How do i get around error 8328 and 416
my partner has tryed to down load a music album and she keeps getting these two error codes for 3 of the songs. How do i get around this problem?
Closing and re-opening iTunes appears to have fixed the 8328 error code for some people on here.
Similar Messages
-
I spilled water on my laptop and my "i", "j" and "k" letters don't work on my laptop. However my main problem is that my password contains an "i" so i am locked out of my computer. Any ideas how I can get around the password and login. I tried the method where you go into single user mode and type in commands, however that method uses some of the letters that are not working on my laptop.
You didn't mention which version of OS X your running but there are password reset utilities provided OS X: Changing or resetting an account password (Snow Leopard and earlier) - Apple Support or OS X: Changing or resetting an account password - Apple Support
Alternately you can use an external keyboard to log in and change the password. Make a backup if you don't have one, it's likely that your problems aren't over. If that water continues to migrate downward and fries the logic board your macbook will be toast. -
Have downloaded 5s iPhone. Instructions for activating iCloud gives wrong email address to verify account. How can I get around this problem and get my phone set up with iCloud
elhoseny wrote:
... Instructions for activating iCloud gives wrong email address to verify account..
The Apple ID and Password that was Originally used to Activate the iDevice is required
If you do not have that information you will not be able to use the Device.
Activation Lock in iOS 7 > http://support.apple.com/kb/HT5818 -
How can I get around error message? "No installation on non-HFS disk:
I am trying to install CS2 on my new Mac. How do I get around the following error message? "Installation onto non-HFS disk is not supported.
Which new Mac?
Is the hard drive PCIe-based flash storage? If so, you will probably need a newer version of AI. -
This error notice doesn't make sense, since many of my file names exceed 31 char. This error message pops up when saving documents, esp. web pages. As a consequence, OSX will refuse to let me save the file, until I shorten the name and so remove informative identifying features of the file name. But most of the time, OSX is perfectly happy to save files with names longer than 31 char. How can I get this error notice and block to turn off?
I have also seen this issue it occurs regularly when transferring word documents files from my Macbook Pro running OSX 10.5.8 to my iMac running 10.9.4.
My iMac HD should be formatted to factory standards as well since I have not mucked around with it since I bought it. -
I'm running OS 10.4 and purchased Mac Box Set with Snow Leopard. When I run the Snow Leo install it errors saying I need OS 10.5 to run the install. How do I get around this? I've read that it's possible to go direcectly from 10.4 to 10.6.
To buy a hard drive try Newegg.com http://www.newegg.com/Store/SubCategory.aspx?SubCategory=380&name=Laptop-Hard-Dr ives or OWC http://eshop.macsales.com/shop/hard-drives/2.5-Notebook/
Here's a cheap SATA external hard drive case on eBay http://cgi.ebay.com/USB-2-5-SATA-HDD-HARD-DRIVE-EXTERNAL-ENCLOSURE-CASE-BOX-/120 636286623?pt=PCC_Drives_Storage_Internal&hash=item1c167ba69f
Here's instructions on replacing the hard drive http://creativemac.digitalmedianet.com/articles/viewarticle.jsp?id=45088 -
I am having trouble setting up my Yahoo! e-mail account on my phone...it asks for my Password and I type it in carefully and correctly, but I get an error window, "MF Message Error Domain error 1032" -what does this mean and how can I get around it? My password is long and convoluted, but it works when I type it in on my main Mac workstation, just fine.....what gives?
try restarting the phone and try again
-
i am trying to restore my ipad, on itunes i get a error code 3194, consequently the ipad won't restore. How can I get around this ?.
Thanks.glasstiger wrote:
i am trying to restore my ipad, on itunes i get a error code 3194,
3194 = http://support.apple.com/kb/ts4451
If that Article does not resolve it... then you have a problem.
Perhaps a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is required..
Be sure to make an appointment first...
Note:
That error message may be indicative of the Device being Hacked / jailbroken.... If this is the case then you are on your own.
Unauthorized modification of iOS... http://support.apple.com/kb/HT3743 -
I have an ipad and just bought a second one for my daughter and she wants all my music on her ipad. All the music is under my itunes account yet she has her own itunes account so she can have her own apps and purchase apps with gift cards (She's only 9)
I subscibe to music match under my account but it wont let me put my music on her ipad under hers or even my itunes account. I get some sort of 90 day error message. How do i get around this so I can let her have my music on her ipad?iTunes Match is not sharable across Apple IDs. The best way to get the music on her iPad is to leave hers signed into her Apple ID on the iTunes Store and sync via USB.
-
i tried to do a backup from my old iphone as i have a new one that was signed into another itunes account. it said i cant do it because the iphone rejected the request. how do i get around this? i have signed out of the old acct and into mine on the phone
What is the precise wording of the error message that occurs on the old iPhone when attempting to do a backup?
Are you attempting to backup via iTunes on the computer or iCloud? -
My ipad battery went dead and after recharging and booting up the ipad, it is asking for a passcode. however, no one remembers ever entering a passcode in to this ipad, isnce it used by everyone in the house. how do i get around this passocde prompt?
How can I unlock my iPad if I forgot the passcode?
http://www.everymac.com/systems/apple/ipad/ipad-troubleshooting-repair-faq/ipad- how-to-unlock-open-forgot-code-passcode-password-login.html
iOS: Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
How can I unlock my iPad if I forgot the passcode?
http://tinyurl.com/7ndy8tb
How to Reset a Forgotten Password for an iOS Device
http://www.wikihow.com/Reset-a-Forgotten-Password-for-an-iOS-Device
Using iPhone/iPad Recovery Mode
http://ipod.about.com/od/iphonetroubleshooting/a/Iphone-Recovery-Mode.htm
You may have to do this several times.
Saw this solution on another post about an iPad in a school environment. Might work on your iPad so you won't lose everything.
~~~~~~~~~~~~~
‘iPad is disabled’ fix without resetting using iTunes
Today I met my match with an iPad that had a passcode entered too many times, resulting in it displaying the message ‘iPad is disabled – Connect to iTunes’. This was a student iPad and since they use Notability for most of their work there was a chance that her files were not all backed up to the cloud. I really wanted to just re-activate the iPad instead of totally resetting it back to our default image.
I reached out to my PLN on Twitter and had some help from a few people through retweets and a couple of clarification tweets. I love that so many are willing to help out so quickly. Through this I also learned that I look like Lt. Riker from Star Trek (thanks @FillineMachine).
Through some trial and error (and a little sheer luck), I was able to reactivate the iPad without loosing any data. Note, this will only work on the computer it last synced with. Here’s how:
1. Configurator is useless in reactivating a locked iPad. You will only be able to completely reformat the iPad using Configurator. If that’s ok with you, go for it – otherwise don’t waste your time trying to figure it out.
2. Open iTunes with the iPad disconnected.
3. Connect the iPad to the computer and wait for it to show up in the devices section in iTunes.
4. Click on the iPad name when it appears and you will be given the option to restore a backup or setup as a new iPad (since it is locked).
5. Click ‘Setup as new iPad’ and then click restore.
6. The iPad will start backing up before it does the full restore and sync. CANCEL THE BACKUP IMMEDIATELY. You do this by clicking the small x in the status window in iTunes.
7. When the backup cancels, it immediately starts syncing – cancel this as well using the same small x in the iTunes status window.
8. The first stage in the restore process unlocks the iPad, you are basically just canceling out the restore process as soon as it reactivates the iPad.
If done correctly, you will experience no data loss and the result will be a reactivated iPad. I have now tried this with about 5 iPads that were locked identically by students and each time it worked like a charm.
~~~~~~~~~~~~~
Try it and good luck. You have nothing more to lose if it doesn't work for you.
Cheers, Tom -
priority:
I am trying to facetime on my mac but keep getting the message "The server encountered an error processing registration. Please try again later." I have gotten this multiple times. how can I get around this?
i also have tried downloading "FaceTap" application to get facetime on my ipad and failed too. i thought i failed because i couldnt download latest 6.0 iOS or later. i downloaded latest software update for iOS but was 5.8 I thinkWait until Apple fix it. See: http://www.apple.com/support/icloud/systemstatus/
-
Flash CS6 can't open play SWF files without importing and destroying them, how can I get around this?
I'm just trying to preview an swf file in flash like I have with all previous versions.What if my SWF loads external content from an online server?
Not only does the current flash player prohibit such activity, it doesn't even pop open an error anymore saying there was an error connecting to an online source.
Normally, I would simply drag the SWF into Flash and all connections would go through. I could see traces, errors, and experience no issues.
Now I can't even do that. So what then? You have crippled a fundamental use of the program, but THANK GOD we have that deco brush that nobody asked for.
And for the record, the nature of my work benefits from not necessarily allowing the Flash Player to connect to online content. The error it pops up? That's simply another method of error checking that I require. Updating the Flash Player options is not an option.
Why would you even remove this key feature from Flash anyways? It's been there for years ... has the ratio of people importing SWFs (a rather useless gesture in an increasing OOP world) really outweighed the people using Flash as a testing environment that much? -
#define ON 1
#define OFF 0
in seperate code
int variable = ON;
variable is globally define for that module.
in seperate code
if (variable == ON)
the complier errors off on the if (variable==ON)
My guess variable is variable in of type int and ON is a preprocessor command. Therefore it is a mismatch and complier doesn't like it. How can I get around this.
thank
MahenMahen
What is the exact message of the compiler?
I think the error is, that the compiler does not find the definition of ON
and OFF. Is it in the same source file?
If not, try to put it into an .h file and include it where you need it.
Stephan
"Mahen" schrieb im Newsbeitrag
news:[email protected]..
> Preprocessor command, assigned the variable and then compare the
> variable to int.
>
> How can I get around this?
>
> #define ON 1
> #define OFF 0
> in seperate code
>
> int variable = ON;
> variable is globally define for that module.
> in seperate code
> if (variable == ON)
> {
>
>
> }
>
> the complier errors off on the if (variable==ON)
> My guess variable is variable in of type int and ON is a preprocessor
> c
ommand. Therefore it is a mismatch and complier doesn't like it. How
> can I get around this.
> thank
> Mahen -
I'm trying to download itunes 10 but I get to a point in the download and it tells me, "The feature you are trying to use is on a network resource that is unavailable" but I haven't had itunes on my computer for a year now so how can I get around this?
iTunes.msi
Perfect, thanks.
Download the Windows Installer CleanUp utility from the following page (use one of the links under the "DOWNLOAD LOCATIONS" thingy on the Major Geeks page):
http://majorgeeks.com/download.php?det=4459
To install the utility, doubleclick the msicuu2.exe file you downloaded.
Now run the utility ("Start > All Programs > Windows Install Clean Up"). In the list of programs that appears in CleanUp, select any iTunes entries and click "Remove", as per the following screenshot:
Quit out of CleanUp, restart the PC and try another iTunes install. Does it go through properly this time?
Maybe you are looking for
-
Does my excel can be opened as a region in my jspx page.
Hi, Am using jdeveloper 11.1.2.4.0., My scenario is I need to open my ADF Integrated Excel as a region in my jspx page. Does it possible? Am expecting help to achieve this. Kindly revert back if am not clear with the scenario. Regards, Prasad K T, 9
-
I recently tried to obtain an Aperture serial number and through the process found out that I am not receiving emails from Apple. With an Apple tech support's help, was able to get her basic email but one with any links in the body of the message, wo
-
SJSAS EE 8.1_02 / Bug in jss4.jar breaks our new release
+[Full environment description below]+ Problem description: our application server contains several applications including one J2EE application made of several WARs and EJBs. One of these EJBs starts some internal services that use an open source lib
-
MyBook Thunderbolt Duo for timemachine backup and external storage of photo library with Raid
Hi, I've recently updated my MacBook Pro to a new model and have therfore moved to a smaller SSD internal storage. I was thinking of buying the Thunderbolt Duo to use as a time machine backup and for working storage. What I was wondering was if I c
-
Tried to change my billing info and got an error message 413. How about supplying a phone number and a real person instead of the inpersonal online activity that apparently does not work.