How to enter BIOS on new Satellite L300?
Hi
Just bought today.... I am anxious to install other operating systems but can't figure how to enter BIOS to enable it to boot from CD.
Any help appreciated
Daka
Hi.
Have you read the User Manual? I think it will be somewhere in the book. However, for this gen, you can access BIOS by F2 and boot up list with F12
Enjoy.
Similar Messages
-
How to enter BIOS settings on Satellite U200?
How can I enter BIOS menu before windows started?
When notebook starts, I push F2 so it give me chose device which need to read.
In my other pc I push DEL and BIOS is there.
I have Satellite U200. I se software called <TOSHIBA HWSetup> and there write BIOS version 1.10.04/03/2004
There must be key to allow enter BIOS settings.
In user??s manuals I didn??t find information about entering BIOS settings.
[email protected]Hi
To enter BIOS settings please press ESC button at start up. After that press F1.
By the way: when you start notebook for a short moment you can see the message how to enter BIOS settings. It is displayer at the bottom left side at start up.
Del button will be used on desktops, not on laptops.
Bye -
How to enter BIOS mode on Satellite 5200?
Hello!
I own a Satellite 5200-801 and Ive recently bought a new CD/DVD - rom cause the original just died. The thing is that the drive I bought is from US market and my laptop is European. So Ive double checked all the serial numbers on it and everything was correct except the manufacture serial number that I suppose makes no difference to be different.
My problem is that when I install it the light indicator flashes normal but when it boots it shoes IDE error boot and windows doesnt see it at all. Do u know how can I enter BIOS setting to change master/slave cause I believe that there is a difference among them at this point....the original is master and the second is csel.
Also is there a key to enter BIOS because I cant enter at all no matter key combinations. Finally if I change the reading head of the DVD/ROM and put back the original would make the change I need?
THANKS FOR YOUR HELP!!!As far as I know you cannot change anything in BIOS but check it again. To enter BIOS settings press ESC button at start up.
Good luck! -
How to enter bios pavilion dv7
I cannot figure out how to enter bios on my pavilion dv7-1135NR, i need to figure out how to change boot order!
Tash2000 wrote:
I have installed a new motherboard into my HP Pavilion.
I have tried to update the BIOS for this motherboard and since doing this it is not possible to change the sata controller mode from RAID to anything ese - it will not save the settings.
I have replaced the CMOS battery and changed the CMOS jumper but nothing has worked. Can anyone provide the original BIOS file so I can try and re-flash it?
Or does anyone have any other suggestion?
Many thanks
Hello Tash2000.
What is the product number for your computer?
Please click the white star under my name to give me Kudos as a way to say "Thanks!"
Click the "Accept as Solution" button if I resolve your issue. -
Just got this laptop.
Can't enter BIOS. NO F1-F12 keys.
On start up, it just gives Lenovo splash screen then boots windows 8. I am clicking F1 (also tried FN+F1) and nothing happens.
How to enter bios...
Thank you
Solved!
Go to Solution.Hi jimmyr, welcome to the forum.
Please see this link, and it should answer the question for you.
http://blog.lenovo.com/en/blog/how-to-enter-the-bios-setup-utility-or-boot-menu-with-windows-8-1/
Cheers
DragonRider
I'm DO'ing IT
Lenovo Y470 085525U 2nd generation Intel® Core™ i7-2630QM processor ( 2.00GHz 1333MHz 6MB )
IdeaCentre A520 Intel® Core™ i5-3230M processor ( 2.60GHz 2600MHz 3MB )
YOGA Tablet 2 Pro-1380F
X1 Carbon 2nd Gen (20A8) ThinkPad + T420 -
How to enter BIOS settings on Equium L10?
Please can someone tell me what button i press too get into the bios setup at the start when i switch my pc on cos i have tried every thing, but nothing works.
Hello
Every time when you switch the notebook ON you can see at the bottom left hand site the short instruction how to enter BIOS settings. In your case you must use F2 button. Please keep it down immediately after switching the notebook ON.
Generally the Toshiba notebooks are delivered with two different BIOS versions (BIOS producer):
- TOSHIBA BIOS: enter using ESC and F1 button
- Phoenix BIOS: enter using F2 button.
According the specification your unit has Phoenix BIOS.
Bye -
How to enter bios Setup (not the F1 stuff, the splash screen display settings)
So I some how got into a seperate bios setting program by pressing ctrl S when some other bios utility was loading and changed the splash screen display (how long it shows the press enter stuff)
but now I have no idea how to get back into that configruator.
the Manual doesn't mention it, so question, how do I bloody do it?
T430S 2542 btwHello
Every time when you switch the notebook ON you can see at the bottom left hand site the short instruction how to enter BIOS settings. In your case you must use F2 button. Please keep it down immediately after switching the notebook ON.
Generally the Toshiba notebooks are delivered with two different BIOS versions (BIOS producer):
- TOSHIBA BIOS: enter using ESC and F1 button
- Phoenix BIOS: enter using F2 button.
According the specification your unit has Phoenix BIOS.
Bye -
How to enter Bios Setup Satellite 4030?
I'm searching for Informations how to enter the Bios Setup.
To enter BIOS settings use ESC button.
-
Satellite C55-A-19D - How to enter BIOS settings?
Hello,
I have recently bought a *Satellite C55-A-19D* notebook with no OS preinstalled, so I have installed Windows 8.1.
My problem is that *I can not access to the BIOS menu*.
I turn the computer on, but I can not see any invitation to "press the F2 key to enter setup". I am only receiving a screen that just has the +Toshiba Leading Innovation >>>+ notice, and then the Windows 8 spinning dots...
I can tap or hold F2/F12/ESC/DEL but nothing is coming up. I have also tried to press Fn+F2 combination.
What should I to get into the BIOS setup?
Thanks in advance!Perform complete shutdown as described here - http://aps2.toshiba-tro.de/kb0/TSB2B03EY0002R01.htm
After doing this start your notebook again and press F12. There you should have option to enter BIOS settings.
Check it out. -
How to enter bios on a Pavillon p7-1459
I am installing a new HDD and I want to install windows 8 with my recovery discs.
So ,how can i enter bios to format the new HDD and start the recovery from mi discs.
Thanks for any help.Cucutitos, welcome to the forum.
You will not have to enter th BIOS to format the new HDD. Here is what you have to do:
System Recovery: This option reformats the system drive (usually C:\), reinstalls the original operating system, and reinstalls all the original hardware drivers and software.
Warning:If the size of the OS partition (usually C:\) was reduced below a minimum size requirement, other user-created partitions will be removed and stored data will be destroyed.
Also, here is a guide to give you further help. Make certain that the new HDD is the same size of larger than the current HDD.
Note: To enter the BIOS begin immediately tapping the "esc" key when the computer begins to boot.
Please click the "Thumbs up + button" if I have helped you and click "Accept as Solution" if your problem is solved.
Signature:
HP TouchPad - 1.2 GHz; 1 GB memory; 32 GB storage; WebOS/CyanogenMod 11(Kit Kat)
HP 10 Plus; Android-Kit Kat; 1.0 GHz Allwinner A31 ARM Cortex A7 Quad Core Processor ; 2GB RAM Memory Long: 2 GB DDR3L SDRAM (1600MHz); 16GB disable eMMC 16GB v4.51
HP Omen; i7-4710QH; 8 GB memory; 256 GB San Disk SSD; Win 8.1
HP Photosmart 7520 AIO
++++++++++++++++++
**Click the Thumbs Up+ to say 'Thanks' and the 'Accept as Solution' if I have solved your problem.**
Intelligence is God given; Wisdom is the sum of our mistakes!
I am not an HP employee. -
How to enter BIOS on Qosmio G50-12Q?
Good Morning
I have a PC Qosmio G50-12Q - OS is Window Vista 32 bit
How I make to enter in the BIOS of the system ?
Which are the keys to press ?
Tank youHello
I asked a friend of me because he has Qosmio G50 and you have to press F2 key to enter BIOS setup.
By the way: If you press F12 you can select the boot device. Therefore its not necessary to enter the BIOS. :) -
How to enter bios, disable onboard sound, and install a sound card
How do I enter bios, disable onboard sound, and install a sound card?
Hi,
You may also have to disable, security for the PCIE x1 slot.
Windows 8.1 - Accessing the UEFI (BIOS) Setup
Regrads -
How to enter bios on a HP Envy TouchSmart 15t-j000?
I have a HP Envy TouchSmart 15t-j000 and I want to enter bios. When I restart the computer just the HP logo appears.I've tried to press ESC, F1 - F12, insert, delete, home, end... Nothing works.Do you know how I can do this?Thanks
Marius_Paval wrote:
I have a HP Envy TouchSmart 15t-j000 and I want to enter bios. When I restart the computer just the HP logo appears.I've tried to press ESC, F1 - F12, insert, delete, home, end... Nothing works.Do you know how I can do this?ThanksHi, Marius. Here is how: 1. Press the Shift key as you shut down your laptop normally.2. Wait at least 10 seconds with the laptop off.3. Press the Power button and then immediately press the ESC key on the upper left of your keyboard, about once per second. You will soon see a Recovery screen menu that instructs you to press the F10 button to go directly to your BIOS menu. Pressing the ESC key is easy to remember; that way, you don't have to memorize the other F button choices. Easy! Good luck! -
How to enter bios on Qosmio E10?
I only need to know how to enter the BIOS on Qosmio E10!
Thanks in advance
globiiYou can enter the BIOS with ESC.
Press ESC directly after power on the notebook.
Good luck! -
How to determine which chipset my Satellite L300/700 has?
I have a SATELLITE L300/700 (PSLB8A-047004). The User Guide covers several models. It indicates that the chipset determines which memory modules I need for a memory upgrade. How do I find out which chipset I have, please?
Kev.> I'm still curious about how to determine which chipset I have - any thoughts?
Go to the device manger and click on IDE Ata/Atapi controllers:
http://img814.imageshack.us/img814/7321/chipset.jpg
There you will see your chipset installed on your laptop. In my case, as shown on the screenshot is Intel ICH9m
Maybe you are looking for
-
ITunes has kidnapped my CD/DVD drive!
CD/DVD Problems 1) I had been using itunes version 6.0.5.20 with no problems. 2) I upgraded to itunes version 7.0.0.70 in late September. 3) I recorded some CD's from my library, using the itunes software, with no problems. However: A) The AV buttons
-
So I was using my iPod Touch 5th generation and the charger wouldnt charge it and it died then while it was in the process of tuening back on the apple logo dissapeered and it kept on turning on and off so i put it into DFU mode and it said to pl
-
OS X resizing PDF problem.
hi everyone! i have an indesign file that needs to be resized to 15.24cm x 22.86cm for printing. using the setup option within the file>print dialogue i am unable to resize it. the options are just greyed out. i dont have any printers installed at t
-
How to setup jobs to run during 8 am to 6 pm every 30 minutes in scheduler
I want to set up a job in the scheduler to run only during 8 am to 6 pm MST every 30 minutes. How do I do such a setting in the job scheduler? Could it be done through RZ04 (operation mode) Regards Ram
-
Problem keying graphics over video when exported.
Hey I'm new to FCE, but I work professionally in the television industry doing graphics/compositing/3d. Outside of work, I mess around with my own movies and hardware. I'm cutting together a piece shot with my Canon VIXIA HG20 camera. The footage/pro