Help please respond my iphone won't turn on

It's been charging all night last night and all day this morning and you know when it is in the process of turning on and the apple comes up, well every single time after the apple comes up it doesn't turn on normal, the apple just disappears and the entire screen goes black with just a loading circle in the center and it has been doing this for over 12 hours. I've tried to reboot it by holding down the circle button and the top button together and it turns of completely that way and then I turn it back on but it still goes to that black screen with the loading circle. Long story short, my phone won't turn on. Please respond if you know a way to fix this.

Here are steps to get DFU Mode: Open iTunes on computer. Connect iPhone to computer. (some turn off iPhone here, I do not) Hold both home and power buttons for exactly 10 seconds, release power button, keep holding home button until iPhone recognizes iPhone in Recovery Mode. Usually takes 10-20 seconds of holding the home button. If the iPhone screen is black (blank) the iPhone is in DFU Mode.

Similar Messages

  • HELP please... iPhone won't start or turn off. Apple logo only

    I try to reboot the phone w/by pressing the button on top and the button on the bottom of the face of the phone. The phone will go dark then come back w/just the apple logo... it goes no where else.
    HELP

    Known issue (better to say known quirk, not issue, however Apple should document it.) When you force boot the phone while it is loaded and running you corrupt some database and next boot will take a long time to rebuild this information. My 32GB 3Gs can take up to 7-8 minutes to boot as I have it full of music and I think it's rebuilding the music database during this long boot startup. The situation you are in now is that you have to wait for it to finish booting. The best way I have found if you phone is not stuck is to push top button until you get Red slider to turn off, slide it and allow phone to power off itself. Once off, Hold Top button and Home buttons, Keep holding them, you will see Apple logo pop up, KEEP HOLDING BUTTONS, do not release them until Apple logo goes away. If when you release both buttons the phone starts up and you see the Apple logo you have not held the buttons long enough as it sometimes will need to cycle down twice. When you have it right, when you release both buttons the screen will stay black and phone will not auto-power up. In this state the phone is fully off, not in standby. If you have previously powered the phone off gracefully with the top-button+swipe then hit top button for a couple of seconds and Apple logo should appear and phone should boot within a minute and be ready for use. If you cycled the phone without first gracefully shutting down, the bootup process can take much longer, give it at least 10 minutes before giving up. I have not found this documented by Apple anywhere, I found it from trial and error. My wife has 16GB 3Gs and while playing with both I found this out. Hope it helps you.
    Message was edited by: JPBOSS

  • SOS help please. Macbook Pro won't turn on. Blinking Light

    Hello to everyone this is my first post here and sadly its about a problem with my macbook pro.
    The notebook in question is a 17'' Macbook Pro I bought in September 2008.
    I simply closed it (without turning it off, just let it go on sleep) and took it with me as usual and when I tried turning it on again, it would not turn on.
    I press the power button and I hear the hard drive/superdrive (not sure which of the two) start up and I see the sleep light turn on but after a few seconds its turns off again. If I hold the power button down for a few seconds the sleep light starts blinking and then the notebook turns off once more. In all cases the screen is black.
    I tried everything here http://support.apple.com/kb/TS1365 and tried removing and re-installing the RAM and nothing changed.
    Short of trying to re-install the RAM again I have no idea what to do. I won't be able to visit a Genius until after the 5th so any ideas/suggestions?

    see http://support.apple.com/kb/HT2674 and http://support.apple.com/kb/HT2341 for some information about beeps and flashes.
    In your case, though, jinnes, the slow blinks suggest that the computer is simply refusing to wake up from sleep.
    One possible, though unusual, cause of this can be if you are using the computer with it stacked on top of a macbook. In this case the magnet in the macbook underneath activates the Hall effect switch in the MBP, making the latter think the lid is closed, and preventing wakeup. I've had this happen to me and it is quite unnerving at the time! Simply moving the MBP will fix it. see http://support.apple.com/kb/TS2917
    The same effect could be generated by proximity to other magnets.
    It is also possible , if this is not your situation, that the hall effect switch in your MBP is actually defective. It may be worth trying simply opening and closing the lid a few times to see if you can get it to activate.
    Cheers
    Rod

  • My iphone won't turn on. I've tried resetting but that doesn't help, the apple icon comes up then disappears.

    My iphone won't turn on. I've tried resetting it but that doesn't help, the apple icon comes on then disappears. Please help!!

    See this: http://support.apple.com/kb/HT1808

  • HELP! I have some songs/interludes on my Garageband app on my Iphone. I was planning on using some for my bands album. Now my Iphone won't turn on and I'm being told to restore the phone. Have I lost all my Garageband songs?

    I have some songs/interludes on my Garageband app on my Iphone. I was planning on using some for my bands album. Now my Iphone won't turn on and I'm being told to restore the phone. Have I lost all my Garageband songs?

    Hi NWL1,
    Thanks for the question. If I understand correctly, the iPhone won't update and is stuck. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
    If you can't update or restore your iPhone, iPad, or iPod touch - Apple Support
    Thanks for using Apple Support Communities.
    Have a great day,
    Mario

  • My iphone won't turn on what should I do

    Please help my iphone won't turn on and I have tried many things

    Try performing a reset on your device. Follow the steps outlined in Turn your iOS device on and off (restart) and reset.

  • IPhone Won't turn on and won't connect to iTunes

    HELP PLEASE my iPhone won't turn on it is stuck at the Apple logo and iTunes won't regocnize it I really don't want to buy a new iPhone please help

    Try the steps in this article: http://support.apple.com/kb/ht1808

  • Reset iphone won't turn back on

    reset iphone won't turn back on

    Your post is extremely vague and several months old but hopefully this info can help others seeking a solution.  I too had a problem with my iPhone (3gs in my case) not coming back up. 
    What happened -- I was using it normally and it rebooted and was stuck on the apple for a long time and wouldn't ever get past it.  So I tried to reboot it by pressing power + home but it would just reset and never power off, and get stuck every time. 
    What I did to fix it -- I actually had to just remove the SIM card then reboot the phone.  After it came back up I put the SIM card back in.  It froze up for a short time after that as the service reactivated. But then it is back to normal now finally.  Whew!

  • Help please. Extended display won't work on MBP and AOC 20" 1600 x 900  60HZ monitor. Mirror display does. I've a mini dvd to vga converter cable. Should this work?

    Help please. Extended display won't work on MBP and AOC 20" 1600 x 900  60HZ monitor. Mirror display does. I've a mini dvd to vga converter cable. Should this work?

    I have the same mini display port adapter and Belkin DVI-HDMI cable (but a Panasonic 42" Plasma HDTV) so just set this up on it to see if I could duplicate your problem, unfortunately for you (but good for me) I can't.
    I connected the adapter+HDMI cable before switching the HDTV on and then powered up the MBP. It (the HDTV) came up with my background right away (it's set at Mirror not extended Desktop) and when I run System Preferences/Displays get the following. Sorry but all I can confirm is that adapter+cable combination should work ...
    Try doing a Parameter RAM reset - hold down command/option/p/r keys at start up and wait for three chimes before releasing the keys?

  • My nano and iPhone4 were face to face for a few seconds and now my iPhone won't turn on.  How do I get it going again?  What happened?

    My nano and iPhone4 were face to face for a few seconds and now my iPhone won't turn on.  It doesn't do anything.  I had just charged it.  How do I get my iPhone going again?  What happened?

    Reset your phone:
    Press the sleep/wake button & home button at the same time, keep pressing until you see the Apple logo, then release.

  • Help please.. my iphone 4 is running ios7... suddenly every app is erased from my iphone.. but they still take space in the storage

    help please.. my iphone 4 is running ios 7 suddenly every app disappeared but they still take space!! what could i do??

    A reset may help. Tap and hold the Home button and the On/Off buttons for approximately 15-20 seconds, until the Apple logo reappears. When the logo appears, release both buttons.
    No content is affected by this procedure.

  • IPhone won't turn on after trying to restore to beta version.

    I was trying to restore my iPhone to the latest beta version and during the restore, an error occurred and my iPhone won't turn on, and iTunes does not recognize it anymore. Now, when i try to turn it on, the logo appears and then appears the "connect to iTunes" image and IMMEDIATELY the screen turns white and Apple's logo appears again and starts all over again.

    If you're a registered developer, you have access to the developers forums. iOS 5 beta can NOT be discussed in the public forums. If you're not a developer, bummer... you shouldn't have installed a stolen beta on your phone, should ya?

  • My iphone won't turn on and when I connected it to Itunes all it shows is the It unes symbol

    My Iphone won't turn on. I connect it to Itunes it doesnt do anything but show the Itunes symbol. And the top button is broken.

    This is what you do
    http://support.apple.com/kb/ht1808
    but without a working sleep/wake button you have a problem

  • My iphone won't turn on after recent update

    My iphone won't turn on after recent update. How do I fix this?

    2 more options:
    Restore from backup
    Restore as new
    http://support.apple.com/kb/HT1414

  • My lock button on my phone is broken and my iphone won't turn on, what should I do? I really need help because i don't know what to do.

    My lock button on my iphone is broken and my iphone turned off somehow and won't turn on now. What do I do?

    Without the sleep/wake button, the only chance to turn it on is to connect it to the charger. You may have to wait for the battery to go completely dead. The only other choice would be to take the device to the Genius Bar for replacement.

Maybe you are looking for

  • Syncing ICal on different computers by Ipod

    hi, I am attempting to synch calendars on different Macs. My Ipod only writes data onto the Mac (but does not receive from it). To truly 'synchronize', I would need my Ipod to send AND receive new calendar events and address book items so both comput

  • Very poor speeds and here are my stats

    I live the contry so at best 2mb is excellent but check out these stats.  I have had my ip profile reset and I have a ADSL V10 socket Can anyone help?  Bt are working on it for the last two days etc but still no difference other than I can open a pag

  • Extreme base station with BT homehub

    Hi I wonder if anyone can help. I have a BT homehub that as result of contention needs to be attached to the first phone point into house. I want to be able to get my Imac to connect wirelessly to the BT hub via airport. I then want to use the ethern

  • How to populate the Error stack during error records in field level routine

    hi, I am capturing the error records in Field level routine in transformation. now i want these records to reflect in error stack. i am using 'Append monitor-rec to MONITOR' at the moment but i cant see any records in error stack. but when i am using

  • I can´t open the orginizer in PSElements 5

    Help! I can´t open the orginizer in Photo Shop Elements 5 any more! All other features are functionally. Tried to reinstal the program but with the same result. Anyone???? /Lasse