HT1212 I have tried the solution but it's still shown disable
I've tried all the solutions but my iphone 5 still shown "iphone is disabled"...
What's the problem and how to resolve it?
Did you go through the steps in the article:
Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button.
iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Similar Messages
-
" 3 items could not be synced. See iTunes for more information" I have searched and I have tried the solutions on the forum. My iPhone has been successfully synced previously on my mac mini without error. I am trying to sync my iPhone with new MacBook Pro.
Modular77: With respect the dialog on the iPhone 'XX items could not be synced. See iTunes for more information.' , would you happen to know where to look in iTunes? I looked in all the places that seemed logical to me.
I am, however, asking only for future reverence, as the initial sync which generated the error dialog was done via USB, and almost immediately after the USB sync, I ran a WiFi Sync—two in a row in fact—both initiated from the iPhone. Both WiFi syncs completed successfully with no error dialog.
I then ran another USB sync initiated from iTunes on the Macintosh, as was the first sync which gave the error. This second USB sync also completed successfully with no errors.
I think someone in this thread mentioned non-AppleStore products or DMR issues which I think could not have been an issue in my case, as I was running the sync to install updated Apps from the AppStore, and additionally had deleted some music and movie items to make sure there was room for the App updates. Nothing was added other than the recently downloaded App updates from the AppStore.
iPhone3GS iOS 5.1.1 build 9B206.
Developer Profile enabled. iCloud enabled.
32 GB “disk.” About 1.5 GB free after sync.
iPhone NOT jailbroken
MacBook 13-inch Aluminum, Late 2008 (NOT Macbook Pro)
Lion 10.4.7 build 11E53. 2 GB RAM.
Thanks for any info or advice. Problem IS now solved, but it absorbed a lot of time to reach that point. -
My iphone4 will not connect to my network. My iPad and my wife's iPad and iphone4 all connect to my network. I have tried the solutions in Apple trouble shooting site. I even tried the freezer option. Still no connection.The "wheel" turns for 2 secOne then stops without connecting. Anyine have a solution to this issue?
I have an AT&T contracted iphone 5. Cannot send mms to anyone but other iPhone users. If you search the Internet, you'll see that the problem is everywhere...both the carriers and Apple are actling like the problem belongs to the other, or feigning any knowledge (which is kind of funny since the no MMS thing was in an ios6 beta that was released awhile ago, so I KNOW apple knows about it). No, I'm not running a beta (obviously, I just got my iphone 5). Awesome. Have a great camera on this thing, but cannot send OR receive MMS from anyone other than other iphone users. Gotta love it.
-
The inbox for Mac Mail lists every incoming message twice. When I delete a message it deleted both entries. I have tried the solution in "help" and it doesn't work. Any suggestions?
I am wondering if anyone is seeing my question? This is my first time and I am not sure if I am communicating correctly. If you are seeing the question above regading deleted messages reappearing please reply so I will at least know I am getting the message out.
Thank you. -
I have no sound for games in my iPad. I have tried the reset but it does not work. The speakers work as I have sound for music and videos.
Try this - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) http://support.apple.com/kb/ht1430
Check your settings. The iPads have a small switch on the right edge. http://support.apple.com/kb/ht1430 It can be used as a rotation lock to keep the screen from automatically reorienting itself as you move around, but you need to have the tablet’s settings configured properly. That same switch, right above the volume buttons, can also be set to function instead as a mute button to silence certain types of audio.
If the switch is set to work as a mute button, you can change its purpose to “screen-rotation lock” by tapping the Settings icon on the home screen. On the Settings screen, tap General on the left side, and on the right side of the screen flick down to “Use Side Switch to.” Tap to select Lock Rotation or Mute to set the button’s function. Even if you set the side switch for your preferred use, you can still mute the Mini or lock the screen. Just double-click the Home button, and when the panel of apps appears along the bottom edge of the screen, flick the row from left to right with your finger. Tap the icon on the far left side of the row to either lock the iPad’s screen or mute the iPad’s alerts, notifications and sound effects. Music, podcasts and video are not muted unless you turn the volume all the way down.
iPhone: No sound or distorted sound from speaker
http://support.apple.com/kb/ts5180
iPhone: Can’t hear through the receiver or speakers
http://support.apple.com/kb/ts1630
http://www.atreks.com/app-no-sound-on-ipad-4-%E2%80%93-what-to-do/
To solve some sound problems, just follow these simple steps
1. Go to Settings
2. Tap on General
3. Tap on Reset
4. Tap on Reset All Settings
What this effectively does is to reset some of your Settings to factory default. It’s not a complete removal of settings. It removes all of your preferences for Wi-Fi, Bluetooth, Do No Disturb, Notifications, General, Sounds, Brightness & Wallpaper and Privacy. It doesn’t affect your data. All of your email accounts will remain intact, as well as any SMS text or iMessages.
Cheers, Tom -
Hi
I have a white screen on my ipod after replacing it, i have tried the reset but it just goes black and wont respond, i cant restore it on itunes because it has a passcode on it, please helpPlace the iPod in recovery mode using one of these programs and then restore va iTunes:
For PC
RecBoot: Easy Way to Put iPhone into Recovery Mode
If necessary:
Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
and
RecBoot tip
RecBoot may have problems on 64X windows, then try:
Tenorshare ReiBoot – Enter & Exit iPhone, iPad, iPod Recovery Mode with a Single Click
For MAC or PC
The Firmware Umbrella - TinyUmbrella
Installs blootware on PC too
A supect a hardware problem -
We have adobe acrobat pro installed on our computer - we have changed the password - but it is still not giving us access to update our adobe reader. The name is showing as Marriner. Is this linked to our account?
What is your operating system?
To install/update Adobe Reader or Acrobat you need to supply your computer's Administrator password. -
how do i install lightroom cc - i have downloaded the application but lightroom 5 still opens instead
Lr5 will install on your computer just fine and the installation will not be "mixed up" with Lr3.
Why do you think it's a mix of both?
In case you are wondering because you sometimes see a different Basic panel in Lr5 and sometimes not, this is dependant on the Process Version (PV) of the image.
With PV 2010 or 2003 Lr5 will display the same Basic panel (the same sliders) as Lr3; but when you update the photo to PV 2012 - or for newly imported photos - the Basic panel and the sliders will change to the new version.
There is a flash icon below the histogram for images that don't have PV 2012. Naturally you can see and change it also in the Camera Calibration panel / Process version. -
TS2446 my apple id has been disabled, i have changed the password but it is still disabled
my apple id has been disabled, i have changed the password but it is still disabled.
can you please tell me what to doGo here:
http://www.apple.com/support/itunes/contact/
and follow the instructions to report the issue to the iTunes Store.
Regards. -
Which case offers the best protection for the ipad2 I have tried the Survivor however the pieces protecting the ports has ripped off. Any suggestions?
You had to have some kudos for the effort put in to your thread as week as the point you make.
-
I have connected the iPhone but iTunes won't recognize it. The phone has a red sign saying " iPhone is disabled connect to iTunes" What can be done?
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: How to back up
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
Have tried turning explorer of and on again and other recommended solutions but nothing seems to work. Any suggestions?
David,
Can you please try Right-Click Setup.exe > Run As Administrator
and see if it helps.
Thanks,
Anwesha -
My 3 year old put in the wrong password too many times. I did not have the setting on that says to erase device. So why can't I unlock it? Is there a "backdoor" way to put in the password? like with iTunes?
Thanks!There's no back door. The passcode is doing it's job.
If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
You may have to force iPad/iPod into Recovery Mode
http://support.apple.com/kb/ht4097 -
My daughter forgot her password but her iPod was never synchronize with my iTunes library. We have followed the suggested steps but when it comes to restoring the settings it says 'cannot connect to iTunes support server'. We can't get any further than this. Any suggestions?
Was it really update server?
Try:
- Powering off and then back on your router.
- iTunes for Windows: iTunes cannot contact the iPhone, iPad, or iPod software update server
- Change the DNS to either Google's or Open DNS servers
Public DNS — Google Developers
OpenDNS IP Addresses
- Try on another computer/network
- Wait if it is an Apple problem -
Hi, my iPad 2 keeps dropping out and going back to a blank screen. I have to again enter my password and go back to what I was doing and then it happens again, I have tried resetting and nothing has changed.
Thanks
RonFirst, try a system reset. It cures many ills and it's quick, easy and harmless...
Hold down the on/off switch and the Home button simultaneously until you see the Apple logo. Ignore the "Slide to power off" text if it appears. You will not lose any apps, data, music, movies, settings, etc.
If the Reset doesn't work, try a Restore. Note that it's nowhere near as quick as a Reset. It could take well over an hour! Connect via cable to the computer that you use for sync. From iTunes, select the iPad/iPod and then select the Summary tab. Follow the on-screen directions for Restore and be sure to say "yes" to the backup. You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod. Again, say "yes."
At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod. As before, say "yes." Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time. If that happens, only the apps that are part of the IOS will appear on your device. Corrective action is simple - choose manual "Sync" from the bottom right of iTunes.
If you're unable to do the Restore, go into Recovery Mode per the instructions here. You WILL lose all of your data (game scores, etc,) but, for the most part, you can redownload apps and music without be charged again. Also, if you have IOS-7, read this.
Maybe you are looking for
-
EJB 3.0: deployment/jar file generation issue
We have a web application project (ADF Faces) which depends on a model project (EJB 3.0 session/entity beans) that implements both business and persistence layers. This EJB project points to a utility jar file containing some classes we have built. W
-
After creating a searchable database I am unable to search documents based off of the bates number.
I just finished creating a searchable database in Adobe Acrobat Pro and it finds documents based off of search terms fine. It does not however locate documents based off of the Bates number that I am using as a search term. Why won't it let me do thi
-
Show a report region only when link in other report is clicked
Hi Friends, I am having 2 report regions.In my first report region i am having a column as a link. I want to show the 2nd report region only when the link in the 1st report region is clicked. There is a button in the 2nd report region i want to show
-
Changes are not updating in infotype 588
Hi, In 0001 subtype of infotype 0588 , when i try to copy the record into another or change the record, i am changing the ESI Number ,but this new number is not updating. It is updating with same old number. What may be the problem? This problem is
-
Why won't my Iphone 4s stay paired in my 2013 Hyundai Elantra?
Thanks for helping me. I am new to this. We also have the same problem with our other Iphone 4 in a 2013 Hyundai Accent. Other people seem to have the same issues. Is there a fix????? Thanks.