How do you replace the hdd in an emac

Question

how do you replace the hdd in an emac

Answer 1

well you need to take of the back shell to do this you will need an alen key and philips screwdriver 1. take of the ram cover of the back of the computer after you unplug all cables and leads 2.take out all alen key screws around your emac lift up the case back about 3-4 inches of and take the little cable going into the powerbutten out than take of the cover fully and put aside 3. on the side whith the computer on (the bottem) and take out fillip screws holding the plate and unclip it and take it of to revele the computer componets 4.unplug the vidio cable (top left corner of logic bord) and all cables on the left bottem and the power cable on the screen side of the computer 5 unscrew the philips screws in the bracket for the fan and power port and move outthe fand and port out of the way 6. take out all screws holding the bracket for the computer part of the emac 7.grab the top of the plate and liftup and take the computer componetns out twords yourself becouse there is a plug at the back that gives the bord power and stuff 8.on the back of the computer components is the hard drive bay and undo the two screws holding the bay in and take out undo four screws and unplug the old hardrive and put in your new one and plug that in 9. put the emac back together in reverse how you pulled it apart makeing shore that the logic bord and powerbutten are pluged backin.