HT1212 my iphone is disabled and it says i need to connect to itunesbut it wont alow me to connect it
how do i connect my iphone to apple?
There's always a solution for a problem. So don't worry about what's going on withyour iOS device. Just follow these steps. I hope It will help you.
Setp - 1.
First of all, make sure that you're device have at least 50% battery. If not, charge your device properly to 50% or higher battery percentage then continue to step 2.
Download a latest version of your iPhone firmware from here:
http://www.idownloadblog.com/download/
Step - 2.
Connect your device to your computer and launch iTunes.
Step - 3.
Power off your device by pressing and holding power button.
Step - 4
Now get ready to put your device into recovery mode as following steps:
Hold down the sleep/power button and home button together for exactly 10 seconds, then release the power button
Continue to hold down the Home button until a message appears in iTunes telling you an iPhone in recover mode has been detected
When you are in DFU mode your iPhone screen will be completely black
Step - 5
Simply click 'OK' button on that message and click 'iPhone' on top-right corner of your iTunes window.
Step - 6
Now you can see 'Restore' button there. Just press and hold your computer's 'Shift' key and click the 'Restore" button and load your latest iOS firmware file.
Wait until the setup will finish. When the setup will complete, you're done.
Similar Messages
-
i just open plugged in into my computer and i press file>press device>press back up and restore,but i just cant press that backup and restore how?my cousin tell me my phone just like cannot plugged into the computer,pls help meeeeeee
There's always a solution for a problem. So don't worry about what's going on withyour iOS device. Just follow these steps. I hope It will help you.
Setp - 1.
First of all, make sure that you're device have at least 50% battery. If not, charge your device properly to 50% or higher battery percentage then continue to step 2.
Download a latest version of your iPhone firmware from here:
http://www.idownloadblog.com/download/
Step - 2.
Connect your device to your computer and launch iTunes.
Step - 3.
Power off your device by pressing and holding power button.
Step - 4
Now get ready to put your device into recovery mode as following steps:
Hold down the sleep/power button and home button together for exactly 10 seconds, then release the power button
Continue to hold down the Home button until a message appears in iTunes telling you an iPhone in recover mode has been detected
When you are in DFU mode your iPhone screen will be completely black
Step - 5
Simply click 'OK' button on that message and click 'iPhone' on top-right corner of your iTunes window.
Step - 6
Now you can see 'Restore' button there. Just press and hold your computer's 'Shift' key and click the 'Restore" button and load your latest iOS firmware file.
Wait until the setup will finish. When the setup will complete, you're done. -
My iphone is Disabled and says to connect to itunes, i did the whole restore thing but then an error pops up and says' sorry we cannot restore the iphone 'iphone'" ... What do i do?
Use recovery mode, you might need to do it a few times.
http://support.apple.com/kb/HT1808 -
HT1212 My iphone is disabled and I do not have access to computer. What do I do?
My iphone is disabled and I do not have access to a computer....what do I do?
One option if you have Find My iPhone turned on:
http://support.apple.com/kb/ht1212
"If you are using Find My iPhone, you can use Remote Wipe to restore your device. If you have been using iCloud to back up, you may be able to restore the most recent backup to reset the passcode."
This still requires access either to a computer or another iOS device. -
hi, i have a problems. my iphone is being disable after my daughter play with it and been entering all the wrong code. so my iphone is now disable and it say connect to itunes. i already plug my iphone to my computer, how ever my computer could not detact my devic. and because of that i cant connect it to my itunes. how do i deal with this problems?
iOS: Device not recognized in iTunes for Windows
-
i have disable my iphone 5 and now its say on my iphone that iphone is disabled connect to itunes and i have tried apple support on how to connect to itunes and it still doesnt work i need help a.s.a.p
Read the article you linked. It tells you how to put it in recover mode
-
When I turn my ipad on it says it is disabled and connect to ITUNES
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTune (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port. Do not release button until you see picture of iTune and plug (very important)
5. Release Home button.
ON COMPUTER
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. Select "Restore iPad"...
Note: Data will be lost -
HT1212 my iphone is disabled and i cant go into the itune
The iphone is disabled , can't connect to itune because the passcode can't be remembered. i needed immediate solution without erasing / deleting all the information in my handset
When you Restore/Recover your phone, all data will be deleted.
-
HT1766 my iphone is disaled and it says i have to connect to itunes how do i do that
my iphone is disabled how can i get it back up
You will need to use the cable that came with it to plug it into the USB port of a computer running a current version of iTunes.
http://support.apple.com/kb/HT1414 -
My phone is disabled for a long time and its not synced how can i change the passcode
You need to restore the device. It is the only way to disable the passcode. Your data is already lost unless you have synced this phone in the past. See this support document. http://support.apple.com/kb/ht1212
-
Find my iPhone is activated on my device. My device is locked. iTunes is prompting me to access my iPhone even though Im locked out of it to disable find my iphone before I can use the backup???
Can anyone help me with this?
Wonder if this has anything to do with iOS7 installation?iOS: Forgotten passcode or device disabled after entering wrong passcode
-
I forgot my passcode to my ipod, so it said ineeded to connect it to iTunes because it's disabled. So, i connected to itunes and it said "Ipod cannot be used because it's being locked with a passcode. Unlock passcode and try again". Well i dont know my passcode and its disabled so i can't do anyhting. Now what do i do??
Try connecting your iPod Touch to iTunes in recovery mode, allowing you to bypass the need to enter in the forgotten passcode. See this article for instructions on getting your iPod into recovery mode.
http://support.apple.com/kb/ht1808
B-rock -
Updated iphone 3gs and now says i need to connect to itunes.
I updated my iphone using itunes(first time ever). Now my phone says to connect to itunes. itunes said to restore. i tried this but there was an error. I can't use my phone at all. Thanks for any help!!!
what is the exact error you received including the number if there is one
-
HT2480 my ipod touch is locked and it says it need to connect to itunes so help me know!!!
help me unlock my ipod
Passcode Locked or Disabled
If nothing else will let you unlock the device - after so many unsuccessful attempts will be locked out - You have to restore the device within iTunes. You want to use the same computer that you always sync with so that you can restore your app data and settings. You can restore with any other computer, but you will lose everything on the Device.
Instructions can be found here.
http://support.apple.com/kb/ht1808 -
My ipad is disabled and it says i need to connect to itunes when i connect it to itunes, it says it wont recognize it until i put my passcode into my ipad, but with my ipad disabled, this is immposible, how can i resolve this problem?
You may need to put the iPad into recovery mode : http://support.apple.com/kb/ht1808 - you should then be able to reset the iPad an resync your content to it
Maybe you are looking for
-
Format ICML text placed in InDesign
Is it possible to format the text of ICMLs placed in an InDesign doc? (see below)
-
Panasonic Lumix LX3, shooting RAW with Film Modes
I've been shooting RAW+JPEG and testing Film Modes (for example B&W) and noticed that RAW images will import "tabula rasa" without any of the Film Mode settings applied. JPEGs are naturally as supposed. I'm wondering if this is how it's supposed to w
-
Cannot do Certifying signature inside an AIC app displaying Acrobat
I have a Windows VB.Net application that displays a PDF file in an embedded Acrobat Control. The PDF has several signature fields with the top one set to do a Certifying signature. This configuration is done using JavaScript earlier in the workflow t
-
How to change my podcast info, description etc..?
hello, I was wondering how i change my description in my podcast once it has been submitted to apple? also It says Unknown on there under the title, how can i change that? what is supposed to be there? the podcast is located here: http://phobos.apple
-
Dear All, Just a general query (I have tried looking for a solution on the forums to avoid repitition as one user informed me in the past...) I am using captivate to build an e-learning module for a project and I would like to insert a flash movie on