How can I get this to work with NAT?

Question

Hi Masters, 
I need to add a route-map to a static NAT but the option seems to be available only if using inside/outside NAT, not if using enable NAT. 
This is a CISCO1921/K9 running 15.2(4)M6
Here's what I mean: 
R2(config)#ip nat inside source static 192.168.3.20 10.10.10.20  ?    -->  allows the route-map option to be appended 
  extendable  Extend this translation when used
  mapping-id  Associate a mapping id to this mapping
  no-alias    Do not create an alias for the global address
  no-payload  No translation of embedded address/port in the payload
  redundancy  NAT redundancy operation
  route-map   Specify route-map
  vrf         Specify vrf
  <cr>
R2(config)#ip nat source static 192.168.3.20 10.10.10.20 ?         -->  no route-map option 
  extendable  Extend this translation when used
  no-alias    Do not create an alias for the global address
  no-payload  No translation of embedded address/port in the payload
  vrf         Specify vrf
  <cr>
What I need is multiple dynamic and static NAT rules between multiple interfaces, so I need a way to assign multiple static NAT depending on the destination. 
For example, if server 192.168.3.0 wants to go to VLAN A, get statically translated to IP 1. 
If the same server 192.168.3.0 wants to go to VLAN B, get statically translated to IP 2. 
AS far as I know I need a route-map attached to the static NAT statements to make this happen, but the option is not available as shown above. And I don't want to use normal inside/outside NAT since I need the interfaces to allow NAT in both directions. 
If anybody can share some light will be very appreciated!

Answer 1

Paul, 
The commands: 
ip nat source list or ip nat source route-map works fine for dynamic NAT or PAT, but I need static NAT. 
And the Static PAT statements won’t work since we need all ports defined. 
So, I guess I need a way to map static NAT depending on the destination using domain-less NAT. 
Can this be accomplished?