HT1414 tried to update to latest iOS and my ipad 4 is frozen on terms and conditions
tried to update to latest iOS and ipad4 is frozen at terms and conditions?
Reset the device:
Press and hold the Sleep/Wake button and the Home button together for at least ten seconds, until the Apple logo appears.
Then try updating the software again.
If that doesn't help, tap Settings > General > Reset > Reset All Settings
No data is lost due to a reset.
Similar Messages
-
will I lose my photos in recovery mode? I tried to update to latest software and I received a message that iphone needs to be updated to factory settings. Please help. I cannot use iphone.
I would "guess", since you were in the middle of backing up, your backup is corrupt & most likely unusable. Only one way to find out though, & that's by trying to restore from that backup. If your pics are not there, they are gone.
-
After update the latest iOS 4 my ipad screen sometimes continues moving
Why after update the latest iOS 4.3, my ipad screen sometimes continues moving and hard to chose or touch the keyboard or icon?
I have the exact same issue. The screen moves up and down just a little so the bars in the top left hand corner are almost hidden. And pressing icons does not work at times. Pressing buttons inside open apps does not work at times or takes forever to execute the command. Also, some apps freeze or open and then suddenly close. I updated all my apps to determine if the cause was an app that is not compatible with the new operating system. This did not work. Is there a way to update again? Could the problem be that the update was corrupted in some way? Any suggestions would be appreciated. It did not happen with my iPhone when I installed the update.
-
I tried to update my iPad to latest ios and it is now asking me for a password...4 digits. I never had a password on it and it is too short to be my apple password. Help anyone? It keeps locking me out as I try different passwords.
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port. Do not release button until you see picture of iTunes and plug (very important)
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note: Data will be lost -
I tried to update the latest update 1/27/14 and it ran into a problem. I am not able to get to my library. I tried to download Itunes and it won't work . What should I do?
Are you sure it was error 0604 since I never heard of that error, it does not appear in the list of errors in the following and a search of Apple's support site gets no hits. However, error 1604 is list and users have reported that error number. If 1604 is the error number the following tell yu wnat to do when you click on that error number:
iOS: Resolving update and restore alert messages -
I have iPhone 4 with updated latest iOS And i am using FIND IPHONE application. But everytime when ever i login in it and serch for the device its shows the device but never give me the location"NO LOCATION AVAILABLE".It is already connected with WIFI and i tried all the stuffs that has been written in the manual. Plese give me the Proper suggetion about this issue..!!
If your router is not identified in a national database (don't recall who maintains it or where it is) then there is no location associated with it. Hence your device cannot be located. I suggest you try your test at some public wifi spot, like a bookstore or coffee shop. These places usually have a location associated with their wifi router.
-
I updated to the latest iOS and now YouTube and the Ap store are no longer on my phone. Also, not all my music will play and if I play a song it will actually play a different song while displaying the one I chose. Any ideas how to fix this?
You have to download the individual youtube app now. It is no longer a nataive ios app from apple in ios6
-
Itunes will not connect to the internet or access store with working internet connection. ive already tried updating to latest version and turning off windows firewall. running a nItunes will not connect to the internet or access store with working internet connection. ive already tried updating to latest version and turning off windows firewall. running a new dell, windows 7 ultimate, no virus or firewall programs installed.
This my sound too simple, but I just kept clikning on the arrow next to the selected music and it finally "Kicked" in.
I live in Europe ,So Be persistent and don't give up ! Aug. 2013 -
My mac is the OS X 10.8.3. I tried to update the latest Adobe flash player and kept getting 'Actionlist not found.' I have uninstalled, enabled and disabled plug-ins and am still unable to download the update and now have no flashplayer at all. Help!
PS I'm still new to Macs so the more broken down the better.Adobe Flash Player 11.8.800.42 is the most recent version from Adobe. It is a pre-release version. I am using it without any noticeable problems.
The current stable version is Download 11.7.700.169. -
I updated to the latest IOS and now my passwords don't work. Reset 4 time which reset for my iPad and iPhone but I cant log into my itunes account using my apple ID it indicates an error, Help?
This may sound crazy, but download any free app. This often "shocks" the other apps into working.
-
I have an Iphone 4s 32gb and i'm trying to update it to ios 5.1. i've downloaded the software from itunes but when i click on it to install it to my actual phone it says: "There was a problem downloading the software for Iphone 'Donnbjj1's Iphone' . An unknown error occurred (1480)."
iOS: Resolving update and restore alert messages
For error -50: See error 13 and 14:
Error 13 and 14: These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network. -
why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon
You are in Recovery Mode. Follow the instructions below to recover your iPad.
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button.
5. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: You need to be patient and repeat the above many times to recover your iPad. Data will be lost. -
Everything was fine, I try to update to latest iOS firmware (4.3.5) and I get an error "Unknown error occured (1394)" What do I do now?
Can anyone help me?
BobbyError 3194, AKA "This device is not eligible.. occurs for several reasons:
1. Update to the latest iTunes - currently 10.4.1.
2. Disable ALL security apps (firewall, antivirus/spyware) running on your computer. Additional measures may be needed.
3. You may need to edit the Hosts file on your computer to remove references to gs.apple.com if you EVER used hacking techniqus or apps such as tinyumbrella.
4. Don't try to downgrade the iOS.
5. If the phone was EVER successfully hacked in the past (jailbreak, downgrade, unauthourized unlock) there may be nothing you can do now to fix this.
"This device is not eligible for the requested build: Also sometimes displayed as an error 3194. If you receive this error, update to the latest version of iTunes. 3rd party security software or router security settings can also cause this issue, to resolve please follow Troubleshooting security software issues. Downgrading to a previous version of iOS is not supported. If you have installed software to perform unauthorized modifications to your iOS device, that software may have redirected connections to the update server (gs.apple.com) within the Hosts file. For steps to edit the Hosts file and allow iTunes to communicate with the update server, see iTunes: Troubleshooting iTunes Store on your computer, iPhone, iPad, or iPod; follow steps under the heading Blocked by configuration (Mac OS X / Windows) > Rebuild network information > The hosts file may also be blocking the iTunes Store. Also, using an older or modified .ipsw file can cause this error. Try restoring moving the current .ipsw file aside, or try restoring in a new user to ensure that iTunes downloads a new .ipsw."
http://support.apple.com/kb/TS3694 -
I am trying to update my phone. And it says it's up to date with 7.1 something but I want IOS 8?
I am trying to update my phone. And it says it's up to date with 7.1 something but I want IOS 8?
An iPhone 4 can't be updated past 7.1.2.
(123402) -
I'm trying to update the latest version of iTunes but my computer gives me an error saying to go to tools then download only and update manually. What do I do?
Try updating using an iTunesSetup.exe (or iTunes64Setup.exe) installer file downloaded from the Apple website:
http://www.apple.com/itunes/download/
Maybe you are looking for
-
How do I convert my document from PDF to Word?
How do I convert my document from PDF to Word?
-
I have a G4 mirror desktop Mac. I need to run the Apple Hardware Test CD on my machine but I have misplaced my copy of the CD. Is there soewhere I can download an image of the AHT CD?
-
Clearing port channel configurations
In one of my 6509s I've got a lot of old port channel configs listed that I can't remove. How do I remove them short of clearing the config entirely? Here's an example... set port channel 3/41-42 64 set port channel 3/43-44 65 set port channel 6/47-4
-
I tried deploying a WAR File in OAS 10G R2. It says that the file deployment was successful. But when in the Enterprise Manager I get a Not Loaded status. I'm attaching the following details for more information application.log (shows that the file w
-
Error related to FullTextSearch database
Guys, I just created a new Portal domain using the Configuration Wizard tool. When starting up the server, I see a flurry of errors relating to the Content FullTextSearch db not being created (see below). Any quick suggestions on how to fix this? ==