structure' and then stated that the disk could not be verified and needed repair. I then proceeded with using 'Repair Disk' and it did say 'Volume repair complete' but then stated 'Updating boot support partitions for the volume as required.' This was when an error popped up and said "Error: Disk Utility can't repair this disk" and then told me to back up my files and reformat the disk.
I'm hoping that I don't have to reformat the disk as I haven't backed up in a while. I do have a separate partition on the hard drive that has Windows 7 on it that I can boot to. At least that means my hard drive hasn't completely died on me. However, I'm unsure what to do at this point to fix the computer. I tried to Safe Boot but it didn't change the outcome of start up.
Any ideas as to what I can do? I appreciate any help.Thanks for the replies! Anyway, I gave DiskWarrior a try and it failed to work. The first time I tried it, I put the disc into the drive of my MacBook Pro and booted it from the disc. After going through the rebuild process it told me that due to a hard drive malfunction it couldn't append any changes to the drive. I then tried putting the disk into my iMac and used my MacBook Pro in Target Disk mode. This wouldn't even attempt to rebuild my drive saying that there was a hardware failure.
So, I booted into Windows 7 and saw that Windows was able to access the drive and read the files perfectly. All the files were in tact. I don't understand why disk warrior had a problem with it. Anyway, what I can do is reinstall Mac OS X Snow Leopard onto the hard drive again after moving the data onto an external hard drive using Windows. The only problem is that I would have to reinstall all of my programs while reimporting all of the settings and data that I can from the external hard drive. What I want to know is can I make an image of my hard drive (with SuperDuper?), and append that back onto my Mac's hard drive? Would that work again after reformatting the disk or would it just give me the same problems as before? Would it be better or easier to just start new and reinstall everything? Thanks! -
Iphone screens switches to Apple logo
This initially began occuring about about 3 weeks ago but is happening more
frequently now. When using Safari after about 15-20 minutes my iPhone screen
displays the Apple logo as though I restarted unit. I usually have to restart but there
are times when screen goes to main menu after awhile. Anyone have similar issues or
familiar with problem? It seems I am more than likely going to have to take to Apple
for repair which ***** since I will then either be without phone for awhile or have to
pay for loner. Peace and thanksAm having the same problem. After updating to iOS 8.3, my Silver 128GB iPhone 6 Plus has been crashing to the Apple logo and the home screen resprings. Before iOS 8.3, I did not have this problem. Hopefully it's software related and Apple has a fix.
-
My iphone 3GS keeps freezing and showing the apple logo during phone calls. Can anybody help plese ? Bja
Hiya thankyou for the answer.
Trying to set it up as a new device but can't find the backup to save it.
I have no "mediasync" folder in my library/application support. Did these folders get moved around with Lion?
Thankyou again, -
Can anybody help in my concern below
I found an update ios6 in my iphone settings and then I tapped on install ,but it is going on and nothing is displaying .Only apple logo is displaying frequently.It has been happening for 13 hours.my question is how much time it will take to update iosRead this: iOS 4: Updating your device to iOS 5 or later
... oh I think it is a 3gs or a 3
This makes a difference. What does it say in Settings > General > About? -
I tried to restore my iPhone 3G by doing so on the iPhone but now it just displays the Apple logo and refuses to proceed any further. Any suggestions?
Hello, Spedellen.
Thank you for visiting Apple Support Communities.
When experiencing issues restoring an iPhone, here are the best articles to go through. If you received a specific error number when restoring, see the section labeled Get more help in the second article below.
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Resolve iOS update and restore errors in iTunes
http://support.apple.com/kb/ts1275
Cheers,
Jason H. -
iphone 4 has a black scrren which will display the apple logo and appears to be at start up but then blacks out for approx 10 seconds and then displays apple logo again. Same action over and over.
I have attempted hard reset but cannot complete. Also attempted to connect with itunes and it does not recongize device.
Device is frozen in this display loop. Have an appointment with genius bar tomorrow but it's a 2.5 hour round trip so suggestion appreciated.Your device may need to be restored as new in iTunes (instead of restored from a back up as it seems that there is a software issue on your phone).
If your phone is not able to connect in iTunes try forcing recovery mode (http://support.apple.com/kb/HT1808)
* power off your phone.
* Hold the home button while connecting your phone to iTunes. You should see the connect to iTunes window and your computer should give you the recover mode alert.
*Restore your device as new. Being sure not to restore from a previous back up.
You will then want to sync your information back to your device from Outlook, iCloud, Google or wherever your information is stored. -
hi my iphone was fully charged and turned its self off, i have tried to turn it back on and reset it, but no luck so i have plugged it in to my pc and it displays the apple logo and then goes back off i have tried this a number of times with no success anyone got any idears?
Try here:
iOS: Not responding or does not turn on -
my iphone 4 will not do anything....i tried restarting and resetting....the phone only displays the apple logo.
Hello there, Faustinamarfo.
The following Knowledge Base article provides some troubleshooting steps for your issue:
iPhone: Hardware troubleshooting
http://support.apple.com/kb/TS2802
Particularly:
Display has no backlight or dark screen
Toggle the ringer switch to see if the unit vibrates. If it does, it could be that iPhone is getting power, but is not displaying any image.
Try turning iPhone off and then on again.
While connected to the iPhone charger, try to reset the iPhone.
If the low-battery screen appears, charge the iPhone.
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro. -
my iphone 4 is acting like crap right i can't even restore it everytime i try to reboot it my iphone freezes at the apple logo it is ******* me off to the point where i just want to smash it how do i solve this problem please help?
Don't worry, just follow these steps to fix iPhone stuck on Apple logo
=> First of all Start your Computer and then connect with Internet connection, now Download the latest version of the iTunes application
=> Now install the iTunes application in your System and connect your Device with computer via Data cable
=> Now connect your Device with iTunes application and then Tab on summary option, see in the left side bar of iTunes
=> Now Select restore option from iTunes and then confirm the Restore Message for better results. After this unplug your Device and Restart it
I hope that will surely
Thank you... -
i reset my iphone 3gs bt have no backup. how to i get it to working order again because its now displaying the apple logo only
http://support.apple.com/kb/HT1808
-
how can i fix my iphone 3g if and only it displays the apple logo when it is connected to its charger but it displays nothing when the charger is removed?
Plug it into a wall outlet and leave it plugged in for approximately 20 minutes.
Then try a reset by pressing and holding the home and power buttons for 15-20 seconds.
Does the device power on at this point? If not, the battery or logic board is gone.
Take it to Apple for evaluation.
It may be worth replacing the battery, but I personally wouldn't spend the $149US for an Out of Warranty replacement on a 3+yr old device. -
My iPhone is flashing the apple logo, and then it turn into black.. And after that, it repeats.. HELP ME
Hello LaugesenDK
Follow the steps in the article below to put your iPhone into recovery mode and then you should be able to restore your iPhone. If you have a back up you can put your back up to get your data back after it completes it restore process.
If you can't update or restore your iOS device
http://support.apple.com/kb/HT1808
Regards,
-Norm G.
Maybe you are looking for
-
Brand new iPod touch did not come with iOS 8
Just got a new 16 GB 5th Generation iPod touch. Not only does it not have iOS 8, I cannot get it to update from 7.1.2. Why is Apple advertising the latest iOS on these devices but selling them with an older operating system? Did they actually sell
-
Image in Page Header set to Underlay Following Section overwrite IBoxObect
Hi There Using Crystal Reports as shipped with VS2008. In the Report Header Section I have an image. I've checked the 'Underlay following Sections' so it appears as a watermark (Back ground) image. All is fine except that it overwrites my borders on
-
EM 10g : java.lang.Exception: Exception in sending Request :: null
I have installed 2 db on 10.2.0.1.0. The first one is running fine and easily manageable via Enterprise Manager. When I open EM on the second db I receive "java.lang.Exception: Exception in sending Request :: null" with no further explanation. When I
-
Does Acrobat X Standard Support "Edit Page Numbering Format"
In Acrobate X Pro, I can edit page numbers using the "Edit Page Numbering Format" feature. This is the icon in the Customize Quick Tools dialog box: One of my users wants to know if Acrobat X Standard supports that feature? Thanks!
-
Duplicating wincrypt algorithm in JAVA
Here is the background on this project: I am creating an automated licensing system for a company that sells telco products. Until now, they have been manually generating the activation keys using an exe program developed in house. I have been hired