HT1937 iphone 3GS carrier always says no service and can't activating
my iphone 3GS always shows no service each time i use a card.
i have just upgrade ios 6.0 and iwant to activate it
but because of the sim card i can't activate my iphone 3GS.
can anyone help me?
everything is accepted...
Riandy Radiation wrote:
what kind of sim that support locked 3gs???
A SIM from the carrier that the device is locked to.
Riandy Radiation wrote:
or is there any tool for unlocking??
No, there are no tools for unlocking.
Only the carrier the device is locked to can officially unlock it. Contact them to find out their requirements for unlocking.
Similar Messages
-
i got problem updating my iphone 3g. my phone doesn't work now. it says no service and can not be activated.beside that it says insert sim even it has sim. please help me.
I have just created this account to tell you that nothing would change if you restored your phone.
The first NO SIM nuisance happened just a week ago. Nothing had been done to the phone before that. I pressed HOME + POWER buttons to restart the phone and SIM card was successfully recognized as if nothing had happened. Then I had a lucky week, not reminded of this issue at all.
Today, however, the same problem keeps annoying me. I've used the same method to heal the phone but all I have done seems more like a placebo. So I tried the ultimate solution, restroing it in iTunes.
Ridicuously, the moment I finished basic setup on the newly restored phone, the same NO SIM CARD INSTALLED message poped up.
So IMO, it's not what you should do to erase and restore your phone.
Plus, I called my native carrier and they said no such problems have been submitted. And since my nano SIM card is quite new (three months old), I'm not going to replace it.
I googled this problem and found something on a Hong Kong webpage. The author of that thread points out that there is a flaw in the SIM card tray that prevents the phone from successfully recognizing SIM cards.
And I really hope Apple could probe into this issue and give official solutions other than restarting / restoring the phone like an idiot. -
My iphone 3gs home screen is very enlarged and can not use slider to go any further, please help
i have switch my iphone 3gs on and the screen is very enlarged and can not use slider bar and go any further on the phone, i have taken sim out and re inserted it and no change, can you help please
http://support.apple.com/kb/TS3129
-
My iphone 4 says no service and can not make phone calls
my iphone cant make calls and it says no service
Hi i have noticed same problem today , I connected to Itunes yesterday night and since today morning I have experiencing " NO Service" problem. if I restart the phone it works for sometime, then goes back to "no service" mode. I changed my location took the phone for a drive, didnt help. most of the time it goes into "no service" mode as soon as I disconnect a call. I am in UK on Vodafone network. I did factory resetting and loaded my back up. It worked for few hours then back to same situation. any pointers?
-
Need Iphone 3GS carrier unlocked..
Hi I am looking for a Iphone 3GS carrier unlocked....Where can I buy?
I live in the UK and paid £440 back in February, had it officially unlocked via the network o2 for £15. So if you find a legit UK Ebayer selling an o2 officially unlocked iPhone, you should be safe. Ask the seller questions for reassurance. The reason why I say this cos I bought a phone EBay once that turned out to be jailbroken, luckily the seller took it back and refunded me.
-
Whenever I try to sync my iPhone 3Gs it always fails, saying the device timed out. Any suggestions with what to do??
Did you recently restore or update your iPhone?
-
Hello! I want to sell my iphone 3g because i have 3gs- i cleared the info in settings and now have black screen saying no service and usb port pointing to itunes - is that all i do ? i am pretty ignorant of computers- lol- i had read that i need to plug it back into itunes to verify it has all cleared out- i want to sell it on craigs list or ebay- i am really hurting for money right now- all your answers appreciated...
It needs to be restored by someone. You can do it, and set it up as a new phone, or the buyer can do it.
-
network says "no service" and it sometimes do have 1 up to 3 bars and until the signal lost (iphone 3gs) ios6.0.1 help plzz...
Have a look at this it might help
http://support.apple.com/kb/TS4148 -
I just got an iPhone 4s and ever since I updated to ios 6.1, it always says my service is "searching"
See:
iOS: Troubleshooting applications purchased from the App Store
Contact the developer/go to their support site if only one app.
Restore from backup. See:
iOS: How to back up
Restore to factory settings/new iPod -
IPhone 3gs says no service and cannot activate it.
I am trying to activate my iPhone 3gs and it says 'No Service' and when connected to iTunes it says that there is no sim card installed. I think it is on i.o.s 5 but not entirely sure as i bought it off of eBay and fixed it.
When i try to activate it on wi-fi it says the activation server is currently down.
Thanks for any advice you could give me on how to get it workingHere's what you do
1.Make sure your phone is not plugged into the computer.
2. Put the iPhone into recovery mode (this is NOT DFU mode). Do this by
a). Hold down both the power/sleep button and the home button until the screen turns black/off
b). As soon as this happens release the power button but NOT the home button
c). If done correctly then the Apple logo will appear, KEEP HOLDING THE HOME BUTTON and eventually a connect to itunes graphic will appear. You can release the home button
3. With the connect to itunes graphic on the screen, plug your phone into the computer. iTunes will start up if it is not already on, and then will say the phone needs restoring. Ignore this and COMPLETELY quit iTunes.
4. With iTunes off and the graphic still on the phone screen, hold down both the power/sleep and the home button again for 9 seconds (count 100, 200, 300...) or until the screen goes black
5. When the screen goes black release the home button straight away.
6. It will start up with the iPhone activation screen ignore this. iTunes should have started up, if not do so. Go to the iPhone tab and either resotre from backup or set up as a new phone.
You're welcome -
Transferred from iPhone 3GS to 4. Backed up and restored smoothly. Still getting a "no service" message in the upper left corner of new phone. Help?.....
Sounds like your iPhone was hacked to unlock and now updating locks back to the original carrier.
Where did you get the iPhone? -
I have just moved to Spain and out in a Spanish sim into my Irish bought iPhone 4. It says 'invalid sim' and 'no service'. The phone is not locked to any provider. I have been told that its a handset issue. Please advise.
1). Are you positive the phone is not locked? Where did you buy it? Did you get it unlocked from your original carrier? Only Apple sells unlocked phones in most countries.
2). Did you try with a diffrent SIM. MAybe the one you have is defective.
3). Does the Spnaish carrier you are using support the iPhone? Who told you it is a handset issue? -
iPhoto won't recognize my iPhone 3Gs. just says there's an "apple iPhone" instead of the device name, and says there are no files to download, but there are 62 items on my phone... what's going on? as far as I can tell I have everything up to date and it's always worked in the past.
Have you already confirmed your Mac as a trusted device? Try this:
Lauch iTunes.
Connect the Phone/iPad
When it asks you to trust it, say yes.
Now try again to import. -
I updated my iphone and when it came time for activation it won't work and keeps telling me to try again. At the top it says "No Service" and I have my SIM card in and a good WiFi connection and have connected it through iTunes but it says I have no SIM card and need to disconnect and insert my SIM. I don't understand why this keeps happening and it's been going on for a wile now. I have tried over and over again to get this iPhone to work but nothig is happening. I've even gone on the website for support (apple.com/support) but cannot find anything that will help me with this situation. Can someone please help me find a solution to this problem? I have been without a phone and do not have money to buy another one and it is crucial for me to get it fixed. Thanks.
wesb
What computer operating system is involved in the Premiere Elements 11 and 13 issues? Same computer or different ones? Are you installing from purchased download installation files or from purchased installation disc? Does Premiere Elements 11 work completely on this computer whereas 13 will not?
Let us go through the typical drill so as to take nothing for granted.
1. Does the problem exist with or without the antivirus and firewall(s) disabled? Are you working with an individual home computer or in a
school or company network?
2. Are you running the program as Administrator and is there any "domain" account involved?
3. Is your video card/graphics card up to date according to the web site of the manufacturer of the card?
4. Do you have the latest version of QuickTime installed on the computer with Premiere Elements?
Let us start by ruling in or out any of the above, and then we can decide what next.
Any questions or need clarification, please do not hesitate to ask.
Thank you.
ATR -
My iphone 3gs will not connect to itunes and it says that I need to do a system restore. It also says that I need to enter my password on the iphone to connect to itunes but I can not do this because the phone is in emergency phone call mode only.
Turn your phone off and connect your cable to the computer, but not the device just yet. Start up iTunes. Now, hold down the home button on your phone and plug it in to the cable - don't let go of the button until iTunes tells you it's detected a phone in recovery mode. Now you can restore to factory settings.
Unfortunately, the data on your phone is already gone if you're seeing the connect to iTunes logo.
Maybe you are looking for
-
Hi, I need to pull out few PERNRs from diffrent payroll areas whose hiring date is 01.04.2013 and Retroactive accounting must be done for them after April 2013. Plese help
-
I am working in LR4 for 30 day and I received an error message; ( bad argument #1 to 'ipairs') (table expected, got nil)) when I am using spot removal. What happen ? It was working fine. Help
-
ICal alarm does not wake up mac
Hi, I'm trying to set up alarm in iCal to launch app at scheduled time. It works when the mac is up and running. But if mac was sleeping at the scheduled time, alarm is missed. I've read from somewhere that the new iCal in Leopard is able to wake up
-
I have a swf file which has a simple animation on it. If I import that animation then apply an effect like a tween, the effect on the animation works great the first time. If I go to the next slide then click back, the effect on the animation does no
-
Syntax error in program ZDOECL_000_00B_STRWRPR when load USERDETAILS MI 7.1
Hi experts, I have a problem, i install MI 7.1 with SP09. I configure all, i have all Distribution Model and Data Objects in green, but, when i do a initial download or delta download for USERDETAILS, appear an error in the queue: In the include "ZDO