HT1766 how long should an icloud restore take to an iphone?

How long should an icloud restore take to an iphone?

Nobody here would know. Depends on how big the backup file is.

Similar Messages

  • HT1438 About how long should an ICloud backup take?

    About how long should an ICloud backup take?

    Well, it went from 8 to 10 to 12 to 18 to 22 hours...then it stopped and said can't restore from icloud. I guess I'll give itunes a shot.

  • How long should this iTunes restore take?? Grrrr

    Upgrading my iPhone 4 to the new software.
    Took over an hour as it was "preparing to restore the software on this iPhone".
    Finally, it changed, to read "iTunes is currently restoring the software on on this iPhone". This has been going on for almost TWO HOURS.
    There's no status graphic to show how far it's gotten so I'm stumped.
    Is this normal??? I need to use my phone and it's been out of commission for hours. Grrrr
    Thanks in advance.

    No it would take at most 2 hour, I think your iPod hardisk is dying causing the delay and iTunes freeze.
    Do a check on the iPod Hardisk using Disk Diagnostic as posted earlier by tt2
    https://discussions.apple.com/message/17776595#17776595
    This will not fix your problem directly, but may save you a lot of frustrations, as it help us in troubleshooting.
    Have a nice day!

  • HT5262 How long should the icloud back up take?

    How long should the iCloud back up take? I only have 4gb of storage but it has taken almost an hour already with approximately 2 hours remaining. 

    Hi RMaskery14,
    If you are concerned about the time your iCloud backup is taking, you may find the following article helpful:
    My backup is taking a long time to finish.
    Backing up and restoring takes time, especially if you have a lot of data or a slow connection. Depending on the size of your backup and the speed of your network, you may need more time than expected to complete the process. Using a reliable connection when backing up your device is highly recommended.
    iCloud: Troubleshooting creating an iCloud backup
    http://support.apple.com/kb/ts3992
    Regards,
    - Brenden

  • HT1176 how long should an initial backup take?

    How long should an initial backup take?

    If the Mac is connected to the Time Capsule using an Ethernet connection, the backup will proceed on average at about 30-35 GB per hour.
    So, if you have 100 GB to backup, the process will be approximately 3 hours.
    Bets are off with a backup using wireless, but it will likely be at least 3-4 times longer than the wired Ethernet connection.

  • HT1766 How long should it take to restore new iPhone backup from iCloud?

    How long should it take to restore new 4s iPhone backup from iCloud?

    That depends mostly on your Internet connection download speed, and how much data you have on the phone. It could take anything from a few minutes to several days. There is no "one size fits all" answer.

  • HT1766 How long should it take for a icloud back up of about 6.4GB?  It has been running all night and not complete.

    How long should it take for an icloud backup of about 6.4GB?  I selected a manual backup and it has been running all night?  Thanks         

    That's going to depend alot on your internet connection speed. 6.4 GB is alot of data, especially if your connection speed is slow (DSL) or low-end cable speeds of ~1.5 Mbps.

  • HT1766 How long should it take to back up my IOS phone to Icloud?

    How long should it take to back up my IOS phone to Icloud?

    Depends on how much needs backing up and your wifi speed.  5-30 mins maybe?

  • HT1766 how long should it take to back up to icloud?

    How long should it take to back up to icloud?

    Depends on how much needs backing up and your wifi speed.  5-30 mins maybe?

  • HT1766 How long should it take to back up my phone?

    How long should it take to back up my phone? So far it has been around 13hrs.

    a normal back up for my iphone4 6.01 with itunes 11 takes 2 mins

  • How long should upgrade to Yosemite take?

    I have downloaded Yosemite from the AppStore and on my initial attempt to install got to the point of having a grey screen with apple in the middle and a progress bar which stopped about 1/4th the way to completion.  I let it run overnight after reading posts online indicating that it should resolve itself with time.  After over 12 hours, I restarted the late 2012 MacBook Air and it would immediately go back to the same point in the installation.  I then booted to the recovery disk and restored Maverick from my TimeMachine.  I have tried to install again and have been stuck in the same spot for over 12 hours.  I've tried entering Command-L to observe the log file with no change in what is being displayed.  How long should I wait?

    Install after download seems to take around a half hour.  Of course it will depend on your hardware.
    Phil

  • How long should Loading Installation Information take with a formatted Drive?

    The OS was corrupted when installed over an incompatible 10.6 version of Centrify.  It should have been uninstalled prior to installing Lion, so I was hoping to do a fresh install without restoring anything related to older applications to sort out network hang conditions.  Restoring from Time Machine does not appear to offer selective restore in terms of Apps and Users. 
    I am now waiting for more than hour at a window over the prompt "To set up the installation of Mac OS X 10.7, click Continue" that says:
    To download and restore Mac OS X, your computer's eligibility will be verified with Apple. This just has a throbber spinning in front of the message
    Loading Installation Information... "  I have about 16mbit/sec Internet connectivity, how long should this phase of the reinstall operation take?
    When I first installed Lion, a bootable image of the initial version of Lion was made that was able to restore Lion to an erased drive in about 28 minutes.  It seems that image has been disabled by changes the MacBook boot flash.  Is there a way to be better prepared, and how long should this process take starting with an erased drive?

    Sorry to hear that saga. This time download another Lion installer from MAS by going to purchases and holding the option key. When downloaded it will appear in /Applications. Save it off to several different places on your disk and off.
    Also, consider keeping bootable clones with SuperDuper or CarbonCopy Cloner.
    That way if you have a problem, just boot up from the clone and keep on working until you're ready to fix.

  • How long should the installation of new software for iphone take.  Mine has been downloading now for over 3 hours.  I don't want to disconnect and lose my data.

    How long should it take to update an I 4 phone to the new system.  Mine has been going for 3.5 hours and is not finished, but I don't want to disconnect and lose my data.

    Mine took about an hour or so but it mostly depends on your modem and processor speeds. You can check the progress by clicking your iphone on the left and then checking the download progress. As long as that is moving I would just leave it and wait but don't let your computer shut down.

  • How long should my iPad 3 take to charge

    How long should it take my iPad with retina display to charge?  It takes about 15 hours to charge now from being dead.

    FYI
    The quickest way (and really the only way) to charge your iPad is with the included 10W or 12W (5W on Mini) USB Power Adapter. iPad will also charge, although more slowly, when attached to a computer with a high-power USB port (many recent Mac computers) or with an iPhone Power Adapter (5W). When attached to a computer via a standard USB port (2.5W, most PCs or older Mac computers) iPad will charge very slowly (but iPad indicates not charging). Make sure your computer is on while charging iPad via USB. If iPad is connected to a computer that’s turned off or is in sleep or standby mode, the iPad battery will continue to drain.
    Apple recommends that once a month you let the iPad fully discharge & then recharge to 100%.
    How to Calibrate Your Mac, iPhone, or iPad Battery
    http://www.macblend.com/how-to-calibrate-your-mac-iphone-or-ipad-battery/
    At this link http://www.tomshardware.com/reviews/galaxy-tab-android-tablet,3014-11.html , tests show that the iPad 2 battery (25 watt-hours) will charge to 90% in 3 hours 1 minute. It will charge to 100% in 4 hours 2 minutes. The new iPad has a larger capacity battery (42 watt-hours), so using the 10W charger will obviously take longer. If you are using your iPad while charging, it will take even longer. It's best to turn your new iPad OFF and charge over night. Also look at The iPad's charging challenge explained http://www.macworld.com/article/1150356/ipadcharging.html
    Also, if you have a 3rd generation iPad, look at
    Apple: iPad Battery Nothing to Get Charged Up About
    http://allthingsd.com/20120327/apple-ipad-battery-nothing-to-get-charged-up-abou t/
    Apple Explains New iPad's Continued Charging Beyond 100% Battery Level
    http://www.macrumors.com/2012/03/27/apple-explains-new-ipads-continued-charging- beyond-100-battery-level/
    New iPad Takes Much Longer to Charge Than iPad 2
    http://www.iphonehacks.com/2012/03/new-ipad-takes-much-longer-to-charge-than-ipa d-2.html
    Apple Batteries - iPad http://www.apple.com/batteries/ipad.html
    iPhone: Hardware troubleshooting (Power/Battery section also applies to iPad)
    http://support.apple.com/kb/TS2802
    Extend iPad Battery Life (Look at pjl123 comment)
    https://discussions.apple.com/thread/3921324?tstart=30
    New iPad Slow to Recharge, Barely Charges During Use
    http://www.pcworld.com/article/252326/new_ipad_slow_to_recharge_barely_charges_d uring_use.html
    iPad: Charging the battery
    http://support.apple.com/kb/HT4060
    Best Practices for iPad Battery Charging
    http://www.ilounge.com/index.php/articles/comments/best-practices-for-ipad-batte ry-charging/
    Tips About Charging for New iPad 3
    http://goodscool-electronics.blogspot.com/2012/04/tips-about-charging-for-new-ip ad-3.html
    How to Save and Prolong the battery life of your new ipad
    https://discussions.apple.com/thread/4480944?tstart=0
    Prolong battery lifespan for iPad / iPad 2 / iPad 3: charging tips
    http://thehowto.wikidot.com/prolong-battery-lifespan-for-ipad
    iPhone, iPod, Using the iPad Charger
    http://support.apple.com/kb/HT4327
    Install and use Battery Doctor HD
    http://itunes.apple.com/tw/app/battery-doctor-hd/id459702901?mt=8
    To Extend a Device’s Battery Life, Get to Know It Better
    http://tinyurl.com/b67c7xz
    iPad Battery Replacement
    http://www.apple.com/batteries/replacements.html
    In rare instances when using the Camera Connection Kit, you may notice that iPad does not charge after using the Camera Connection Kit. Disconnecting and reconnecting the iPad from the charger will resolve this issue.
     Cheers, Tom

  • HT3805 If I have 500,000 images, how long should a library rebuild take?

    I have close to 500k images and had to do a library rebuild. It took over 10 hours, but never stopped.  Now that it has processes all the photos, it is still saying processing and I'm just waiting.  How long should I wait?

    40 hours.
    Seriously.
    It will finish.
    There's not much else you can do.  If you stop the process, you just have to start over.

Maybe you are looking for

  • Open Page in new window using action link

    How do I open a page in a new window, using action link ? If I put javascript window.open in OnClick event, the action event ins�t called.

  • Need Help on Weblogic JMS Clustering

    Hi All Our code is moving to a clustered environment (2 OSB managed servers), in order to support JMS clustering i have already done the below, I just need your advice whether i have done it correctly or not. Please advise 1) Created 2 JMS Servers, t

  • Report Queries and collections

    Hello! I want to intergrate a collection query into the report query for pdf-printing. (Home>Application Builder>Application 111>Shared Components>Report Queries>Edit Report Query) I trigger the report generation by a submit button. Wheras the collec

  • Smartform program name

    Hi everybody, I have one doubt. I know only smartform name. now i want to know the program name of that smartform. for example: if the smart form name is ZSMARTFORM  now what is the program name of this smartform. where does all these smartforms stor

  • FCP crashes when opening particular project file

    I have one particular FCP project file that crashes each time I try to open it. I have read other threads and tried to follow their suggestions, but to no avail. I have tried opening it on different computers (both PowerPC and Intel), disconnecting h