How to fix ur mic

help me! my mic wot work on my macbok air

Look in System Preferences > Sound > Input tab > make sure the volume slider is in the half way position > Make noise and observe the input level.
Then try a Pram and SMC reset
Pram
http://support.apple.com/kb/ht1379
SMC reset.
http://support.apple.com/kb/HT3964

Similar Messages

  • Mic level too high when recorded, how to fix?

    I have an interview where the mic level has been too high when recorded.
    The sound is basically usable, it's not all rubbish, but how to fix this?
    I know there are tools for this, just don't know what they are.
    Thanks for helping.

    If the audio is clipped there's not much you can do other than re-record. But there is this: http://www.izotope.com/products/audio/RX/
    -DH

  • How to fix the delay problem while recording? Can't set the Latency to 0. Win7, CS6,Realtek,C03u Mic

    I am using Win7, with CS6, Realtek soundcard and Samson C03U microphone.
    There is a problem that's really been bothering me. When I record songs the recorded audio always comes 0.1 seconds after where it's supposed to be and I need to fix the problem every time. How to fix the delay problem while recording? I can't set the Latency to zero. The minimum is 30ms and I still get an obvious delay.
    I saw some previous discussions saying that installing ASIO would help. Is it gonna work on my PC?
    Thank you in advance guys.

    You probably should look at a more 'serious' audio interface rather than the Realtek
    Yes ASIO drivers are the way to go
    If you want zero latency you need to monitor via your audio hardware (hence the 'serious' audio interface suggestion)
    There are a heap of reasonable audio interfaces which will do the job for you that are pretty inexpensive and I'm sure that someone will jump in with a suggestion

  • HT1665 my iphone headphones remote has stopped working after a few uses. does anyone have any suggestions on how to fix it please??....

    Hi all.
    My headphones are new form apple as they came with the phone. They have been good for the few times i have used them but out of the blue after about a weeks use they have stopped allowing me to skip forwrd or backwards???????? I am still able to pause and use my mic for Siri so im a little bit confused as to what the problem can be.. Is there anyone out there who knows what the problem might be or how to fix it??
    Thanks.

    Go to the settings in your Jeep, "forget" the iPhone. And on the iPhone "forget" the jeep. Then put the Jeep in Pairing Mode and tap Settings/BlueTooth on the phone and pair them anew (which sounds less confusing than "repair them").

  • How to fix my ipod tilt?

    Can someone please help me?
    My iPod Touch 3g (3.1.3) tilt isn't working. I am very very unhappy. I tried to restore it to 3.1.3 again ( I saw other discussions and they said to restore) and restoring to 3.1.3 doesn't work (error 3194). I searched on youtube how to fix error 3194, still doesn't work. I don't want to upgrade to 4.3.3 because it's jailbroken. This is very unfair. Please, Please someone help me. I've been looking for ages to find the correct 100% working answer. Please give me an easy way how to fix my tilt. (Orientation lock for some reason doesn't work on my ipod i dont know why)

    Does the Voice Memo app work? In that app can you see the needle of the VU meter move with sound level?
    Is the mic hole clear? I is the little hole on the backside of the iPod by the camera lens.
    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:       
    iOS: How to back up           
    - Restore to factory settings/new iOS device.
    -  Make an appointment at the Genius Bar of an Apple store.
    Apple Retail Store - Genius Bar

  • A movie I bought a while ago will no longer play, instead it just shows a black screen and no audio. All of the other movies in my library play fine. Any ideas as to whats going on or how to fix it? Thanks for any help.

    A movie I bought a while ago will no longer play, instead it just shows a black screen and no audio. All of the other movies in my library play fine. Any ideas as to whats going on or how to fix it? Thanks for any help.

    Hi 22chill,
    I recommend that we delete and re-download the movie from your purchase history:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store
    http://support.apple.com/kb/HT2519
    Thanks,
    Matt M.

  • How I fixed my iTunes 7 / Nano 1.2 problem.

    Like so many of you, I too lost the ability to connect my 4gb Nano to my iTunes when I upgraded to v7. Of course, Apple hasn't figured this out yet, but several here have.
    Here is how I fixed mine. Once you connect the Nano (after the firmware upgrade), iTunes 7 reports it as corrupt and in need of a restore. The problem is that it won't. Try the following to fix the problem:
    (note: this will reset your Nano entirely, and you WILL lose any music which is loaded on it. You will not lose whatever you have in iTunes).
    1. Unplug the Nano USB cable and perform a reset on the Nano.
    2. Restart your computer to ensure all services are running correctly.
    3. Once restarted, open My Computer and plug in your Nano. Wait until it show's up as a disk drive (this can take several minutes).
    4. Right-click on the drive which represents the Nano and wait again (up to several minutes) for the menu to pop up.
    5. Select Format and (you guessed it) wait for the format utility to appear.
    6. Make sure the File System is set to FAT32 then click Start. Do not click Quick Format. Wait some more (up to ten minutes. You'll see the progress bar move after a while).
    7. Once finished, the Nano should now be recognized by iTunes. If it isn't, unplug it, wait a minute and replug it.
    BTW, this retains the 1.2 firmware. I think the 1.2 firmware is incompatible with the data which written by previous versions. The format clears this data out.
    As always, YMMV.
    Good Luck,
    Steve
    HP   Windows XP Pro   P4 H/T

    bump
    I was having trouble seeing my Nano 2nd in iTunes and was afraid to do this step; but it works. My Nano was updated to version 1.1.1 and now everything seems to work perfectly. Keep in mind you will lose everything that is stored on your Nano when you format it.
    Gateway 733mhz   Windows XP  

  • How to fix applepushservice.dll issues for downloading iTunes on Windows 7 64 bit

    I recently had iTunes crash on my home PC, Windows 7 64-bit.  I have tried several attempts to uninstall and reinstall the program and it still does not work and I receive error messages.  The latest:  The program can't start because ApplePushService.dll is missing from your computer.  Try reinstalling the program to fix the problem.  Problem is, the articles that I have seen state this is an Unknown source and my firewall will not allow it to be installed.  The original error was a Windows Error 7 (registry & .dll issues).  Any suggestions on how to fix this problem?

    For general advice see Troubleshooting issues with iTunes for Windows updates.
    The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down the page in case one of them applies.
    Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
    tt2

  • Recently loaded Lion on my laptop and now my computer crashes often. Black screen and keyboard lights up. Any ideas on what's wrong and how to fix this?

    Recently loaded Lion on my laptop and now my computer crashes often. Black screen and keyboard lights up. Any ideas on what's wrong and how to fix this?

    Everytime this happens Ihave to power down and restart! Any ideas would be appreciated!

  • I updated Xcode 5 to Xcode 6.0.1. It messed up my previous apps and i don't know how to fix it. Is it possible to uninstall Xcode 6 and go back to Xcode 5?

    Hello,
    I updated Xcode 5 to Xcode 6.0.1. It messed up my previous apps and i don't know how to fix it. Is it possible to uninstall Xcode 6 and go back to Xcode 5?

    I found this solution http://objcsharp.wordpress.com/2014/09/21/how-to-get-back-the-ios-7-sdk-after-up grading-to-xcode-6/

  • TS1702 I cannot get the keyboard to come up on the ipad mini when in the citrix receiver.  Has anyone ran into this and do you know how to fix it?

    I cannot get the keyboard to come up on the ipad mini when in the citrix receiver.  Has anyone ran into this and do you know how to fix it?

    I am not familiar with Citrix Reciever but is it possible it is open or being used in another open app?
    Try quitting all apps then try again.
    Quit all apps: Double tap the Home button and swipe the app preview page up for each open app

  • Does anyone know how to fix an error in cc photoshop on Win8 that says puppet warp could not complete request due to program error?

    Does anyone know how to fix an error in cc photoshop on Win8 that says puppet warp could not complete request due to program error?

    Questions on using a specific program should go in that program forum
    This forum is about the Cloud as a delivery process, not about using individual programs
    If you start at the Forums Index https://forums.adobe.com/welcome
    You will be able to select a forum for the specific Adobe product(s) you use
    Click the "down arrow" symbol on the right (where it says All communities) to open the drop down list and scroll

  • In Firefox can not see the Downloads window, in the jump in the boot to be seen - the download speed Downloaded much and now can not see how to fix it?

    in Firefox can not see the Downloads window, in the jump in the boot to be seen - the download speed
    Downloaded much and now can not see how to fix it?

    I hate the new downloads-in-a-tab scheme. This was an unnecessary change in my book (if it aint broke, don't "fix it").
    So in order to get it back, I performed the about:config browser.download.useToolkitUI change, but now all I get is a blank download window that pops up every time I download something.
    Is there something else that I need to do? I've checked the change and it was saved, but it didn't resolve my issue as much as it just caused me a new issue.

  • Can anyone help me with Magicjack? after I purchased US number I am unable to log in on my Iphone, I keep getting an error "YOUR DEVICE IS NOT ON THIS ACCOUNT" I contacted MJ support but they are very much useless and dont know how to fix it!

    can anyone help me with Magicjack? after I purchased US number I am unable to log in on my Iphone, I keep getting an error "YOUR DEVICE IS NOT ON THIS ACCOUNT" I contacted MJ support but they are very much useless and dont know how to fix it!

    There's a whole lot to read in your post, and frankly I have not read it all.
    Having said that, this troubleshooting guide should help:
    http://support.apple.com/kb/TS1538
    In particular, pay attention to the mobile device support sections near the bottom, assuming you have already done the items above it.

  • I am unable to hear anything on my iphone 4 nor can the person i call hear anything when i speak - I think that my ear piece and mike have both got magnetised how do fix the problem

    I am unable to hear anything on my iphone 4 nor can the person i call hear anything when i speak -
    I think that my ear piece and mike have both got magnetised how do fix the problem
    Please help

    I have the same problem!! It lead to many other problems with my phone
    I just arranged a repair with apple. Yes its inconvenient to be without a phone for a while but if your phone is in warranty its good to get it looked at professionally!

Maybe you are looking for

  • Parsing an XML string

    How would I get the Oracle XML Parser to parse an XML string? The example ("DOMSample") only demonstrates how to parse an XML file -- I would like to do something of the form... parser.parse("<test>testing</test>"); On a related note, whilst the PL/S

  • ASP Includes in Dreamweaver cs3

    Hi all, My issue is that I can't get more than 1 include to display in the editor view of dreamweaver...I have all my settings setup correctly for my site, but it fails to show anything past the first one. I don't ever use this editor view, but my bo

  • Hooking up my mixer??????

    what would be the best way to hook up a mixer with normal av connections to my G5 IMAC. What is the product and where do i buy it????? If you have the answers call 914-850-0882.

  • Providing users with a URL that will open up a Discoverer Worksheet

    Hi, As above.. The plan is to use a URL within an iFrame on our website which automatically logs the user into a worksheet. I have created a generic Oracle user and created a workbook with one worksheet - these have both been shared with the new gene

  • How to specify multiple sequence for multiple fields in a primary key!

    Hi, i have a table which has about 15 fields, one of the field is primary key and i am able to specify the sequence for it using toplink and when the object is created through toplink the sequence get generated automatically, which is fine. Now i hav