How much time is needed to receive a gift

I've sent a gift to a friend, one our ago. He did not get it yet. How much time is needed?

Perhaps he should look in any spam/junk filters that may be filtering his account. Check for filtering by his email service, his ISP and his client app itself.

Similar Messages

  • HT1569 how much time i need to update the iOS 7.0.6

    how much time i need to update software iOS 7.0.6

    Depends on your connection. Mine took very little time at all.

  • How much time ipod needs to restore after plugging with external power?

    how much time ipod needs to restore after plugging with external power?

    Restore? Do you mean power on after it's been drained for awhile? It depends how long it's been dead. Sometimes it can take awhile (10-20 minutes maybe more) in some cases.

  • How much time is needed to account activation?

    I paid forma a Adobe Export PDF pack on mobile 12 HOURS ago but I can't still convert my documents.

    I mean "for" not "forma"

  • Ctios failover. how much time spent to to recover the ctios agent

    on cce 7.5.x    
    using  /load 0  to put agent on not ready after ctios failover. how much time is needed for agent to do a ready request?.
    or using /load 1 (i think is the default behavior) this cause to log out agent. soo How much time must left to do a log in again.
    any ideas?

    This is what SRND Guide of 7.5 says
    When the active CTI Manager Service or PG software fails, the PG JTAPI Gateway/PIM detects an OUT_OF_SERVICE event and induces a failover to the redundant (duplex) PG. Because the redundant PG is logged into the backup Unified CM subscriber CTI Manager Service already, it registers the IP phones and configured dialed numbers or CTI route points automatically. This initialization service takes place at a rate of about 5 devices per second. The agent desktops show them as being logged out or not ready, and a message displays stating that their routing client or peripheral (Unified CM) has gone off-line. (This warning can be turned on or off, depending on the administrator's preference.) All agents and supervisors lose their desktop third-party call control functionality until the failure recovery is complete. The agents and supervisors can recognize this event because call control action buttons on the desktop will gray out, and they will not be able to do anything with the desktop. Any existing calls should remain active without any impact to the caller.
    Regards

  • I need help getting my ipod to show me how much time left on a song !

           How can i get my ipod to show me how much time left on a song @ the top under the song that's playing it went away and i dnt know how to put it bck please help me out  . . .

    No, tap the screen briefly. If you hold your finger on the Now Playing screen - even for one second - the scrubber bar (with the time on it) will not appear.
    Tap - the quickest touch you can do.

  • While running the query how much time it will taken, I want to see the time

    Hi Folks
    I would like to know ... While running the query how much time it will be taken, I want to see the time? in WEBI XI R2.....
    Plz let me know  the answer.......

    Hi Ravi,
    The time a report runs is estimated based on the last time it was run. So you need to run the report once before you can see how long it will take. Also it depends on several factors... the database server could cache some queries so running it a second time immediately after the first time could be quicker. And there is the chance of changing filters to bring back different sets of data.
    You could also schedule a report and then check the scheduled instance's status properties and view how long a report actually ran.
    Good luck

  • Is there a plug-in that tracks how much time you've spent in specific files?

    I want an easy way to track how much time I've spent on certain projects. I really just need a plug-in that tracks how long files have been open. I'm having trouble searching for one like that; does anyone know if this exists as a plug-in or even as a function of Photoshop (or Illustrator)? This would be very helpful for freelancers. Thanks.

    Found this link via Google. I have CS6 and it looks like this, don't know about CC.
    How to Keep a Log of Your Work in Photoshop - Digital Photography School

  • Possible to check how much time an update statement on a table would take ?

    Hello @all
    I have a table with a fragmented Index, the table has an actula "user_updates" from 226'699.
    How can i find out how much time an update on this table takes ?
    i would like to check if there is any performance increase when i regroup the index (rebuild), cause the index has a fragementation of 85% now... (or should i delete the index completely) cause there are no user_seeks... only user_updates on the table...
    and i thought that indexes only makes sense if users are reading from the table... am i wrong ? (cause on every update from the table, the index (indexes) have to be updated too...
    Thanks and Regards
    Dominic

    Rebuilding the index will not likely result in a modification be quicker. At least not more than marginal. In fact, it might wven be slower, since if you currently have space on the index page for the new row and then rebuild so you *don't* have space then
    the index rebuild will make that update be slower (at least for the cases where you get page splits). 
    However if the index isn't used to find rows (any of the other three columns), then you have an index which only cost you and doesn't help you!
    Tibor Karaszi, SQL Server MVP |
    web | blog
    Tibor, check out this forum thread:
    http://social.technet.microsoft.com/Forums/sqlserver/en-US/64ad4f52-2fd8-4266-b4a4-5657c8870246/needed-more-answerers?forum=sqlgetstarted
    Ed Price, Power BI & SQL Server Customer Program Manager (Blog,
    Small Basic,
    Wiki Ninjas,
    Wiki)
    Answer an interesting question?
    Create a wiki article about it!

  • How much time I had to charge my new I phone 5s for first time?

    How much time I had to charge my new I phone 5s for the first time?

    I would say that is a matter of judgement
    If we are being pedantic it may noteven  need a charge initially in that case ,it may have sufficient power ,
    assume we are ok with the green battery being full green for 100% charge

  • How much time would you say a 3 G I pad would give you?

    Hi I am thinking about purchasing an I Pad with 3 G to take on a cruise so I would not have to depend on the internet on the ship.  Is this worth It?  How much time would I have if I were to purchase 2 GB from Verizon? 

    Matthew349 wrote:
    Hope this helped.
    I suspect that, in the last ten months, the OP has figured out their data needs.

  • How much time does 8.2 software have?

    I've been reviewing software revisions for the Cisco ASA 5500 family.  We have a few clients running 8.2 and the jump to 8.3 will require significant effort to make sure everything translates properly.  There are no features in 8.3 that these clients require so it seems in their, and our, best interest to let them ride the 8.2 software until an upgrade is necessary to continue receiving security patches.  I have looked for EOL notifications but have not found anything for 8.2.  I have also placed an inquiry with our SE at Cisco, but I thought I would ask if anyone knows anything about how much time 8.2 has before we could expect to see an EOL notification.

    Hi,
    Here is some information related to 8.1 Software.
    http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/end_of_life_c51_640618.html
    Table 1. End-of-Life Milestones and Dates for the Cisco ASA 5500 Series Adaptive Security Appliance Software Release 8.1
    Milestone
    Definition
    Date
    End-of-Life Announcement Date
    The date the document that announces the end of sale and end of life of a product is distributed to the general public.
    January 15, 2011
    End-of-Sale Date
    The last date to order the product through Cisco point-of-sale mechanisms. The product is no longer for sale after this date.
    July 16, 2011
    Last Ship Date:
    OS SW
    The  last-possible ship date that can be requested of Cisco and/or its  contract manufacturers. Actual ship date is dependent on lead time.
    October 14, 2011
    End of SW Maintenance Releases Date:
    OS SW
    The  last date that Cisco Engineering may release any final software  maintenance releases or bug fixes. After this date, Cisco Engineering  will no longer develop, repair, maintain, or test the product software.
    July 15, 2012
    End of New Service Attachment Date:
    OS SW
    For  equipment and software that is not covered by a service-and-support  contract, this is the last date to order a new service-and-support  contract or add the equipment and/or software to an existing  service-and-support contract.
    July 15, 2012
    End of Service Contract Renewal Date:
    OS SW
    The last date to extend or renew a service contract for the product.
    October 11, 2015
    Last Date of Support:
    The  last date to receive service and support for the product. After this  date, all support services for the product are unavailable, and the  product becomes obsolete.
    July 31, 2016
    HW = Hardware OS SW = Operating System Software App. SW = Application Software
    I can't seem to find the same for the 8.2.
    Though I would consider that there are still alot of users happily going about with the very old PIX firewalls running software 6.x or even older. Not saying its a good thing but it work.
    And considering 8.2 is the latest software before the BIG NAT change I would imagine it will stay in use for a long time for those that dont want to learn/adopt the new NAT format.
    - Jouni

  • It´s possible know in OLT how much time one scenario spend in each system?

    Hi,
    It´s possible know in OLT how much time one scenario spend in each hardware component system?
    Thanks,
    Daniel

    Daniel
    You would need to set up the server stats there is a document in the [docs |http://www.oracle.com/technology/software/products/app-testing/index.html] folder that shows you how to do so.
    Regards
    Alex

  • How much time is on that Playlist-Burning CD

    Is there a better, even slightly more sophisticated way of determining just how much time is on a playlist? For burning to a CD?
    I'm trying to burn a CD that holds 80 minutes, or 700 MB. I know that what that really means is that the CD can accommodate about 74 minutes of recorded time.
    In iTunes, the particular playlist says I've used about 1.3 hours.
    What does that mean?
    How does iTunes calculate the "." something? Does the .1, .2, .3, .4, etc. translate into a defined amount of minutes?
    Does the memory, or size of the particular tune factor in? I didn't think so. I've just been looking at "time." (By the way, all of the tunes on this playlist are AIFF. Didn't bother to convert them to MP3 or AAC.) But I would if I had to. (Just a lot more time and work.)
    There must be a better way of measuring just how much time one has included in a Playlist for burning.
    Any thoughts, advice, suggestions would be very much appreciated.
    P.S. As always, iTunes "Help" has been of no help. Unless they're keeping it a secret somewhere.

    HangTime,
    You're here in iTunes too? You're everywhere. What the heck would I do without you?
    As always, you are right. Problem solved.
    But one more thing, when I went to print out the song list for the CD, the order was all changed. In an order I don't comprehend. How do I get it to print out the songs in the order I have them on my playlist? I need that, to put into the CD sleeve. Have no idea why it came out all jumbled up. Totally, random. Tried to show lists according to Artist, Album, Song, etc. to no avail.

  • How much free space needed for client export

    Hi
    My PRD database size is 72 gb .how much free space should be needed for client export at os level. and how much time it will take tto do client export.

    > My PRD database size is 72 gb .how much free space should be needed for client export at os level
    about 8 - 10 % of the client size
    > . and how much time it will take tto do client export.
    Depends on how fast your system and your harddisks are.
    Markus

Maybe you are looking for