How do i know if the WRK54G rounter i have works?

I've followed the directions and all the lights light up but i get no IP address even when i reset the rounter and renewed the IP address, i know the modem works as i use it. I have a comcast dsl modem. I can not get to the set up page so does that mean the rounter is no good even if it powers up?
Solved!
Go to Solution.

Welcome to the Cisco Home Community.
You need to configure your router to work with your DSL modem.
Follow this link.
http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=20ee1457387f40178cd5f41d4b585db4_3687.xml&pid=94&s...
The Search Function is your friend.... and Google too.
How to Secure your Network
How to Upgrade Routers Firmware
Setting-Up a Router with DSL Internet Service
Setting-Up a Router with Cable Internet Service
How to Hard Reset or 30/30/30 your Router

Similar Messages

  • HT3939 How do I know if the 4G LTE iphone 5S works in Lebanon?

    How do I know if the new GSM iphone 4G LTE works on Lebanon?

    It will work outside of the US with any GSM carrier according to my recent chat with an Apple support representative.
    See: https://discussions.apple.com/message/23296974#23296974

  • My film has not totally downloaded, I did not realise this until it stopped 15 minutes before the end, how do I know when the rented film I have purchased has been fully downloaded. Can I retrieve anyhow

    My film I rented has not fully downloaded I only realised that when it stopped 15 minutes before the end , how do I know when a film has been fully downloaded. Oi would not have thought the film would not have started unless the film was fully downloaded. The film warned me prior to tarting that I only had 48 hours to watch once starting!

    I'm sorry but this is too funny to pass up. 

  • HT204350 How do I know if the migration assistant is actually working? I got as far as a screen that says it is "Transferring your information" and there is what looks like a progress bar but that has moving blue diagonal lines rather than any progress

    The fan on my target computer is whirring away and so it sounds like something is happening. But there doesnt seem to be any way of telling from either the traget or the source computer if the thing is actually working.  How many hours should I wait before concluding that something has gone wrong?  I have over 100GB of data so I am not expecting it to be fast! 
    Is it normal for the source computer to just drop out of migration asssistant at the begining, or should there be some sort of indication that it is working?  What about if I use activity monitor is there any clues I should be looking for there?

    Hello gatormommy97,
    If that migration happens to still be chugging along, you're in luck. We've got step-by-step instructions for performing an Erase & Install on the new MacBook Pro. This will restore it to 'factory defaults,' just like it came out of the box for the first time, allowing you to start fresh with an alternative migration method.
    OS X Mountain Lion: Erase and reinstall OS X
    http://support.apple.com/kb/PH11273
    Cheers,
    Allen

  • How do you know if the Maverick download is happening?

    I am now trying to download Maverick .. & have been hearing a whirring sound. But it starts then stops?
    - BUT I can't tell if it's done. I've kept the "page" on the screen, and the "download" button shows grey & it shows "Downloading"
    - BUT I don't see any circles, to show anything is happening.
    - NOR can I see anything on download in Finder. I've been checking the apple icon to see & it still shows Lion, 10.7.5 that I got in 2012. I have 4GB.
    So, How do you know if the Maverick download is happening - & when it's done?
    Last, do you have to restart the computer? I haven't been able to find a "how to" about this download.
    Thanks

    With App Store open, purchases or updates pane (can't recall which), CMD+R to reload the page, and you should see a progress bar. Should look like this:

  • HT204088 We entered an app store gift card # onto our ipod. How do I know if the purchases are getting charged to the gift card vs. my credit card? Also how do I found out what the balance left on the gift card is?

    How do I know if the app purchases are being taken from the app gift card vs. my credit card?
    And how can I see the balance remaining on the gift card?

    If the card has been redeemed then its remaining amount should be on your account, the card itself is now effectively zero. My account's balance shows at the top left of the store's page on my computer's iTunes, and by logging in to view my account via the Store > View Account menu option. On my devices it shows at the bottom of, for example, the Featured tab in the App Store app under my account id (or you can view your account via Settings > iTunes & App Stores and it should show on the screen that you are taken to).
    As long as you are buying content for yourself then purchases should be deducted from your balance - if you are gifting content then that can only be done from a credit card.
    How purchases are billed : http://support.apple.com/kb/HT5582

  • How do I know if the apps are free or not if I already have them on my ipad??

    How do I know if the apps are free or not if I already have them on my ipad?? I have an ipad and it was open by another person's Apple ID and all the applications too. Now I have change the Apple ID by my name and I wanted to update the apps and I can't remember if the apps were free or not, and I don't want to delete them without knowing if they are free.

    When you buy an app the app is permanently allocated to the AppleID account you bought it through.  You can then download that app on up to five devices,  as many times as you want, without buying it again.  So deleting an App is not a big problem, you just log into your account in iTunes again, find the app, and instead of showing you a 'BUY' button it shows you a 'DOWNLOAD' or 'INSTALL' button.
    If you change the AppleID account  you use in your iPad then Apple will think you sold the iPad to someone else, and all the apps with that name will stop working anyway.
    But you can change the name and email address for an AppleID account, without moving to a new AppleID account, by following these instructions:
    http://support.apple.com/kb/ht5621

  • HT4060 iPad will not charge if hooked by USB to pc or plugged into wall.  How do I know if the problem is with iPad, cable or power adapter.  I have a 12, 10 and 5W adapters no success with any.  Only one lightening cable so can't swap cables.

    iPad will not charge if hooked by USB to pc or plugged into wall.  How do I know if the problem is with iPad, cable or power adapter.  I have a 12, 10 and 5W adapters no success with any.  Only one lightening cable so can't swap cables.

    I'm sorry but this is too funny to pass up. 

  • HT1212 how do I know what the restrictions passcode is, selling mini ipad and need to erase all content

    selling ipad mini, how do i know what the restrictions passcode is in order to delete all content

    See this article:
    HT4213
    As it says in the notes, "If you lose or forget the restrictions passcode, you will need to perform a factory restore to remove it."

  • I just got my iPhone 4 finger tips (CDMA) how do I know if the operating system is up to date?

    I just got my iPhone 4 finger tip (CDMA) How do I know if the operating system is up to date?

    Check Settings > General > About. Latest version for the CDMA phone is 4.2.10
    Stedman

  • How can i know if the face time is working on the iPad before i buy it?

    How can i know if the face time is working on the iPad before i buy it?

    I am plan to buy new ipad2 and i want to check before i buy it, if there is facetime or not?
    As far as i know if it is from KSA there is no face time in, but if it from US there is facetime in?
    And i have the serial number.

  • HT5244 how do i know if the flashback malware is on my system?

    how do i know if the flashback malware is on my system?  And how can i get rid of it.?
    I cant upgrade to a higer os.. becouse my powermac does not have intel.. processors.
      Modelnaam:          Power Mac G5 Quad
      Modelaanduiding:          PowerMac11,2
      Processornaam:          PowerPC G5 (1.1)
      Processorsnelheid:          2.5 GHz
      Aantal processors:          4
      L2-cache (per processor):          1 MB
      Geheugen:          8 GB
      Bussnelheid:          1.25 GHz

    X423424X wrote:
    For some, if not complete peace of mind, go to F_Secure's Flashback Removal Tool web page, download their Flashback trojan detection/removal tool, and follow the instructions you find there.
    Turns out their tool won't run on a PPC Mac (unless you extract and modify the AppleScript so it will run the shell script).
    The only one I know of that does is Norton's. I glanced over it and gave it a test run. Looks OK, but I cannot attest to how well it might work.
    And as has already been said, nobody we've run into here using a PPC Mac has been shown to be infected and all the samples I have been able to examine contained Intel only executables.

  • TS3198 After doing the backup and restore how do you know if the phone is unlocked if you do not get the message: "Unlock Complete. Congratulations, your iPhone has been unlocked. To set up and sync this iPhone, click Continue."

    After doing the backup and restore how do you know if the iphone is unlocked if you do not get the message: "Unlock Complete. Congratulations, your iPhone has been unlocked. To set up and sync this iPhone, click Continue."

    If you don't get the message, your phone is NOT unlocked.

  • How do I know if the safari browser is closed on the iPad?

    How do I know if the safari browser is closed on the iPad?

    This is what I was told:
    Double tap the home key...press and hold the icon...when the minus appears on the icon, tap the minus.
    This will delete the aforementioned icon from the task bar. When the icon disappears, the browser, or any app, is then closed.
    Is that correct?
    Thanks in advance for your help.

  • How do I know if the Maverick software update has been installed on my mac?

    How do I know if the Maverick software update has been installed on my mac?

    It will not download if you already have it.
    Just to be 100% clear …
    Look in /Applications for "Install OS X Mavericks"
    Use the Finders Go menu > Applications. To open it.
    You may have an Applications folder in your Home directory too, it shouldn't be in there but it is possible.
    Also try Spotlight to see if it can find that filename.
    Can you also tell us what system you have?
    Apple menu > About this Mac > more info button… What is the Model (under the Overview tab).
    10.9 doesn't install on all systems, so it could explain why you can't get it, however it usually displays a dialog stating that fact.

Maybe you are looking for

  • Cannot get maile connection to server failed

    followed the instructions for icloud set up in apple support for ipad and iphone even deleted the account and then set the account up with the correct ID and password.  I do use a different ID  than my apple ID for my icloud account.  I use my me.com

  • Error while executing SQL through Java snippet in ADF

    Hi, I am taking inputs taken from user using ADF UI and storing this input data in XML File.With this Input.xml, I build a sql Query and execute using java program within the same ADF application. I am getting following error: java.sql.SQLException:

  • Mplyer sound doesn't work, instead amarok's sond work !!!

    hi everyone, the problem is that mplayer's sound doesn't work. the sound with Amarok and Firefox(e.g youtube) works, but with mpalyer no !!! i've posted some commands: thanks /etc/mplayer/ codecs.conf   example.conf  input.conf /etc/mplayer/example.c

  • Exporting Java Add in and Importing to Standalone Java system

    Hi, I have a requirement to export Java system which is  ABAP+JAVA  and build a new standalone Java system through import.  Is it possible, if so please provide any documents or links. Thanks Shiv

  • Dreamweaver CS4 software updates

    Hi Folks, I purchased Dreamweaver CS4 (version 10) some years ago, and just reinstalled the software. The product launches fine. I'm trying to re-install any patches for this product, but can't seem to find any on the Adobe site. The Updates... funct