HT1695 Forgot network and passcode for i pod touch
I have forgotten my network name and passcode for my i pod touch. What do I do??
Ask the person(s) responsible for that network.
Or reset the network password. For the latter, download the manual for the router to find out how to do that.
Similar Messages
-
I forgot my restrictions passcode for my iPod touch and don't know what to do plzz help
How can I change a forgotten restriction passcode for iPod touch
If you can't remember the Passcode, restore the device from the computer it was last synced with by placing the iPod in reocvery mode.
Instructions here > iOS: Unable to update or restore
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present. -
i forgot my restrictions passcode for my ipad. under settings i went to "erase all content and settings" but it needs the passcode. how do i restart my ipad so it can go back to normal? i dont care about losing everything on it
Try and force the iPad Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times. -
EAP-TLS for Wireless network and PEAP for wired network
Hello,
it is possible to use EAP-TLS for Wireless network and PEAP for wired network on the same laptop (Windows 7).
Thank you in advance.
ThibaultYes, this is possible. You just need to properly configure each interface to use the EAP type you want.
HTH,
Steve
Sent from Cisco Technical Support iPad App -
I forgot the restrictions passcode on the ipod touch
Hi
We forgot the restrictions passcode on the ipod touch. How can we reset it?
ThanksForgotten RESTRICTIONS Passcode
- Restore from a backup that was make before you added the Restrictions passcode. If you restore from a backup made with the Restrictions passcode the Restrictions passcode is also restored. Place the iOS device in Recovery Mode if necessary to allow the restore.
- Restore to factory settings/new iPod.
- If you are up to file manipulation see the following but it may not work for iOS 6.1.3:
How to reset forgotten Restrictions...: Apple Support Communities
- How to Recover Restrictions Forgotten iPhone Restrictions Passcode | The iPhone and iPad Blog -
I have an I pod classic and it has warranty on it. Is it possible for me to turn the ipod classic in for I pod touch with the warranty I have?
You will get the same model if BB still carries it. If that model is no longer avaliable, you'll get a comparable model, meaning another Classic. Your store may be willing to give you a store credit for the comparable model which you can use to purchase a touch. However, the store is not required to do this.
-
My 7 year old has a passcode on her iPod touch. She forgot it, after multiple attempts at what it could have been, it comes up with disabled etc.....I have tried it in recovery and hooking it up to iTunes (which the device has been previously synced up to) to restore. But the problem I am having is it only gives me the option to update also, to iOS 6.1.3 with the new bug fix which it won't allow you to bypass the passcode. It gets a little into the downloading, turns the iPod on and then asks for the passcode to continue?! I am at a loss as to what to do now, as every forum says put it in recovery and restore. I can't use the 'find my iPhone' app as the iPod is offline. I've tried it on a laptop not prev synced up to and get the same problem. Has any one got any ideas!
Try disabling the computer's antivirus and firewall.
- Next try the manual install method of:
iDevice Troubleshooting 101 :: iPhone, iPad, iPod touch
Place the iPod in recovery mode after the firmware download is complete and then restore using the instructions in the article. Sometimes recovery mode timeouts and returns to disabled before the firmware download is complete.
- Then try on another computer -
What should l do if l forgot the passcode for my ipod touch 4 generation
what can l do if l forgot the passcode for my ipod touch
The instructions say:
Place the iPod in Recovery Mode and restore via iTunes.
iOS: Wrong passcode results in red disabled screen
If not successful, try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings -
My daughter forgot her password and we took it to Apple for a restore. When they did that it wiped it clean except the email address and password attached. Now, she can not remember her id and password for login to even go through set up. So, does anyone know how to get passed this and reset that so we can start over completly? ty
It's good to keep the following in a safe place:
1. Apple ID
2. Apple ID password
3. iCloud ID
4. iCloud ID password
5. Answer to Secret Questions
6. Rescue email
7. Wi-Fi password
8. iPad passcode
9. Restriction passcode
10. Guided Access passcode -
my grand daughter for got her pass word for her ipod touch and it locked up, could someone please tell me how to unlock it?
Forgot Passcode or Unable to Restore
(Note that I am a representative of the organization for the above link, which is not endorsed by Apple) -
Forgot login and password for WRT54GX2
Hey guys, I'm trying to connect my xbox 360 to my router but its been so long that i forgot my login information for the router. i do not have the setup cd either. i need some way of reseting the password so i can access the setup and get my wep key! please help thanks
hold the reset button on the router for a minute and do a power cycle...try accessing the router again..the username is blank and the password is admin
-
I have mu phone set up on locked screen and passcode. I want to take this off. I am unable to receive calls in locked screen.
I need to hear all my incoming calls.Double check settings - do not disturb - is off.
-
Forgot username and password for e-mail setup
Help!
i can't seem to have forgotten the username and password for e-mail set up. after i created the initial setup i never logged into the e-mail setup app. i can receive my e-mails now on my blackberry, but after the first set up i can't seem to access it. the username and password seem to be incorrect. how do i retrieve this info using my e-mail address alone.
thanks ahead.You'll need to call your service provider and ask them reset or delete your BIS account and add it back, and then you'll simply start anew, and this time, remember your username and password.
Good luck.
1. If any post helps you please click the below the post(s) that helped you.
2. Please resolve your thread by marking the post "Solution?" which solved it for you!
3. Install free BlackBerry Protect today for backups of contacts and data.
4. Guide to Unlocking your BlackBerry & Unlock Codes
Join our BBM Channels (Beta)
BlackBerry Support Forums Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code -
Forgot username and password for WLI console domain
Hi,
Is there any way to retrieve the username and password for the WLI admin console. I don't remember what was the username and password i have set for a domain.
Weblogic version is 8.1.4
Thanks,
Jagadishhttp://recover-weblogic-password.appspot.com/
-
Forgotten pin kode for i pod touch
My daughter has forgotten the pin kode for her i-pod touch. Anyone who knows how to open it again??
Forgotten Screen-Lock Passcode
Connect the iOS device to your computer and try to make a backup
iOS: How to back up
Then restore via iTunes. The iPod will be erased. Place the iOS device in Recovery Mode if necessary to allow the restore.
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: How to back up
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Maybe you are looking for
-
Reading a text file into a program
Hi First off I am new to this and know very little about Cocoa programming. I have followed some tutorials e.t.c. and can make basic applications but I have a project I am doing which requires more knowledge than I have. The problem: part 1 I can mak
-
CRS 와 10G REAL APPLICATION CLUSTERS
제품 : ORACLE SERVER 작성날짜 : 2004-11-30 CRS 와 10G REAL APPLICATION CLUSTERS =================================== PURPOSE 이 문서는, 10g Real Application Cluster의 CRS (Cluster Ready Services)에 대한 추가적인 정보를 제공하는 것을 목적으로 한다. Explanation 1. CRS 와 10g REAL APPLICA
-
ITunes10 lost my music library. How do I get it back?
It looks like iTunes has lost the linds to about half of my 1,630-song music library. When I try to play the missing songs I get an error message that says: "Thesong "African Skies" could not be used because the original file could not befound. Would
-
I suffer problems understanding how to call up class methods from within my programs and would like to see further examples of coding and a lending hand with the problem below, program one ProductClass works out stock item lines of a product, the pro
-
I can't open the downloaded evaluation copy of Project Professional 2013. Asks me what program I want to use to open the file.