How do I fix my ipod classic that says very low batter after I have charged it and the problem persists?

I have an Ipod video 30g that says Please wait very low battery. I charged it for about a day and the problem persists. I've tried using some solutions on the internet and none of them worked including: holding the menu and select, holding select and play to put it in disk mode with no avail. Is there anyone who can help me!!!

Have you read this post written by another forum member?
The Sad iPod icon.
However, as your iPod was purchased on Boxing Day, why not get it serviced under the warranty?
You can arrange online service here.
Service request.
Or if an Apple store is near you, take it there and have them check your iPod.
You can make an appointment by using this link.
Genius Bar Appointments.

Similar Messages

  • My Ipod, keeps on saying very low battery then restarting. then turning bright with the apple logo and going back to very low battery again.

    My Ipod, keeps on saying very low battery then restarting.Then turning bright with the apple logo and going back to very low battery again. HELP PLEASE.. I have plugged it in for 2 hours now.

    If you are trying to charge from your computer, try a different USB port, or try charging from a wall outlet.
    And try here.   Troubleshooting iPhone hardware
    Powering Apple and third party peripherals through USB

  • Hello my ipod touch does not open to applications.  I have charged it and the ipod is thinking.  The wheel just spins

    I have turned it off.  I have charged it.  Its like the system is thinking.  The wheel spins and then the charge dies.  Please help.

    If the iPad connects to iTunes using the same cable and USB port:
    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Does it charge when connectes?
    - Look at the dock connector on the iPod. Look for abnormalities like bent or corroded contacts, cracked or broken plastic.
    -  Make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar

  • HT201263 how do i fix my ipod when it says ipod is disabled connect to itunes?

    how do i fix my ipod when it says ipod is disabled connect to itunes?

    Place the iPod in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen
    If recovery mode does not work try DFU mode.
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings

  • My iphone 4s lose signal and only say serching to fix it i need to restore  , this happen whe i dont have more battery and the iphone turn off

    my iphone 4s lose signal and only say serching to fix it i need to restore  , this happen whe i dont have more battery and the iphone turn off

    Is the battery drained after it shuts itself off?
    Did you already try to set it up as new device?
    How to back up your data and set up as a new device

  • How do I get my ipod classic that is windows based sync to my new mac

    I have an iPod classic that is windows based and now have a macbook and a new ipod touch that I would like to sync together.  Is it possible?

    Did you try to connect your ipod classic to your Mac, let iTunes set it up for Mac and choose the content to sync?
    Thsi might also help: Restoring iPod to factory settings

  • I purchased a movie from I-tunes. Why won't it copy to my I pod? I receive a message "Smoke Signals was not copied to Ipod because it cannot be played on this ipod". All other movies purchased from I-tunes have been copied and no problem playing.

    What can I do to view this movie I downloaded from I tunes on my Ipod classic? Thanks very mcuh for any information.

    Are you aware of how movies must be encoded for the iPad if the specs are different than Apple TV's?
    You can find the specifications for iPad playback compatibility on the iPad Tech Specs web page of the Apple site. If using HandBrake, it best to use one of the included presets from the latest set preset updates. If you change these settings, there is always the possibility you may create problems, For instance, one person has already reported that using audio data rates above the recommended 160 Kbps limit will indeed cause problems. The iPad will play movies made using any of the Apple device presets. Since I also have the TV unit, I normally use that preset so as to get double use out of the same iTunes managed file. Having a passive secondary AC3 5.1 audio track does not cause any problems. In addition, the iPad will also support a text chapter track and at least one alternative AAC language track. (I.e., have not tried to test anything greater.) Have not tested any custom podcast files containing layering effects which have not been "flattened" either as this is not normally a part of my work flow. In short, there are a number of user settings in HandBrake that may create playback problems for different devices and that is why I would normally caution casual users to stick with one of the Apple device presets since these are tied to the specific profiles accepted by each device. If you are using custom settings and the file will not play, please post a sample snippet in order for me to see if I can locate a specific problem.

  • I dropped my ipod now it says "very low battery"!!

    I dropped my old ipod from 2006 and now it says "very low battery" and "www.apple./support/ipod !!!
    and also a picture of an weird looking iPod with X as eyes and sometimes sounds come out of the ipod.
    Please I´m in desperate need of help!
    Message was edited by: niinaa

    Firstly, i believe it is the time to have the battery replacement, see if the following helps
    http://discussions.apple.com/thread.jspa?threadID=1591975&tstart=0

  • How can I fix my ipod classic to use headset

    my ipod classic does not play music thru the headset - does anyone else have this problem? how can I get it fixed without spending more than what it is worth?

    Hello eddie8625,
    I would recommend enabling 'manual mode' on the iPod so that it can be synced to two libraries without affecting the existing content on the device.
    Using iPhone, iPad, or iPod with multiple computers
    http://support.apple.com/kb/HT1202
    If you'd like to use your iPod to transfer your music to the new system, the following article should be helpful.
    How to use your iPod to move your music to a new computer
    http://support.apple.com/kb/HT1329
    Cheers,
    Allen

  • How do i fix my ipod touch that wont turn on?

    my ipod youch was completly dead. wen i went to recharge it i let it charge for over an hour and when i try turning it on it will go to the screen with the apple logo but it wont go any further than that. how would i fix this problem

    Try here:
    iOS: Not responding or does not turn on

  • How can I update my iPod classic that will not mount on iMac computer?

    I can't update my iPod classic from my iTunes on my iMac computer with OSX 10.9.  It will not mount or be recognized by iTunes version 12.1.
    I plug it into the USB port and it charges, gives the "Do not disconnect" symbol but the computer does not recognize or mount the iPod at all.  I haven't been able to update the music for years. I have four other devices associated with my Apple ID for automatic downloads. Is it too antiquated to upload any of my music from my computer to it anymore?

    Ahh! The plot thickens!
    I went thru the console and read the error logs. It appears that the .ipsw file does load.....I think. It's been years since I spoke computer....
    Here is what I got after double clicking the .ipsw file and iTunes opened:
    2014-12-28 11:05:02.430 AM syspolicyd[450]: assessment granted for iPod_13.1.3.ipsw by _XProtect com.apple.message.domain: com.apple.security.assessment.outcome2 com.apple.message.signature2: bundle:UNBUNDLED com.apple.message.signature3: iPod_13.1.3.ipsw com.apple.message.signature5: UNKNOWN com.apple.message.signature4: 3 com.apple.message.signature: granted:_XProtect SenderMachUUID: C6FC6A41-170C-3D84-BAAE-6983F164E903

  • How can I fix my Ipod Touch thats been disabled and isnt detected in ITunes?

    My son gave me his 8GB Ipod Touch that he locked or disabled and it says to connect to ITunes but It dosnt show up on my computer or ITunes.Iv done everything suggested by Itunes support but still cant get it to work. Can someone tell me how to solve this problem? I wanted to restore it but Im begining to think its nothing but a paper weight now.

    iOS: Unable to update or restore

  • I have a new hp computer and it says there's a ploblem with the "driver" and it cannot be scanned to be fixed. How do I fix my ipod so that it syncs to itunes.

    I can't get my ipod to sync to itunes on my new hp. Not all of my songs are on cloud, so I really don't want to reset my ipod without them all being on cloud. Is there another way to fix my ipod so it will sync?

    Transfer purchases over from your phone to your computer before you sync your apps. See Transferring Purchases for more details.

  • HT4113 how do i fix my ipod if it says ipod is disabled connect to itunes and when i follow the steps it still doesnt work

    how do i restore my ipod touch when it says ipod is disabled connect to itunes

    Are you doing this:
    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up     
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        
    If you are just what happens?

  • How can i fix dvd ram driver, that says "a driver(service) for this device has been disabled code 32

    how can i fix  my pc problems, Idon't see dvd/cd name listed in "Devices and printer" window. And when I do hp dvd/cd rom check,
    an dilog box opens up; sayes "A driver(service) for this devices may be disabled. An alternate driver may be providing this functionality. (code 32). Please help. Thank you.

    Hi,
    First, try the automated fixit from Microsoft on the link below.
    Windows 7
    Vista
    Check if the drive is now working.
    If it still doesn't work, click the Start Menu, open All Programs, open Accessories, right click the Command Prompt and select 'Run as Administrator'.  In to the prompt type the following command and hit enter.
    sfc /scannow                 ( note that there is a space between sfc and the / )
    Let the process complete, then type exit and hit enter. 
    Next, click the Start Menu, open the Control Panel and click on Device Manager.  Next click to open DVD/CD-ROM Drives.  Right click the drive and select uninstall.  Do not delete drivers if asked.  When the device has uninstalled click on the 'Scan for Hardware Changes' icon ( usually just below Help on the toolbar ).  Let windows reinstall the drive and see if it now works.
    Regards,
    DP-K
    ****Click the White thumb to say thanks****
    ****Please mark Accept As Solution if it solves your problem****
    ****I don't work for HP****
    Microsoft MVP - Windows Experience

Maybe you are looking for

  • Can't log in with wireless router

    I have successfully used my WRT54GS v.2 wireless router for a year of two. Tonight I am attempt to connect and cannot. I am using for username and admin for password, per Lynksis instructions (and what has worked in past). It apparently is not recogn

  • WIndows 8.1 app tiles don't work since window update on 12/14/14

    My computer with windows 8.1 went through several updates on 12/14/14 and now none of my window tiles will open and several are now missing. I tried to install them again, and it says go back to the app store and install them again. It doesn't work.

  • Application builder subvi

    I'm just learning to use the application builder, my interest is in creating a stand alone application & installer.    Is it possible to generate a single executable file which contains the top level VI as well as all of its sub-Vis ??  If the answer

  • How to Net price of materail with respect to plant

    Hi Gurus,                  Kindly let me know is there any standard BAPI or FM to get net value of Material Code including taxes or combination of BAPIs and FM or any existing program developed by you for reference. Thanks in Advance, Rams

  • Another strange behaviour: Horizontal stripes

    Hello, since the last update, the display has started to behave strange. When scrolling down in Safari while surfing, various stripes around text and images appear and the only way to get rid of them is scroll the back out out of the screen and in ag