HT1363 iPod Classic and Disk Mode

I have a 5th generation iPod and I can't seem to get it to into disk mode. I've tried to complete the mentioned process on a flat surface and still no luck. I have a lot on my device and I'd love to be using it. Any ideas would be appreciated. Thank you!

Did you see the Apple logo, after 6 secs?
When you put it in Disk Mode, you are using it as a Portable Hardisk, so I can't get what you meant by this statement,
      I have a lot on my device and I'd love to be using it.
In Diskmode, you cant play music or watch video or Podcast
Before placing the iPod into Disk Mode, verify that it is charged.
Toggle the Hold switch on and off (set it to Hold, then turn it off again.)
Press and hold the Menu and Select buttons for at least six seconds, until the Apple logo appears.
When the Apple logo appears, release the Menu and Select buttons and immediately press and hold the Select and the Play/Pause buttons until the Disk Mode screen appears.
Connect the iPod to your computer; the screen on the iPod will should say "Do not disconnect".

Similar Messages

  • TS1372 I have iPod Classic in Disk Mode and when i connect it to my apple computer it does not appear in iTunes and the screen displays a message saying "Do not disconnect" with a circle with a line through it, flashing. What do I do now?

    I have iPod Classic in Disk Mode and what do I do next cause it's not showing up in iTunes?

    Does the iPod appear on your desktop as an external hard drive?  Has the iPod ever successfully connected before?  Disconnect your iPod and reset it using the Select (Center) and Menu button combo.  Then reboot your Mac, open iTunes, and reconnect your iPod to a high powered USB 2.0 port and see if it's recognized.
    Have you worked through all the troubleshooting here?
    iPod not recognized in iTunes and Mac desktop
    B-rock

  • HT1378 i am unable to put my ipod classic into disk mode. what do i do to reset/restore it?

    i am unable to put my ipod classic into disk mode. what do i do to get the red x tto go away and restore my ipod?

    imlockedoutofmyiphone wrote:
    I have looked at multiple websites; they all have the same instructions for putting your IPhone into recovery mode using ITunes.
    My computer was not downloading ITunes before, but I recently made it work. I turned my phone off, held the home button, plugged in the phone to the computer with ITunes already up. The little USB cord and ITunes logo showed up. The instructions said that a popup would say that ITunes had 'detected and IPhone in recovery mode', and from there I would be able to reset my phone. However, the popup never happens. I have tried this several times, and it's the same: I see the USB cable and ITunes logo on my phone screen, and in the corner of ITunes, a picture comes up of a phone with a little 'X' next to it. I clicked on the phone, on the X, but nothing works. The popup just never shows. I am unable to reset my IPhone because of it. I have not found any other way for me to reset my phone, since I didn't activate Find My Phone or ICloud.
    There is no icloud on an iphone 3, because you need IOS 5.0 or higher, the highest IOS is 4.2.1

  • Ipod Classic in disk mode does not show on desktop or finder

    Ipod Classic in disk mode shows in Itunes but not on desktop or in finder? Can't add any files to it.

    With the Finder as the front most application, choose Finder -> Preferences -> General and make sure there is a tick mark next to CDs, DVDs, and iPods, under the option Show these items on the desktop.
    Any luck there?
    B-rock

  • ITunes won't recognize my iPod classic in disk mode.

    I have a iPod classic that has the sad face. I read all the articles, and videos that show how to fix it, and all of them show that you need to force it into disk mode and plug it into your computer and restore it with iTunes. I can get it into disk mode fine, but when I plug it into my computer iTunes won't recognize it.
    Do you have any suggestions?
    Thanks for your help.

    Is there any way to hard restore it, with out hooking it up to the computer.

  • HT4235 Itunes only sees ipod nano in disk mode and still won't sync it

    I have to place my ipod nano in disk mode for itunes (or Windows for that matter) to find it. In disk mode Windows and Itunes see the ipod and it passes all the diagnostic tests save for the sync test where it can no longer see the ipod and apparently a file is also not found. I'm ready to just reset it, but am unable to make that happen.
    This problem began when I downloaded some songs from Amazon and fumbled the job purchasing and downloading some of them twice. Not very smart, but it was late. Anyway, I also downloaded their Cloud player and had it pass the songs to itunes. It was in itunes that I saw the duplicate copies of the songs. Itunes and the cloud player proceeded to butt heads, I deleted the the extra song copies and also uninstalled the Amazon cloud player. Then itunes went into the state I've described above.
    I'd appreciate any help.

    Hi GChild6,
    If your iPod is being recognized as a disk, you may find the following article helpful:
    iPod: Appears in Windows but not in iTunes
    http://support.apple.com/kb/TS1363
    Regards,
    - Brenden

  • HT1363 how to put ipod touch into disk mode

    Hello,
    Does anyone know how to put an ipod touch in disk mode? I don't have the box in itunes to enable disk use!
    Thanks,
    Don

    This article doesn't mention it being possible with a Touch.
    Using your iPod as a storage drive - http://support.apple.com/kb/ht1478

  • How to make itunes recognize ipod when in disk mode

    my ipod classic was in a reboot loop and after reading up about it i put my ipod into disk mode and connected it to my pc to restore it to factory settings. However when i connected it itunes hasnt recognized it despite it appearing in my computor folder. i'm really stuck for ideas so any help at all would be very much appreciated

    I have the same problem, but my ipod stays in disk mode all the time. Won't show in iTunes.tried Apples suggestion to restore in disk utility, but no dice! I have tried everything and now I will give up, maybe it's too old?

  • IPod Classic and the new software upgrade

    I've had my 80GB iPod Classic since December. I loaded it up with all my music and hadn't plugged it back into my computer until a couple days ago. I got a notice to update my iPod software so I did and it came back that it couldn't because there was an unknown error. Not only that but after I ejected it from there I wasn't able to restore it automatically) all my music was gone. A couple days have past since then and I've not gotten around to restoring it, which it suggested. It told me it would be reappear in the iTunes window when it was done. Since then it hasn't shown up and I've been prompted twice to restore. Has anyone else had this problem?? Can someone help me out?? It's now nothing but a blackish-grey screen with the apple icon. It's not even registering on my computer......

    I've tried all afternoon to get it fixed and I think I finally found the answer. To all of those 80GB iPod owners having problems with the reset please try this, it worked for me!
    iPod Classic keeps Continuously resetting at Apple Logo
    Posted: Mar 6, 2008 1:45 PM Reply Email
    Okay, I have sent in my iPod Classic, and let me just say its AWESOME! Okay first I found that other people were having a problem with the NEWEST iPod Continuously resetting at Apple Logo. There is a 10 step process in getting the help you need, follow these instructions:
    *I got these from Jimmy_Dean, thanks bud...*
    10 Simple Steps To Fix Your iPod That Is Stuck In A Continuous Reset Loop:
    1) While the iPod was resetting itself over and over (continuously resetting itself), press the Play/Pause button and the center select button simultaneously, for about 5 seconds, and it will display that it is now in disk mode.
    2) Start up iTunes on your computer and then connect the iPod to your computer with the USB cable.
    3) Click on the iPod in the left pane, select "Restore" to restore it to its original blank state. Follow the prompts to continue.
    4) When the computer completes the Restore update, and it displays a message saying that the iPod will disappear and reappear in iTunes in a minute, immediately disconnect the iPod (unplug it from your USB cable).
    5) On the iPod, you should see the main menu, in a few seconds. Pick a couple of settings to update for example the English language, and Eastern Time Zone (New York or Washington, DC), etc.
    6) Press and hold the Play/Pause button to power the iPod off.
    7) Re-connect the iPod to your comptuer with the USB cable.
    8) Start syncing using iTunes, as normal.
    9) All should be well.
    10) Remember to always click on Eject in iTunes, and waiting for visual confirmation, before disconnecting the iPod.
    If these do not work, please go to:
    https://selfsolve.apple.com/GetWarranty.do
    This site brings you to a step by step process in getting your iPod fixed. Its very hands on, and the day I requested a repair or a replacement, they sent me a box. I got it in less that 1 day! Mind you that was the 4th of March when I requested the box. I got it the 5th of March, and I sent it in that same day with NO CHARGE! Apple pays for it if you have the warranty, if your iPod is in the first 180 days of purchase (they can tell), everything is free unless its obvious that you dropped it or something like that. Anyways, I got an email toay (March 6th), that says that they have recieved the product and are diagnosing it. Thats really fast, mind you! Well, I am now waiting for that, and then they will let me know if they can fix it or have to replace it. In that case, I will NOT BE CHARGE A PENNY for the services, they told me the process is really fast and I will get my iPod back in a few weeks at most.
    So a total of 2 weeks for everything at most FOR FREE, thats a deal!
    I live in a city that DOESNT have an Apple store in it (Colorado Springs, Colorado) and I am on tour ALL the time with bands, and I am just lucky everything is coming together fast and smooth!
    If your city has an Apple store, you can check here:
    http://www.apple.com/retail/
    You can bring it to them and they will tell you if they have to replace it or fix it, if you can get a NEW iPod for free TAKE IT there and then. You will save time and effort!
    Let me know how this helped on this blog!!!
    Thanks everyone,
    Matt (Zero)
    -Rise Records
    -Victory Records
    -Strike First Records
    -Pluto Records

  • What problems or issues do i have if even after all the steps i took to fix my problem with the ipod classic and even after i restore it it fails to be recognized by itunes

    even after i restore my ipod it fails to be recognized on my itunes and doenst allow me to format it. been through all the trouble shooting steps and disk mode an still wont work properly plz help someone

    I need my phone not only because it it my alarm clock in the morning, but because i use it excessively at work. PLEASE HELP !

  • How to restore ipod via itunes while ipod is in disk mode?

    I am trying to restore my ipod via itunes. My ipod is corrupted and I can only connect it to the computer while the ipod is in disk mode. After ipod is connected and in disk mode, the first stage of restore via itunes begins, the bar appears, fills up and then disappears. Then my ipod seems to disconnect from the computer and begin an infinite reset loop algorithm. How do I successfully restore my ipod while it is in disk mode?

    I have the same problem, but my ipod stays in disk mode all the time. Won't show in iTunes.tried Apples suggestion to restore in disk utility, but no dice! I have tried everything and now I will give up, maybe it's too old?

  • I have restored my iPod classic and everything has been wiped off, now when I connect it to the laptop, iTunes doesn't recognise it and windows won't format it, an error message comes up "unable to format"

    I have restored my iPod classic and everything has been wiped off, now when I connect it to the laptop, iTunes doesn't recognise it and windows won't format it, an error message comes up "unable to format". Can someone please help me sort this problem, it's so frustrating!!!!!!

    It could be an indication or a damaged or dying hard drive.  I would recommend doing a disk diagnostic on the iPod's HD using the instructions given by turingtest2 in this older thread.  He also covers what the resulting numbers indicate.
    https://discussions.apple.com/thread/3784647?start=0&tstart=0
    B-rock

  • I have the old ipod classic and cant drag or drop/update music on the new itunes?

    I have the old iPod classic and cant drag or drop/update music on the new iTunes?

    Try using this program to place the iPod in recovery mode
    RecBoot: Easy Way to Put iPhone into Recovery Mode
    You can also try:
    The Firmware Umbrella - TinyUmbrella

  • I just see ok to disconnect and disk mode ?

    i just see ok to disconnect and disk mode in my newipod nano how can i make it start???

    I have this on mine after I charge the battery, which takes putting it into disk mod as I explained in the other thread "Itunes doesn't recognize my ipod"
    I have to reset and it works. It can't be good to be constantly doing this though, I would assume.
    I'm really getting ticked at these problems since the upgrade. There are 4 nanos in my house, all bought since Christmas, and I don't think we'll ever be buying another unless apple gets it's act together.

  • I have a ipod classic and my itunes will not download songs I have brought help

    I have a ipod classic and my itunes will not download songs I have brought help

    Are you sure the error message/prompt isn't referring to the amount of disk space available on your PC's internal hard drive?  If you head to Start -> My Computer.  How much space is free on your C: drive?
    Maybe it would help if you could post a small screen shot of the error.
    B-rock

Maybe you are looking for

  • Question related to dynami calc

    Hi all, I have a question related to dynamic calc members, I read in the dbag saying , it is not possible to add more than 100 members as a children under a dynamic calc member...is it right even with 9 and 11 versions.. What are the options we have

  • IDOC_OUTBOUND_WRITE_TO_DB

    Hi, Could any one give me idea regarding the following function module? Why these are used in IDOC and how to use them? If any one could please forward me sample coding using these function module. CRM_UPLOAD_BTMBDOC_FILL CMS_UPLOAD_BTMBDOC_START_FLO

  • Photoshop Elements 11 and tags

    I have a new laptop running windows 7 and have transferred my photos from my old computer running Elements 4 where I used the tags extensively. I have purchased Elements 11 for the new laptop. My research suggests that when upgrading to a newer Eleme

  • I cant see facebook notifications in the notifications bar on mountain lion?

    i cant see facebook notifications in the notifications bar on mountain lion?

  • Passing arguments to overidden messages

    Hi. Is it possible to override a default message and then pass dynamic data to be displayed in the custom message? I know this is possible with Struts tags, but I have not been able to do this with a JSF tag. For example, if I have the following JSF