Hi, my phone turned off by itself, the battery is fully charged, and now i can't turn it back on. Does anyone know what to do?
hi my phone suddenly turned off, it has a fully charged batterie and i cant turn it back on. Does anyone know what to do?
Tamara Holding both buttons the Power and the Lower Volume is Known as a Power Cycle) In the event that your Razr shuts down and you Try to turn it on and it Doesn't press the power button for 10 sec Let off and then re-peat the process and your Razr should come back on Mine has done this and this is what i done. b33
Similar Messages
-
I own a I phone 4. I recently changed my service from AT&T to Straight Talk. It was working fine but then I deleted the vpn file on accident. Now when I try to get on line I get a message that I am not signed up with a cellular data network. Does anyone know how I can retrieve or download the vpn file?
I have taken it back to the Apple store genius bar, but they say they don't see anything wrong. Well unless you use it all day and experience the problems when they happen, you wont see anything wrong. But there are lots wrong with it. But this would be the same store as I purchased the phone. And they backed up my old Iphone 4, but were not able to get anything to load back onto my new phone. So, I lost pretty much everything. But over time, some of my contacts have started showing up, although i am still missing over 800 of them.
-
After a one week logout and shutdown my macpro 1,1 laptop running OSx 10.6.8 shows a black screen at startup attempts. The battery is fully charged and both resetting the power manager and zapping the PRAM have failed to permit startup. What else can I try?
Startup – Black screen with cursor
Startup Issues - Resolve
Startup Issues - Resolve (2) -
I was playing aaroound with the size of my window and now I can't get it back to standard size. Any suggestions?
If you're using Lion, you can resize by dragging from any corner, in Leopard and lower it can only be resized from the bottom right hand corner.
-
Sometimes my iPad1 locks up and has the flat battery graphic after charging all night, but will not work until you disconnect the charger, then it reboots and the battery is fully charged and works normally.
It has only happened for the last month or so
Also, sometimes it drops out of apps, ie facebook etc. just like you have hit the stop buttonWho replaced the battery? If it wasn't Apple the replacement is probably bad also. Either that, or the logic board is bad.
-
Should I disconnect my iphone lighting connector when the battery is fully charged? or i can connected always?is there any issue using iphone powered in?
It can stay connected fully charged without any problems.
No issue using the iPhone while charging. -
is it ok to keep the power always connected on a macbook even though the battery is fully charged and battery sign shows power cable symbol?
How would it effect the battery life..Apples recommendations on this http://www.apple.com/batteries/notebooks.html
Stefan -
Hi, ive go an iphone 3gs and im about to sell it, so i wanted to reset the phone, i went into settings and clickes erase iphone and then it turned off and wont turn on now does anyone know what to do. thanks x
http://support.apple.com/kb/HT1414
-
my i pod 4th gen will not power up and the battery was fully charged about 5 days ago. it just won't come back on and the computer doesn't recognize that it is plugged in. what should i do? i tried to call apple and they wanted 30 dollars just to talk to me
Have you tried a reset?
Are you able to restore?
iPod touch User Guide (For iOS 5.0 Software) -
My iPod touch won't turn on it is fully charged and when I plug it into the computer iTunes doesn't recognize it how can I fix this?
Seen this?
How to reset iPod - Apple Support -
Hi My battery on my macbook pro keeps running low on power very quickly and I have to keep recharging it. This has never happened before. I have used all the power saver options, but it keeps happening. Can anyone help. The battery seems to be losing power even when it is turned off.
Hi BigThinker,
How old is your Mac? If it is an older one, then the battery may just be dying. You can check by clicking on the Apple in the upper left-hand corner, then clicking on About This Mac>More Info>System Report, then click on Power (about half way down the list). At the top of the resulting display, you should see the following type of info:
The Health Information will tell you if your battery is going to need replacement soon. If it says Normal, then it is not the battery.
Cheers,
GB -
so i had a full battery on my iphone and it just shut off and now it will not turn on it has no water damage nothing
Restart iPhone: Hold down the Sleep/Wake button and the home button together until the apple logo appears (ignore the ON/OFF slider) then let both buttons go and wait for phone to restart (no data will be lost).
-
WWanted to clean my Mac Book so when it was off I lightly sprayed it with some ecover then I haven't been able to turn it on since. Does anyone have any ideas or tips about getting it working again please???
Please make a Genius Appointment and take it in for service.
-
My new 4s had the battery run all the way down, how do I get restarted?
"You have to change your router's IP address to be able to access it. It will not give you the internet."
I'm not sure what that means Richard, but I did change the router's IP address from 192.168.1.1 to 192.168.5.1- isn't that what you meant in your first post. I know that isn't reflected in my screen capture that I took last night, but I did do that this morning after I read your post.
"Log on to your router and change two settings.
Change the setting in Setup from PPPoE to Automatic Configuration-DHCP and click on save.
Click on Advance Routing and change the setting from Gateway to Router then click on save."
I did this and still same results as far as I can tell. Can't get online through the router.
"Click on MAC address clone under setup tab ... click enable & click clone ...click save settings ... Check the IPaddress under WAN page ....
If getting IP in public range .... try going online ...."
I tried this- at least to the part about checking the IP address under WAN. I assume you mean the WAN page in the modem setup- nothing looked any different after trying what you suggested, and I'm not really sure where I would be "getting IP in public range" or what that means.
I'm about to give up and just buy a new router to see if I can get the same lack of results with a different one. My ISP maintains that everything is set up correctly on their end and really can't do anything more for me. The Modem works and is set up correctly and they can give tech support for a router.
Here's what my basic setup looks like now:
http://i490.photobucket.com/albums/rr270/SukarUDL/BasicSetup.png
Here's what the advanced tab looks like now:
http://i490.photobucket.com/albums/rr270/SukarUDL/AdvancedRouting.png
Modem setup looks the same
Message Edited by Writersbloc on 09-25-2008 07:05 PM -
on my I phone next to battery symbol there is a "locked lock surrounded by aa circled arrow" does any one know what this is for?
drsoif, this is the Portrait Orientaion Lock, which means you locked your phone in a way for it not to have landscaping mode. To correct this you will need to: double tap your home button and swipe to the right, first icon will be the icon with the ''arrow'' going in a circle, tap on it once and the lock will disappear:)
Maybe you are looking for
-
Problems with track pad and osx installation disc on macbok.
Okay so I am having two separate problems with my macbook. First, the track pad, or the button beneath it, is pretty much completely out of commission. When I try and use it, the computer acts as if I am holding down the button all the time. Example,
-
Photoshop CS can't show the actual print size & other bugs...
Although I have set in preferences my display's exact dots per inch (which is 92.72) , the rulers in mm and the real print size of the document, when I click on view print size, the document is displayed much smaller than the actual size! I have also
-
Hi Experts, I have a requirement for a report in BW showing different Status counts per Weeks as shown in below Status Week1 WeeK2 Week3---n(Date Range as Per User) S1 10 10
-
Infospoke inactive after transport
Experts, In version 3.5, I have created an infospoke with transformation and unit tested in Dev box. After transport I have got an error 8 while importing in QA. I checked all objects if anything missing or inactive in dev box related with this trans
-
DTP running long time to load master data due to lock on SID table
Hi, we are facing a problem while DTP loading master data into targets(Info Objects). It is taking long time to load data due to below error. 18.03.2014 01:03:23 All records forwarded