How do I get list of client IP Addresses using new Airport Utility v6.3?

I have purchased and Airport Time Capsule 3TB (newest model).  Previous models were still compatible with Airport Utility 5.6 and I could use "manual" mode to get a list of client IP addresses attached to the device.  The new Airport Time Capsule is only compatible with Airport Utility 6.3 and I cannot figure out how to get a list of client IP addresses with this new model. Does anyone know how to do this?

Try a ping broadcast - for example if your network were 192.168.1.xxx (netmask of 255.255.255.0) try this from a Termnal.app window (located in /Applications/Utilities):
     ping 192.168.1.255
If you have a different type netmask, you need to put 255's where the 0's are in your netmask.
Everyone on the local network (the 192.168.1.xxx network) should reply that is up and running unless you have them setup to not respond to pings (the WAN port on your TC should not reply cause it's in a different network) and you have your list of clients on the network. If you setup the TC to dedicate a range of addresses for WiFi clients you can even identify which of them are wired and which are wireless.
good luck.

Similar Messages

Maybe you are looking for