HT1212 my ipad has been disabled due to lack of password. I hooked it up tp the computer but it did not work
Imy ipad is disabled and I can not remember passcode
Hope these instructions are clearer.
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary.
Similar Messages
-
my ipad has been disabled due to entering wromh password. how do i enable it again? Thanks and Regards
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Pay particular attention to Steps 3 and 4.
Some users have reported as many as 8 or 9 attempts were necessary before success
After you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
My iPad has been disabled due to wrong passcode which I have forgotten,How can open it again?I'm so desperate right now
If you cannot remember the passcode, you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and resync the data from the device (or restore from a backup).
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.
You may have to force iPad into Recovery Mode
http://support.apple.com/kb/ht1808 -
my ipad mini has been disabled due to one of my household trying the 4 digit pin to unlock it..they obviously got it wrong...i have plugged into my itunes as requested on screen into my laptop but it is still disabled ..what do i do to unlock and re enable??
Hey ade17768,
Thanks for the question. The following resource outlines what to do if your device is disabled:
iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/HT1212
If you have previously synced your device with iTunes, you may be able to reset the passcode by restoring the device:
1. Connect the device to the computer with which you normally sync and open iTunes.
Note: If iTunes asks you to enter the passcode, try another computer that you have synced with. Otherwise, go to "If you have never synced your device with iTunes, or you do not have access to a computer" section below.
2. If the device is still disabled, or if iTunes does not automatically sync your device, sync the device with iTunes.
3. When the backup and sync is complete, restore your device.
4. When iOS Setup Assistant asks to set up your device, choose "Restore from iTunes backup".
5. Select your device in iTunes and choose the most recent backup of your device.
Thanks,
Matt M. -
how do we reinstate ipad use when it has been disabled by pin number being entered incorrectly too many times. it is now locked
This article contains instructions on what to do if your device is disabled:
iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212 -
i cant use my ipad it has been disabled. my younger brother changed the password and no longer remembers it.... Now i am stuck as the laptop i last synced the iPad with no longer works and the ipad is disabled. Can anyone help...????
And you are going to maintain regular backups of the computer that holds the data synced from your iPad? You know, just in case your iPad AND your computer get a problem?
-
HT1212 MY Ipad has been disabled as the passcode was wrongly pressed by my child
can anyone help me on the above subject.
If the iPad was running iOS 7, iCloud: Find My iPhone Activation Lock in iOS 7
http://support.apple.com/kb/HT5818
How can I unlock my iPad if I forgot the passcode?
http://www.everymac.com/systems/apple/ipad/ipad-troubleshooting-repair-faq/ipad- how-to-unlock-open-forgot-code-passcode-password-login.html
iOS: Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
How can I unlock my iPad if I forgot the passcode?
http://tinyurl.com/7ndy8tb
How to Reset a Forgotten Password for an iOS Device
http://www.wikihow.com/Reset-a-Forgotten-Password-for-an-iOS-Device
Using iPhone/iPad Recovery Mode
http://ipod.about.com/od/iphonetroubleshooting/a/Iphone-Recovery-Mode.htm
You may have to do this several times.
Saw this solution on another post about an iPad in a school environment. Might work on your iPad so you won't lose everything.
~~~~~~~~~~~~~
‘iPad is disabled’ fix without resetting using iTunes
Today I met my match with an iPad that had a passcode entered too many times, resulting in it displaying the message ‘iPad is disabled – Connect to iTunes’. This was a student iPad and since they use Notability for most of their work there was a chance that her files were not all backed up to the cloud. I really wanted to just re-activate the iPad instead of totally resetting it back to our default image.
I reached out to my PLN on Twitter and had some help from a few people through retweets and a couple of clarification tweets. I love that so many are willing to help out so quickly. Through this I also learned that I look like Lt. Riker from Star Trek (thanks @FillineMachine).
Through some trial and error (and a little sheer luck), I was able to reactivate the iPad without loosing any data. Note, this will only work on the computer it last synced with. Here’s how:
1. Configurator is useless in reactivating a locked iPad. You will only be able to completely reformat the iPad using Configurator. If that’s ok with you, go for it – otherwise don’t waste your time trying to figure it out.
2. Open iTunes with the iPad disconnected.
3. Connect the iPad to the computer and wait for it to show up in the devices section in iTunes.
4. Click on the iPad name when it appears and you will be given the option to restore a backup or setup as a new iPad (since it is locked).
5. Click ‘Setup as new iPad’ and then click restore.
6. The iPad will start backing up before it does the full restore and sync. CANCEL THE BACKUP IMMEDIATELY. You do this by clicking the small x in the status window in iTunes.
7. When the backup cancels, it immediately starts syncing – cancel this as well using the same small x in the iTunes status window.
8. The first stage in the restore process unlocks the iPad, you are basically just cancelling out the restore process as soon as it reactivates the iPad.
If done correctly, you will experience no data loss and the result will be a reactivated iPad. I have now tried this with about 5 iPads that were locked identically by students and each time it worked like a charm.
~~~~~~~~~~~~~
Try it and good luck. You have nothing more to lose if it doesn't work for you.
Cheers, Tom -
HT1386 ipad has been disabled due to blocked password, how to solve it?
And iTunes cannot connect to it due to the password trouble. How do I solve it???
You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your app data and settings. You can restore with any other computer, but you will lose everything on the iPad.
iOS: Device disabled after entering wrong passcode -
iPad4 - unable to backup due to lack of iCloud storage . The pad is frozen. Cannot access any info.
However, if the iPad is frozen, a reset may allow you to get back into it again. It hurts nothing to try this. It is like rebooting your computer.
Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up. -
I cannot delete duplicate photos off my IPad 2 which were synced on my computer. I deleted duplicates from My pictures on my computer, but they were still duplicated when I added them back.
The links below have instructions for deleting photos.
iOS and iPod: Syncing photos using iTunes
http://support.apple.com/kb/HT4236
iPad Tip: How to Delete Photos from Your iPad in the Photos App
http://ipadacademy.com/2011/08/ipad-tip-how-to-delete-photos-from-your-ipad-in-t he-photos-app
Another Way to Quickly Delete Photos from Your iPad (Mac Only)
http://ipadacademy.com/2011/09/another-way-to-quickly-delete-photos-from-your-ip ad-mac-only
How to Delete Photos from iPad
http://www.wondershare.com/apple-idevice/how-to-delete-photos-from-ipad.html
How to: Batch Delete Photos on the iPad
http://www.lifeisaprayer.com/blog/2010/how-batch-delete-photos-ipad
(With iOS 5.1, use 2 fingers)
How to Delete Photos from iCloud’s Photo Stream
http://www.cultofmac.com/124235/how-to-delete-photos-from-iclouds-photo-stream/
Cheers, Tom -
How can I get into my disabled ipod if I can't connect it to the original computer?
Download and install iTunes: http://www.apple.com/itunes/download/
Restore iPod in recovery mode: http://support.apple.com/kb/ht1808
These steps do not require the original computer the iPod synced with. -
Hi all, My ipad has been disabled due to incorrect password keyed. I know I can recover it by connecting it to the old pc that was used to sync with this ipad.Yet, my real problem is that that old PC has was not working any more...pls help...:(
You have to restore the device within iTunes. There is no other way to do it. You need a computer. You can restore with any other computer, but you will lose everything on the iPad.
This will tell you how to restore
iTunes: Backing up, updating or restoring iOS software
If you cannot restore that way, you may have to use recovery mode
iPad: Unable to update or restore -
My apple id has been disabled, i have reset my password and turned my phone on and of but no joy....please help me
http://support.apple.com/kb/TS2446?viewlocale=en_US
-
Hello,
My IPAD has been disabled as I lost it in the office and it was just recently returned to me. It says on the screen that IPAD DISABLED and says please try again in 22,641,304 minutes. Can you please advise how to enable this as the computer I am using now (MAC RETINA) is not the original computer that the IPAD was synced on.
ThanksLocked Out, Forgot Lock or Restrictions Passcode, or Need to Restore Your Device: Several Alternative Solutions
1. iOS- Forgotten passcode or device disabled after entering wrong passcode
2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
3. Restoring iPod touch after forgotten passcode
4. What to Do If You've Forgotten Your iPhone's Passcode
5. iOS- Understanding passcodes
6. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
Forgotten Restrictions Passcode Help
You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New.
Also, see iTunes- Restoring iOS software. -
My Ipad has been disabled. What do I do next?
My Ipad has been disabled. What do I do next?
Disabled device due to entering wrong passcode?
You will need to connect the device to the computer that you normally sync to and you should then be able to reset the device and re-sync your content to it (http://support.apple.com/kb/HT1212) - you may need to put the device into recovery mode :http://support.apple.com/kb/ht1808
Maybe you are looking for
-
I am new to Java and am having trouble figuring out why I am throwing this error when running the jar file. My code builds the jar file without error, but when I try to run the application from the jar file, I get the error in my code that reads, " U
-
Help installing Sql server 2014
Sir i am currently using Visual studio 2013 (with built in Local DB v11), sir i need to use SQL Server Agent (for timed jobs) and cannot find that option in Local DB. Do i need to install SQL Server management studio 2014 for this purpose? If yes, i
-
Hi, I want to write a while loop to compare 2 variables: I tried the below options but no success. while [$i -le $ROWS] gives "unary operator expected" while [${i} -le ${ROWS}] same error while ["$i" -le "$ROWS"] gives "integer expression expected" I
-
Upgrading EBS 11.5.9 from 32-bit to 64-bit
my company is planning upgrade EBS 11.5.9 from 32-bit to 64-bit. I have found out in this forum mentioned 11i Apps tier cannot be upgrade to 64-bit. Can we upgrade our oracle database 9.2.0.3.0 from 32-bit to 64-bit? Which version of RHEL can support
-
IBM Blade HS23 Emulex Adapter Woes
I inherited an IBM Blade chassis with three HS23 blades in it, each sporting an Emulex 10GbE VFA Advanced II module. I have been tasked with adding three additional blades to the chassis with the same cards. I am having terrible trouble setting these