How do I adjust Timeline length?

Hello,
I know Pr automatically extend the timeline length but I ran into a problem when the Timeline's grown to 4hr whereas all my assets are 2hr long.
Is there any way to shorten the length (they are blank video anyway) of the Timeline?
It is also weird to see the existence of several Edit Points after the 2hr video cut off, I believe that is what's causing the excessive Timeline. However, there isn't any asset on the Timeline as indicated by those Edit Points.
Any help is appreicated.
Thanks very much!

Welcome to the forum.
As Colin surmises, you have some "orphans" out beyond where you think the Timeline should end. It could be just one frame from a Clip.
This ARTICLE will give you more background, but it was written for PrElements and earlier versions of PrPro, so be sure to follow Colin's instructions above.
Good luck,
Hunt

Similar Messages

  • How can I adjust the length of a note? Please help.

    How can I adjust the length (the sustain time) of a note after I have selected the note? Many thanks.

    Just drag the right end back and forth (mouse over the end of the note - a ] appears) - by holding down ctrlshiftdragging you can change the subdivision into ticks. In the Midi event editor you can do it numerically - just change the numbers displayed in the length section.

  • How to I adjust the length of a track?

    New to Garage Band. Took a one to one session and I can't stop playing with the program. I created a song through the Magic Garage Band feature which I am trying to match up to a video. My video is about 4 minutes but the track I created is about 1:30. How do I set the length of the track?

    If the audio Regions of the Project only go as far as 1:30 you can extend each Region by looping them. This repeats the audio. Hold the cursor at the upper right corner of the Region until it changes to a loop, then drag out as far as you like.

  • How do you adjust the length of a project?

    Im currently working on a project and Logic won't let me extend my loops out past 4 minutes 50 seconds. Does anybody know how I extend the length of my project?

    In the transport window below the tempo display you find the End point of your project. Maximum project length is 13 hours equaling 21601 Bars at tempo 120 or 901 bars at tempo 5.

  • How do I adjust the length of an image without adjusting the height?

    I'm making labels for playdoh for my son's bday party so I need the label to be long and short in length to fit. I inserted my image/photo onto a blank slide in keynote. I have tried to make the photo longer but it is also making it taller. I'm used to working w/Powerpoint where you stretch the corner to adjust height and width...and if you wanted only length to be stretched you simply stretch the arrow on the side and the height stays the same. I have spent over an hour trying to figure this out! I realize it is probably easy but please help if you can! Thanks so much!

    Hi Lieven, I did exactly as you said except it would not allow me to check or uncheck the constrain proportions options. It appears to be unchecked but it does not give me an option to do anything under the Metrics tab. Do you have any idea why? Thanks.

  • How do I adjust the length of a genius list in Itunes 11

    Aside form any number of problems I am finding with this new version, my current favorite is how do you get more than 25 songs on a genius list? and don't get me started on what happened to find duplicates function.
    Thanks

    Simply double click on the playlist name.
    Really easy
    Let me know

  • SmartWatch 2, how do you adjust the length of the Stainless Steel Strap ???

    I have just purchased the SmartWatch 2 and the Stainless Steel Strap is way to long for my wrist.
    No problem you might think ?
    Yes it is .. there are no instructions how to shorten it anywhere !!!!!
    I can't believe Sony have missed the instructions out !
    HELP.... PLEASE, it is unusable as it is :-(

    this question has already been asked and answered, just a couple of posts down
    http://talk.sonymobile.com/t5/Wireless-accessories/SW2-metal-wrist-strap/m-p/411597#U411597

  • How do you adjust the lenght of a transition?

    How do you adjust the length of a transitions? I'm trying to adjust a video and audio fade in and fade out at different lengths.

    Video transition durations are controlled in the 'Project Properties.'

  • ? Flash CS4, Is it possible to adjust the length of multiple timelines at once?

    Hi,
    I am using Flash CS4. Is there any way to adjust the length of multiple timelines at once? I am doing an animation of leaves falling from a tree. The leaves alone have 17 separate timelines on separate layers plus each has it's own guide layer.
    If I had the ability to to select all of the timelines together and adjust all of their respective start and end times at the same same time, relative to each other as well as separately, life would be so much easier!
    Of course I can do it timeline by timeline, no problem, but I can't seem to adjust the length of more than one timeline at a time. (no pun intended)
    Even when I select more than one timeline, the double arrow only adjusts the length of one timeline. Even each guide layer's length has to be adjusted separately. I understand the benefit of this, but, testing timing and making adjustments would be so much simpler and go so much faster if I could select and drag multiple timeline lengths at the same time.
    Is there any way to do this?
    I'm new to Flash so, thanks in advance for your patience with me!
    SabelV

    Thanks! I had a feeling. It's nice to have the answer. Oh well, now I can get back to work and not waste any more time with that part of the puzzle. You've been very helpful and I'm sure your answer is correct.  Wish I knew how to rate your answer even higher. Thanks again!

  • How do you change timeline's length of time?

    How do you change the length of time of the timeline?
    Thanks.

    CTRL + K or CMD + K brings up your comp settings, change the length of your composition setting there or right click, CTRL/CMD click on timeline and alter it directly

  • How do you adjust the duration of audio loop?

    How do you adjust the duration of the audio loop that you can setup to play in the main menu?

    Your best bet is to bring your audio into DVDSP at the length you need it. You can adjust the menu loop time in the inspector but this also adjusted your video as well. DVDSP is not an editor - only an authoring tool All adjustments need to be made outside the tool.

  • How can i change the length of a narration ?

    how can i change the length of a narration ?

    hotts77
    Thanks for the reply.
    Still not sure what version of Premiere Elements that you are using. But, the following should apply nonetheless
    What you describe is what I have described in my blog post and for which I have discussed all aspects of the issue. There
    is no workaround to force the program to give you more than you are getting now without other clips also on the track(s). The
    blog post just about says it all.
    You might have to weigh the pros and cons of
    a. Recording your narrations as .wav files in a free audio editor such as Audacity
    Audacity: Free Audio Editor and Recorder
    and then importing those into your Premiere Elements project with Premiere Elements' Add Media/Files and Folders/Project Assets from where you drag the narration to the Narration Track.
    b. Put any video clips on the Timeline when you are recording your Premiere Elements narrations with its Narration Tool. Then remove these video clips and replace them with the real thing when you are ready to put narration and clips into the project.
    Please let me know if you are OK with the details.
    Thank you.
    ATR

  • How do I set the length of a podcast?

    How do I set the length of a podcast? I am using Garageband 3.0.2

    Drag the little purple left facing triangle at the top of the timeline to where you want the export to end.
    (Note, GB does impose a minimum length, but I dont' recall what that is at the moment)

  • How to create the timeline chart in SSRS 2008

    Hello Everyone!!
    How to create basic timeline chart with x asix as month and  show project start date as marker on this in ssrs reports
    Which type of chart i should use and any sample link?
    Something like in below link
    Timeline
    image

    Hi SonikaJ,
    After testing the issue in my local environment, we can enable the Scalar axis option to display a set of axis values on a continuous scale and reset the “Interval” property of the X-Axis. For more details, please see the following steps:
    Drag a Column Chart to design surface, insert corresponding fields.
    Right click on the Horizontal Axis and open the “Category Axis Properties” window.
    Check the “Scalar axis” option, set the “Interval type” to “Months” and set the “Interval” to 1 for example.
    Right click on the Vertical Axis and uncheck “Show Axis” option to hide the Y-Axis.
    Right-click the series columns to select “Show Data Labels”, then right-click on the Label and select Series Label Properties.
    In the Expression dialog box, modify the expression to anything you like.
    To adjust the width simply select the appropriate series and go to the properties pane and drill down into the Custom Attributes and find the PointWidth. Then set the value to 0.1 for example.
    If there are any other questions, please feel free to let me know.
    Thanks,
    Katherine Xiong
    Katherine Xiong
    TechNet Community Support

  • Timeline length on Final Cut X

    How do I extend the timeline length on Final Cut X to more than 59 minutes?

    I wanted to insert some video which exceeds this duration and I get error message this is not allowed as the timeline is not long enough. However I can't see anywhere to extend the time line.

Maybe you are looking for