How can i restart my ipad2 forgot password and its completey disabled, its telling me to go to itunes,? but then what

i just the ipad2 for my daughter she forgot her password we retryed too many times that its completey disabled, its saying to go to itunes., then what?? i need help Please

Connect to iTunes on the computer you usually Sync with and “ Restore “...
http://support.apple.com/kb/HT1414
If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808

Similar Messages

How can i back up my apple iphone 3g its telling me to unlock the screene but i cant the touch screen doesnt work

i have a apple iphone 3g and my touch screen doesnt work i tried to back it up to my itunes but its telling me unlock it i need my contacts off it like asap help

If the touch screen physically doesn't work, it's too late to back it up. You should have been syncing your contacts with something... a cloud service or contact manager on a PC. If you were not, then I'm afraid you're going to lose them.

How can I change the Apple ID associated with my iCloud account? I changed it in my itunes but the old id is still hijacking my icloud!

how can I change the Apple ID associated with my iCloud account? I changed it in my itunes but the old id is still hijacking my icloud!

Hello pscorning1,
I apologize, I'm a bit unclear on the exact nature of your question. If you have already changed the information associated with your current Apple ID (*not* created an entirely new Apple ID), you may find the following article about updating the various Apple ID services helpful:
What to do after you change your Apple ID email address or password - Apple Support
Sincerely,
- Brenden

I forgot the code to the lock screen to my phone and its telling me to connect to itunes....what do I do?

I forgot the code to the lock screen to my phone and its telling me to connect to itunes....what do I do?

You need to connect the phone to your computer's iTunes, and that should recognise the phone and let you reset it back to factory defaults - you can then restore/resync your content to it.
Disabled device : iOS: Forgot passcode or device disabled

How do i unlock my ipod, forgot password and now disabled

My daughter forgot her password and her ipod is now disabled, help.

Read this
iOS: Unable to update or restore
This is asked and answered countless times every day.
You can do a forum search on the right side of this page, and look at the More Like This section to find an answer

I shared an ipod 5th generation with my ex partner and she set it up with her email and password. how can i change it for my password and email address so that i can wipe it and start again?

i shared an ipod 5th gen with my ex partner and she set it up with her email and password. i have the ipod now but no password and would like to put it on my email and password so that i can wipe it clean and start again, any ideas?

The iPod isn't tied to an Apple ID, but is likely tied to an iTunes library. If you want to set it up as a new iPod (as if you were just pulling it out of the box), restore it to factory settings in iTunes.
Restoring iPod to factory settings
B-rock

HT201363 how can I re-set my security password and answers?

I have tried to buy tunes but I have forgotten my security answers and questions how can I re-set those? Please

You need to contact Apple. Click here, phone them, and ask for the Account Security team, or fill out and submit this form.
(92870)

How can I identify new new added harddisk and its device file

Hello:
I am confuse about it. It is about new harddisk map to device file issue.
Example:
I set up two harddisks by VMware SCSI 1:0 & SCSI 1:1, and I can see /dev/sdb /dev/sdc by "lvmdiskscan".
The puzzle is how can I distinguish this two new harddisk mapping device file if SCSI 1:0 & SCSI 1:1 are also 1GB of each?
Just like one which is right SCSI 1:0 map to /dev/sdb or /dev/sdc ? How can I check them using command?

Normally /dev/sda is SCSI ID 0, /dev/sdb SCSI ID 1, etc.
You can try lsscsi command, e.g.:
# lsscsi
[0:0:0:0]    disk    VBOX     HARDDISK         1.0   /dev/sda
[0:0:1:0]    disk    VBOX     HARDDISK         1.0   /dev/sdb
[0:0:2:0]    disk    VBOX     HARDDISK         1.0   /dev/sdc
[0:0:3:0]    disk    VBOX     HARDDISK         1.0   /dev/sdd
[2:0:0:0]    cd/dvd VBOX     CD-ROM           1.0   /dev/sr0

How do you unlock iphone when forgotton password and phone is disabled?

phone is disabled, wont reset on computer

If You Are Locked Out Or Have Forgotten Your Passcode
iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
iOS- Understanding passcodes
     If you have forgotten your Restrictions code, then follow the instructions
     below but DO NOT restore any previous backup. If you do then you will
     simply be restoring the old Restrictions code you have forgotten. This
     same warning applies if you need to restore a clean system.
A Complete Guide to Restore or Recover Your iDevice (if You Forget Your Passcode)
If you need to restore your device or ff you cannot remember the passcode, then you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and re-sync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
Follow these steps to restore your device:
     1. Verify that you are using the latest version of iTunes before attempting to update.
     2. Connect your device to your computer.
     3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
     4. Select the Summary tab.
     5. Select the Restore option.
     6. When prompted to back up your settings before restoring, select the Back Up
         option (see in the image below). If you have just backed up the device, it is not
         necessary to create another.
     7. Select the Restore option when iTunes prompts you (as long as you've backed up,
         you should not have to worry about restoring your iOS device).
     8. When the restore process has completed, the device restarts and displays the Apple
         logo while starting up:
           After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
          to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
          iOS, keep your device connected until the "Connect to iTunes" screen goes away or
          you see "iPhone is activated."
     9. The final step is to restore your device from a previous backup.
If you can not restore your device then you will need to go to recovery mode.
Placing your device into recovery mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
     1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the other end
         of the cable connected to your computer's USB port.
     2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the
         red slider appears, then slide the slider. Wait for the device to turn off.
          If you cannot turn off the device using the slider, press and hold the Sleep/Wake
          and Home buttons at the same time. When the device turns off, release the Sleep/Wake
          and Home buttons.
     3. While pressing and holding the Home button, reconnect the USB cable to the device.
         The device should turn on. Note: If you see the screen pictured below, let the device
         charge for at least ten minutes to ensure that the battery has some charge, and then
         start with step 2 again.
     4. Continue holding the Home button until you see the "Connect to iTunes" screen.
         When this screen appears you can release the Home button.
     5. If necessary, open iTunes. You should see the following "recovery mode" alert:
     6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

HT4113 my ipad is locked i forgot password and its not connecting to itunes

my i pad is locked i forgot password , on screen its saying conact to itune but its not conactin its asking for password wich i forgot

Forgotten passcode
http://support.apple.com/kb/HT1212

How can I extract both my mp3 file and its associated .jpg out of itunes

Hi everybody,
I'm a DJ and once a month, I like to share a set of mine with my friends. For each set, I also make a dedicated flyer.
I usually put the recorded set in Itunes, then I add the flyers using the "Illustration" (I'm using a French version) tag.
Then, I drag the new file (both the .mp3 and .jpg) on a folder on my computer and I can see the flyers and not the normal Mac icon for music file.
I had always worked, but today I tried to do the same but it doesn't work anymore. In Itunes, my mp3 file contain the flyers, but when I drag it to another folder, the flyer is not there anymore.
What happened???
does anybody know a freeware to associate a mp3 with a .jpg?
Thanks for your help,
Have a nice day
Jean

Bonjour.
I'm not firm with the french iTunes but I'm sure its similar to all other iTunes in the world, except the language of the menus.
You can include the cover (Illustration) inside the music file. mp3, AAC or Lossless makes no difference.
To do so go to:
The song (or songs) by marking it (them) in the main iTunes window. Then right click mouse (or two fingers on touchpad) and choose "Information"
In the information window go to the tab called "cover"
Move the wanted picture via drag & drop into this window. The best format for such illustrations are 500 x 500 pixels. If yours are bigger then iTunes will resize it to fit.
Click on save
If you will change the cover for more than one file (song) you will be ask "you are sure to change all files"
Simply press ok
After that the cover will show up in iTunes and will be exported within the file if you pass the song to others..
There is no reason to place the cover / Illustration in the Music folder cause iTunes uses for imported covers the "Album Artwork" Folder in the Library.

My phone is disabled.its telling me to connect to itunes but itunes wont connect to my phone what can i do to fix my phone?

my phone is disabled how can i fix it?

See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps.
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766

HT5622 Goodmorning, trying to change my apple ID password, how can i verify if i forgot password?

I M trying to change apple ID on cell iphone 5

Go to http://appleid.apple.com. Underneath where it says "Already have an Apple ID?," click Manage your Account. Click on the "Forgot my password" link below the password field.

I need to restart my iPad , forgot password and it is now disabled

I need to restart my iPad mini from scratch, it has been wiped clean and disabled on ITunes. I want to know how to restart the iPad and put a new password in , connected to iTunes and don't know where to start.....

Locked Out, Forgot Lock or Restrictions Passcode, or Need to Restore Your Device: Several Alternative Solutions
1. iOS- Forgotten passcode or device disabled after entering wrong passcode
2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
3. Restoring iPod touch after forgotten passcode
4. What to Do If You've Forgotten Your iPhone's Passcode
5. iOS- Understanding passcodes
6. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
7. iOS - Unable to update or restore
Forgotten Restrictions Passcode Help
iPad,iPod,iPod Touch Recovery Mode
You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New.
You can restore from a backup if you have one from BEFORE you set the restrictions passcode.
Also, see iTunes- Restoring iOS software.

How can I get back a pages file and its backup if I did not save them to my documents?

Hallo community!
My mac got stock on a website because of a java update so I was forced to shut down the computer using the on-botton. Upon restarting my work on Pages I clicked on the file I was working on so as to open both the file and pages but the file wouldnt open. I checked if I had also saved the file on my documents to try to restart it from there. But this file comes originally from a USB which I dont have at this moment although I could kee on working on this file without the usb. The file is not my documents yet it shows on the last files-list of pages.
I cant open this file anymore, maybe because I did not save it to my files. Although this is strange because I even named another file I worked on along this first document. Enfin, the first file even has a backup according to the list but the backup wont open either. I don't know how to get this file back I am in big trouble If I dont get to open it soon! I hope somebody can help me. Anyone knows a trick or something!?

What version of Pages?
It sounds like it may be damaged.
You do not have to save to Documents.
Peter

How can i restart my ipad2 forgot password and its completey disabled, its telling me to go to itunes,? but then what

Similar Messages

Maybe you are looking for