HT1414 cannot get phone signal

Cannot get phone sinal?

Make sure you put a valid sim card into the phone firstly and if you have, take it out and put it in again.
Other than that you need to contact your carrier regarding phone signals - a signal is the province of the carrier and nobody else.
Contact your carrier.

Similar Messages

  • I cannot get phone signal when abroad

    I have an iPhone 4S and cannot get a signal when out of my home country. Is there a solution for this by changing the phone settings?

    Did you enable international use with your carrier before you left? If you did, check Settings>General>Network and make sure that Roaming is turned on.

  • 5130 cannot get phone connection, using as modem

    Recently purchased 5130 to use as modem for my laptop.  Am using sim card from primary phone to access internet (primary phone has internet service), and connection with USB cable.  Downloaded PC suite, have Vista OS.  Have set specs to phone and internet provider (AT&T) but cannot get connection.  Error display says cannot get phone connection.  Phone works in phone mode, although cannot see contacts.
    ( I have a new bluetooth USB adaptor, but do not want to open package if I can get cable to work.  No point in opening blue tooth yet as cannot even get phone connection.)
    Any advice? 

    Hello, dthurnherr.
    Thank you for visiting Apple Support Communities.
    Here are a couple troubleshooting articles that I would recommend going through when experiencing this issue.
    FaceTime for Mac: Troubleshooting FaceTime
    http://support.apple.com/kb/ts4185
    Unable to make or receive FaceTime calls after April 16, 2014
    http://support.apple.com/kb/TS5419
    Cheers,
    Jason H.

  • Getting phone signal into Logic via M-Audio

    To record phone calls on my land line, I got a Radio Shack Recording Control (43-228A), plugged it up, and set it to "Record." I plugged the 3.5mm plug into an adapter for 1/4 inch plug, which went into Input 1 on my M-Audio Fast Track Pro, from which point everything else is set as usual going into my Mac's FW. I made sure I had Input 1 selected, went to record as I spoke on a test call, and -- nothing but a hummmmmm. Just to be sure, I switched from line to mic input, and that didn't affect the hum.
    Does anyone know of what details I may have overlooked here to get the phone signal into Logic? FWIW, I also tried with the chintzy little $8 suction-cup on the handset, since it also has a 3.5mm plug. Not even any hum.
    I checked the usual suspects of "DUH" carelessness within Logic itself: making sure I matched the input to the M-Audio (tried both 1 and 2 anyhow), level up high, etc.
    Also, would anyone recommend other procedures for telephone recording? I'd rather stick with land lines instead of Skype or iChat, since not everyone I'll be calling to interview will have those. Suggestions?
    Thanks,
    c

    are the xp80 audio outputs wired into UL audio inputs?

  • TS3682 After updating cannot get phone to turn on. On screen it's has a pic to plug in to iTunes

    After updating iPhone via iTunes I cannot get the phone to turn on. Black screen with pic telling me to connect to iTunes

    Something went wrong with your update; you are in Recovery Mode.
    Follow step 1 to 6 closely to recover your iPad.
    http://support.apple.com/kb/HT1808
    Note: You may have to repeat the above a few times

  • Cannot get phone to recieve calls

    My husband accidentally erased his iphone on the "find my iphone" app and now he cannot get his phone to recieve calls or texts. He cannot get into the home page. It seems to be locked somehow....HELP

    The phone will have to be restored via iTunes, since it was erased.

  • HT4126 I CONNECTED MY MACBOOK TO THE TV USING AN ADAPTOR, BUT I STILL CANNOT GET ANY SIGNAL

    I CONNECTED MY MACBOOK TO THE TV USING AN ADAPTOR, BUT I STILL DO NOT GET A SIGNAL, WHAT SHOULD I DO?

    I just corrected my problem.  After connecting to the TV, go to System Preferences, Sound, and select the HDMI rather than Internal Speakers.

  • HT4061 i updated iphone 4 with the software update ios7. i cannot get phone to restore i am stuck with a black screen or a screen with the apple ico that disapears and then the icon of itunes and the usb icon.  Itunes is not picking up my phone to even re

    cannot restore phone since update.  I tried to upload to itunes but itunes isnt picking it up. Phone is frozen with Itunes icon and the usb cord.  I tried some suggestions posted but it is still not restoring does anyone know how this can be fixed???
    Thanks

    Hello reneywacky,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iOS: Unable to update or restore
    http://support.apple.com/kb/HT1808
    Connect your USB cable to your computer but not to the iPhone, iPad, or iPod touch until step 3.
    Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
    While pressing and holding the Home button down, connect the USB cable to the iPhone, iPad, or iPod touch. The device should turn on.
    Continue holding the Home button until you see the Connect to iTunes screen. When this screen appears, you can release the Home button:
    Note: If the image of a battery appears, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again. If you don't see the Connect to iTunes screen, try these steps 1 through 4 again.
    iTunes should automatically open and display the following message:
    "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes."Note: If iTunes not open after two minutes, please open iTunes yourself.
    Use iTunes to restore the device.
    Best of luck,
    Mario

  • My iPhone 4 was disconnected during ios 5 update - now i have error -50 showing and cannot get phone back on. Help!

    during IOS5 update my phone was disconnected from itunes. i reconnected it and continued the update by clicking 'continue restore'. Itunes is now saying the the phone is updated to version 5 and appears to have fully synced. however, when i turned the phone back on i have the set-up screen and when i select to restore the phone through itunes i get a message with options to 'continue restore' or 'delete backup'. when i select 'continue restore' itunes then gives me an 'error -50' message and just syncs the phone but nothing seems to happen - the phone does not do anything. 
    Should i delete the back up and start over, or will that delete all my contacts?
    Any help is much appreciated!

    Everything is Sorted!
    The release of iTunes 11.0.2 and iOS 6.1.2 for my iPhone 4, seems to have sorted everything. I can now sync music, films and photos between my MacBook and my phone.
    I was dubious about blindly doing the updates but decided they couldn't really mess up any further functionality so I went for it and it's sorted now.
    Look in to, and take the gamble, it's up to you.

  • TS5458 I cannot get phone calls on Mac to work

    I have a 2010 mac mini and an iPhone 5s. both are on the latest softwares. when a call comes in, my Mac will alert me as it should in Yosemite. But if fails when i try to answer. i also get a failure when i try to make a call from my Mac. i have
    restarted both the mac an iPhone
    made sure bother using the same FaceTime and iCloud
    turned off handoff and reenabled it
    turned off and reenabled FaceTime cellular calling
    so far nothing. the only thing that works as advertised is SMS on Mac from my iPhone
    please help.

    I have the top-of-the line 2013 MBP w/Retina that I just updated to Yosemite. I also have an iPhone 6+ 128Gb. They won't "handoff" and won't channel phone calls to my MBP like talked about.
    I've tried everything I can think of in the changing of the settings but there doesn't seem to be any published list of setting requirements anywhere. It's all been SWAGs.
    The two won't even pair over bluetooth.

  • Cannot get phone upgrade status

    Everytime I try to get upgrade status of my phones online I get a page that says this service is not available at this time. This has been going on for over a month. Can anyone help?

    RANDERSO2 & HelloKitty
    As Leiko27 posted, you can dial #UPG to check your upgrade date. 
    As for trying to verify it via My Verizon online, have you tried to access the page from a different computer? Did it give the same response? Do you have problems accessing any other links/pages on our site?
    If so, please PM me and I would be happy to get some details from you in order to get the online portion working for you. 

  • Installing new modem and I cannot get phone line to stop flashing

    I followed instructions and the power, online and wifi are not flashing. The telephone line is still flashing and I have no internet

    Did you get it provisioned (activated) for both internet and phone service (if you have it) ?

  • Cannot get phone unlocked after successful unlock request from Apple

    I continually get "The SIM card inserted in this iPhone does not appear to be supported" after successfully restoring an unlocked iphone4 (even after a restore from recovery mode) Is there any advice out there please?

    You use the O2 card to do the unlock.
    You only change the SIM card after you get to the Congads..........message.
    This is the Process in full.
    The process is contact your network supplier .
    Ask IF they offer unlocking.
    IF yes request the unlock and pay any fees requested.
    Your network supplier then contacts Apple to request the White listing (Unlocking) of your phone on the iTunes servers.
    Apple do this -It takes anything from 3 days to several weeks to complete.
    On completion Apple confirms this back to your Network supplier (NOT YOU)
    Your network supplier contacts you via email or SMS inviting you to connect your iPhone with your computer via the supplied USB cable and launch iTunes and follow on screen prompts through to the "Congratulations your iPhone is now unlocked" screen.
    All these steps need to be carried out with the ORIGINAL SIM and by REGISTERED account holder used when setting up the phone.
    Once the Congats...... screen has been reached you can swap out the REGISTERED SIM and replace with a compatable SIM on another network.
    CAVEATS
    Only the original SIM and Account holder can initiate an unlock- If you bought the phone used/second hand you CAN NOT UNLOCK through official routes
    Once unlocked use of a Mobile Virtual Network SIM may result in difficulties sending SMS messages.
    You may have to go into Setting /Network/Cellular/Cellular Data Network and enter the correct settings manually.
    Further caveat Cellular Data Network menu is SIM card dependant if its not supported you CAN NOT change the settings manually then you may need to contact the SIM card company - They can send a setup SMS if they support this process.
    Sorry for the lecture.
    PRESEE -
    ONLY REGISTERED ACCOUNT HOLDER AND SIM CARD CAN BE USED TO UNLOCK THROUGH OFFICAL ROUTES
    ANYONE SELLING THEIR IPHONE SHOULD UNLOCK THE DEVICE BEFORE SELLING ON

  • CANNOT GET PHONE TO GO BACK TO WORKING

    I TRIED INSTALLING ITUNES UPDATE ON MY IPHONE FROM MY COMPUTER AND NOW ALL I HAVE ON MY IPHONE 4S NOW IS THE USB CORD POINTING TO THE ITUNES ICON I TRIED TURNING THE COMPUTER OFF AND RESTARTING IT   AND TAKING THE USB CORD OUT OF THE PORT AND NOTHING WORKS  HOW DO I GET MY PHONE TO WORK AGAIN?

    IT ONLY HAS THE ITUNES ICON WITH THE USB CORD POINTING TO THE ICON I'VE TRIED TURNING IT OF IT'S JUST FROZEN IT WILL NOT TURN OFF OR ON WHAT SHOULD I DO

  • Why can I not get phone signal in France

    I am not able to signal in France Help???

    Jennifer,
    Thanks for the reply, I had tried all that to no avail. I have borrowed a phone from a French friend and bought a SIM card so I am now ok in France.
    From all the non Verizon answers I got to my posted problem, I seriously doubt there is anywhere in France except along the border with Germany or Belgium that the Verizon phone and the international package will actually work.
    I wonder why you sold it to me.
    Again, thanks for the reply.
    Eric
    Sent from my iPad
    >>Personal information removed to comply with the Verizon Wireless Terms of Service <<
    Message was edited by: Verizon Moderator

Maybe you are looking for

  • Document contains no items - Carry Out Sourcing From External Requirements

    Hello Experts, I have a problem in carrying-out sourcing in SRM 701 with external requirements come from ECC 6.0 I want to process the requirements into purchase order, everything is OK because I see the line item of requirement is there. But when I

  • Update cell Sprite in DataGrid

    Hi, I have a datagrid with a LOT of sprites (1700 circles, squares, and triangles) that I created in an itemRenderer in Actionscript using Peter Ent's excellent tutorial on custom item renderers. http://www.adobe.com/devnet/flex/articles/itemrenderer

  • Center alignment inside JScrollPane

    Hi guys. How can I get a JScrollPane to place a table in the center? I call scrollPane.setAlignmentY(CENTER_ALIGNMENT); on the JScrollPane object, but when the window is resized the scroll pane is resized along with and the table sticks to the left s

  • Opening .fla and or .swf files

    I know the newer version of Quicktime stopped opening these files a while back. I download files from the www.animationfactory.com all the time. Some are .fla and .swf (flash) files. Can anyone tell me what application I need to get/buy to open these

  • Several Inbound Delivery types in one plant?

    Hi Guru´s, 1. Is it possible to have several inbound delivery types and also to be able to use all inbound delivery types in one plant at the same time but in different process? E.g: 1a. I have plant with a sloc and WM connected which I would like to