HELP Stuck in RECOVERY MODE with MUVO ^2
My MUVO ^2 FM is stuck in recovery mode, when i boot up the player it first says firmware error then it brings me to recovery mode. I've downloaded the updated driver and installed it and tried to install the updated firmware upgrade but theres a problem. As im folling the instructions to install firmware file, it gets stuck in "searching for device" so i could never install the firmware. HELP how can i fix this problem?Message Edited by yungg on 04-2-2006 07:56 PM
Still will not work.
Similar Messages
-
My iPod touch 4th gen is stuck in recovery mode with a broken 'lock' button.
My iPod touch 4th generation is stuck in recovery mode with a black screen and I can't get it out. It has a broken lock button and I have tried everything to get it out of recovery mode. Every time I plug it into iTunes, it recognises my iPod and says 'iTunes has detected an iPod in recovery mode. You must restore this iPod before it can be used in iTunes, so I have restored it several times and every time, it says there is an unknown error. Please Help!! (my iPod is IOS 6.0.1)
What is the complete wording of the error message that says unknown error? Usually more information like a error number is also given.
-
My Ipod is stuck in recovery mode with the plug in to itunes thing on the screen I tryed to restore it but I keep getting a error 28 and I tryed to do the reset thing but it did not work what do I do?
Hi,
You could see if this helps...
DFU Mode / Unable to Update or Restore
http://support.apple.com/kb/HT1808
DFU Mode
Open iTunes and Connect the iPod to your Mac
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time
After 10 Seconds release the Sleep/Wake Button until iTunes tells you it has Detected an iPod in Recovery Mode...
The Phone Screen will remain Black... Now Restore.
Backing up, Updating and Restoring
http://support.apple.com/kb/HT1414 -
my iphone 5 is stuck in recovery mode with error 14 unknown error coming up each time i try to restore.
Any suggestions?Hi ShinefromOKC,
Welcome to the Support Communities!
The article below may be able to help you with this.
Click on the link to see more details and screenshots.
iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/ts3694
Error 13, 14, 35 and 50 (or -50)
These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different Dock Connector or Lightning Connector to USB cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. An incorrectly set default packet size can cause this error. Contact the software manufacturer that installed the packet-size modification for assistance. Or, follow this article by Microsoft to reset the packet size back to the default for Windows:How to reset Internet Protocol (TCP/IP).
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network.
I hope this information helps ....
Happy Holidays!
- Judy -
IPad1 stuck in recovery mode with and ITunes cannot restore with an error code of 11?
I tried to update to IOS 4.3.4 today but now my iPad1 stuck in recovery mode with and ITunes cannot restore with an error code of 11?
(With the old discussion groups it was easy to see where other people had similar problems, these new groups seems clunky in comparison)OK, fixed it by using SHIFT+RESTORE to load the iPad1,1_4.3.4_8K2_Restore.ipsw file in directly from the
C:\Documents and Settings\<user name>\Application Data\Apple Computer\iTunes\iPad Software Updates
folder.
No idea why the upgrade to 4.3.3 failed in the first place and no idea why iTunes was not clever enough to just do it by itself when it detected that there was a problem in the first place. -
4s stuck in recovery mode with error 29
The problems started when I changed the battery, now phone is stuck in recovery mode with an error code 29. Ive turned the firewall off and anti virus on my norton security, switched the computer on and off and tried to restore the phone about 6 times now. Has anyone any other ideas please?
That's a hardware problem, most likely cause when you broke something in the process of changing the battery.
http://support.apple.com/kb/ts3694#10
Find a competent 3rd party repair shop or buy a new phone. Apple won't touch that one now that you've opened it. -
My iPod is stuck in recovery mode with a error code 1
my ipod is stuck in recovery mode with a error code 1
ERROR (1)
- Place the iPod in DFU mode and then restore
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- Try on another computer
- Try another cable
- Also, confirm your security software and settings are allowing communication between your device and update servers.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
iphone stuck on recovery mode,,, cannot restore due to error 21. tried all ways to solve the error, but no use... plz help
Hi D’pak,
Thanks for using the Apple Support Communities. I understand that you are receiving error 21 when attempting to restore your device in recovery mode. The following resource provides troubleshooting information for this error message:
Get help with iOS update and restore errors - Apple Support
http://support.apple.com/en-us/TS3694#hardware
Check for hardware issues
Related errors: 1, 3, 11, 12, 13, 14, 16, 20, 21, 23, 26, 27, 28, 29, 34, 35, 36, 37, 40, 1002, 1004, 1011, 1012, 1014, 1667, or 1669.
These errors mean that your device or computer might have a hardware issue that stops the update or restore from completing.
Check that your security software and settings aren't blocking your device from communicating with the Apple update server.
Then try to restore your iOS device two more times while connected with a cable, computer, and network you know are good.
Make sure that your security software and settings are allowing communication between your device and update servers.
If you still see the error message when you update or restore, contact Apple support.
- Matt M. -
PLEASE HELP IM STUCK IN RECOVERY MODE WITH NO BACKUP
CAN ANYBODY PLEASE TELL ME WHAT TO DO. IM STUCK IN RECOVERY MODE, IVE NEVER BACKED UP MY IPHONE AND I CANT RESTORE IT TO FACTORY BECAUSE IT WILL DELETE ALL MY DATA.
<Edited by Host>It's too late to back up now and you need to restore. Why did you not back up?
-
Please help stuck in recovery mode
Hi can someone at apple please help me. I was updating my ipod to ios 8.3 when it was half way done i accidentally shut it of. Now my ipod is stuck in recovery mode. When i try updating it via itunes i tried to update it however it keeps saying that it will take over 500 hours and i also have a very good inter net connection and now i dont know what to do. someone please help me!!!!
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
First gen ipad stuck in recovery mode with error 28
I have a first generation ipad that is stuck in recovery mode (just shows the itunes logo all the time). I have tried putting it in dfu mode and restoring it from itunes. It gets to the point where the computer reboots the ipad and says that it is beginning the restore, but the progress bar never fills up on the ipad and I get an error 28. It charges and docks fine. The battery holds a charge for a long time. The water indicator is still white. I don't see any visible damage anywhere on the ipad.
I have checked the firewalls on my computer and tested the cable. Both are fine. I have also tried using another computer, but I get the same results.
Could it be a bad dock connector even though it charges and is recognized successfully by itunes? One of the support forums said that error 28 was a hardware issue, but is there any way to tell what is bad without having to take it in to Apple? It would cost too much to have it serviced, with it being a first generation, so I was hoping that someone out there had some ideas that could help me save it and not have to sell it for parts.A simple search of the forum for "error 28" yields may results, one being...
Error 20, 21, 23, 26, 28, 29, 34, 37
These errors typically occur when security software interferes with the restore and update process. FollowTroubleshooting security software issues to resolve this issue. In rare cases, these errors may be a hardware issue. If the errors persist on another computer, the device may need service.
http://support.apple.com/kb/TS3694#error28 -
IPod stuck in recovery mode with home button not working
Hi, I was restoring my iPod and everything went fine until it was restarting with the apple logo and loading symbol. My iPod's home button hasn't been working in a while so I use assistive touch. Now the iPod is stuck in recovery mode and I can't press the home button, I don't know what to do. Pls help!
Try:
- iOS: Not responding or does not turn on
Whenit says place the iPod in recoivery mode:
Place the iPod in recovery mode using one of these programs:
For PC
RecBoot: Easy Way to Put iPhone into Recovery Mode
or
http://joshuabailey1997.wordpress.com/2010/09/02/recboot-v1-3/
If necessary:
Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
and
RecBoot tip
RecBoot may have problems on 64X windows, then try:
Tenorshare ReiBoot – Enter & Exit iPhone, iPad, iPod Recovery Mode with a Single Click
For MAC or PC
The Firmware Umbrella - TinyUmbrella
Installs blootware on PC too
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
IPhone 3GS stuck in recovery mode with error -1
Can somene please help. My iPhone has been stuck like this for 3 weeks now, and I'm starting to get really fed up with not having a phone.
My phone just keeps going around in circles stuck in recovery mode and can't get it to work.have you seen this ?
http://thehowto.wikidot.com/ipad-stuck-recovery-mode -
Brand new ipad stuck in recovery mode with error 21
Brand new ipad just out of box starting setting up and now its stuck in recovery mode and keeps giving error 21 - tried turning off firewalls as suggested and another PC... nothing working... is it a complete turkey or is it me?
Sorry I can't help with your issue. Just wanted to point out that it's not a good idea creating multiple posts on the same topic as it only serves to cause confusion, duplicate answers and divides responses between threads.
http://discussions.apple.com/thread.jspa?threadID=2572252&tstart=0 -
Ipod touch is stuck in recovery mode with a error code 9
my ipod touch is stuck in recovery mode and when i try to restore it getting an error code 9
Error 9: This error occurs when the device unexpectedly drops off the USB bus and communication stops. This can occur if the device is manually disconnected during the restore process. This issue can be resolved by performing USB isolation troubleshooting, using a different USB dock-connector cable, trying another USB port, restoring on another computer, or by eliminating conflicts from third-party security software.
From:
http://support.apple.com/kb/TS3694
Maybe you are looking for
-
How to cancel/reverse an inbound idoc?
I wish to cancel then reverse an inbound idoc specifically, WPUUMS01 (sales data compressed) as if the idoc never existed and wasn't processed in SAP. The said idoc was already processed in SAP and the material and billing documents (in WPER) were al
-
Unable to login to Oracle E-Business Suite R12 on Windows 2003
Hi, I have recently installed EBS R12 on WIN 2003 that finished successfully. I can launch the login page - http://prora.com.au:8000/OA_HTML/AppsLogin I entered user/passwd as SYSADMIN/sysadmin but it didn't allow me to get inside. It doesn't display
-
ipod touch for Christmas, but cannot get started: after installing itunes, when connecting to my laptop I get no instruactions, just the error message "This iPod cannot be used because the Aplle Mobile Device service is not started". Any suggestions?
-
Is there a 64 bit Plug-in availalbe for Office 2010?
I would like to be able to open and edit MS Office documents using Office 2010 when the documents reside in SkyDrive. The only plug-in I can find is for a 32 bit applications and it wont download to my PC which is running Windows 8.1 64 bit. Can anyo
-
Bluetooth two mini speakers ?
Is it possible to bluetooth two mini speakers to an iPod Touch ?