HT1349 Phone will not power off or take picture

My iPhone will not power off.

Try to reset it: hold the on/off and home buttons until you see the Apple logo (ignoring the off slider that appears first), then release.  If it won't reset just let the battery run down until it turns off, then recharge it.

Similar Messages

  • Phone will not power off

    Phone does not power off. It only does in safe mode. Once in safe mode still can not normally power off but only on safe mode.
    Any advise?
    Thanks
    T

    And ticked the enable quick boot mode. Deactivated and now is fine.
    Sorry and thansk

  • 4s phone will not power off

    i need help

    Your question is a bit vague. If the iPhone is shutting down but then turning right back on. The fix can be to clean the iPhone charging port with a clean dry toothbrush. See if fixed. If still problem, and there is Warranty or AppleCare make Genius reservation and take to Apple for resolution. If no coverage, then clean the iPhone charging port again with the toothbrush and small amount of Isopropyll Alcohol. If still problem, some users have been able to turn it OFF, by connecting just the USB cable and then turning it OFF.

  • Updated to 4.5, Phone will not power on

    I just upgraded to 4.5 software for my blackberry 8110 (AT&T), and my phone will not power on... Nor will it connect to Desktop manager.... nor will it do anything.
    I've done a battery pull, I've attempted re-installing 4.5, I've attempted restoring to previous status using my recent backup file, and nothing works. Any advice...?

    You've tried every possible alternatives. Nothing to suggest!!!
    If you can  warranty then take to your operator and ask for replacement/repaid otherwise...
    tanzim                                                                                  
    If your query is resolved then please click on “Accept as Solution”
    Click on the LIKE on the bottom right if the post deserves credit

  • IPhone Will Not Power Off or Go Into Silent Mode

    Yesterday I discovered that I had my phone switch flipped to Silent Mode, and my phone was still making the General Sounds and Still Ringing. No matter what I do I can't get it to Vibrate instead of ring.
    Also it will not power off, no matter how long I hold the button nothing happens, it wont even lock. I tried performing a hard rest by holding the Home Key & Power Button, but instead of reseting the Voice Control pops up and my iPod starts playing.
    Any Help Is Greatly Appreciated ♥

    - Try another cable.
    - Try on another computer
    - Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
    - Make an appointment at the Genius Bar of an Apple store.
      Apple Retail Store - Genius Bar

  • My iPhone will not power off. It automatically turns back on after trying to shut it off. Any Ideas?

    My iPhone 5 will not power off. I hold the power button down and it lets me turn it off but then it automatically turns back on. It is as if I am just restarting it. Any ideas on how to fix it? I already had it exchanged and the replacement is now doing it.

    I had this same problem about a year ago. It is most likely because debris has been caught in the cable connector. Get a cotton bud or something soft so that you don't cause any damage, and gently clean the inside of the dock connector of your phone. Do not use any liquids. Hope this helps.

  • Phone will not power down?

    Phone will not power down?

    I lost my slide to power down after updating. Now I got to hold the buttons longer than normal and it just shuts off.. Not to mention lost my iMessage & FT(activation pending) problems. Hope theres some fixes soon

  • HT4528 The flash on my phone will not turn off. How do i manually turn it off?

    The flash on my phone will not turn off and is draining the battery. I've already tried turning the flash off in camera mode and resetting the phone to factory settings. Neither worked.

    Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new).  Try each of these in order until the issue is resolved.
    If these steps do not resolve the issue, take it to Apple for evaluation and possible replacement.

  • HT201401 4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out l

    4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out loud.

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
    Be sure to make an appointment first...

  • HT201401 My home button does not respond and the phone will not shut off

    Has anyone had a similar problem where the phone will not shut off and the home button does not respond

    You should try taking it to the Apple Store and asking for a replacement.
    Or you could enable Assistive Touch from Settings>General>Accessibility.

  • HT6147 i need help, i did the update on my iphone 5s and now the phone will not power on?

    hey, i need some help with my iphone 5s, i did the update ios 7.0.6 and now my phone will not power on?? can someone please help me!

    Hello ABrosz
    If you are not able to get your iPhone to power on, try to reset it by holding the Sleep/wake button and Home button at the same time for about 10 seconds and see if it turns on. Check out the articles below to troubleshoot your iPhone further.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/ts3281
    If you can't update or restore your iOS device
    http://support.apple.com/kb/HT1808
    Regards,
    -Norm G.

  • My iphone will not power off

    My Iphone 4s will not power off and the battery is draining with a couple of hours ? Help please

    Try an iPhone reset first which is done by pressing and holding the home button and the sleep/wake or on/off button simultaneously until you see the Apple logo and then release. This is similar to a computer restart.
    Try powering the iPhone off again after doing so.

  • IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software is up to date with 6.1.6.  PLEASE  HELP!

    version 6.1.6(10B500); model#MC547LL/A; 60GB (40 used/20 avail)
    IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software states up to date with iOS 6.1.6.  PLEASE  HELP!

    Try:
    - Reset the iOS device. Nothing will be lost      
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes      
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar

  • My iPad will not power off

    I have a 32GB iPad 1st Gen. It sits with a pinwheel rotating, but will not power off. When I tried connecting it to iTunes, it says there is an unknown problem connecting this iPad. What Can I do?

    I'm sure you've tried the hard reset using the home and power button?  If that won't work, next check your cables.  If you own a iPod, or iPhone and have mixed up the sync cables, that can sometimes cause an issue depending on how old they are.  If that doesn't work, I'd try a different computer with iTunes on it, if you have it, or a buddy to see if it recognized then.
    Let us know how it goes.

  • My iPad will not power off. Buttons won't work

    My iPad will not power off. Buttons won't work

    Hi Try a Reboot press & hold power button & menu button hold both down until you see Apple Logo Try this with ipad conected to charger. Cheers Brian

Maybe you are looking for

  • Conflicts with Lulu

    With the original release of 'Pages', there is a known conflict with www.lulu.com ( a book publishing site). Apparently .pdf files created from within 'Pages' do not embed Fonts correctly and a 'work around' is published at http://www.anvilwerks.com/

  • Logon in Visual Studio Fails Only with NW 2004s

    Hi, Initially, I was working on a function to retrieve Performance-Log-History Data form a C# Application, using the .net-Connector and MS Visual Studio 2003. I got a "XML-Type Conversion" Problem, and found some entries in the SDN, that brought me t

  • Image edges bleeding to next page when exporting

    Wondering if anyone can help me? I've created a newsletter in Indesign and have placed images and coloured boxes to the edges of some of my pages. But when I export the newsletter to PDF the image edges are showing up on the adjacent page (even thoug

  • Express making no difference..am i doing something wrong?!

    Ok, I've finally managed to get a 'green light' situation on my new airport express. I bought it in order to extend my wireless network to an upstairs room. The base router i am currently using is a Netgear WGT624. I configured the AE as a client and

  • Class loading from JavaTasks, ScheduleTask, ThirdParty, etc...

    Does anyone know why it is that if I copy a JAR into JavaTasks, ScheduleTask, ThirdPary, or ext on my development cluster, it is automatically loaded by OIM, but if I try the same in my QA cluster, I must explicitly add the JAR to my classpath? Thank