HT1766 my iphone was charging and turned off and wont turn on now even when it is connected it will just turn the apple and turn back off
my iphone was charging and turned off and wont turn on now even when it is connected it will just turn on just the apple and turn back off
steps665 wrote:
..., the problem is that my Sleep/mode button does not work.
Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is Required...
Be sure to make an appointment first...
Similar Messages
-
TS1363 Iphone just shows the apple and blinks on and off.
Iphone just shows the apple and blinks on and off.
Hello grumpy48,
The article linked below details a number of useful troubleshooting steps that can help restore functionality to your iPhone.
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Cheers,
Allen -
MacBook Pro doesnt start. When I start my lap top, it shows the apple and the line uploading but it only goes like to 1/3 and then it goes blank for some seconds, then it turns off by itself and turn on again and happen the same, apple logo, line .. the noise like-fan going on, then turn off and turn on again. Tried starting holding option command P and R key and didnt work either. Starting to think I have lost all my data inside
Try a SMC reset.
http://support.apple.com/kb/ht3964
It might be helpful if you indicated the exact model/year of your MBP. Are you running Lion OSX?
Ciao. -
helpppp
I dropped my iPhone 5 and it doesn't turn on it just shows the apple and says to plug into iTunes.. then i restore it and it says error , what do i do to get my phone to turn on fully ?See if this helps: http://support.apple.com/kb/TS3694#USB
If it does not help, the drop probably damaged something inside the phone. -
My iphone 4S wont allow me to restore a bckup of icloud it has just rebooted the os and for over 24 hours i have been trying to fix it i use this phone for my job so i need help. when i try to restore it says "Your iphone could not be activated becuase the activation server is unavailable, If the problom presests goto apple.com/support" It has done this for 27 hours now PLEASE HELP!!!!!!!!!
- Connect the iPod to the computer and see if iTunes sees it. If it sees it try to get the photos off the iPod.
- Next let the battery fully drain. It will likely take days. After charging for at least an hour try again
- Last, make an appointment at the Genius Bar of an Apple store. -
When I switch to Front Camera, it just blurs the screen and hangs. Any help?
I had the same problem. After numerous attemps to Restore from Itunes, I decided to use the "Setup as New Ipad" option. It went through a few question on new setups. Afterwards all my apps, data, photo's were still intact. Which shows that the Restore from Itunes worked. There must be a small bug that prevents the Ipad to open after "Restore from Itunes" . Hope it will help you.
-
I can tur en on the ipad just appear the apple and no answer
the last nigth I try to restar the Ipad and eraser all the aplications and this mornig just appear the apple in the screen and no answer just the apple work
what can i do?
I puch at the same time the booton to stat an the central button now is turn in of
i need to recovery my ipadI would take it to your nearest apple store and have them help you. You should be able to connect the ipad to your computer and by using itunes reset it to the factory defaults and this should return your ipad to the state it was in when you purchased it. If that is not what you are trying to do then can you provide some more details about your problem.
Paul -
trying to sync, but when i disconnect from wall charger it sort of dies until i plug it into the usb cord, the the apple logo rolls on and off
nevermind i just realized that its because the battery is flat dead.
-
My iPhone won't turn on all the way. It just has the apple and white background
I've tried pressing the top button and home button but still doesn't work
Hello Evelyn,
Thank you for providing the details of the issue you are experiencing with your iPhone. It is definitely inconvenient and frustrating when you are not able to access your iPhone.
I recommend following steps 4-6 below for an issue like this:
If a single application is not responding or stops responding when it opens, you can force it to close.
If the device is unresponsive or if certain controls aren't working as expected, restart your device.
If the device remains unresponsive or does not turn on (or power on),reset your device.
If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
Let charge for at least twenty minutes, then see if it starts normally.
If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
If the screen displays a red battery icon, continue charging the device until the battery is fully charged.
If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
Connect the device to your computer and open iTunes.
If the device appears in iTunes, select and click Restore on the Summary pane. Learn more about restoring iOS software.
If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
If the above steps do not resolve the issue, contact Apple.
You can find the full article here:
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
If you get to step 5, I recommend backing up your iPhone before performing the restore:
iOS: How to back up and restore your content
http://support.apple.com/kb/HT1766
Thank you for using Apple Support Communities.
Best,
Sheila M. -
So my phone won't turn on and when I plug it in it just flashs the apple logo
Anyone help me out. Oh I also already tried holding the power and home button and nothing.
Hello RyukBelmont
Try putting your iPhone in to recovery-mode and restore it to see if it comes back on. With your iPhone powered off, plug it into your computer and hold the Home Button, you will then see a Connect to iTunes icon and you will have the option to restore. It will erase all the data on your iPhone, but if you have a back up you can restore from it.
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
iOS: How to back up and restore your content
http://support.apple.com/kb/HT1766
Regards,
-Norm G. -
i wanted to reset my iphone 4 from the phone settings and everything started okay until i realised it was not working at all now my phone is tuck with the apple logo and won't start can not connect to the itunes store as well what to do please help
Place your iPhone into recovery mode as described here. You may have to try to enter recovery mode more than once to succeed.
http://support.apple.com/kb/HT1808 -
I responded to install new software message and was asked to restart--I did that--went to lunch and when I returned my screen showed the message that said, "unable to complete update for unknown reason" or something to that regard-and asked me to restart. I tried to restart and now see the apple but the time scroll is in an unending loop and my computer will not boot.-I recently installed snow leopard in order to be able to sync my mobile me accounts--since then my computer runs hot. Not sure if that has anything to do with current issue.
You will need to reinstall Snow Leopard:
Reinstall OS X without erasing the drive
Do the following:
1. Repair the Hard Drive and Permissions
Boot from your Snow Leopard Installer disc. After the installer loads select your language and click on the Continue button. When the menu bar appears select Disk Utility from the Utilities menu. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the installer.
If DU reports errors it cannot fix, then you will need Disk Warrior and/or Tech Tool Pro to repair the drive. If you don't have either of them or if neither of them can fix the drive, then you will need to reformat the drive and reinstall OS X.
2. Reinstall Snow Leopard
If the drive is OK then quit DU and return to the installer. Proceed with reinstalling OS X. Note that the Snow Leopard installer will not erase your drive or disturb your files. After installing a fresh copy of OS X the installer will move your Home folder, third-party applications, support items, and network preferences into the newly installed system.
Download and install the appropriate Combo Updater to return to the Snow Leopard version you prefer from support.apple.com/downloads/. -
phone wont progress from icloud transfer
Hey there ddjild,
It sounds like you are restoring your previous phones backup to your new one, but the progress bar appears to be stuck. According to this article:
iOS: Apple logo with progress bar after updating or restoring from backup
http://support.apple.com/kb/TS3681
the process can take from several minutes to an hour to complete. The amount of time depends on the number of files on the device and whether you're erasing, updating, or upgrading your iOS.
If the device has stil not finished the process, I would recommend resetting the device with the following article:
Turn your iOS device off and on (restart) and reset
http://support.apple.com/kb/ht1430
To reset, press and hold both the Sleep/Wake and Home buttons for at least 10 seconds, until you see the Apple logo.
If that does not get the phone booted back to the Lock Screen so you can get to your Home Screen, I would next try putting the device into recovery mode and attempting another restore from that backup:
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Thank you for using Apple Support Communities.
Cheers,
Sterling -
I'm using Windows XP (I think), and MS Office 97 (I think), on a PC.
Hi Mac Attack,
My computer will not disconnect from the internet. It seems to find a clone router and continues even when I shut down and unplug my my own home iy
Your main question was 'chopped' in the title. Please reply in the body of a reply box with the full question and anything you have tried. And no, the long report was not helpful .
If the same website is opening each time you launch a browser (Safari?) hold down the shift key as you launch to prevent previous pages from opening.
Have a look at your settings in Safari > Preferences. Especially General and Privacy.
Reset Safari to remove cookies and other stored data.
System Preferences > General
Have a look at your settings in System Preferences > Security & Privacy.
Call back with more questions.
Regards,
Ian -
When I open up Firefox the page is blank. I have to click on the tool bar to open it. Never did this before. In general options, it says on start up, "when firefox starts" And I have it set to "show my home page" Page is still blank.
Could you describe in a bit more detail what you mean by clicking on the toolbar to open your home page: are you clicking the Home button, or using reload, or using a bookmark?
Does the same problem occur when you open a new window (Ctrl+n), or only when you use your Firefox desktop icon?
''If the problem is specific to your shortcut on the desktop:''
Check whether the shortcut specifies any command-line parameters. Here's what I mean:
right-click the icon > Properties > Shortcut tab
The "Target" line should be selected. That line should not have any extra stuff after the following:
32-bit Windows:
"C:\Program Files\Mozilla Firefox\firefox.exe"
64-bit Windows:
"C:\Program Files (x86)\Mozilla Firefox\firefox.exe"
If you see extra text after that, clear it out, save your change, and try the shortcut again. Any improvement?
Maybe you are looking for
-
I am new to Main Stage. I have not bought any hardware interfaces yet because I don't know what will be the most flexible in the long run. I would be using the Main Stage's innate synths and keyboards, drums, an acoustic/electric guitar, bass, harmon
-
im new to java programming and i really don't know most of the terms like state set. I was trying to figure out how to make a JScrollPane only appear when it was necessary when someone suggested to read the JScrollPane API. I don't even know what API
-
How to make contents to be displayed in sam window by selec node in JTree
hi, am a starter only, i need some help in JTree. I was able to make a tree using JTree. But the problem is..i want the contents corresponding to each node selected, at right side of the window.. Just like we select node of a tree which is left side
-
Maintaining 16:9 aspect ratio when exporting
I am still using FCP 5.0.4 and Compressor 2.0.1. My problem is that I can not work out how to export FCP projects in 16:9 aspect. All my raw files in FCP are either 16:9 .mov files from DVD's or footage from my Sony PDX10P in widescreen format. They
-
I have 2 Content Sources crawled to URL1 and URL2. While searching in 'Everything' navigation link, I need to have a URL1 refiner on the left that shows only contents from URL1. Can I do that?