How to open an ipad after it is disabled due to wrong password

what to do when i pad is locked due to wrong password entry by kids

You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your app data and settings. You can restore with any other computer, but you will lose everything on the iPad.
Instructions can be found here.
http://support.apple.com/kb/ht1212
You may need to restore using Recovery Mode. You can read about it here.
http://support.apple.com/kb/ht4097
Recovery Mode Instructions
Disconnect the USB cable from the iPad, but leave the other end of the cable connected to your computer's USB port.
Turn off iPad: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for iPad to turn off.
If you cannot turn off iPad using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the iPad turns off, release the Sleep/Wake and Home buttons.
While pressing and holding the Home button, reconnect the USB cable to iPad. When you reconnect the USB cable, iPad should power on.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears you can release the Home button.
If necessary, open iTunes. You should see the recovery mode alert that iTunes has detected an iPad in recovery mode.
Use iTunes to restore iPad.

Similar Messages

  • My iPad mini was disable due to wrong password how can It be able again??

    My iPad mini was disable due to wrong password how can It be able again??

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. If you did not do step 4 properly, start all over again.

  • My ipad air2 has been disabled due to incorrect password input

    Please help me to restore my ipad air2 (4th generation) as it was disabled by entering incorrect password attempts.

    FORCE IPAD INTO RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. You must follow step 1 to step 4 VERY CLOSELY.
    3. Repeat the process if necessary.

  • I cant open my ipad after i turned on the voice in accessibility i have a passcode and i tried to enter my password but it not working. help me please

    i cant open my ipad after i turned on the voice in accessibility i have a passcode and i tried to enter my password but it not working. help me please..
    i updated my ipad in ios 6

    Turn off VoiceOver
    1. Press the Home button
    2. Tap Settings.
    3. Then double-tap Settings.
    4. Tap General.
    5. Then double-tap General.
    6. Use three fingers on the screen to scroll to Accessibility
    7. Tap Accessibility.
    8. Then double-tap Accessibility
    9. Tap VoiceOver
    10. Then double-tap VoiceOver.
    11. Tap "On" next to VoiceOver
    12. Then double-tap "On" to turn it off.

  • How to enable my Ipad after it has been dissable by too many wrong attempts to enter passcode?

    How to enable my Ipad after it has been dissable by too many wrong attempts to enter passcode?

    You have to restore the iPad in order to unlock it using these instructions.
    http://support.apple.com/kb/HT1212?viewlocale=en_US&locale=en_US

  • HT4061 How to restore my ipad after downloading itunes?

    How to restore my ipad after downloading itunes?

    Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
    Before restoring:
    Verify that you are using the latest version of iTunes.
    Back up your device.
    Transfer and sync content to your computer.
    Restoring your iOS device
    Connect your device to your computer.
    Select your iPhone, iPad, or iPod touch when it appears in iTunes. Select the Summary tab, and click the Restore button.
    Click Restore.
    After a restore, the iOS device restarts. You should then see "Slide to set up". Follow the steps in the iOS Setup Assistant.
    If needed, restore your device from a previous backup.
    If restoring does not finish successfully or if a restore error appears, see iOS: Resolving update and restore alert messages.
    Additional Information
    If your device is continually restarting, not responding, or showing the Apple logo with no progress bar or a stopped progress bar, place the device into recovery mode and try restoring again.
    Devices with cellular service should activate after a restore. If activation is not successfu, see the options below.
    Symptoms
    Your iPhone may display one of the following messages when you attempt to activate it:
    "Your iPhone could not be activated because the activation server is temporarily unavailable."
    "The iPhone is not recognized and cannot be activated for service."
    "iTunes was unable to verify your device."
    Resolution
    Perform the following steps if you receive one of the messages above:
    Restart the iPhone.
    Try another means of reaching the activation server and attempt to activate.
    Try connecting to Wi-Fi if you're unable to activate using a cellular data connection.
    Try connecting to iTunes if you're unable to activate using Wi-Fi.
    Restore the iPhone.
    If you receive an alert message when you attempt to activate your iPhone, try to place the iPhone in recovery mode and perform a restore. If you're still unable to complete the setup assistant due to an activation error, contact Applefor assistance.

  • My iPad has been disabled due to wrong passcode which I have forgotten,How can open it again?I'm so desperate right now

    My iPad has been disabled due to wrong passcode which I have forgotten,How can open it again?I'm so desperate right now

    If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
    If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
    You may have to force iPad into Recovery Mode
    http://support.apple.com/kb/ht1808

  • How to fix your iPod after it got disabled to how it says connect to iTunes

    How to fix your iPod after it got disabled to how it says connect to iTunes

    i can probably help but i need more information

  • My i pod 2 gen is disabled due to incorrect password how do i fix this?

    my i pod 2 gen is disabled due to incorrect password how do i fix this?

    Follow the instructions here:
    iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen

  • HT201363 My iPod Touch was disabled due to incorrect password entries.  How do I unlock it?

    My iPod Touch was disabled due to incorrect password entries.  How do I unlock it?

    Hi there EllaBella0,
    You may find the information in the article below helpful.
    iOS: Forgotten passcode or device disabled after entering wrong passcode
    http://support.apple.com/kb/ht1212
    -Griff W. 

  • My ipad 2 has permanent disabled due to passcode what can I do

    My ipad 2 has permanent disabled due to passcode what can I do

    If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
    If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
    You may have to force iPad into Recovery Mode
    http://support.apple.com/kb/ht1808

  • HT1212 Ipad is disable due to wrong passcode entered

    Ipad is disable due to wrong passcode entered. Could you please help on this

    Follow the directions in the HT1212 article you attached above.  It's the article that sent you here.

  • HT201413 my ipad is disabled due to incorrect password

    my ipad is disabled due to incorrect password what i should do

    This is what you need
    http://support.apple.com/kb/ht1212

  • How to Customize the Error Message when a user enters a wrong password

    Hi Gurus
    Pls Help out me that
    How to Customize the Error Message when a user enters a  wrong password ?
    I need the Help to Customize the messege ?
    How  we can do
    Pls Tell me indetail

    Firstly many appologies I have given you slightly duff information here, I had been editing the file above for email notification texts not logon / password texts.
    The file you need is actually a portal .par file and can be found in the deployment/pcd directory.  The file you need is called com.sap.portal.runtime.logon.par (with a .bak extension at this time). 
    You need to copy this file to a local machine and unzip the contents.  The files you need to edit are contained in a further jar file which can be found in the \PORTAL-INF\lib directory - it is called umelogonbase.jar.  It too needs to be extracted and the file you need to edit is logonMessages_xx.properties (where the xx is the language code you are using).
    In this file you will find lines like:
    NUMERIC_REQUIRED=Invalid new password (must contain digits)
    You need to identify which texts you wish to modify and edit the text to the right of the equals sign.  Once complete rezip the umelogonbase.jar file and then the com.sap.portal.runtime.logon.par (this time name it without the .bak extension.  Then logon to the portal and upload the new par and you should see your new logon messages.
    Haydn

  • I forget my ipad passcode how to open my ipad

    i forget my ipad passcode how to open my ipad

    Locked Out, Forgot Lock or Restrictions Passcode, or Need to Restore Your Device: Several Alternative Solutions
    1. iOS- Forgotten passcode or device disabled after entering wrong passcode
    2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
    3. Restoring iPod touch after forgotten passcode
    4. What to Do If You've Forgotten Your iPhone's Passcode
    5. iOS- Understanding passcodes
    6. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
    Forgotten Restrictions Passcode Help
    You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New.
    Also, see iTunes- Restoring iOS software.

Maybe you are looking for

  • Header data in ALV

    Hi, I've got a requirement, wherein I need to display a few fields of the ALV page, as the header data, and the remaining as line items. How do I do.  I'm able to get all the data fields to a ALV report, how do I go?? Please help me. Thank you, in Ad

  • Preorders "stuck" after release.

    So a few weeks ago I posted about my preorders randomly saying there was a billing error (still seems to be an issue for many). A couple people were able to help me out before the preorders I really care about were cancelled. However, now a new probl

  • Replication SUN == openLDAP

    Hi ! I would like to replicate the data of my sun directory server to an openLDAP directory server. Is it possible to configure the slapd process of the sun directory server to use the slurpd process, which replicates data Does anyone have a solution

  • X301 fingerprint software for win 7 not available (please help)

    Hey out there! I can't get the fingerprint reader of my X301 under Win 7 to work. When I check under the d&d section on the lenovo site it says fingerprint software wasn't compatible with X301. Is there another way to get it working than waiting for

  • Calibrating 27in iMac with Spyder 2, yellow tone.

    Hello, I've been all over the net researching trying to calibrate a 27in Imac with Spyder 2 express 2.3 software, which is what i'm using. When I try to calibrate i've been leaving the brightness at full and not changing anything else. 6500k with 2.2