HT1212 ipod says ipod disabled connect to itunes ive turned it on while holding sleep & a music symbol with a usb cord end is the only thing thay appears when it turns back on if i let go of the home button it will after a min go back to the off position
My ipod is saying ipod disabled connect to itunes I have followed the instructions givin in the support section I leave the usb plugged in PC & unplug ipod I turned device off & than held the home button while plugging the ipod back into the cord when it comes back on it shows the itunes music note symbol apears with itunes written below it & the picture of a usb cord end pointing toward it with an arrow but that is as far as it will go it stays on that screen unless I unplug the device & after a min or so the ipod will go back to the off position.
Confused on what to do from here
Try placing the iPod in DFU made and then restore.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
Similar Messages
-
HT1320 my ipod says its disabled connect to itunes. what do i do
My iPod says its disabled connect to I iTunes what do I do
Hey enchanted.hands,
It sounds to me like this is for an iPod touch? If that's the case, you'll want to check out this article, which will guide you through how to fix it step by step:
iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/HT1212
Regards,
Delgadoh -
my ipod says connect to itunes permanently disabled i did and it says enter passcode on device. its not showing the slide board that brings up the psscode entry
iOS: Unable to update or restore - Support - Apple
-
Hi I have an Iphone 4 and when I open the app store, all that appears is a white screen. I can't do anything? what can I do?
Try a hard reset. Hold Power button and home button until it restarts. Hold both till the Apple logo is displayed. Do not slide power off.
If that does not work you may need to restore. -
hi, my daughter hers ipod touch is disabled connect to itunes after say its itunes couldnot connect to the "ipod touch" because its is locked with a passcode please help how to fix connect...i did turn off her ipod touch put usb back on there same in doenot say still ipod is disabled i dont understand please help how???
If You Are Locked Out Or Have Forgotten Your Passcode or Just Need to Restore Your Device
1. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
3. iOS- Understanding passcodes
If you have forgotten your Restrictions code, then follow the instructions
below but DO NOT restore any previous backup. If you do then you will
simply be restoring the old Restrictions code you have forgotten. This
same warning applies if you need to restore a clean system.
A Complete Guide to Restore or Recover Your iDevice (if You Forget Your Passcode)
If you need to restore your device or ff you cannot remember the passcode, then you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and re-sync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
Follow these steps to restore your device:
1. Verify that you are using the latest version of iTunes before attempting to update.
2. Connect your device to your computer.
3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
4. Select the Summary tab.
5. Select the Restore option.
6. When prompted to back up your settings before restoring, select the Back Up
option (see in the image below). If you have just backed up the device, it is not
necessary to create another.
7. Select the Restore option when iTunes prompts you (as long as you've backed up,
you should not have to worry about restoring your iOS device).
8. When the restore process has completed, the device restarts and displays the Apple
logo while starting up:
After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
iOS, keep your device connected until the "Connect to iTunes" screen goes away or
you see "iPhone is activated."
9. The final step is to restore your device from a previous backup. If you do not have a
backup to restore, then restore as New.
If you are restoring to fix a forgotten Restrictions Code or as a New device, then skip Step 9 and restore as New. -
i have an 8gb ipod touch that says its disabled connect to itunes but it is locked..when u connect it to itunes it tells you the passscode is incorrect so what do i do , would like to get it working with out losing everything on it if i can but if not i can redo it
Do as the manual says to do and restore the ipod.
If you are unable:
iOS: Unable to update or restore -
HT4623 My screen says iphone disabled connect to itunes? what do i do to get my phone back?
My phone says iphone disabled connect to itunes, what do i do to get my phone back
Connect the iPhone to your computer and restore via iTunes. Place the iPhone in Recovery Mode if necessary to allow the restore.
For how to restore:
iTunes 10 for Windows: Update and restore software on iPod, iPhone, or iPad -
HI,
I HAVE AN IPHONE4, I CHANGED MY PASSCODE BUT FORGOT WHAT IT WAS THE NEXT DAY, AFTER SEVERAL ATTEMPTS TO UNLOCK MY PHONE BECAM DISABLED AND SAYING IPHONE DISABLED CONNECT TO ITUNES, HOWEVER MY PHONE ISNT SYNCED TO ITUNES NOR A COMPUTER, PLEASE TELL ME WHAT DO I DO AND HOW TO REGAIN ACCESS TO MY PHONE?You will have to put your phone into recovery mode and restore the phone as new. Since you don't have a back up, you will lose all the data on your phone but you will be able to use it again.
Use this article iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/HT1212?viewlocale=en_US
Good luck! -
HT201263 ipad saying ipad disabled connect to itunes
i have put in the wrong pin code for my ipad 3 and on the screen it is saying = ipad disabled connect to itunes.
i dont belive i have updated this ipad on my computer before so im not sure if it will find it ?????iOS: Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
Using iPhone/iPad Recovery Mode
http://ipod.about.com/od/iphonetroubleshooting/a/Iphone-Recovery-Mode.htm
Cheers, Tom -
My daughter has managed to forget her new passcode and now it says iphone disabled connect to itunes, but it wont let me....help!
Hi there esbrewer,
You may find the troubleshooting steps in the article below helpful.
iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
If the device is not being recognized in iTunes, take a look at the article below for some additional troubleshooting steps.
iOS: Device not recognized in iTunes for Mac OS X
http://support.apple.com/kb/ts1591
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/ts1538
-Griff W. -
Entered apasscode and forgot what it is. and now it says iphone disabled connect to itunes.. and when i connect it to itunes it tells me please enter the passcode for your iphone and connect it to itunes.. I dont know what to do now..
iOS: Forgot passcode or device disabled - Apple Support
-
I disabled and blocked my phone when it was stolen, i have retrieved the phone and restored service. Now when i turned it on it says iphone disabled connect to itunes.. I have and no change, what do i do?
You need to restore the phone in itunes in order to use it again, You will have to put the phone into recovery mode and restore to factory settings http://support.apple.com/kb/ht1808
-
Hi my friend gave me an iphone but on the screen it says 'iphone disabled connect to itunes
I have got an iphone 3 from my friend that had been used by his ex wife. The phone says ' iphone disabled connect to itunes.
She 'cant remember her passcode'
I have put the phone into restore mode and connected to itunes, ( i downloaded the latest edition ) but it says its going to take 3 hours to download software - its still downloading and then earlier I got an error code oxE800002D. I cant find the error code so dont know what it means.
I dont know if I am wasting my time trying to get it working or if it will be possible to get the phone in working order ( with lots of help from you all :-) )
Any help or advice will be gratefully recievedThanks.
I did this and moved on a little but now am getting error code 3194.
i looked on the support site but dont really understand
Any ideas ? -
The number pad would not let me type in a 1 2 3 for my 4 digit code. After numerous tries, the phone now says iphone disabled connect to itunes. When I connected to itunes, it asked for the code which I was unable to enter. Help!
Open iTunes on computer, connect iPhone to computer with USB cable. Hold both Home and Power buttons on iPhone until iTunes recognizes iPhone in Recovery Mode. This usually takes about 20 seconds of holding both buttons. Restore the iPhone Firmware.
-
How can I access an iPhone when I receive a message saying iPhone disabled connect to iTunes?
How can I access an iPhone when I receive a message saying iPhone disabled connect to iTunes?
Tried connecting to itunes and hitting restore and get a error message 3194.
Any help would be greatly appreciated.odds are entering password too many times
Maybe you are looking for
-
In R12 unable to transfer payroll data to gl
My company has implemented xx Legislation with Global HRMS Internationl,Oracle R12. I have run all pre-payroll and Quick-pay for 3 employees also i have run Post payroll processes for all the 3 emps, i.e. Pre-Payment Cheque Writer Costing Cost Break
-
Overwrite mapping in design repository with the last one deployed
Hi We have a Single Design Environment with 2 runtime environnment (Dev, Prod). When I log in the Dev Control Center, I see there is a mapping "changed". It has been changed by an employee who don't work here anymore and I have no clue what have been
-
Muic will not sync with new iphone
Hi, I've just got the new iphone & every new iphone i've had for the last 5 years when i go to restore from backup it never syncs my music. In the past ive just acepted this and got on with it but i'm sick of it now!! Anyone had the same problem and
-
How do I change mouseover or rollover text in iweb08
I've gone through the web and iWeb as best I can. I can't seem to get a simple answer to this one, so I'm hoping somebody here shares this question. I use iWeb08. It's great. I've built a complicated website from scratch and it's great. I simply cann
-
Is it possible to control a GPIB instrument by the instrument through GPIB
I'm having a Function generator, it has an in built GPIB, I'm writing an application on oscilloscope which also as GPIB, I have connected the GPIB port of oscilloscope to the FG GPIB port. I tried to send a GPIB command from the oscilloscope to the f