How to fix music buttons on lock screen?

Updated my iPhone 5 to iOS7.2 and music buttons (skip forward/backward, play/pause/stop) do not work; volume still works. Is there a way to fix this??

I did see a reply on a similar post:
You can try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings      
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:                                 
iOS: How to back up                                                                
- Restore to factory settings/new iOS device.             
However, some onther users have reported the same problem so it it may be a bug in iOS
I did the RESET DEVICE only to mine (i.e., did not reset all settings...) and it did work to fix the buttons (haven't tested on the car, but it'll likely be OK now...).  Certainly there is a bug somewhere that needs fixed...

Similar Messages

  • It's not showing the play or next song buttons on locks screen when the musics are played

    it's not showing the play or next song buttons on locks screen when the musics are played

    kaeandcolesmon,
    If you open the recovery drive (partition) it should only have a single folder (Recovery).
    To make sure that your not saving restore points to that drive.
    See:
    Start, Control Panel, System, System Protection tab. Make sure the D drive partition is set to OFF so that it does not save there.
    I am a volunteer. I am not an HP employee.
    To say THANK YOU, press the "thumbs up symbol" to render a KUDO. Please click Accept as Solution, if your problem is solved. You can render both Solution and KUDO.
    The Law of Effect states that positive reinforcement increases the probability of a behavior being repeated. (B.F.Skinner). You toss me KUDO and/or Solution, and I perform better.
    (2) HP DV7t i7 3160QM 2.3Ghz 8GB
    HP m9200t E8400,Win7 Pro 32 bit. 4GB RAM, ASUS 550Ti 2GB, Rosewill 630W. 1T HD SATA 3Gb/s
    Custom Asus P8P67, I7-2600k, 16GB RAM, WIN7 Pro 64bit, EVGA GTX660 2GB, 750W OCZ, 1T HD SATA 6Gb/s
    Custom Asus P8Z77, I7-3770k, 16GB RAM, WIN7 Pro 64bit, EVGA GTX670 2GB, 750W OCZ, 1T HD SATA 6Gb/s
    Both Customs use Rosewill Blackhawk case.
    Printer -- HP OfficeJet Pro 8600 Plus

  • How to get rid fo emergency button on lock screen?

    Need to disable emergency button on lock screen. I do not like it when the police call me saying I made a false 911 call while I am working.
    Anyone figure out how to disable?
    Please help.
    Scott

    Hi and Welcome to the Community!
    This article may be partially on point:
    KB26459 How to prevent accidental emergency calls from a BlackBerry smartphone
    Many jurisdictions require that ability, and so it cannot be overridden.
    Good luck!
    Occam's Razor nearly always applies when troubleshooting technology issues!
    If anyone has been helpful to you, please show your appreciation by clicking the button inside of their post. Please click here and read, along with the threads to which it links, for helpful information to guide you as you proceed. I always recommend that you treat your BlackBerry like any other computing device, including using a regular backup schedule...click here for an article with instructions.
    Join our BBM Channels
    BSCF General Channel
    PIN: C0001B7B4   Display/Scan Bar Code
    Knowledge Base Updates
    PIN: C0005A9AA   Display/Scan Bar Code

  • Ios7 music from the lock screen via control centre

    Help!!! whilst i can see how it is quicker to access music from the lock screen via control centre it doesn't appear to work correctly
    when returning to the control centre from the lock screen after a few minutes listening to music it works fine i.e. the track you were listening to appeas there
    my issue is that if you return to the control centre after not listening to music say for a few hours or overnight it does no return to the track you were listening to and decidess for itself that its in shuffle mode. very frustrating
    is this correct or is this in the settings

    You can try the standard fixes:
    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up                                                                
    - Restore to factory settings/new iOS device.             
    - Wait for next iOS update

  • No reverse seek on music player during locked screen

    I noticed that there is no reverse seek << on music player on locked screen, it only displayed the forward seek >>. This shouldn't happened because in Kitkat all is complete forward or rewind. Sony pls fix this bug.

    It is indeed gone, have you checked this out?
    http://talk.sonymobile.com/t5/WALKMAN/Walkman-Beta-Test/m-p/953659#U953659
    "I'd rather be hated for who I am, than loved for who I am not." Kurt Cobain (1967-1994)

  • How to fix keyboard clicks and lock sounds when they are on in setting , sounds and still do not work?

    How to fix keyboard clicks and lock sounds when they are on in setting , sounds and still do not work?

    Double-click the Home button and swipe the Task Bar to the right. Check Volume and Mute Settings.
    Message was edited by: Diavonex

  • How do I shut off the lock screen feature on my iPhone 5s?

    How do I shut off the lock screen feature on my iPhone 5s?

    You can turn Auto-Lock off and you can choose not to have the Passcode Lock feature enabled, but there will always "slide to unlock" available after manually turning the iPhone's screen off with the sleep/wake button or with Auto-Lock enabled without having the Passcode Lock feature enabled.
    This is to prevent anything from being selected on the iPhone after the screen has been turned off or or placing the iPhone in sleep mode if the iPhone were in your pocket and the home button or sleep/wake button was selected without your knowledge.

  • How to close siri from the lock-screen in ios 7.1??

    How to close siri from the lock-screen in ios 7.1??
    Some times when I place something on the phone siri start woking and the phone get hot fast and the battery is dead faster than normal.

    Sorry, that cannot be changed.

  • How to disable save button on selection screen (1000) run from other report

    Hi Experts,
    Can any one let me know how to disable save button on selection screen (1000) run from other report.
    Say I am running from report R1 which submits report R2, but the save button should be disabled on
    report R2(selection screen 100).
    Thanks in advance.
    Regards
    RP.

    Hi RPReddy16 ,
    Try this:
    DATA :BEGIN OF t_extab occurs 0,
                     fcode like rsmpe-func,
                 END OF t_extab.
    REFRESH T_EXTAB.
    MOVE 'SAVE' TO T_EXTAB-FCODE.
    APPEND T_EXTAB.
    CLEAR T_EXTAB.
    SET PF-STATUS 'STATUS' EXCLUDING T_EXTAB.
    Regards,
    José

  • How do I set a customized lock screen in iOS7?

    How do I set a customized lock screen in iOS7?

    Thank you, but I need to put my name and contact info on an image to be the lock screen.  It is what my university really really wants us to do.  I used to be able to make a PowerPoint or Keynote page, save it as a jpeg, email it to myself and open it on the iPad, send it to cameral roll, then have the option to set it as the lock screen there.  Can't do that any more.

  • How to Add Push Button On Selection Screen

    Hi Experts,
    How to add Push button on Selection Screen.
    Points will b rewarded for useful help.
    Bohra.

    Hi,
    To create a pushbutton on the selection screen, you use:
    SELECTION SCREEN PUSHBUTTON [/]<pos(len)> <push>
    USER-COMMAND <ucom> [MODIF ID <key>].
    The [/]<pos(len)> parameters and the MODIF IF addition have the same function as for the formatting options for underlines and comments.
    <push> determines the pushbutton text. For <push>, you can specify a text symbol or a field name with a maximum length of eight characters. This character field must not be declared with the DATA statement, but is generated automatically with length <len>. The field must be filled before the selection screen is called.
    For <ucom>, you must specify a code of up to four characters. When the user clicks the pushbutton on the selection screen, <ucom> is entered in the UCOMM of the SSCRFIELDS interface work area. You must use the TABLES statement to declare the SSCRFIELDS structure. The contents of the SSCRFIELDS-UCOMM field can be processed during the AT SELECTION-SCREENevent.
    Ex.
    REPORT DEMO.
    TABLES SSCRFIELDS.
    DATA FLAG.
    SELECTION-SCREEN:
    BEGIN OF SCREEN 500 AS WINDOW TITLE TIT,
    BEGIN OF LINE,
    PUSHBUTTON 2(10) BUT1 USER-COMMAND CLI1,
    PUSHBUTTON 12(10) TEXT-020 USER-COMMAND CLI2,
    END OF LINE,
    BEGIN OF LINE,
    PUSHBUTTON 2(10) BUT3 USER-COMMAND CLI3,
    PUSHBUTTON 12(10) TEXT-040 USER-COMMAND CLI4,
    END OF LINE,
    END OF SCREEN 500.
    AT SELECTION-SCREEN.
    CASE SSCRFIELDS.
    WHEN 'CLI1'.
    FLAG = '1'.
    WHEN 'CLI2'.
    FLAG = '2'.
    WHEN 'CLI3'.
    FLAG = '3'.
    WHEN 'CLI4'.
    FLAG = '4'.
    ENDCASE.
    START-OF-SELECTION.
    TIT = 'Four Buttons'.
    BUT1 = 'Button 1'.
    BUT3 = 'Button 3'.
    CALL SELECTION-SCREEN 500 STARTING AT 10 10.
    CASE FLAG.
    WHEN '1'.
    WRITE / 'Button 1 was clicked'.
    WHEN '2'.
    WRITE / 'Button 2 was clicked'.
    WHEN '3'.
    WRITE / 'Button 3 was clicked'.
    WHEN '4'.
    WRITE / 'Button 4 was clicked'.
    WHEN OTHERS.
    WRITE / 'No Button was clicked'.
    ENDCASE.
    This example defines four pushbuttons on a selection screen that is displayed as a
    dialog box. The selection screen is defined in a statement chain for keyword
    SELECTION-SCREEN.
    If the text symbols TEXT-020 and TEXT-040 are defined as 'Button 2' and 'Button 4',
    the four pushbuttons appear as follows on the selection screen displayed as a dialog box.
    Regards,
    Bhaskar

  • How do we change the Yosemite lock-screen background?

    How do we change the Yosemite lock-screen background?
    Would like it to match our desktop.
    At present, lock-screen appears to be a blurred version of one of the standard Yosemite desktops.

    It typically uses your Screen Saver definition in System Preferences > Desktop & Screen Saver > Screen Saver tab.
    Or I'm misunderstanding the question...
    Captfred

  • Can't play music from the lock screen.

    Has anyone else notice this problem, since I updated up ISO 7.0.2 I cant control the music from the lock screen.

    yup, same problem.
    does not work when connected through USB to my car stereo.
    It pauses, but fast forward or reverse does not work
    this worked for me
    http://support.apple.com/kb/HT1430

  • Camera button on lock screen locked

    My phone updated yesterday and ever since then the camera button the lock screen won't go away. Unlike everyone else I have no problem getting the camera to appear - I can't get it to go away! There are two lines above and below the camera button and it won't go away no matter what. Any help would be appreciated!

    It cannot be deleted. It is there. That is the way it is. You can provide feedback to Apple here www.apple.com/feedback/iphone.html if this is something you would like to suggest they change.

  • Whenever I try to pause or skip music on my lock screen it doesn't allow me to. It doesn't allow me to do that from the control center either. I am running on iOS7. How to fix this problem ?

    I've had this issue since I downloaded iOS 7. Is there any way to fix this ?

    I have the same problem!
    I came on here to see if anyone has a solution, but it seems there might not be one just. Keeping my fingers crossed. Quickly adjusting music selections from the lock screen was one of my favorite and most used features (not to mention this bug renders control center pretty much useless to me if I have not access to my music from it).

Maybe you are looking for