HT1551 I have a USB cable showing up and the iTunes logo, what do I do?
I have a USB cable showing up and the iTunes logo, what do I do?
it's trying to tell you that you need to use an usb cable to connect
the appletv with a computer running itunes so you can restore the firmware of the appletv
Similar Messages
-
i tried to reset my ipod 1st gen and its stuck on the screen where it has a pic of a usb cord and the itunes logo what do i do???????
Connect the iPod to your computer and restore via iTunes
iTunes: Restoring iOS software -
HT1430 What if it has a picture of the cable an arrow and the Itunes logo?
Please help me because this has old friends numbers and important infromation for school and work.
1) Connect to iTunes on the computer you usually Sync with and Restore...
http://support.apple.com/kb/HT1414
2) If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808
Note on Recovery Mode.
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Once you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
My iPhone 4s is stuck on a black screen that shows a USB cable connecting to iTunes. The phone will not turn on and the iTunes logo as I described only shows up when I plug the phone into the charger or my computer. I have tried the reset in restore mode as well as the DFU? mode and it still will not work. I have the latest version of iTunes on my Mac. My error code was 2002. I also tried it on my laptop (windows 8.1) and none of the above worked. My error code on my laptop was 02. The phone is through Verizon and it has absolutely no damage. It was working fine up until this and I have been trying to fix it for 2 days. Please help! I am unsure of what version the phone was currently running on before this because I have another iphone that's my primary phone and have not used this one in about a month. I do not believe it was updated to IOS 7.
Your iPhone is in recoverty mode at the moment so to possibly get it back up and running you would need to do a restore as you have been trying. Follow the steps in the article below for the specific error messages you have been receiving. If after following all steps the issue remains book an appointment at a local Apple Retail Store to have the iPhone evaluated.
Resolve specific iTunes update and restore errors -
My iphone is no longer working I have black screen with a picture of the itunes logo and a USB cable. When I try to connect my iphone to itunes the device is not detected, can anyone help me? I desperatley need my phone back
I have had a 3GS for 2+ years. After upgrading to IOS 4 (now 4.3.5) I began having problems. In the past week, my screen went to the itunes logo and USB cable twice -- unprovoked -- just found it sitting there like that! I connected to itunes and it did restore from a backup but it is a major inconvenience. I am also searching for answers, but better back-up regularly!
-
I got a new Ipad 2 and I am trying to get it work in vain. I have downloaded the iTunes on my PC, but even after executing the program nothing happens to the IPAD. I still get the image of the USB cable and the iTunes logo. What am I doing wrong?
You know that you have to connect the iPad to your PC with the cable that came with it - and then iTunes should start automatically and it will guide you through the set up process?
If you have already tried to connect the iPad - and you have launched iTunes - and you still have no luck - reboot your PC and then begin the process again. -
My screen on the touch is frozen. the screen shows a usb cable and the itunes logo above it. How can I get it back to the main screen
The screen is telling you to connect the iPod to a computer with iTunes via the USB cable. iTunes should open and give you instructions. If not, open iTunes and retore the iPod via iTunes.
-
Today I was updating my phone to the newest IOS 7 and after it finished downloading. An error showed up on my screen telling me it was unable to update. So I decided to just unplug my phone and maybe do it later but on my screen I have a USB cord and the iTunes logo asking me to connect. So I hooked it back up and still at this point my iTunes will not connect and when I unplug the phone the screen stays the same. I have tried turning off the phone and restarting and both times the screen goes back to the connect screen.. How can I fix this?
I have tried the steps to fix it but no solution! Please someone tell me what to do!
-
I can't open my ipad now. It is stuck with the picture of the usb cord and the itunes logo on the front.
Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times. -
I tried to restore my ipod touch 2nd generation and now it won't sync to itunes. On the screen is the USB end of the cord and the iTunes logo over it.
I have turned it off and on, held the off button down and the select button down but it still comes up with that picture on the screen. Have I broken it?
Please help.
MimiIt means the device is in recovery mode. You'll need to reconnect it to iTunes and restore it again.
You may need to connect it in recovery mode manually using the instructions in this Apple support document.
iOS: Unable to update or restore
B-rock -
What do i do when the usb and the itunes logo show up?
What do i do when the usb and the itunes logo show up?
Connect the iPod to your computer and restore via iTUnes
iTunes: Backing up, updating, and restoring iOS software -
I Turn on my Ipad and all it will do is show a usb cord and the Itunes logo and it won't go away
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
Cheers, Tom -
iphone is frozen. the screen only shows the usb plug icon, the word itunes and the itunes logo. the whole phone is frozen
Connect it to your computer and open iTunes, it will probably prompt you to restore it.
-
my will not do anything and it has a picture of the usb cable and the itunes logo on the screen
Your iPhone is telling you you need to restore it using iTunes on a computer. Follow the instructions below.
Use iTunes to restore your iOS device to factory settings - Apple Support -
I have the picture of the Apple TV box with a USB coming out of it and the iTunes logo. It will not let me reset it I have tried holding down the menu button and the other one but it just returns to the same screen
Please assist as it was fine yesterday
ThanksYou have to connect to iTunes via micro usb and restore the device.
http://support.apple.com/kb/HT4367?viewlocale=en_US&locale=en_US
Maybe you are looking for
-
Determining the size of an Image
I am running Pages 5.2 and I have a document with a whole load of images taken from photos. Usually I shrink the original images to keep the document size manageable but I forgot on some but I don't know which. Is there a way I can determine the size
-
Hi, I was stupid and edited my blank templates xml files without backing up the original, and now it's giving me font not found errors. I just don't want to have to change the font to TNR every time I open a new document. Can someone upload or email
-
Java.lang.LinkageError in SessionBean
I get this error: Error occurred in server thread; nested exception is: java.lang.LinkageError: Class org/jdom/Document violates loader constraints I try to call method from SessionBean like this: org.jdom.Document doc = home.getJDOMDocument(); Remot
-
Merge multiple sales orders in One
Hi All, I want to merge multiple sales orders into a sales order (new), with all pricing details. How do I do that by using standard SAP BAPI 's or FM's. Currently I am doing it through BDC programing which is taking long time. Kapil Shivaji Sonavane
-
Revision: 7204 Author: [email protected] Date: 2009-05-21 16:30:20 -0700 (Thu, 21 May 2009) Log Message: Tweaks to appearance of Halo skins for WindowedApplication/Window to match Spark appearance. Bug: SDK-19653 QA Notes: Baseline images of Ha