HT1430 how to reset whole ipod

how do you reset you whole 3rd generation ipod beause you have forgotten your password

iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen

Similar Messages

  • HT1430 How to reset my iPod if I forgot the password

    How do I reset my iPod if I forgot my pass code

    If you cannot remember the passcode, you will need to Restore your device...
    Connect to iTunes on the computer you usually Sync with and Restore...
    http://support.apple.com/kb/HT1414
    If necessary Place the Device into Recovery mode...
    http://support.apple.com/kb/HT1808

  • HT1430 How to reset an iPod touch locked?

    How to Rest an iPod touch locked!!

    Put it in recover mode.
    Explained here:
    iOS: Unable to update or restore

  • HT1430 how to reset my ipod to factory settings

    I lost all my music off my ipod and have been told to reset it to factory settings - how the **** do I do this.  Not overly technologically savvy!!!

    Either:
    - Go to Gettings>General>Reset>Erase all content and settings
    - Connect the iPod to yur computer and restore via iTines. See:
    iTunes: Restoring iOS software

  • How to restore whole ipod without knowing passcode

    how to restore whole ipod without knowing passcode

    If You Are Locked Out Or Have Forgotten Your Passcode or Just Need to Restore Your Device
      1. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
      2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
      3. iOS- Understanding passcodes
         If you have forgotten your Restrictions code, then follow the instructions
         below but DO NOT restore any previous backup. If you do then you will
         simply be restoring the old Restrictions code you have forgotten. This
         same warning applies if you need to restore a clean system.
    A Complete Guide to Restore or Recover Your iDevice (if You Forget Your Passcode)
    If you need to restore your device or ff you cannot remember the passcode, then you will need to restore your device using the computer with which you last synced it. This allows you to reset your passcode and re-sync the data from the device (or restore from a backup). If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. Refer to Updating and restoring iPhone, iPad and iPod touch software.
    Try restoring the iOS device if backing up and erasing all content and settings doesn't resolve the issue. Using iTunes to restore iOS devices is part of standard isolation troubleshooting. Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition.
    Before restoring your iOS device, Apple recommends that you either sync with iTunes to transfer any purchases you have made, or back up new data (data acquired after your last sync). If you have movie rentals on the device, see iTunes Store movie rental usage rights in the United States before restoring.
    Follow these steps to restore your device:
         1. Verify that you are using the latest version of iTunes before attempting to update.
         2. Connect your device to your computer.
         3. Select your iPhone, iPad, or iPod touch when it appears in iTunes under Devices.
         4. Select the Summary tab.
         5. Select the Restore option.
         6. When prompted to back up your settings before restoring, select the Back Up
             option (see in the image below). If you have just backed up the device, it is not
             necessary to create another.
         7. Select the Restore option when iTunes prompts you (as long as you've backed up,
             you should not have to worry about restoring your iOS device).
         8. When the restore process has completed, the device restarts and displays the Apple
             logo while starting up:
               After a restore, the iOS device displays the "Connect to iTunes" screen. For updating
              to iOS 5 or later, follow the steps in the iOS Setup Assistant. For earlier versions of
              iOS, keep your device connected until the "Connect to iTunes" screen goes away or
              you see "iPhone is activated."
         9. The final step is to restore your device from a previous backup. If you do not have a
              backup to restore, then restore as New.
    If you are restoring to fix a forgotten Restrictions Code or as a New device, then skip Step 9 and restore as New.

  • HT3728 how to reset my ipod touch

    I have been locked out of my ipodtouch and do not know the passcode

    Please check out the following Apple Support article for the details on how to reset your iPod.

  • HT1212 how to reset the "ipod touch"

    i need to know how to reset my ipod

    If you forgot your screen-lock passcode:
    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                          
    If recovery mode does not work try DFU mode.                         
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings         
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store

  • HT1212 how to reset your ipod touch

    how to reset my ipod touch when wrong passcode results in red disabled screen?

    Restore it.  if you are unable to restore
    iOS: Unable to update or restore
    iPod touch User Guide (For iOS 5.1 Software)

  • How to reset my iPod touch thats disabled it doesn't work even charging

    How to reset my iPod touch thats disabled it doesn't work even charging

    If the sleep/wake button doesn't work use the home button and if the home button doesn't work it's the other way around, however if both of them don't work charge it with your connector connected with your computer or wall socket and it will turn on. Hope this helps.

  • How to reset my ipod when i forgot the code

    how to reset my ipod code when i forgot it

    You must connect the device to iTunes and restore it to factory settings.
    Restoring iPod to factory settings
    B-rock

  • HT1430 How to reset Ipod touch to factory settings?

    I'm having trouble. I forgot my restrictions passcode and need to reset my Ipod touch to the factory settings and don't know how to.
    Someone please help?

    Go to Settings>General>Reset>Erase all content and settings. Then set up the iPod either via wifi (iOS 5 and later) oer connect to computer and restore via iTunes.
    iTunes: Backing up, updating, and restoring iOS software

  • How to reset my ipod touch

    For the past 2 hours I have been trying to reset my ipod without a password. my computer does not accept my ipod because it does not have the new update. So when i tried to update my computer it won't accept my password to start the download. So when I tried to see wat was wrong with my password cause I knew it was right I found nothing. So I tried to restart my ipod anyway but it didn't work either. Is there a way to restart it without the computer or icloud or anything else. I'm extremly fustrated. When I restarted my nook tablet a couple months ago it wasn't nearly as difficult and it took me 5 minutes. Please help! I'm about readying to return it and get a new one cause I still got 6 months warranty on it. But I want to avoid that so please help.

    If the iPod is Disabled or yur fogot the scree-lock pascode and the iPod has iOS 5 or higher, have an internet connection to the iPod
    If you don't have access to a computer
    If you are using Find My iPhone, you can use Remote Wipe to restore your device. If you have been using iCloud to back up, you may be able to restore the most recent backup to reset the passcode.
    Otherwise:
    Place the iOS device in Recovery Mode and then connect to a computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                          
    If recovery mode does not work try DFU mode.                         
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings         
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store

  • HT1212 hi my name is ari and i have an ipod touch newest gen that was disabled and it was given to me disabled ..i downloaded i tunes to my computer but i cant figure out how to reset the ipod to factory settings

    hi i have an ipod touch that was given to me that was disabled and it belongs to a kristien but she no longer lives here and my apple id doesnt work for this ipod and i wasnt to reset the ipod to factory settings so it can be my ipod and i dont know how to go about that

    You can restore from backup since the screen-lock passcode is not restored.
    Disabled
    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: Back up and restore your iOS device with iCloud or iTunes       
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload most iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        
    If problem what happens or does not happen and when in the instructions? When you successfully get the iPod in recovery mode and connect to computer iTunes should say it found an iPod in recovery mode.

  • HT1853 how to reset my ipod touch

    i am locked out of my apple ipod and i dont know how to reset it

    Connect the iOS device to your computer and restore via iTunes. Place the iOS device in Recovery Mode if necessary to allow the restore.
    If recovery mode does not work try DFU mode.
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store

  • How to reset my iPod like erase all my data

    how to reset ipod like take all data off

    Go to Settings>General>Reset>Erase All Content and Settings

Maybe you are looking for

  • R/3 work process will not start

    hi! i have 4.7e and oracle 8i in my machine. and i was used past 5 months. now when i start sap server, the work process will show 'ended'. why? and following error message will created. trc file: "dev_w0", trc level: 1, release: "620" ACTIVE TRACE L

  • All Firefox versions crash when I open them

    I haven't been able to open Firefox at all for several months. I have tried everything that's listed in the support section and none of that applies. I click to open it and two seconds later it crasher and I get a message that says "Firefox had a pro

  • How do I convert a .pdf with columns into a word doc?

    I know how to convert a regular .pdf to a word doc but when I try and convert one with columns it combines the columns as if it thinks it is all straight across lines with a big space in it.

  • Reg:BPM

    Hi All, I am new to Business Process Management(BPM) can anyone tell me What is BPM? and the business scenario actual use of BPM and provide me any useful material on this. Thanks, Rahul. Edited by: rahul.girmaji on Dec 22, 2011 7:27 PM

  • [svn:fx-trunk] 13693: Initial version of the mirroring layout code.

    Revision: 13693 Revision: 13693 Author:   [email protected] Date:     2010-01-21 12:25:54 -0800 (Thu, 21 Jan 2010) Log Message: Initial version of the mirroring layout code.  Only Spark is supported.  API revisions for this feature are very likely to