HELP NEEDED! My wife's 5c won't recognise on my laptop anymore. I plug it in and the laptop makes a sound but won't show up the phone. I only recently discovered this problem when I upgraded. It will recognise my 5c and even the iPad but not her 5c
I discovered this problem when I upgraded my iPhone 4 to a 5c.
My laptop will recognise my 5c and even the wife's iPad but won't recognuse her 5c, when I plug it in it makes a sound but just doesn't show up in iTunes.
It DID work on my laptop as recently as November when I backed up her phone and updated her software but like I say ever since I upgraded it just won't recognise her 5c but does mine.
I just can't think what is wrong? I haven't messed around with anything on the laptop or messed around with the wife's settings on her 5c
HELP!!!!
I would test with another computer and another cable
if it the device would not be detected by any computer I
would say that it's connector was broken
Similar Messages
-
Im having major problems syncing my iphone 4 to itunes, this problem started after upgrading to ios 5. I have upgraded my itunes, turned sync by wifi on and off but still nothing. Everytime I try to sync my iphone it just says sync cancelled. Please help.....
I'm having the same problem ! Each time the sync starts it suddenly stops and says finished syncing
-
I'm getting this problem when trying to update my iphone 3gs it says that the iphone software could not be contacted and I went on youtube got some advise to go into my hard drive to fix the error I have nothing in my host file please help me if you can this is all new to me.
Read this: iOS 4: Updating your device to iOS 5 or later
... oh I think it is a 3gs or a 3
This makes a difference. What does it say in Settings > General > About? -
Hello All, I bought an Iphone of eBay. It seemed fine until this morning when it switched itself off and now it won't come on unless it's plugged in. And even then it is asking that it needs to be activated, but it can't connect to iTunes
Try Recovery Mode... http://support.apple.com/kb/HT1808
-
since update to 9.3, when I click thumbnails of photos i get an error message that original photo cannot be found. Didn't have this problem prior to upgrade to 9.3 and 9.3.1. Any thoughts?
This is the iPhoto for iOS forum. You should ask in the Mac iPhoto forum. iPhoto for is OS only on version 1.
-
I am unable to switch on my IPad as it states that 'iPad is disabled'. How do I fix this problem when I have no access to the iPad? Any help or advice will be gratefully received.
Forgotten Passcode or device disabled after entering wrong passcode
-
I made a ringtone and it did go into my tones and it won't upload to my phone. I have done this several times and never had any problems til now. Can anyone help me on this?
Try assigning Queen as the Album Artist on the compilations in iTunes on your computer.
-
hello guys i face a problem when i upgrade from iOS 4.2.1 to iOS 5.1.1 on ipad 3 .when i upgrade i don' t found the camera app from the built in apps.when i try to install from the app store i don't found the correct camera app .please help me .please give any suitable link where i find the correct camera app
It's a built-in app, so it can't be deleted nor downloaded from the store. If you can't find it on any of your homescreens or app folders, and you can't find it via the spotlight search screen (swipe your first home screen to the right), then is it hidden by Settings > General > Restrictions > Camera being set 'off' ?
If not then have you tried a reset to see if you can find it after the iPad has restarted ? Press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot. -
have i-phone 3gs purchased unlocked from usa 2 years back version 4.1 recently when i upgrade my version using i-tunes to 6.o I can not activate my i-phone , the msg server busy since last week I not understand what is the problem ?
The 3GS was not sold as an unlocked phone in the US 2 years ago and AT&T did not offer unlocking then.
You bought a hacked phone. The Apple servers can detect the hack and have now disabled activation. Contact AT&T and find out if you qualify to have it unlocked or buy a new legitimately unlocked phone. -
i have a 2008 imac with snow leopard. i installed update 10.9.3 not realizing it's best for Maverick's users. Now my Itunes 11.2.2 won't burn playlists to CD. Anyone else with this problem? CAn I uninstall the 10.9.3 update? Also my HP scannerwill not save the displayed scanned document since this update! it just saves gray.
If you have your old system backed up then erase the drive and restore your backup. If you don't have a backup then backup your entire Home folder. Erase the drive and install Snow Leopard after which you can restore your Home folder from the backup.
Clean Install of Snow Leopard
Be sure to make a backup first because the following procedure will erase
the drive and everything on it.
1. Boot the computer using the Snow Leopard Installer Disc or the Disc 1 that came
with your computer. Insert the disc into the optical drive and restart the computer.
After the chime press and hold down the "C" key. Release the key when you see
a small spinning gear appear below the dark gray Apple logo.
2. After the installer loads select your language and click on the Continue
button. When the menu bar appears select Disk Utility from the Utilities menu.
After DU loads select the hard drive entry from the left side list (mfgr.'s ID and drive
size.) Click on the Partition tab in the DU main window. Set the number of
partitions to one (1) from the Partitions drop down menu, click on Options button
and select GUID, click on OK, then set the format type to MacOS Extended
(Journaled, if supported), then click on the Apply button.
3. When the formatting has completed quit DU and return to the installer. Proceed
with the OS X installation and follow the directions included with the installer.
4. When the installation has completed your computer will Restart into the Setup
Assistant. Be sure you configure your initial admin account with the exact same
username and password that you used on your old drive. After you finish Setup
Assistant will complete the installation after which you will be running a fresh
install of OS X. You can now begin the update process by opening Software
Update and installing all recommended updates to bring your installation current.
Download and install Mac OS X 10.6.8 Update Combo v1.1.
Or you can:
Try these in order testing your system after each to see if it's back to normal:
1. a. Resetting your Mac's PRAM and NVRAM
b. Intel-based Macs: Resetting the System Management Controller (SMC)
2. Restart the computer in Safe Mode, then restart again, normally. If this doesn't help, then:
Boot to the Recovery HD: Restart the computer and after the chime press and hold down the
COMMAND and R keys until the Utilities menu screen appears. Alternatively, restart the
computer and after the chime press and hold down the OPTION key until the boot manager
screen appears. Select the Recovery HD and click on the downward pointing arrow button.
3. Repair the Hard Drive and Permissions: Upon startup select Disk Utility from the Utilities menu. Repair the Hard Drive and Permissions as follows.
When the recovery menu appears select Disk Utility. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the main menu. Select Restart from the Apple menu.
Reinstall the 10.9.3 update: OS X Mavericks 10.9.3 Update (Combo).
4. Reinstall Lion/Mountain Lion, Mavericks: Reboot from the Recovery HD. Select Reinstall Lion/Mountain Lion, Mavericks from the Utilities menu, and click on the Continue button.
Note: You will need an active Internet connection. I suggest using Ethernet if possible because it is three times faster than wireless.
Reinstall the 10.9.3 update: OS X Mavericks 10.9.3 Update (Combo). -
When I right click on my Bookmark Toolbar to choose Open All in Tabs and click it, nothing happens. This is when I upgraded to 4.0. I've rebooted. How do I fix this?
You can middle-click a link to open the link in a new tab.
Start Firefox in <u>[[Safe Mode]]</u> to check if one of the extensions or if hardware acceleration is causing the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > Appearance/Themes).
*Don't make any changes on the Safe mode start window.
*https://support.mozilla.com/kb/Safe+Mode -
Why and how do I fix this? When I go into cellular data and view account it says my ipad is activated and ready to go. What gives???
It was working fine up until I upgraded the OS which I hadn't done in many versions so the ipad was not working as well as it should. Now it is searching for the network.
.Hello noodles074!
Let's get your device working again! It's possible that your device just needs to be reprovisioned on our network. Please go to Settings>General>Reset>Subscriber Services>Reprovision Account. This may take several minutes. After allowing about 5 minutes for completion, please power your iPad off and back on, and test it again. Let us know if this takes care of it!
Thank you,
MichelleH_VZW
Follow us on Twitter @VZWSupport -
Somehow my iPad got switched for messaging to showing from my email. There is no option showing to use my phone number. How do I get it back to my phone number? This happened when I upgraded my iPhone today, but the iPhone messaging is using the phone number fine. It's only the iPad messaging that is messed up. Help, pls.
thanks!You can link the phone number to the iPad again, if you follow the instructions here.
iOS 6 and OS X Mountain Lion: Link your phone number and Apple ...
The relevant information for you will be at the end of the article. You may have to sign out of messages on the iPhone and the iPad and start all over again. -
i use gmail , it says i can't access it because browsers cookies are disabled , THEY ARE NOT. I go into tools and options and cookies are enabled. I do not have this problem when i switch to internet explorer. If the issue is not resolved i will switch back to internet explorer . any help you can give would be appreciated.
refer to the
* [[Websites say cookies are blocked - Unblock them]]
* [[JavaScript settings and preferences for interactive web pages]]
* [[Settings for fonts, languages, pop-ups, images and JavaScript]]
articles
Thank you! -
The hyperlink window won't open in 2014 version. Anyone else having this problem?
The hyperlink window won't open in 2014 version. Anyone else having this problem? I'm using HP Envy Laptop with Windows 8.1.
Sort of. As part of the next update we'll make Muse ignore the 125% scale setting. This will make it easier for you to use that setting with all your other applications, but even when your Display is set to scale 125% the Muse UI will be presented at 100%. Unfortunately the current transition architecture of Muse (part native 64-bit app and part Adobe AIR app internally) combined with how Windows 8 and 8.1 achieve 125% scaling means it will be quite some time before Muse will be able to correctly support 125% Display scaling. Sorry for the inconvenience.
Maybe you are looking for
-
Medical records. How to protect your old hard drive or how to destroy it.
How do you get a new iMac with AppleCare so that you don't have to return the old hard drive if the hard drive ever needs to be replaced?... so that you can protect or destroy the old hard drive yourself in accord with HIPAA Health Information and Pr
-
Is it possible to get hacked from safari on your Iphone
When I was browsing a site a white badge icon popped up and asked if I wanted to go to a site. Assuming that this was malicious I went to take safari off multitask. When I did that my screen went black w/the white apple logo and a few seconds later m
-
Using Fieldpoint from Labview RT on a PXI System
I have a PXI system with Labview RT (PXI 8186 controller with LVRT ver 7.1). I wanted to connect a FP remote I/O system to this controller. The Fieldpoint system I have has a FP-1000 RS-232 Network module. I was hoping to be able to connect the FP-10
-
Safari 2.0.3 on MAC OS X 10.4.5
I am experiencing a problem with my Safari browser. Since I bought this new computer I have been running into several web pages and emails that have thumbnails or pictures that only display as question marks. I have cleared the cache and all that - d
-
Help ! lost FCP app support folder ?
Hi there, I might be lookin in the wrong place.... but if I look into home/users/myname/library/application support/final Cut Studio I don't find any folder other than" DVD Studio Pro"," Motion", "Patches", "Shapes" Is that right ? ??? Shouldn't have