HT1414 apple ipad will not turn on

I have held the sleep/wake button down for a long time to do a reset.  It doesn't work either.

You need to hold both the power button and the home button together until you see the apple then let go.

Similar Messages

  • HT1414 My ipad will not turn on or take a charge

    My ipad will not turn on or take a charge

    Try:                           
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • HT1414 My iPad will not turn on

    I am having a problem turning my iPad on

    I did that and it did not work  It is charged.  I am a new owner of an iPad.  I am afraid maybe I am just being stupid.  I have been moving buttons, which way should the little button next to the volume be when it is on.  Should the orange dot show?

  • HT201412 my Ipad will not turn on to charge, the apple symbol appears then it blank out

    Ipad will not turn on to charge

    Try a reset:
    Hold the Sleep and Home button down (approximately 10 seconds) until you see the Apple logo.
    Note: Data will not be affected.

  • My IPad will not turn on, despite charging all night and all day. The Apple pops up then goes away. What is wrong and how can I fix it?

    My IPad will not turn on despite charging all night and all day.  The Apple pops on but then shuts off again.  It does this over and over. How can I fix this and get it up and running again?

    Hey bellabeanbag,
    Thanks for the question. The following resource outlines troubleshooting steps if your iPad is not responding:
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    If iPad won't turn on, or the display stops responding
    Follow these steps, testing after each:
    1. Turn the iPad off and turn it on again. Press and hold the Sleep/Wake button on top of iPad for a few seconds, until a red slider appears. Then slide the slider. Then press and hold the Sleep/Wake button until the Apple logo appears.
    2. Reset iPad. Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears.
    If iPad still won't respond after you restore it
    Follow these steps, testing after each:
    1. If you receive an alert in iTunes while restoring your iPad, refer to this article for instructions on how to resolve common issues with updating and restoring.
    2. If you cannot restore your iPad in iTunes, or if iTunes does not recognize the device, refer to this article for instructions on restoring using recovery mode.
    Thanks,
    Matt M.

  • My iPad will not turn on but the apple sign keeps popping on and off.

    My iPad will not turn on and when I connect it to itunes a error message 0xE8000024. What do i do?

    Hello Summer,
    Welcome to the Apple Support Communities. If you are seeing the Apple logo continuously, then the next step is the following article.
    iOS: Unable to update or restore
    http://support.apple.com/kb/HT1808
    Regards,
    -Norm G.

  • HT201210 ipad will not turn on??????????

    ipad will not turn on? only black screen with apple symbol

    Connect to iTunes on the computer you usually Sync with and “ Restore “...
    http://support.apple.com/kb/HT1414
    If necessary Place the Device into Recovery mode...
    http://support.apple.com/kb/HT1808

  • My iPad will not turn on at all any suggestions?

    My iPad will not turn on at all, any suggestions??

    Try this  - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased. http://support.apple.com/kb/ht1430
    Frozen or unresponsive iPad
    Resolve these most common issues:
        •    Display remains black or blank
        •    Touch screen not responding
        •    Application unexpectedly closes or freezes
    http://www.apple.com/support/ipad/assistant/ipad/
    iPad Frozen, not responding, how to fix
    http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    Black or Blank Screen on iPad or iPhone
    http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • When tryed to run diagnostic test  windows blacked out then blue screen ipad will not turn on now

    when I ran a diaganostic test windows blacked out and then the "blue screen of death"........and now my ipad will not turn on ......has anyone had this problem ?...if so...what now

    Have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds, after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.

  • Ipad will not turn on when you slide to unlock

    ipad will not turn on when you slide to unlock

    Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.

  • All of a sudden my ipad will not turn on. Even on charger, no go.

    All of a sudden my ipad will not turn on. Even on the charger, no go.
    I will probably go to the Genius bar tomorrow, just thought I'd see if anyone else had a similar problem
    Thanks

    Hold power and home until apple logo appears.
    And make sure the outlet is good.
    Or try the first but by plugging it in.

  • My 1st generation iPad will not turn off and I have performed the suggested fix. What's next?

    My iPad will not turn off. I have done the off/sleep key home button procedure.

    Just to be perfectly clear, when you reset the iPad by hod,ing down on the sleep and home buttons at the same time for about 10 seconds until the Apple logo appears on the screen, that is a way of resetting the system and restrating the device. If you want to shut down, you still have to hold down on the power button until the slider appears and then slide to the right to shut the iPad off.
    IS this what you are doing and if so what happens when you try to shut down? Describe what happens in detail.

  • My iPad will not turn on. I have tried to reset, with no results. I have also tried to restore from iTunes, but it could not recognize the iPad.

    My third gen iPad will not turn on.
    I tried to reset, and the apple icon appears, but it will not load.
    I attempted to restore it through iTunes, but it could not recognize it.
    Any suggestions would be appreciated. Of course, it is out of warranty.

    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • HT1766 My Ipad will not turn on

    My Ipad will not turn on.
    I am getting a blank screen.
    I tried charging with two different chargers. No luck. Any advise

    Try reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • HT4623 How come my Ipad will not turn on????

    How come my ipad will not turn on for no reason i couldn't turn it back on?

    It could be the battery has completely drained. Plug the iPad in the charger that came with it and plug that into a good wall outlet. Wait one hour. It may take that long for the iPad to respond. Then reset your device. Press and hold the Home and Sleep buttons simultaneously until the Apple logo appears. Let go of the buttons and let the device restart.
    If the iPad restarts let it continue to charge until the battery is at 100%.
    If it does not restart you might have experienced some sort of hardware failure. Make an appointment at an Apple Store to have your device examined by a technician. Or contact Apple Support.

Maybe you are looking for

  • Error loading operating system- windows xp/windows me

    Hi, So, I have a Hp Pavillion 9715 desktop with windows xp professional and basically yesterday I turned on my computer and all it would do would go to the black screen saying "error loading operating system" Now I'm not really sure what tp do I was

  • Cannot find SOA Suite 11.1.1.2

    I download SOA suite 11.1.1.2 (ofm_soa_generic_11.1.1.2.0_disk1_1of1.zip), weblogic 10.3.2, and RCU 11.1.1.2. Then, I install them. However during SOA configuration, in the step of Generate a domain configured automatically to support the following p

  • SQL Developer Problem: Connect Database Windows Wont Show

    Hi, I have Windows Vista Home Basic and I have installed Oracle XE 10g which works great. However, I need to install SQL Developer too but it wont work. I think it may be a compatibility issue, or else some problem with Java. The thing is that no mat

  • Solaris 8 x86 installation runs out of space

    I am installing Solaris 8 x86 on to a Dell PowerEdge Server with a 9.1 SCSI drive. Utilizing the Solaris installation process and choosing "Entire Solaris Software Group" the process completes successfully. When signed on as root and installing softw

  • Labview controlling Matlab

    I'm trying to get Labview 8.6 to programatically launch and run MATLAB 7.5.0.  We have routines currently written in MATLAB that interface with a third party's software to download data from some proprietary equipment.  Is there an ActiveX example or